Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1210.3988 · IEEE Transactions on Applied Superconductivity

Detection Efficiency of a Spiral-Nanowire Superconducting Single-Photon Detector

D. Henrich, Laura Rehm, S. Dorner, M. Hofherr, K. Ilin, Alexej D. Semenov, M. Siegel

Published Jan 24, 2013• 22 citations
arXivHTMLPDF

Abstract

We investigate the detection efficiency of a spiral layout of a superconducting nanowire single-photon detector. The design is less susceptible to the critical current reduction in sharp turns of the nanowire than the conventional meander design. Detector samples with different nanowire widths from 100 to 300 nm are patterned from a 4-nm-thick NbN film deposited on sapphire substrates. The critical current ICat 4.2 K for spiral, meander, and single-bridge structures is measured and compared. On the 100-nm-wide samples, the detection efficiency is measured in the wavelength range 400-1700 nm and the spectral bandwidth of the intrinsic detection efficiency is determined. In the optical range, the spiral detector reaches a detection efficiency of 27.6%, which is ~ 1.5 times the value of the meander. In the infrared range the detection efficiency of the spiral superconducting nanowire single-photon detector is more than doubled.

DOI
10.1109/tasc.2013.2237936

Related papers

Spiral superconducting nanowire single-photon detector with efficiency over 50% at 1550 nm wavelength

Jia Huang, Weijun Zhang, Lixing You +8 more

Abstract Superconducting nanowire single-photon detectors (SNSPDs) are widely used for the detection of visible and near-infrared single photons. Due to the nature of the polarization sensitive absorption of the nanowire, the detection efficiency (DE) of the meander SNSPD is polarization sensitive. In order to obtain a polarization-insensitive device with high DE, we fabricated NbN SNSPDs with spiral structure, which were embedded into an optical cavity. No meaningful current crowding effect was observed in the spiral SNSPDs. The spiral SNSPD showed a maximal system detection efficiency of 52.5% at 1550 nm with a dark count rate of 100 Hz and a polarization extinction ratio of 1.04, due to the combination of a spiral geometry and an optical cavity.

Superconductor Science and Technology•Apr 12, 2017•36 citations

Current dependence of the hot-spot response spectrum of superconducting single-photon detectors with different layouts

Ilya Charaev, A Semenov, S Doerner +3 more

Abstract We show that avoiding bends in a current-carrying superconducting nanowire enhances the probability for low energy photons to be detected and that this enhancement is entirely due to the increase in the experimentally achievable critical current. We studied nanowires shaped as either meander or spiral. The spirals had different layouts, a double-spiral layout with an S-turn in the middle and a single-spiral layout without such a turn. Nanowires were prepared from films of niobium nitride with a thickness of 5 nm. For specimens with each layout we measured the spectra of the single-photon response in the wavelength range from 400 nm to 1600 nm and defined the cut-off wavelength ( λ c ) beyond which the response rolls off. The largest and the smallest λ c were found for the single-spiral layout and for the meander, respectively. For all three layouts the relationship between λ c and the relative bias current falls onto a universal curve which has been predicted earlier in the framework of the modified hot-spot model. For the single-spiral layout, the efficiency of photon detection at wavelengths smaller than λ c reaches the expected absorbance of the spiral structure and the timing jitter per unit length of the nanowire has the smallest value.

arXiv:1608.06083•Superconductor Science and Technology•Dec 23, 2016•23 citations

Superconducting nanowire single-photon detectors: Quantum efficiency vs. film thickness

M. Hofherr, Dagmar Rall, K. Ilin +4 more

The quantum efficiency of superconducting nanowire single-photon detectors has been systematically studied in a broad spectral range from near ultra-violet to near infrared radiation. Detectors were made from NbN films on sapphire substrates and had thicknesses between 4 and 12 nm. The gradual reduction of the quantum efficiency with increasing wavelength is caused by a crossover from the "hot-spot" to the "vortex" detection scenario. For thicker films the wavelength demarcating the two regimes shifts to shorter wavelengths.

Journal of Physics Conference Series•Jun 1, 2010•9 citations

Superconducting nanowire single-photon detectors at a wavelength of 940 nm

W. J. Zhang, Hao Li, Lixing You +9 more

We develop single-photon detectors comprising single-mode fiber-coupled superconducting nanowires, with high system detection efficiencies at a wavelength of 940 nm. The detector comprises a 6.5-nm-thick, 110-nm-wide NbN nanowire meander fabricated onto a Si substrate with a distributed Bragg reflector for enhancing the optical absorptance. We demonstrate that, via the design of a low filling factor (1/3) and active area (Φ = 10 μm), the system reaches a detection efficiency of ∼60% with a dark count rate of 10 Hz, a recovery time <12 ns, and a timing jitter of ∼50 ps.

arXiv:1506.07921•AIP Advances•Jun 1, 2015•7 citations

Intrinsic detection efficiency of superconducting nanowire single-photon detectors with different thicknesses

M. Hofherr, Dagmar Rall, K. Ilin +4 more

We evaluate experimentally the intrinsic detection efficiency (IDE) of superconducting NbN nanowire single-photon detectors in the range of wire thicknesses from 4 to 12 nm. The study is performed in the broad spectral interval between near-ultraviolet (wavelength 400 nm) and near-infrared (wavelength 2000 nm) light with plane waves at normal incidence. For visible light the IDE of the thinnest detectors reaches 70%. We use numerically computed absorptance of the nanowire-structures for the analysis of the experimental data. Variations in the detection efficiency with both the wire thickness and the wavelength evidence the red boundary of the hot-spot photon-detection mechanism. We explain the detection at larger wavelengths invoking thermal excitation of magnetic Pearl vortices over the potential barrier at the edges of the wire.

