Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1504.06030 · Physical Review A

Quantum theory of a bandpass Purcell filter for qubit readout

Eyob Alebachew Sete, John M. Martinis, Alexander N. Korotkov

Published Jul 21, 2015• 115 citations
arXivHTMLPDF

Abstract

The measurement fidelity of superconducting transmon and Xmon qubits is partially limited by the qubit energy relaxation through the resonator into the transmission line, which is also known as the Purcell effect. One way to suppress this energy relaxation is to employ a filter which impedes microwave propagation at the qubit frequency. We present semiclassical and quantum analyses for the bandpass Purcell filter realized by E. Jeffrey et al. [Phys. Rev. Lett. 112, 190504 (2014)]. For typical experimental parameters, the bandpass filter suppresses the qubit relaxation rate by up to two orders of magnitude while maintaining the same measurement rate. We also show that in the presence of a microwave drive the qubit relaxation rate further decreases with increasing drive strength.

DOI
10.1103/physreva.92.012325

Related papers

Purcell effect with microwave drive: Suppression of qubit relaxation rate

Eyob Alebachew Sete, Jay Gambetta, Alexander N. Korotkov

We analyze the Purcell relaxation rate of a superconducting qubit coupled to a resonator, which is coupled to a transmission line and pumped by an external microwave drive. Considering the typical regime of the qubit measurement, we focus on the case when the qubit frequency is significantly detuned from the resonator frequency. Surprisingly, the Purcell rate decreases when the strength of the microwave drive is increased. This suppression becomes significant in the nonlinear regime. In the presence of the microwave drive, the loss of photons to the transmission line also causes excitation of the qubit; however, the excitation rate is typically much smaller than the relaxation rate. Our analysis also applies to a more general case of a two-level quantum system coupled to a cavity.

arXiv:1401.5545•Physical Review B•Mar 21, 2014•71 citations

Broadband bandpass Purcell filter for circuit quantum electrodynamics

Haoxiong Yan, Xuntao Wu, Andrew Lingenfelter +10 more

In circuit quantum electrodynamics, qubits are typically measured using dispersively coupled readout resonators. Coupling between each readout resonator and its electrical environment, however, reduces the qubit lifetime via the Purcell effect. Inserting a Purcell filter counters this effect while maintaining high readout fidelity but reduces measurement bandwidth and, thus, limits multiplexing readout capacity. In this Letter, we develop and implement a multi-stage bandpass Purcell filter that yields better qubit protection while simultaneously increasing measurement bandwidth and multiplexed capacity. We report on the experimental performance of our transmission-line-based implementation of this approach, a flexible design that can easily be integrated with current scaled-up, long coherence time superconducting quantum processors.

arXiv:2306.06258•Applied Physics Letters•Sep 25, 2023•15 citations

Mechanical Purcell filters for microwave quantum machines

Agnetta Y. Cleland, Marek Pechal, Pieter-Jan Stas +3 more

In circuit quantum electrodynamics, measuring the state of a superconducting qubit introduces a loss channel, which can enhance spontaneous emission through the Purcell effect, thus decreasing the qubit lifetime. This decay can be mitigated by performing the measurement through a Purcell filter, which strongly suppresses signal propagation at the qubit transition frequency. If the filter is also well-matched at the readout cavity frequency, it will protect the qubit from decoherence channels without sacrificing measurement bandwidth. We propose and analyze design for a mechanical Purcell filter, which we also fabricate and characterize at room temperature. The filter is composed of an array of nanomechanical resonators in thin-film lithium niobate, connected in a ladder topology, with series and parallel resonances arranged to produce a bandpass response. Their modest footprint, steep band edges, and lack of cross talk make these filters an appealing alternative to analogous electromagnetic versions currently used in microwave quantum machines.

arXiv:1905.08403•Applied Physics Letters•Dec 23, 2019•13 citations

Saturable Purcell filter for circuit quantum electrodynamics

Ivan Iakoupov, Kazuki Koshino

We consider a typical circuit QED setup where an artificial atom encodes a qubit and is dispersively coupled to a measurement resonator that in turn is coupled to a transmission line. We show theoretically that by placing another artificial atom in this transmission line to act as a filter, the Purcell decay of the qubit into the transmission line is suppressed. When strong control fields are applied in the transmission line, the filter is saturated and effectively switched off. Such a Purcell filtering capability permits both the control and measurement of the qubit using the single transmission line, while maintaining the long coherence time of the qubit in the absence of the control pulses. We show that high fidelity Pauli ${\ensuremath{\sigma}}_{x}$ gates on the qubit can be realized using simple pulse shapes. For devices that already use one transmission line both for control and measurement of the qubit, our paper provides a way to completely filter out the qubit frequency without removing the possibility of controlling the system. Further, combining the proposed filter with frequency multiplexing potentially enables both control and measurement of several qubits using a single Purcell-filtered transmission line. This will enhance the scalability of superconducting quantum processors by decreasing the number of the required transmission lines.

