Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1409.8160 · Journal of Applied Physics

Characterization of a multimode coplanar waveguide parametric amplifier

M. Simoen, C. W. S. Chang, Philip Krantz, Jonas Bylander, W. Wustmann, V. Shumeiko, P. Delsing, C. M. Wilson

Published Oct 16, 2015• 49 citations
arXivHTMLPDF

Abstract

We characterize a Josephson parametric amplifier based on a flux-tunable quarter-wavelength resonator. The fundamental resonance frequency is ∼1 GHz, but we use higher modes of the resonator for our measurements. An on-chip tuning line allows for magnetic flux pumping of the amplifier. We investigate and compare degenerate parametric amplification, involving a single mode, and nondegenerate parametric amplification, using a pair of modes. We show that we reach quantum-limited noise performance in both cases.

DOI
10.1063/1.4933265

Related papers

Parametric Microwave Amplification using a Tunable Superconducting Resonator

C. W. Sandbo Chang

In this Master thesis, I present a theoretical description and experimental measurements of a tunable microwave resonator operated as a parametric amplifier. Superconducting parametric amplifiers have attracted great interest in recent years as it has been demonstrated that they can operate with a noise performance at the standard quantum limit. \nParametric amplification is achieved in the devices by modulating the electrical length of the resonator at twice the resonance frequency. The device measured in this thesis consists of a quarter-wavelength microwave resonator fabricated in a thin-film aluminum coplanar waveguide geometry. With a termination to ground through a Superconducting Quantum Interference Device (SQUID), the boundary condition of the resonator becomes sensitive to an applied magnetic field. This enables the tuning of the resonance frequencies, using a DC magnetic field, over a wide frequency range of 670MHz. Similarly, an AC magnetic field then allows for the modulation of the resonator electrical length at microwave frequencies. \nWe characterized the device by first measuring the DC tuning curves of the 2nd and 3rd harmonics of the resonator, around 4 GHz and 6 GHz respectively. We then studied parametric amplification in the device when the electrical length was modulated at approximately twice the resonance frequency of one of the modes. We scanned the pump frequency and pump power over a wide range to study the region in parameters which gives parametric gain. We performed an in-depth parameter sweep over this region, identifying pump parameters that provided maximum gain and maximum system noise improvements compared the following HEMT amplifier. \nWe find that the use of the parametric amplifier can improve the system noise temperature by more than 10 dB compared to a start-of-the-art commercial HEMT amplifier. This implies a performance near the standard quantum limit.

•Sep 2, 2015•0 citations

Design and characterization of a lumped element single-ended superconducting microwave parametric amplifier with on-chip flux bias line

J. Mutus, T. White, Evan R. Jeffrey +18 more

We demonstrate a lumped-element Josephson parametric amplifier, using a single-ended design that includes an on-chip, high-bandwidth flux bias line. The amplifier can be pumped into its region of parametric gain through either the input port or through the flux bias line. Broadband amplification is achieved at a tunable frequency ω/2π between 5 and 7 GHz with quantum-limited noise performance, a gain-bandwidth product greater than 500 MHz, and an input saturation power in excess of −120 dBm. The bias line allows fast frequency tuning of the amplifier, with variations of hundreds of MHz over time scales shorter than 10 ns.

arXiv:1308.1376•Applied Physics Letters•Sep 16, 2013•106 citations

Broadband flux-pumped Josephson parametric amplifier with an on-chip coplanar waveguide impedance transformer

Peng Duan, Zhi-Long Jia, Chi Zhang +11 more

Abstract The rapid progress towards scalable quantum processors demands amplifiers with large bandwidths and high saturation powers. For this purpose, we present a broadband flux-pumped Josephson parametric amplifier integrated with an on-chip coplanar waveguide impedance transformer. Our device can be fabricated with simple and straightforward photo-lithography. This device experimentally achieves an operational bandwidth over 600 MHz with a gain above 15 dB, and a high saturation power with quantum-limited noise performance. In addition, the center frequency of this device can be tuned over several hundred megahertz, which in turn broadens the effective operational bandwidth to around 1 GHz.

