Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1911.04880 · Optics Express

Single-channel electronic readout of a multipixel superconducting nanowire single photon detector

Johannes Tiedau, Timon Schapeler, Vikas Anant, Helmut Fedder, Christine Silberhorn, Tim J. Bartley

Published Jan 10, 2020• 16 citations
arXivHTMLPDF

Abstract

We present a time-over-threshold readout technique to count the number of activated pixels from an array of superconducting nanowire single photon detectors (SNSPDs). This technique places no additional heatload on the cryostat, and retains the intrinsic count rate of the time-tagger. We demonstrate proof-of-principle operation with respect to a four-pixel device. Furthermore, we show that, given some permissible error threshold, the number of pixels that can be reliably read out scales linearly with the intrinsic signal-to-noise ratio of the individual pixel response.

DOI
10.1364/oe.383111

Related papers

Operation of Superconducting Nanowire Single-Photon Detectors Embedded in Lumped-Element Resonant Circuits

Steffen Doerner, Artem A. Kuzmin, S. Wünsch +2 more

We propose a new operation principle for superconducting nanowire single-photon detectors (SNSPDs) enabling an efficient frequency-division multiplexing of the bias and readout signals of a large multipixel detector array. The SNSPD is part of a resonant circuit, and the microwave signal inside the device is used to bias the detector close to the critical state. Hence, an n×m pixel SNSPD array requires only two coaxial cables from room temperature to the detector ambient temperature of 4.2 K. We show the microwave characterization and single-photon response of such devices and compare the detector efficiencies with conventional dc-biased SNSPDs. Furthermore, we demonstrate the feasibility of array applications with the new operation mode in a two-pixel proof-of-principle device.

IEEE Transactions on Applied Superconductivity•Feb 5, 2016•19 citations

Superconducting nanowire single-photon detector array with pixel-level photon-number resolution

Chenrui Wang, Chaomeng Ding, Jingxue Chen +6 more

We report a 16-pixel (4×4) superconducting nanowire single-photon detector (SNSPD) array featuring pixel-level photon-number-resolving capability. This multidimensional sensing is enabled by integrating a compact four-element series nanowire architecture into each spatial pixel, allowing direct discrimination of one to four photons. Under single-mode fiber illumination, the device achieves a total system detection efficiency of 41.5%, given the array geometrical fill factor of 53%. Across all channels, the device exhibits reliable multiphoton discrimination, maintaining minimum readout fidelities of 96%, 89%, 73%, and 77% for one- to four-photon states, respectively. Furthermore, independent channel evaluations reveal low timing jitter and negligible inter-channel crosstalk (<0.1 % ). By implementing differentiating pulse shaping for high-flux operation, a maximum single-channel −3 dB count rate of 984 MHz is achieved, establishing an aggregated array bandwidth potential of 8.9 GHz. This sensing architecture may provide a viable pathway toward high-flux single-photon imaging, offering potential applications in quantum optics and light detection and ranging (LiDAR) systems.

Photonics Research•Aug 28, 2026•0 citations

Operation of Multipixel Radio-Frequency Superconducting Nanowire Single-Photon Detector Arrays

Steffen Doerner, Artem Kuzmin, S. Wünsch +2 more

The concept of the radio-frequency superconducting nanowire single-photon detector (RF-SNSPD) allows frequency-division multiplexing of the bias and readout lines of several SNSPDs. Using this method, a multi-pixel array can be operated by only one feed line. Consequently, the system complexity as well as the heat load is significantly reduced. To allocate many pixels into a small bandwidth the quality factor of each device is crucial. In this paper, we present an improved RF-SNSPD design. This new design enables a simple tuning of the quality factor as well as the resonant frequency. With a two-pixel device we have demonstrated the operation without crosstalk between the detectors and showed the time, spatial, and photon number resolution. Thereby a single pixel requires only a bandwidth of 14 MHz.

arXiv:1612.02228•IEEE Transactions on Applied Superconductivity•Dec 9, 2016•8 citations

Optical Bias and Cryogenic Laser Readout of a Multipixel Superconducting Nanowire Single Photon Detector

