Quasiparticle tunneling as a probe of Josephson junction barrier and capacitor material in superconducting qubits
Cihan Kurter, Conal E. Murray, R. T. Gordon, B. B. Wymore, Martin Sandberg, Robert M. Shelby, Andrew Eddins, Vivekananda P. Adiga, A. D. K. Finck, E. Rivera, Adam Stabile, Bryan Trimm, Brent A. Wacaser, K. Balakrishnan, Adam Pyzyna, Jeffrey W. Sleight, Matthias Steffen, Kenneth P. Rodbell
Abstract Non-equilibrium quasiparticles are possible sources for decoherence in superconducting qubits because they can lead to energy decay or dephasing upon tunneling across Josephson junctions (JJs). Here, we investigate the impact of the intrinsic properties of two-dimensional transmon qubits on quasiparticle tunneling (QPT) and discuss how we can use quasiparticle dynamics to gain critical information about the quality of JJ barrier. We find the tunneling rate of the non-equilibrium quasiparticles to be sensitive to the choice of the shunting capacitor material and their geometry in qubits. In some devices, we observe an anomalous temperature dependence of the QPT rate below 100 mK that deviates from a constant background associated with non-equilibrium quasiparticles. We speculate that this behavior is caused by high transmission sites/defects within the oxide barriers of the JJs, leading to spatially localized subgap states. We model this by assuming that such defects generate regions with a smaller effective gap. Our results present a unique in situ characterization tool to assess the uniformity of tunnel barriers in qubit junctions and shed light on how quasiparticles can interact with various elements of the qubit circuit.
Abstract Non-equilibrium quasiparticles are possible sources for decoherence in superconducting qubits because they can lead to energy decay or dephasing upon tunneling across Josephson junctions (JJs). Here, we investigate the impact of the intrinsic properties of two-dimensional transmon qubits on quasiparticle tunneling (QPT) and discuss how we can use quasiparticle dynamics to gain critical information about the quality of JJ barrier. We find the tunneling rate of the non-equilibrium quasiparticles to be sensitive to the choice of the shunting capacitor material and their geometry in qubits. In some devices, we observe an anomalous temperature dependence of the QPT rate below 100 mK that deviates from a constant background associated with non-equilibrium quasiparticles. We speculate that this behavior is caused by high transmission sites/defects within the oxide barriers of the JJs, leading to spatially localized subgap states. We model this by assuming that such defects generate regions with a smaller effective gap. Our results present a unique in situ characterization tool to assess the uniformity of tunnel barriers in qubit junctions and shed light on how quasiparticles can interact with various elements of the qubit circuit.
The performance of various superconducting devices operating at ultra-low temperatures is impaired by the presence of non-equilibrium quasiparticles. Inelastic quasiparticle (QP) tunneling across Josephson junctions in superconducting qubits results in decoherence and spurious excitations and, notably, can trigger correlated errors that severely impede quantum error correction. In this work, we use "gap engineering" to suppress the tunneling of low-energy quasiparticles in Al-based transmon qubits, a leading building block for superconducting quantum processors. By implementing potential barriers for QP, we strongly suppress QP tunneling across the junction and preserve charge parity for over 103 seconds. The suppression of QP tunneling also results in a reduction in the qubit energy relaxation rates. The demonstrated approach to gap engineering can be easily implemented in all Al-based circuits with Josephson junctions.
Micro-fabricated superconducting circuits have emerged as a leading candidate for quantum computers. However, typical error rates of 10-3 for quantum gates remain a challenge for performing error correction and need to be further decreased for achieving practical quantum computation. Improving qubit coherence times for superconducting qubits is a continuous endeavor in order to decrease error rates. As part of this effort, a topic addressed in this dissertation is the study of the generation mechanism and dynamics of non-equilibrium quasiparticles (QPs), which are electron-like excitations of a superconductor. This source of decoherence was studied by measuring the rate of single-electron changes in the parity state of multiple charge-sensitive transmon qubits under different conditions. The presence of non-equilibrium QPs in superconducting resonators and qubits operating at millikelvin temperature has been known for decades. Understanding the sources and dynamics of these QPs is crucial to evaluate and improve the performance of the devices. Specifically, for superconducting qubits, a single QP tunneling across the Josephson junction changes the total charge parity from even to odd or vice versa, and can induce energy relaxation and dephasing, limiting the coherence of the device. To study the dynamics of non-equilibrium QPs, I utilized a Ramsey-like pulse sequence to measure the rate of single-electron parity changes in transmon qubits, which had a weak charge dispersion, with different shunting capacitor geometries and materials. I started out by measuring a charge parity rate of ~ 33 s-1 for a grounded "x-mon" qubit and ~ 17 s-1 for a galvanically isolated "two-pads" qubit with our standard setup. These rates decreased to ~ 5 s-1 and ~ 2 s-1 for the x-mon and two-pads respectively when IR-filters and extra layers of shielding were installed. From my measurements, I found that the charge parity rates are sensitive to the geometry of the shunting capacitor, weakly depend on the amount of shielding surrounding the device, and independent of using Al or Ta for the superconducting shunting capacitor. To distinguish between two possible mechanisms for the parity switching, I measured the parity rates after cooling one of the qubit devices in an external magnetic field to induce vortices in the superconducting electrodes. After increasing the magnetic field above 23 μT, I measured a faster QP trapping rate and a much smaller T1, suggesting that at least one vortex was added to the superconducting