Applied Physics Express•Mar 18, 2021•31 citations

Flux-driven Josephson parametric amplifier

Tsuyoshi Yamamoto, K. Inomata, 道生 渡部 +5 more

We have developed a Josephson parametric amplifier comprising a superconducting coplanar-waveguide resonator terminated by a dc superconducting quantum interference device (SQUID). An external field (the pump, ∼20 GHz) modulates the flux threading of the dc SQUID and, therefore, the resonant frequency of the cavity field (the signal, ∼10 GHz), which leads to the parametric signal amplification. We operated the amplifier at different band centers and observed amplification (17 dB at maximum) and deamplification depending on the relative phase between the pump and the signal. The noise temperature is estimated to be less than 0.87 K.

arXiv:0808.1386•Applied Physics Letters•Jul 28, 2008•485 citations

Broadband coplanar-waveguide-based impedance-transformed Josephson parametric amplifier

Bingcheng Qing, Long B. Nguyen, Xinyu Liu +9 more

Quantum-limited Josephson parametric amplifiers play a pivotal role in advancing the field of circuit quantum electrodynamics by enabling the fast and high-fidelity measurement of weak microwave signals. Therefore, it is necessary to develop robust parametric amplifiers with low noise, broad bandwidth, and reduced design complexity for microwave detection. However, current broadband parametric amplifiers either have degraded noise performance or rely on complex designs. Here, we present a device based on the broadband impedance-transformed Josephson parametric amplifier that integrates a hornlike coplanar waveguide transmission line, which significantly decreases the design and fabrication complexity while keeping comparable performance. The device shows an instantaneous bandwidth of 700 (200) MHz for 15 (20) dB gain with an average input saturation power of −110 dBm and near quantum-limited added noise. The operating frequency can be tuned over 1.4 GHz using an external flux bias. We further demonstrate the negligible backaction from our device on a transmon qubit. The amplification performance and simplicity of our device promise its wide adaptation in quantum metrology, quantum communication, and quantum information processing. Published by the American Physical Society 2024

arXiv:2310.17084•Physical Review Research•Feb 22, 2024•13 citations

Multimode Parametric Amplifier for K-Band Quantum Measurements

Chulwoo Ahn, Vladimir Manucharyan

We demonstrate K-band nondegenerate three-wave-mixing amplification in a multimode resonator comprising an array of 500 SNAILs. Pairing K-band signal modes with lower-frequency internal idler modes enables 20 dB of gain continuously from 19.6 to 25.6 GHz with pump frequencies below 32.2 GHz. At 20 dB gain, the 3-dB bandwidth ranges from 2.6 to 11.7 MHz, and the input-referred 1-dB compression power reaches -100.9 dBm. In the 20-22 GHz band, the average added noise is 0.73 quanta. A two-mode nondegenerate parametric amplification model describes the measured gain response and gain-bandwidth behavior, while a multimode Kerr model captures the overall compression scale. Our amplifier provides a practical solution for implementing a state-of-the-art readout of superconducting qubits in the K-band.