Frederik Thiele, Niklas Lamberty, Thomas R. Hummel +1 more

Cryogenic opto-electronic interconnects are gaining increasing interest as a means to control and read out cryogenic electronic components. The challenge is to achieve sufficient signal integrity with low heat load processing. In this context, we demonstrate the opto-electronic bias and readout of a commercial four-pixel superconducting nanowire single-photon detector array using a cryogenic photodiode and laser. We show that this approach has a similar system detection efficiency to a conventional bias. Furthermore, multi-pixel detection events are faithfully converted between the optical and electrical domain, which allows reliable extraction of amplitude multiplexed photon statistics. Our device has a passive heat dissipation of 2.6mW, maintains the signal rise time of 3ns, and operates in free-running (self-resetting) mode at a repetition rate of 600kHz. This demonstrates the potential of high-bandwidth, low noise, and low heat load opto-electronic interconnects for scalable cryogenic signal processing and transmission.

arXiv:2403.14276•Mar 21, 2024•0 citations

Optical bias and cryogenic laser readout of a multipixel superconducting nanowire single photon detector

Frederik Thiele, Niklas Lamberty, Thomas Hummel +1 more

Cryogenic opto-electronic interconnects are gaining increasing interest as a means to control and readout cryogenic electronic components. The challenge is to achieve sufficient signal integrity with low heat load processing. In this context, we demonstrate the opto-electronic bias and readout of a commercial four-pixel superconducting nanowire single-photon detector array using a cryogenic photodiode and laser. We show that this approach has a similar system detection efficiency to a conventional bias. Furthermore, multi-pixel detection events are faithfully converted between the optical and electrical domains, which allows reliable extraction of amplitude multiplexed photon statistics. Our device has a latent heat load of 2.6 mW, maintains a signal rise time of 3 ns, and operates in free-running (self-resetting) mode at a repetition rate of 600 kHz. This demonstrates the potential of high-bandwidth, low noise, and low heat load opto-electronic interconnects for scalable cryogenic signal processing and transmission.

APL Photonics•Jul 1, 2024•6 citations

Characterisation of multi-pixel superconducting nanowire single photon detectors

Jeroen Swens

Single-photon detection is extremely important for a number of different applications such as quantum cryptography, CMOS testing and even biomedical research. Most of the applications of single-photon detector require high efficiency combined with high time resolution, high count rates and low dark counts. Superconducting nanowire single-photon detectors has emerged provides this combination unlike any other available single-photon detectors. Some of the applications of superconducting nanowire single-photon detectors (SNSPD's) require larger area SNSPD's without affecting it's performance. For this purpose, multi-pixel SNSPD's would provide a solution. To this end, prototype 4- and 16-pixel detectors have been characterised in terms of a number of performance parameters such as critical current, count rate behaviour and timing jitter. Aside from this, simulations have been performed on detection statistics and relative illumination of the individual pixels of a multi-pixel SNSPD. Results show that for 4-pixel detectors, all desired aspects have been achieved, but not yet combined in one detector. The 16-pixel detectors showed excellent critical currents and count rate behaviour but, most likely due to the fact that they were prototype chips with little to no protection, had several not functioning pixels.

