We propose a design to realize integrated broadband nonreciprocal microwave isolators and circulators using superconducting circuit elements without any magnetic materials. To obtain a broadband response, we develop a waveguide-based design by temporal modulations. The corresponding compact traveling-wave structure is implemented with integrated superconducting composite right-/left-handed transmission lines. The calculations show that the bandwidth of 580 MHz can be realized over a nonreciprocal isolation of 20 dB in reflections. Such on-chip isolators and circulators are useful for cryogenic integrated microwave connections and measurements, such as protecting qubits from the amplified reflected signal in multiplexed readout.
We propose a design to realize integrated broadband nonreciprocal microwave isolators and circulators using superconducting circuit elements without any magnetic materials. To obtain a broadband response, we develop a waveguide-based design by temporal modulations. The corresponding compact traveling-wave structure is implemented with integrated superconducting composite right-/left-handed transmission lines. The calculations show that the bandwidth of 580 MHz can be realized over a nonreciprocal isolation of 20 dB in reflections. Such on-chip isolators and circulators are useful for cryogenic integrated microwave connections and measurements, such as protecting qubits from the amplified reflected signal in multiplexed readout.
Nonreciprocal circuit elements form an integral part of modern measurement and communication systems. Mathematically they require breaking of time-reversal symmetry, typically achieved using magnetic materials and more recently using the quantum Hall effect, parametric permittivity modulation or Josephson nonlinearities. Here we demonstrate an on-chip magnetic-free circulator based on reservoir-engineered electromechanic interactions. Directional circulation is achieved with controlled phase-sensitive interference of six distinct electro-mechanical signal conversion paths. The presented circulator is compact, its silicon-on-insulator platform is compatible with both superconducting qubits and silicon photonics, and its noise performance is close to the quantum limit. With a high dynamic range, a tunable bandwidth of up to 30 MHz and an in situ reconfigurability as beam splitter or wavelength converter, it could pave the way for superconducting qubit processors with multiplexed on-chip signal processing and readout.Nonreciprocal optical elements often require magnetic materials in order to break time-reversal symmetry. Here, Barzanjeh et al. demonstrate a magnetic-free on-chip microwave circulator that utilizes the interference from six electro-mechanical signal paths.
Abstract In quantum information detection, significant interest has recently emerged in replacing conventional ferrite circulators with superconducting magnetic-free nonreciprocal devices. However, superconducting non-reciprocal devices with simpler structures and easier manufacturing processes still require further development. Inspired by conventional microwave circuits, we demonstrate a superconducting nonreciprocal circulator by parametric modulation of three identical, strongly and symmetrically coupled resonators. The circulator requires only three DC superconducting quantum interference devices, achieving an isolation of 20 dB , insertion loss of 0.47 dB , and return loss better than 25 dB over an instantaneous bandwidth of 50 MHz . The center frequency of the circulator is tunable within the range of 4– 8 GHz . Detailed design considerations for the experimental realization of a three-port superconducting circulator are presented, together with simulation results for a four-port circulator. Compared with previously reported superconducting magnetic-free nonreciprocal devices, the proposed circulator features a simpler circuit topology, demonstrating strong potential for scalable superconducting quantum information detection.
Abstract Nonreciprocal microwave devices play critical roles in high-fidelity, quantum-nondemolition (QND) measurement schemes. They impose unidirectional routing of readout signals and protect the quantum systems from unwanted noise originated by the output chain. However, cryogenic circulators and isolators are disadvantageous in scalable superconducting architectures because they use magnetic materials and strong magnetic fields. Here, we realize an active isolator formed by coupling two nondegenerate Josephson mixers in an interferometric scheme and driving them with phase-shifted, same-frequency pumps. By incorporating our Josephson-based isolator into a superconducting qubit setup, we demonstrate fast, high-fidelity, QND measurements of the qubit while providing 20 dB of protection within a bandwidth of 10 MHz against amplified noise reflected off the Josephson amplifier in the output chain. A moderate reduction of 35% is observed in T2E when the Josephson-based isolator is turned on. Such a moderate degradation can be mitigated by minimizing heat dissipation in the pump lines.
The cryogenic hardware required to build a superconducting-qubit-based quantum computer demands a variety of microwave components. These elements include microwave couplers, filters, amplifiers, and circulators and/or isolators. Traditionally implemented as discrete components, integration of this peripheral hardware, in an effort to reduce overall footprint, thermal load, and added noise, is a key challenge to scaling modern quantum processors with qubit counts climbing over the one hundred plus mark. Ferrite-based microwave isolators, generally employed in the readout chain to decouple qubits and resonators from readout electronics, persist as one of the volumetrically largest devices still utilized as discrete components. Here, we present an alternative two-port isolating integrated circuit derived from the dc superconducting quantum interference device (dc SQUID). Nonreciprocal transmission is achieved using the three-wave microwave-mixing properties of a flux-modulated dc SQUID. We show that when multiple dc SQUIDs are embedded in a multipole admittance-inverting filter structure, the three-wave mixing derived from the flux pumping of the dc SQUIDs can provide directional microwave power flow. For a three-pole filter device, we experimentally demonstrate a directionality greater than 15 dB over a 600-MHz bandwidth.
Abstract Nonreciprocal microwave devices play critical roles in high-fidelity, quantum-nondemolition (QND) measurement schemes. They impose unidirectional routing of readout signals and protect the quantum systems from unwanted noise originated by the output chain. However, cryogenic circulators and isolators are disadvantageous in scalable superconducting architectures because they use magnetic materials and strong magnetic fields. Here, we realize an active isolator formed by coupling two nondegenerate Josephson mixers in an interferometric scheme and driving them with phase-shifted, same-frequency pumps. By incorporating our Josephson-based isolator into a superconducting qubit setup, we demonstrate fast, high-fidelity, QND measurements of the qubit while providing 20 dB of protection within a bandwidth of 10 MHz against amplified noise reflected off the Josephson amplifier in the output chain. A moderate reduction of 35% is observed in T2E when the Josephson-based isolator is turned on. Such a moderate degradation can be mitigated by minimizing heat dissipation in the pump lines.
Nonreciprocal microwave devices, such as circulators and isolators, are needed in high-fidelity qubit readout schemes to unidirectionally route the readout signals and protect the qubits against noise coming from the output chain.However, cryogenic circulators and isolators are prohibitive in scalable superconducting architectures because they rely on magnetic materials.Here we report a fast (750 ns) high-fidelity (95%) quantum nondemolition readout of a coherent superconducting qubit (T 1 = 52 μs, T 2E = 35 μs) without any nonreciprocal magnetic devices.We use in our readout chain a microwave-controlled qubit readout multichip module (QRMCM) that integrates interferometric directional Josephson devices consisting of an isolator and a reconfigurable isolator or amplifier device, and an off-chip low-pass filter.Using the QRMCM, we demonstrate isolation up to 45 dB within 13 MHz, when both directional devices are operated as isolators, and low-noise amplification in excess of 10 dB within a dynamical bandwidth of 10 MHz, when the reconfigurable device is operated as an amplifier.We also investigate the dependence of the qubit coherence times T ϕ and T 2E on the isolation response of the QRMCM, which we control in situ using the microwave drives feeding the isolators.Furthermore, by directly comparing the QRMCM performance with that of a state-of-art configuration (with T 2E ≈ 2T 1 ) that uses a pair of wideband magnetic isolators, we find that the excess pure dephasing measured with the QRMCM (for which T 2E ≈ T 1 ) is likely limited by the residual thermal photon population in the readout resonator.Improved versions of the QRMCM could replace magnetic circulators and isolators in large superconducting quantum processors.