quant-pharXiv:2610.27743•Oct 21, 2026•0 citations
We characterize a Josephson parametric amplifier based on a flux-tunable quarter-wavelength resonator. The fundamental resonance frequency is ∼1 GHz, but we use higher modes of the resonator for our measurements. An on-chip tuning line allows for magnetic flux pumping of the amplifier. We investigate and compare degenerate parametric amplification, involving a single mode, and nondegenerate parametric amplification, using a pair of modes. We show that we reach quantum-limited noise performance in both cases.
In this Master thesis, I present a theoretical description and experimental measurements of a tunable microwave resonator operated as a parametric amplifier. Superconducting parametric amplifiers have attracted great interest in recent years as it has been demonstrated that they can operate with a noise performance at the standard quantum limit. \nParametric amplification is achieved in the devices by modulating the electrical length of the resonator at twice the resonance frequency. The device measured in this thesis consists of a quarter-wavelength microwave resonator fabricated in a thin-film aluminum coplanar waveguide geometry. With a termination to ground through a Superconducting Quantum Interference Device (SQUID), the boundary condition of the resonator becomes sensitive to an applied magnetic field. This enables the tuning of the resonance frequencies, using a DC magnetic field, over a wide frequency range of 670MHz. Similarly, an AC magnetic field then allows for the modulation of the resonator electrical length at microwave frequencies. \nWe characterized the device by first measuring the DC tuning curves of the 2nd and 3rd harmonics of the resonator, around 4 GHz and 6 GHz respectively. We then studied parametric amplification in the device when the electrical length was modulated at approximately twice the resonance frequency of one of the modes. We scanned the pump frequency and pump power over a wide range to study the region in parameters which gives parametric gain. We performed an in-depth parameter sweep over this region, identifying pump parameters that provided maximum gain and maximum system noise improvements compared the following HEMT amplifier. \nWe find that the use of the parametric amplifier can improve the system noise temperature by more than 10 dB compared to a start-of-the-art commercial HEMT amplifier. This implies a performance near the standard quantum limit.
We demonstrate a lumped-element Josephson parametric amplifier, using a single-ended design that includes an on-chip, high-bandwidth flux bias line. The amplifier can be pumped into its region of parametric gain through either the input port or through the flux bias line. Broadband amplification is achieved at a tunable frequency ω/2π between 5 and 7 GHz with quantum-limited noise performance, a gain-bandwidth product greater than 500 MHz, and an input saturation power in excess of −120 dBm. The bias line allows fast frequency tuning of the amplifier, with variations of hundreds of MHz over time scales shorter than 10 ns.
Abstract The rapid progress towards scalable quantum processors demands amplifiers with large bandwidths and high saturation powers. For this purpose, we present a broadband flux-pumped Josephson parametric amplifier integrated with an on-chip coplanar waveguide impedance transformer. Our device can be fabricated with simple and straightforward photo-lithography. This device experimentally achieves an operational bandwidth over 600 MHz with a gain above 15 dB, and a high saturation power with quantum-limited noise performance. In addition, the center frequency of this device can be tuned over several hundred megahertz, which in turn broadens the effective operational bandwidth to around 1 GHz.
We have developed a Josephson parametric amplifier comprising a superconducting coplanar-waveguide resonator terminated by a dc superconducting quantum interference device (SQUID). An external field (the pump, ∼20 GHz) modulates the flux threading of the dc SQUID and, therefore, the resonant frequency of the cavity field (the signal, ∼10 GHz), which leads to the parametric signal amplification. We operated the amplifier at different band centers and observed amplification (17 dB at maximum) and deamplification depending on the relative phase between the pump and the signal. The noise temperature is estimated to be less than 0.87 K.
Quantum-limited Josephson parametric amplifiers play a pivotal role in advancing the field of circuit quantum electrodynamics by enabling the fast and high-fidelity measurement of weak microwave signals. Therefore, it is necessary to develop robust parametric amplifiers with low noise, broad bandwidth, and reduced design complexity for microwave detection. However, current broadband parametric amplifiers either have degraded noise performance or rely on complex designs. Here, we present a device based on the broadband impedance-transformed Josephson parametric amplifier that integrates a hornlike coplanar waveguide transmission line, which significantly decreases the design and fabrication complexity while keeping comparable performance. The device shows an instantaneous bandwidth of 700 (200) MHz for 15 (20) dB gain with an average input saturation power of −110 dBm and near quantum-limited added noise. The operating frequency can be tuned over 1.4 GHz using an external flux bias. We further demonstrate the negligible backaction from our device on a transmon qubit. The amplification performance and simplicity of our device promise its wide adaptation in quantum metrology, quantum communication, and quantum information processing. Published by the American Physical Society 2024
We demonstrate K-band nondegenerate three-wave-mixing amplification in a multimode resonator comprising an array of 500 SNAILs. Pairing K-band signal modes with lower-frequency internal idler modes enables 20 dB of gain continuously from 19.6 to 25.6 GHz with pump frequencies below 32.2 GHz. At 20 dB gain, the 3-dB bandwidth ranges from 2.6 to 11.7 MHz, and the input-referred 1-dB compression power reaches -100.9 dBm. In the 20-22 GHz band, the average added noise is 0.73 quanta. A two-mode nondegenerate parametric amplification model describes the measured gain response and gain-bandwidth behavior, while a multimode Kerr model captures the overall compression scale. Our amplifier provides a practical solution for implementing a state-of-the-art readout of superconducting qubits in the K-band.