this study significantly emphasizes on the entanglement engineering using a transmon qubit. A transmon qubit is created with two superconducting islands coupled with two Josephson Junction embedded into a transmission line. The transmon qubit energies are manipulated through its coupling to the transmission line. The key factor here is the coupling factor between transmission line and qubit by which the quantum features of the system such as transmon decay rate, energy dispersion, and related coherence time are controlled. To complete knowledge about the design, the system is quantum mechanically analyzed and the related Hamiltonian is derived. Accordingly, the dynamics equation of motions is derived and so the energy dispersion and the coupled system coherence time are investigated. The system engineering should be established in such a way that satisfies the energy dispersion and the coherence time. However, to analyze the entanglement between modes, it needs to calculate the number of photons of the transmission lines and the transmon qubit, and also the phase sensitive cross-correlation. The important section of this study emphasizes on engineering the coupling between the transmon qubit and transmission line to enhance the entanglement. The results show that around the Josephson Junction location where the more coupling is established the more entanglement between modes is created.
this study significantly emphasizes on the entanglement engineering using a transmon qubit. A transmon qubit is created with two superconducting islands coupled with two Josephson Junction embedded into a transmission line. The transmon qubit energies are manipulated through its coupling to the transmission line. The key factor here is the coupling factor between transmission line and qubit by which the quantum features of the system such as transmon decay rate, energy dispersion, and related coherence time are controlled. To complete knowledge about the design, the system is quantum mechanically analyzed and the related Hamiltonian is derived. Accordingly, the dynamics equation of motions is derived and so the energy dispersion and the coupled system coherence time are investigated. The system engineering should be established in such a way that satisfies the energy dispersion and the coherence time. However, to analyze the entanglement between modes, it needs to calculate the number of photons of the transmission lines and the transmon qubit, and also the phase sensitive cross-correlation. The important section of this study emphasizes on engineering the coupling between the transmon qubit and transmission line to enhance the entanglement. The results show that around the Josephson Junction location where the more coupling is established the more entanglement between modes is created.
The leading approach to attempt quantum computing is based on superconductors. In particular, Circuit Quantum Electrodynamic systems (circuit QED) are used to couple photons stored in a microwave resonator to a quantum bit (qubit), allowing the qubit to be controlled and measured. A lumped element parallel RLC circuit will be used to model a superconducting coplanar microwave resonator, in order to gain an intuitive understanding of how various parameters affect its electromagnetic properties, and how they can be optimised to provide desired specifications. Resonator quality factors will also be realised, which describe the effects of coupling the microwave resonator to external input/output transmission lines. The qubit is generated by a superconducting capacitively shunted Josephson Junction; the transmon, and its operation and non-linear behaviour will be discussed in this report. The transmon is integrated with a microwave resonator to generate the circuit QED system, and the derivation of the systems Hamiltonian will allow us to determine the equations describing the behaviour of the system, and therefore how it may be controlled and measured. The Bloch sphere will be introduced, which provides a useful geometric representation of the state space of a two-level quantum system. Mapping the derived Hamiltonian to the time-dependent Schrodinger equation facilitates realisation of control mechanisms of the qubit based on rotations about the Bloch sphere.
Superconducting qubits are a promising technology for building a scalable quantum computer. An important architecture employed in the field is called Circuit Quantum Electrodynamics (circuit QED), where such qubits are combined with high quality microwave cavities to study the interaction between artificial atoms and single microwave photons. The ultra-strong coupling achieved in these systems allows for control and readout of the quantum state of qubits to perform quantum information processing. The work on circuit QED performed in this thesis consisted of realizing an experimental setup for qubit experiments in a new laboratory, investigating the coherence and decay of higher energy levels of superconducting transmon qubits and finally demonstrating a novel coaxial form of circuit QED. Designing and building a 3D circuit QED setup involved the following main accomplishments: producing high quality 3D cavities; designing and installing the cryogenic microwave setup as well as the room temperature amplification and data acquisition circuitry; successfully developing a recipe for the fabrication of Josephson junctions; controlling and measuring superconducting 3D transmon qubits at 10mK. Several qubits were fully characterised and have shown coherence times of several microseconds and relaxation times up to 25μs. Superconducting qubits in fact possess higher energy levels that can provide significant computational advantages in quantum information applications. In experiments performed at MIT, preparation and control of the five lowest states of a transmon qubit was demonstrated, followed by an investigation of the phase coherence and decay dynamics of these higher energy levels. The decay was found to proceed mainly sequentially with relaxation times in excess of 20μs for all transitions. A direct measurement of the charge dispersion of these levels was performed to explore their characteristics of dephasing. This experiment was also reproduced on a 3D transmon fabricated and measured in Oxford, where due to a higher effective qubit temperature a multi-level decay model including thermal excitations was developed to explain the observed relaxation dynamics. Finally, a coaxial transmon, which we name the coaxmon, is presented and measured with a coaxial LC readout resonator and input/output coupling ports placed inline along the third dimension. This novel coaxial circuit QED architecture holds great promise for developing a scalable planar grid of qubits to build a quantum computer.