arXiv:2202.07229•Physical Review Research•Feb 27, 2023•5 citations

Broadband Purcell Filter for Fast Superconducting Qubit Reset and Readout

Yu Zhao, Zhixu Chen, Hanxian Liu +12 more

Rapid reset and readout of qubit states are essential for quantum error correction, yet accelerating these operations through stronger coupling to a dissipative environment inevitably increases qubit decay via the Purcell effect. Here we present a broadband Purcell filter that decouples the reset and readout paths, enabling both operations to be independently optimized without compromising qubit coherence. The filter employs two engineered notches - an intrinsic notch and a bandstop notch - to provide broadband Purcell protection, together with an additional reset stub that creates a reset mode below the protected band. To enable fast reset while suppressing filter-mediated interactions between qubits, we couple each qubit to a dedicated reset resonator. We experimentally demonstrate Purcell-limited relaxation times exceeding 1 ms across a 1.2 GHz bandwidth, simultaneously with 500 ns readout without a Josephson parametric amplifier and 100 ns reset with 99.6% efficiency. The reset resonator is designed with a deliberate kappa-chi mismatch, which suppresses photon-shot-noise-induced dephasing by a factor of 70 compared to the readout resonator. Our work provides a scalable hardware solution that resolves the traditional trade-off between fast qubit operations and qubit protection, advancing the prospects for fault-tolerant quantum computing.

quant-pharXiv:2609.14081•Sep 15, 2026•0 citations

Josephson Junction-Based Compact Notch Purcell Filters for Superconducting Qubit Readout

Simona Zaccaria, A. Gnudi

High-fidelity qubit readout in circuit QED requires suppressing relaxation due to the Purcell effect, typically achieved through the use of Purcell filters. A key limitation of existing Purcell filter implementations is their large footprint. In this work, we propose a compact notch Purcell filter based on a Josephson junction (JJ) chain embedded in series with the readout resonator. We analytically derive the conditions for operation in the dispersive regime using a lumped-element model, and validate the concept through an example design that is analyzed through both lumped-element and full electromagnetic simulations. The results indicate that the proposed architecture achieves a Purcell decay time exceeding 1 ms, with a dispersive shift and resonator linewidth of approximately 10 MHz, enabling fast, high signal-tonoise ratio readout. As typical of notch filters, also this solution exhibits an inherent parameter sensitivity. SQUIDs can be used for post-fabrication frequency tuning, at the expense of an increase of the number of required control lines.