electrode near the Josephson junction. On the other hand, the measured charge parity rates exhibited no clear dependence on the background QP trapping rates. These data suggest that a large portion of parity switching events occurs from QPs being produced at the Josephson junction, where pair-breaking radiation is rectified into QPs by the junction, as opposed to tunneling of QPs residing in the electrodes. To understand the difference in the measured parity rates, I simulated the absorption efficiency of pair-breaking radiation for my two designs and observed a similar difference in absorption rates when a single-mode blackbody radiation with an effective temperature T* ~ 300 mK was assumed to be illuminating the devices. This large T*, which is significantly higher than the device's nominal temperature of 20 mK, is consistent with values reported in the literature. However, its physical origin remains not fully understood. For the other part of my dissertation, I developed a new simplified process for making superconducting air bridges. Air bridges are used to suppress unwanted extraneous high frequency chip modes parasitic to superconducting quantum circuits that can couple to qubits and cause decoherence. Traditional ways of making air bridges utilize thermal reflow to create arched photoresist scaffolds that are limited in heights. This results in insufficient mechanical strength of the bridges which tend to collapse when spanning to larger lengths. My simplified fabrication method that utilizes two-photon lithography, a technique that enables creation of three-dimensional micron-scale structures, relaxes this limitation and is capable of making mechanically stable bridges with lengths up to 100 μm. The resulting Al air bridges, having a superconducting transition temperature of Tc = 1.08 mK and a dc residual resistivity ratio of 3.85, were confirmed to form a good electrical contact with the base metal layers and exhibit a small measurable amount of rf loss when placed over coplanar waveguide resonators, on par with other air bridge fabrication methods.
We study decoherence in superconducting qubits due to quasiparticle tunneling which is enhanced by two known deviations from the equilibrium BCS theory. The first process corresponds to tunneling of an already existing quasiparticle across the junction. The quasiparticle density is increased, e.g., because of an effective quasiparticle doping of the system. The second process is quasiparticle tunneling by breaking of a Cooper pair. This can happen at typical energies of superconducting qubits if there is an extended quasiparticle density inside the gap. We calculate the induced energy decay and pure dephasing rates in typical qubit designs. Assuming the lowest reported value of the nonequilibrium quasiparticle density in Aluminum, we find for the persistent-current flux qubit decay times of the order of recent measurements. Using the typical subgap density of states in Niobium we also reproduce observed decay times in the corresponding Niobium flux qubits.
In superconducting qubits, the interaction of the qubit degree of freedom with quasiparticles defines a fundamental limitation for the qubit coherence. We develop a theory of the pure dephasing rate ${\ensuremath{\Gamma}}_{\ensuremath{\phi}}$ caused by quasiparticles tunneling through a Josephson junction and of the inhomogeneous broadening due to changes in the occupations of Andreev states in the junction. To estimate ${\ensuremath{\Gamma}}_{\ensuremath{\phi}}$, we derive a master equation for the qubit dynamics. The tunneling rate of free quasiparticles is enhanced by their large density of states at energies close to the superconducting gap. Nevertheless, we find that ${\ensuremath{\Gamma}}_{\ensuremath{\phi}}$ is small compared to the rates determined by extrinsic factors in most of the current qubit designs (phase and flux qubits, transmon, fluxonium). The split transmon, in which a single junction is replaced by a SQUID loop, represents an exception that could make possible the measurement of ${\ensuremath{\Gamma}}_{\ensuremath{\phi}}$. Fluctuations of the qubit frequency leading to inhomogeneous broadening may be caused by the fluctuations in the occupation numbers of the Andreev states associated with a phase-biased Josephson junction. This mechanism may be revealed in qubits with small-area junctions, since the smallest relative change in frequency it causes is of the order of the inverse number of transmission channels in the junction.
As low-loss nonlinear elements, Josephson junctions are the building blocks of superconducting qubits. The interaction of the qubit degree of freedom with the quasiparticles tunneling through the junction represents an intrinsic relaxation mechanism. We develop a general theory for the qubit decay rate induced by quasiparticles, and we study its dependence on the magnetic flux used to tune the qubit properties in devices such as the phase and flux qubits, the split transmon, and the fluxonium. Our estimates for the decay rate apply to both thermal equilibrium and nonequilibrium quasiparticles. We propose measuring the rate in a split transmon to obtain information on the possible nonequilibrium quasiparticle distribution. We also derive expressions for the shift in qubit frequency in the presence of quasiparticles.
Quasiparticles are a prominent decoherence source in superconducting qubits, but their effects are notoriously difficult to isolate in fluxonium. Unlike the transmon, fluxonium is insensitive to offset charge, precluding charge-parity detection of quasiparticle tunneling. We address this challenge by measuring the excitation and de-excitation rates in a fluxonium qubit under controlled on-chip quasiparticle injection and isolating the quasiparticle-induced contribution by subtracting the background transition rates. We show that to accurately model the external magnetic flux dependence of the quasiparticle-induced transition rates, it is necessary to account for the superconducting gap asymmetry across the Josephson junctions. A comparison between theory and experiment constrains the relative quasiparticle densities in the small junction and the junction array and helps explain previously reported discrepancies between the bounds on the quasiparticle densities inferred for these two circuit elements.