Superconducting quantum computing is a solid state quantum computing technology based on Josephson junction circuits. It becomes one of the most promising candidates for realizing practical quantum computer/simulator, because of its scalability, easy to coupling and control, compatibility to semiconductor technologies, etc. As the complicated electromagnetic environment in solid state metal and insulator, superconducting quantum bits (qubits) suffered from shot coherence time since its early development. In this review, we described some recently developed superconducting qubit structures, including Transmon/Xmon, Fluxonium and C-shunt flux qubit. Although these new qubit structures have very different circuit parameters and energy scales, they all find their way to effectively suppress environmental noises. As a result, their coherence time were improved significantly. Transmon, a transmission-line shunted plasma oscillation qubit, was now among the most popular structures for building a multi-qubit superconducting quantum circuit. It introduced a relatively large shunt capacitor to remarkably reduce the charge dispersion. Although the non-linearity is also decreased, by operating in a properly chosen EJ/Ec, transmon can greatly reduce the charge noise while only sacrificing a small amount of non-linearity. Xmon can be considered as a modified version of transmon. It is designed and optimized for multi-qubit operation and measurement with separate X/Y and Z control lines for each qubit, and a readout bus (a transmission line or a low-Q bandpass filter) for simultaneous readout of all the qubits. Fluxonium provide another solution for suppressing the charge noise in Cooper-pair box (CPB). It introduces a large shunt inductance to filter low-frequency offset charge in the small capacitor of the phase-slip junction (the small junction). To keep the qubit operating in the charge region, the shunt inductor should be large enough to keep the impedance larger than the superconducting impedance quantum RQ~1 kΩ. As a result, the inductance can only be provided by a large series of Josephson junctions. Fluxonium keeps the advantage of high anharmonicity of CPB. In addition, it introduces another degree of freedom: external flux Φext. Quasiparticles (electrons or holes) tunneling at the small junction add coherently to produce a ″1+cosφ″ term. As a result, when Φext= Φ0/2, dissipation caused by quasiparticle tunneling is suppressed and the energy relaxation time (T1) increases drastically. C-shunt flux qubit (CSFQ) decreases α and EJ to suppress flux noise in the qubit. While the charge noise becomes the dominant noise source, a large shunt capacitor is added to suppress the charge noise, similar to that in a transmon qubit. It is worth to notice that in CSFQ, the α decreases to below but near 1/2. As a result, the double-well potential no longer exists. The energy structure become similar to transmon, with the anharmonicity be opposite. CSFQ can get a much improved coherence time, while its anharmonicity can be larger than that of transmon. Those new superconducting qubit structures provide different solutions to improve the coherence time. Although it looks much different in circuit models and parameters, they have ideas in common, and may act as guides to other novel designs with longer coherence time. We can summarize as below. (1) The qubit circuit should be free of small superconducting islands. Charge fluctuation in small islands is a major source of decoherence. As a result, increase the area of the islands, that is, increase the capacitance becomes a straight forward way to suppress the charge noise. In Fluxonium, the small junction is connected with a large series of large junctions that there is also no small islands in the whole loop. (2) Remove superconducting loops in the qubit circuit, or minimize the loop size and loop current to suppress flux noise. (3) Bias the phase difference of the small junction to π, where dissipation caused by quasiparticle tunneling can be suppressed coherently. (4) Decrease the coupling bandwidth of qubit to the environment. In a circuit-QED readout scheme, a high-Q readout resonator that dispersively coupled to the qubit protects the qubit from exposed to the electromagnetic environment of the readout circuit. A ″Purcell filter″ can also be added to suppress such decoherence further. In conclusion, we overviewed some qubit engineering techniques or ideas to improve the coherence time, which is a very important figure for building practical quantum computer/simulator. We hope that someone can combine and optimize these ideas, while interact with developments in materials and micro-fabrication technologies, to develop novel new generation superconducting qubit structures in the near future.