IEEE Transactions on Applied Superconductivity•Sep 15, 2025•3 citations
The measurement fidelity of superconducting transmon and Xmon qubits is partially limited by the qubit energy relaxation through the resonator into the transmission line, which is also known as the Purcell effect. One way to suppress this energy relaxation is to employ a filter which impedes microwave propagation at the qubit frequency. We present semiclassical and quantum analyses for the bandpass Purcell filter realized by E. Jeffrey et al. [Phys. Rev. Lett. 112, 190504 (2014)]. For typical experimental parameters, the bandpass filter suppresses the qubit relaxation rate by up to two orders of magnitude while maintaining the same measurement rate. We also show that in the presence of a microwave drive the qubit relaxation rate further decreases with increasing drive strength.
We analyze the Purcell relaxation rate of a superconducting qubit coupled to a resonator, which is coupled to a transmission line and pumped by an external microwave drive. Considering the typical regime of the qubit measurement, we focus on the case when the qubit frequency is significantly detuned from the resonator frequency. Surprisingly, the Purcell rate decreases when the strength of the microwave drive is increased. This suppression becomes significant in the nonlinear regime. In the presence of the microwave drive, the loss of photons to the transmission line also causes excitation of the qubit; however, the excitation rate is typically much smaller than the relaxation rate. Our analysis also applies to a more general case of a two-level quantum system coupled to a cavity.
In circuit quantum electrodynamics, qubits are typically measured using dispersively coupled readout resonators. Coupling between each readout resonator and its electrical environment, however, reduces the qubit lifetime via the Purcell effect. Inserting a Purcell filter counters this effect while maintaining high readout fidelity but reduces measurement bandwidth and, thus, limits multiplexing readout capacity. In this Letter, we develop and implement a multi-stage bandpass Purcell filter that yields better qubit protection while simultaneously increasing measurement bandwidth and multiplexed capacity. We report on the experimental performance of our transmission-line-based implementation of this approach, a flexible design that can easily be integrated with current scaled-up, long coherence time superconducting quantum processors.
In circuit quantum electrodynamics, measuring the state of a superconducting qubit introduces a loss channel, which can enhance spontaneous emission through the Purcell effect, thus decreasing the qubit lifetime. This decay can be mitigated by performing the measurement through a Purcell filter, which strongly suppresses signal propagation at the qubit transition frequency. If the filter is also well-matched at the readout cavity frequency, it will protect the qubit from decoherence channels without sacrificing measurement bandwidth. We propose and analyze design for a mechanical Purcell filter, which we also fabricate and characterize at room temperature. The filter is composed of an array of nanomechanical resonators in thin-film lithium niobate, connected in a ladder topology, with series and parallel resonances arranged to produce a bandpass response. Their modest footprint, steep band edges, and lack of cross talk make these filters an appealing alternative to analogous electromagnetic versions currently used in microwave quantum machines.
We consider a typical circuit QED setup where an artificial atom encodes a qubit and is dispersively coupled to a measurement resonator that in turn is coupled to a transmission line. We show theoretically that by placing another artificial atom in this transmission line to act as a filter, the Purcell decay of the qubit into the transmission line is suppressed. When strong control fields are applied in the transmission line, the filter is saturated and effectively switched off. Such a Purcell filtering capability permits both the control and measurement of the qubit using the single transmission line, while maintaining the long coherence time of the qubit in the absence of the control pulses. We show that high fidelity Pauli ${\ensuremath{\sigma}}_{x}$ gates on the qubit can be realized using simple pulse shapes. For devices that already use one transmission line both for control and measurement of the qubit, our paper provides a way to completely filter out the qubit frequency without removing the possibility of controlling the system. Further, combining the proposed filter with frequency multiplexing potentially enables both control and measurement of several qubits using a single Purcell-filtered transmission line. This will enhance the scalability of superconducting quantum processors by decreasing the number of the required transmission lines.
Rapid reset and readout of qubit states are essential for quantum error correction, yet accelerating these operations through stronger coupling to a dissipative environment inevitably increases qubit decay via the Purcell effect. Here we present a broadband Purcell filter that decouples the reset and readout paths, enabling both operations to be independently optimized without compromising qubit coherence. The filter employs two engineered notches - an intrinsic notch and a bandstop notch - to provide broadband Purcell protection, together with an additional reset stub that creates a reset mode below the protected band. To enable fast reset while suppressing filter-mediated interactions between qubits, we couple each qubit to a dedicated reset resonator. We experimentally demonstrate Purcell-limited relaxation times exceeding 1 ms across a 1.2 GHz bandwidth, simultaneously with 500 ns readout without a Josephson parametric amplifier and 100 ns reset with 99.6% efficiency. The reset resonator is designed with a deliberate kappa-chi mismatch, which suppresses photon-shot-noise-induced dephasing by a factor of 70 compared to the readout resonator. Our work provides a scalable hardware solution that resolves the traditional trade-off between fast qubit operations and qubit protection, advancing the prospects for fault-tolerant quantum computing.
High-fidelity qubit readout in circuit QED requires suppressing relaxation due to the Purcell effect, typically achieved through the use of Purcell filters. A key limitation of existing Purcell filter implementations is their large footprint. In this work, we propose a compact notch Purcell filter based on a Josephson junction (JJ) chain embedded in series with the readout resonator. We analytically derive the conditions for operation in the dispersive regime using a lumped-element model, and validate the concept through an example design that is analyzed through both lumped-element and full electromagnetic simulations. The results indicate that the proposed architecture achieves a Purcell decay time exceeding 1 ms, with a dispersive shift and resonator linewidth of approximately 10 MHz, enabling fast, high signal-tonoise ratio readout. As typical of notch filters, also this solution exhibits an inherent parameter sensitivity. SQUIDs can be used for post-fabrication frequency tuning, at the expense of an increase of the number of required control lines.