Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2205.02716 · AVS Quantum Science

TV and video game streaming with a quantum receiver: A study on a Rydberg atom-based receiver's bandwidth and reception clarity

Nikunjkumar Prajapati, Andrew P. Rotunno, Samuel Berweger, Matthew T. Simons, Alexandra B. Artusio‐Glimpse, Stephen Voran, Christopher L. Holloway

Published Aug 17, 2022• 55 citations
arXivHTMLPDF

Abstract

We demonstrate the ability to receive live color analog television and video game signals with the use of the Rydberg atom receiver. The typical signal expected for traditional 480i National Television Standards Committee format video signals requires a bandwidth of over 3 MHz. We determine the beam sizes, powers, and detection method required for the Rydberg atoms to receive this type of signal. The beam size affects the average time the atoms remain in the interaction volume, which is inversely proportional to the bandwidth of the receiver. We find that small beam diameters (less than 100 μm) lead to much faster responses and allow for color reception. We demonstrate the effect of the beam size on bandwidth by receiving a live 480i video stream with the Rydberg atom receiver. The best video reception was achieved with a beam width of 85 μm full-width at half-max.

DOI
10.1116/5.0098057

Related papers

Quantum-Limited Atomic Receiver in the Electrically Small Regime

Kevin C. Cox, David H. Meyer, Fredrik K. Fatemi +1 more

We use a quantum sensor based on thermal Rydberg atoms to receive data encoded in electromagnetic fields in the extreme electrically small regime, with a sensing volume over 10^{7} times smaller than the cube of the electric field wavelength. We introduce the standard quantum limit for data capacity, and experimentally observe quantum-limited data reception for bandwidths from 10 kHz up to 30 MHz. In doing this, we provide a useful alternative to classical communication antennas, which become increasingly ineffective when the size of the antenna is significantly smaller than the wavelength of the electromagnetic field.

arXiv:1805.09808•Physical Review Letters•Sep 11, 2018•184 citations

Instantaneous Bandwidth Enhancement Measurement of Rydberg Atoms Based on Laser Rabi Frequency

Qimeng Wang, Qiang An, Yunqi Fu

Improving the bandwidth of Rydberg atom-based receivers is an ongoing challenge because of the long-lived Rydberg state lifetimes that limit the refresh rate of ground-state atoms. In particular, the local oscillator (LO)-based Rydberg mixer approach allows for bandwidths in a few MHz ranges. Here, we use the laser parameters of the Rydberg atomic receiver superheterodyne detection technology to study their respective bandwidths. We have confirmed through experiments that laser power and waist diameter can affect the Rabi frequency and thus alter the instantaneous bandwidth. The experimental results indicate that the instantaneous bandwidth is directly proportional to the Rabi frequency of the coupled light and inversely proportional to the Rabi frequency of the probe light. Optimal parameters for quantum sensing applications are identified through powerdependent Rabi oscillation measurements.

International Conference on Microwave and Millimeter Wave Technology (ICMMT)•May 19, 2025•0 citations

Detecting and Receiving Phase-Modulated Signals With a Rydberg Atom-Based Receiver

Christopher L. Holloway, Matthew T. Simons, Joshua A. Gordon +1 more

The recent developments of Rydberg atom-based sensors with the ability to measure phase have made it possible to receive digital phase-modulated signals. In this letter, we demonstrate the reception of binary phase-shift keying, quadrature phase-shift keying, and quadrature amplitude modulation signals with an atom-based receiver. We present measured values of error vector magnitude as a function of symbol rate for various modulation schemes and discuss the bandwidth of a Rydberg atom-based receiver system. The results show that we can now interrogate ensembles of atoms to such extent that we can use them to receive data from a phase-modulated communication signal.

arXiv:1903.10644•IEEE Antennas and Wireless Propagation Letters•Jul 29, 2019•157 citations

Bandwidth Enhanced Rydberg Atomic Quantum Receivers for Wireless Communication and Sensing