•Jan 1, 2018•0 citations
We present a time-over-threshold readout technique to count the number of activated pixels from an array of superconducting nanowire single photon detectors (SNSPDs). This technique places no additional heatload on the cryostat, and retains the intrinsic count rate of the time-tagger. We demonstrate proof-of-principle operation with respect to a four-pixel device. Furthermore, we show that, given some permissible error threshold, the number of pixels that can be reliably read out scales linearly with the intrinsic signal-to-noise ratio of the individual pixel response.
We propose a new operation principle for superconducting nanowire single-photon detectors (SNSPDs) enabling an efficient frequency-division multiplexing of the bias and readout signals of a large multipixel detector array. The SNSPD is part of a resonant circuit, and the microwave signal inside the device is used to bias the detector close to the critical state. Hence, an n×m pixel SNSPD array requires only two coaxial cables from room temperature to the detector ambient temperature of 4.2 K. We show the microwave characterization and single-photon response of such devices and compare the detector efficiencies with conventional dc-biased SNSPDs. Furthermore, we demonstrate the feasibility of array applications with the new operation mode in a two-pixel proof-of-principle device.
We report a 16-pixel (4×4) superconducting nanowire single-photon detector (SNSPD) array featuring pixel-level photon-number-resolving capability. This multidimensional sensing is enabled by integrating a compact four-element series nanowire architecture into each spatial pixel, allowing direct discrimination of one to four photons. Under single-mode fiber illumination, the device achieves a total system detection efficiency of 41.5%, given the array geometrical fill factor of 53%. Across all channels, the device exhibits reliable multiphoton discrimination, maintaining minimum readout fidelities of 96%, 89%, 73%, and 77% for one- to four-photon states, respectively. Furthermore, independent channel evaluations reveal low timing jitter and negligible inter-channel crosstalk (<0.1 % ). By implementing differentiating pulse shaping for high-flux operation, a maximum single-channel −3 dB count rate of 984 MHz is achieved, establishing an aggregated array bandwidth potential of 8.9 GHz. This sensing architecture may provide a viable pathway toward high-flux single-photon imaging, offering potential applications in quantum optics and light detection and ranging (LiDAR) systems.
The concept of the radio-frequency superconducting nanowire single-photon detector (RF-SNSPD) allows frequency-division multiplexing of the bias and readout lines of several SNSPDs. Using this method, a multi-pixel array can be operated by only one feed line. Consequently, the system complexity as well as the heat load is significantly reduced. To allocate many pixels into a small bandwidth the quality factor of each device is crucial. In this paper, we present an improved RF-SNSPD design. This new design enables a simple tuning of the quality factor as well as the resonant frequency. With a two-pixel device we have demonstrated the operation without crosstalk between the detectors and showed the time, spatial, and photon number resolution. Thereby a single pixel requires only a bandwidth of 14 MHz.
Cryogenic opto-electronic interconnects are gaining increasing interest as a means to control and read out cryogenic electronic components. The challenge is to achieve sufficient signal integrity with low heat load processing. In this context, we demonstrate the opto-electronic bias and readout of a commercial four-pixel superconducting nanowire single-photon detector array using a cryogenic photodiode and laser. We show that this approach has a similar system detection efficiency to a conventional bias. Furthermore, multi-pixel detection events are faithfully converted between the optical and electrical domain, which allows reliable extraction of amplitude multiplexed photon statistics. Our device has a passive heat dissipation of 2.6mW, maintains the signal rise time of 3ns, and operates in free-running (self-resetting) mode at a repetition rate of 600kHz. This demonstrates the potential of high-bandwidth, low noise, and low heat load opto-electronic interconnects for scalable cryogenic signal processing and transmission.
Cryogenic opto-electronic interconnects are gaining increasing interest as a means to control and readout cryogenic electronic components. The challenge is to achieve sufficient signal integrity with low heat load processing. In this context, we demonstrate the opto-electronic bias and readout of a commercial four-pixel superconducting nanowire single-photon detector array using a cryogenic photodiode and laser. We show that this approach has a similar system detection efficiency to a conventional bias. Furthermore, multi-pixel detection events are faithfully converted between the optical and electrical domains, which allows reliable extraction of amplitude multiplexed photon statistics. Our device has a latent heat load of 2.6 mW, maintains a signal rise time of 3 ns, and operates in free-running (self-resetting) mode at a repetition rate of 600 kHz. This demonstrates the potential of high-bandwidth, low noise, and low heat load opto-electronic interconnects for scalable cryogenic signal processing and transmission.
Single-photon detection is extremely important for a number of different applications such as quantum cryptography, CMOS testing and even biomedical research. Most of the applications of single-photon detector require high efficiency combined with high time resolution, high count rates and low dark counts. Superconducting nanowire single-photon detectors has emerged provides this combination unlike any other available single-photon detectors. Some of the applications of superconducting nanowire single-photon detectors (SNSPD's) require larger area SNSPD's without affecting it's performance. For this purpose, multi-pixel SNSPD's would provide a solution. To this end, prototype 4- and 16-pixel detectors have been characterised in terms of a number of performance parameters such as critical current, count rate behaviour and timing jitter. Aside from this, simulations have been performed on detection statistics and relative illumination of the individual pixels of a multi-pixel SNSPD. Results show that for 4-pixel detectors, all desired aspects have been achieved, but not yet combined in one detector. The 16-pixel detectors showed excellent critical currents and count rate behaviour but, most likely due to the fact that they were prototype chips with little to no protection, had several not functioning pixels.