Abstract Superconducting quantum circuits are a leading platform for quantum-information processing, but their development requires expertise spanning device design, microfabrication, cryogenic operation, microwave control, and quantum characterization. In this work, we report the realization of a flux-tunable superconducting transmon platform and present an integrated workflow encompassing design, fabrication, measurement, and numerical modeling. The device consists of an Al/AlOx/Al transmon coupled to a three-dimensional microwave cavity operating in the circuit quantum electrodynamics (cQED) dispersive regime. Two-tone spectroscopy reveals a fundamental transition frequency of ω01=5.0122GHz and an anharmonicity of α/2π=−202.4MHz , corresponding to EJ/EC≈82.9 . Flux spectroscopy yields a cavity-qubit coupling strength of g/2π=260MHz , while the cavity linewidth gives a loaded quality factor of QL=6127 and a Purcell limit of T1Purcell≈82μs . Time-domain measurements yield coherence times of T1=17.4μs and T2∗=5.8μs . To investigate coherence and dissipation in the device, the experimental observations are analyzed within a Lindblad master-equation framework describing cavity photon loss and thermal excitation, qubit energy relaxation, and pure dephasing processes. Using a set of experimentally extracted parameters, the model reproduces the measured spectroscopic and time-domain observables, providing a quantitative description of the open-system dynamics of the transmon-cavity platform. The analysis shows that the measured coherence is primarily limited by pure dephasing and energy-relaxation processes, whereas thermal excitation plays a minor role under the experimental conditions. Inspired by the broader framework of quantum dissipation in macroscopic quantum systems pioneered by Caldeira and collaborators, this approach enables a quantitative analysis of relaxation and dephasing processes in superconducting quantum circuits. Beyond the characterization of a single device, the present work demonstrates the establishment of the expertise, infrastructure, and experimental workflow required for the design, fabrication, measurement, and modeling of superconducting quantum circuits, contributing to the development of quantum technologies in Brazil and related applications.
PhD Thesis: Superconducting circuit quantum electrodynamics (QED) has developed into a powerful platform for studying the interaction between matter and different states of light. In this context, superconducting quantum bits (qubits) act as artificial atoms interacting with quantized modes of the electromagnetic field. The field can be trapped in superconducting microwave resonators or propagating in transmission lines. In this thesis, we particularly study circuit QED systems where microwave fields are coupled with superconducting flux and transmon qubits. We optimize the coherence properties of the resonators, by analyzing loss mechanisms at excitation powers of approximately one photon on average. We find that two-level fluctuators associated with oxide layers at substrate and metal surfaces and metal-metal interfaces represent the predominant loss channel. Furthermore, we show how broadband thermal photon fields influence the relaxation and dephasing properties of a superconducting transmon qubit. To this end, we study several second-order loss channels of the transmon qubit and find that the broadband fields introduce a larger decay rate than expected from the Purcell filter defined by the resonator. Additionally, we show that qubit dephasing at the flux-insensitive point as well as low-frequency parameter fluctuations can be enhanced by thermal fields. Finally, we study how artificial atoms react to changes in inherent properties of the light fields. We perform a detailed analysis of the photon statistics of thermal fields using their relation to the qubits coherence properties. We quantitatively recover the expected n2+n-law for the photon number variance and confirm this result by direct correlation measurements. We then show a novel technique for the in-situ conversion of the interaction parity in light-matter interaction. To this end, we couple spatially controlled microwave fields to a flux qubit with two degrees of freedom.
In superconducting circuit quantum systems, transmon qubits are typically controlled through applying classical microwave pulses on a transmission line capacitively coupled to the qubit. In order to design a pulse that achieves the desired result, modeling the coupled dynamics of the transmission line and transmon is necessary. Existing models consider the dynamics of both portions of the system, but often fail to account for effects such as the back-action of each subsystem on the other. This work begins to study this effect using a 1-D finite element time-domain solution to the equations governing the transmission line flux and transmon phase in a fully classical treatment, which will be extended to a full-wave semiclassical model in a future work.