Huizhi Wang, Tierui Gong, Emil Björnson +1 more

Rydberg atomic quantum receivers (RAQRs) have emerged as highly sensitive receivers for future communication and sensing systems. However, conventional RAQRs are primarily effective for single-carrier and narrowband reception, typically with an operational bandwidth of only a few hundred kilohertz. To enable the reception of multi-carrier signals with larger bandwidth, we propose a multi-carrier Rydberg atomic quantum receiver (MC-RAQR) architecture based on a five-level quantum system model. We analyze the amplitude and phase of the output laser in MC-RAQR and extract the baseband electrical signal for signal processing. Furthermore, we quantify the performance of MC-RAQR in multi-carrier communication and sensing by studying the channel capacity and distance estimation, respectively. Numerical results show that the MC-RAQR is capable of achieving a bandwidth of $7.2$ MHz, which is an order of magnitude larger than conventional RAQRs. Besides, compared to conventional receivers, MC-RAQR can improve the capacity and distance estimation by $18$-fold and $10^3$-fold, respectively. This validates the superiority of MC-RAQR in receiving multi-carrier signal, and demonstrates its compatibility in detecting waveforms such as orthogonal frequency‐division multiplexing.

International Conference on Communications•May 24, 2026•0 citations

Bridging gaps in Rydberg RF receivers using modulation transfer bandwidth enhancement

Mickael Branco, K V Adwaith, Gabriel Boccara +5 more

We optimize theoretically and experimentally the performances of the recently demonstrated modulation transfer protocol [D.-A. Trinh, K. V. Adwaith, M. Branco, A. Rouxel, S. Welinski, P. Berger, F. Goldfarb, and F. Bretenaker, Applied Physics Letters 125, 154001 (2024)] aiming at extending the bandwidth of quantum RF receivers based on hot Rydberg atoms. This optimization relies on tuning the parameters of the phase modulation of the coupling beam, which is converted by the nonlinear response of the atoms into an amplitude modulation of the probe beam. We develop a theoretical model to optimize both the modulation frequency and the modulation amplitude of the coupling beam, thereby maximizing the atomic response. Once optimized, the sensitivity to detuned RF fields of this modulation transfer protocol is measured and compared with that of the conventional protocol. This comparison shows that the new protocol permits a strong increase in the detection bandwidth. Indeed, it outperforms the usual one as soon as the RF signal to be measured is detuned by more than a few MHz. We illustrate the capability of this modulation transfer protocol to enhance the detection bandwidth by showing experimentally how it permits to bridge the gap between two Rydberg transitions separated by 166 MHz. In all cases, the experimental results are in good agreement with the simulations.

quant-pharXiv:2601.02070•Physical Review Applied•Jan 6, 2026•0 citations

Reception of a Broadband Noise-Like Spread Spectrum Waveform Using a Rydberg Atom-Based Quantum RF Receiver

Hoang-Van Do, David Bair, Eric Bottomley +3 more

We present experimental results demonstrating broadband reception of a noise-like spread-spectrum waveform using a Rydberg atom-based quantum radio frequency (RF) receiver. The transmitted waveform occupies a 20 MHz bandwidth around a 2.5 GHz carrier and is intentionally engineered to exhibit noise-like spectral characteristics. To enable recovery of this broadband signal, the Rydberg sensor was configured to achieve sufficiently uniform sensitivity across intermediate frequencies up to 10 MHz (corresponding to a ±10 MHz signal band about the carrier, i.e., 20 MHz total bandwidth). Under these conditions, we demonstrate successful detection and recovery of noise-like spread-spectrum waveforms spanning a 20 MHz bandwidth. These results validate the feasibility of using atomic sensors for broadband RF waveform reception and highlight their potential in photonics-enabled RF sensing applications.

IEEE photonics journal•Apr 9, 2026•0 citations
We demonstrate the ability to receive live color analog television and video game signals with the use of the Rydberg atom receiver. The typical signal expected for traditional 480i National Television Standards Committee format video signals requires a bandwidth of over 3 MHz. We determine the beam sizes, powers, and detection method required for the Rydberg atoms to receive this type of signal. The beam size affects the average time the atoms remain in the interaction volume, which is inversely proportional to the bandwidth of the receiver. We find that small beam diameters (less than 100 μm) lead to much faster responses and allow for color reception. We demonstrate the effect of the beam size on bandwidth by receiving a live 480i video stream with the Rydberg atom receiver. The best video reception was achieved with a beam width of 85 μm full-width at half-max.
We use a quantum sensor based on thermal Rydberg atoms to receive data encoded in electromagnetic fields in the extreme electrically small regime, with a sensing volume over 10^{7} times smaller than the cube of the electric field wavelength. We introduce the standard quantum limit for data capacity, and experimentally observe quantum-limited data reception for bandwidths from 10 kHz up to 30 MHz. In doing this, we provide a useful alternative to classical communication antennas, which become increasingly ineffective when the size of the antenna is significantly smaller than the wavelength of the electromagnetic field.
Improving the bandwidth of Rydberg atom-based receivers is an ongoing challenge because of the long-lived Rydberg state lifetimes that limit the refresh rate of ground-state atoms. In particular, the local oscillator (LO)-based Rydberg mixer approach allows for bandwidths in a few MHz ranges. Here, we use the laser parameters of the Rydberg atomic receiver superheterodyne detection technology to study their respective bandwidths. We have confirmed through experiments that laser power and waist diameter can affect the Rabi frequency and thus alter the instantaneous bandwidth. The experimental results indicate that the instantaneous bandwidth is directly proportional to the Rabi frequency of the coupled light and inversely proportional to the Rabi frequency of the probe light. Optimal parameters for quantum sensing applications are identified through powerdependent Rabi oscillation measurements.
The recent developments of Rydberg atom-based sensors with the ability to measure phase have made it possible to receive digital phase-modulated signals. In this letter, we demonstrate the reception of binary phase-shift keying, quadrature phase-shift keying, and quadrature amplitude modulation signals with an atom-based receiver. We present measured values of error vector magnitude as a function of symbol rate for various modulation schemes and discuss the bandwidth of a Rydberg atom-based receiver system. The results show that we can now interrogate ensembles of atoms to such extent that we can use them to receive data from a phase-modulated communication signal.
Rydberg atomic quantum receivers (RAQRs) have emerged as highly sensitive receivers for future communication and sensing systems. However, conventional RAQRs are primarily effective for single-carrier and narrowband reception, typically with an operational bandwidth of only a few hundred kilohertz. To enable the reception of multi-carrier signals with larger bandwidth, we propose a multi-carrier Rydberg atomic quantum receiver (MC-RAQR) architecture based on a five-level quantum system model. We analyze the amplitude and phase of the output laser in MC-RAQR and extract the baseband electrical signal for signal processing. Furthermore, we quantify the performance of MC-RAQR in multi-carrier communication and sensing by studying the channel capacity and distance estimation, respectively. Numerical results show that the MC-RAQR is capable of achieving a bandwidth of 7.27.27.2 MHz, which is an order of magnitude larger than conventional RAQRs. Besides, compared to conventional receivers, MC-RAQR can improve the capacity and distance estimation by 181818-fold and 10310^3103-fold, respectively. This validates the superiority of MC-RAQR in receiving multi-carrier signal, and demonstrates its compatibility in detecting waveforms such as orthogonal frequency‐division multiplexing.
We optimize theoretically and experimentally the performances of the recently demonstrated modulation transfer protocol [D.-A. Trinh, K. V. Adwaith, M. Branco, A. Rouxel, S. Welinski, P. Berger, F. Goldfarb, and F. Bretenaker, Applied Physics Letters 125, 154001 (2024)] aiming at extending the bandwidth of quantum RF receivers based on hot Rydberg atoms. This optimization relies on tuning the parameters of the phase modulation of the coupling beam, which is converted by the nonlinear response of the atoms into an amplitude modulation of the probe beam. We develop a theoretical model to optimize both the modulation frequency and the modulation amplitude of the coupling beam, thereby maximizing the atomic response. Once optimized, the sensitivity to detuned RF fields of this modulation transfer protocol is measured and compared with that of the conventional protocol. This comparison shows that the new protocol permits a strong increase in the detection bandwidth. Indeed, it outperforms the usual one as soon as the RF signal to be measured is detuned by more than a few MHz. We illustrate the capability of this modulation transfer protocol to enhance the detection bandwidth by showing experimentally how it permits to bridge the gap between two Rydberg transitions separated by 166 MHz. In all cases, the experimental results are in good agreement with the simulations.
We present experimental results demonstrating broadband reception of a noise-like spread-spectrum waveform using a Rydberg atom-based quantum radio frequency (RF) receiver. The transmitted waveform occupies a 20 MHz bandwidth around a 2.5 GHz carrier and is intentionally engineered to exhibit noise-like spectral characteristics. To enable recovery of this broadband signal, the Rydberg sensor was configured to achieve sufficiently uniform sensitivity across intermediate frequencies up to 10 MHz (corresponding to a ±10 MHz signal band about the carrier, i.e., 20 MHz total bandwidth). Under these conditions, we demonstrate successful detection and recovery of noise-like spread-spectrum waveforms spanning a 20 MHz bandwidth. These results validate the feasibility of using atomic sensors for broadband RF waveform reception and highlight their potential in photonics-enabled RF sensing applications.