Journal of Applied Physics•Jul 1, 2010•94 citations

Effect of the Wire Width and Magnetic Field on the Intrinsic Detection Efficiency of Superconducting Nanowire Single-Photon Detectors

R. Lusche, Alexej D. Semenov, K. Ilin +6 more

We present thorough measurements of the intrinsic detection efficiency in the wavelength range from 350 to 2500 nm for meander-type TaN and NbN superconducting nanowire single-photon detectors with different widths of the nanowire. The width varied from 70 nm to 130 nm. The open-beam configuration allowed us to accurately normalize measured spectra and to extract the intrinsic detection efficiency. For detectors from both materials the intrinsic detection efficiency at short wavelengths amounts at 100% and gradually decreases at wavelengths larger than the specific cut-off wavelengths, which decreases with the width of the nanowire. Furthermore, we show that applying weak magnetic fields perpendicular to the meander plane decreases the smallest detectable photon flux.

IEEE Transactions on Applied Superconductivity•Dec 20, 2012•16 citations
We investigate the detection efficiency of a spiral layout of a superconducting nanowire single-photon detector. The design is less susceptible to the critical current reduction in sharp turns of the nanowire than the conventional meander design. Detector samples with different nanowire widths from 100 to 300 nm are patterned from a 4-nm-thick NbN film deposited on sapphire substrates. The critical current ICat 4.2 K for spiral, meander, and single-bridge structures is measured and compared. On the 100-nm-wide samples, the detection efficiency is measured in the wavelength range 400-1700 nm and the spectral bandwidth of the intrinsic detection efficiency is determined. In the optical range, the spiral detector reaches a detection efficiency of 27.6%, which is ~ 1.5 times the value of the meander. In the infrared range the detection efficiency of the spiral superconducting nanowire single-photon detector is more than doubled.
Abstract Superconducting nanowire single-photon detectors (SNSPDs) are widely used for the detection of visible and near-infrared single photons. Due to the nature of the polarization sensitive absorption of the nanowire, the detection efficiency (DE) of the meander SNSPD is polarization sensitive. In order to obtain a polarization-insensitive device with high DE, we fabricated NbN SNSPDs with spiral structure, which were embedded into an optical cavity. No meaningful current crowding effect was observed in the spiral SNSPDs. The spiral SNSPD showed a maximal system detection efficiency of 52.5% at 1550 nm with a dark count rate of 100 Hz and a polarization extinction ratio of 1.04, due to the combination of a spiral geometry and an optical cavity.
Abstract We show that avoiding bends in a current-carrying superconducting nanowire enhances the probability for low energy photons to be detected and that this enhancement is entirely due to the increase in the experimentally achievable critical current. We studied nanowires shaped as either meander or spiral. The spirals had different layouts, a double-spiral layout with an S-turn in the middle and a single-spiral layout without such a turn. Nanowires were prepared from films of niobium nitride with a thickness of 5 nm. For specimens with each layout we measured the spectra of the single-photon response in the wavelength range from 400 nm to 1600 nm and defined the cut-off wavelength ( λ c ) beyond which the response rolls off. The largest and the smallest λ c were found for the single-spiral layout and for the meander, respectively. For all three layouts the relationship between λ c and the relative bias current falls onto a universal curve which has been predicted earlier in the framework of the modified hot-spot model. For the single-spiral layout, the efficiency of photon detection at wavelengths smaller than λ c reaches the expected absorbance of the spiral structure and the timing jitter per unit length of the nanowire has the smallest value.
The quantum efficiency of superconducting nanowire single-photon detectors has been systematically studied in a broad spectral range from near ultra-violet to near infrared radiation. Detectors were made from NbN films on sapphire substrates and had thicknesses between 4 and 12 nm. The gradual reduction of the quantum efficiency with increasing wavelength is caused by a crossover from the "hot-spot" to the "vortex" detection scenario. For thicker films the wavelength demarcating the two regimes shifts to shorter wavelengths.
We develop single-photon detectors comprising single-mode fiber-coupled superconducting nanowires, with high system detection efficiencies at a wavelength of 940 nm. The detector comprises a 6.5-nm-thick, 110-nm-wide NbN nanowire meander fabricated onto a Si substrate with a distributed Bragg reflector for enhancing the optical absorptance. We demonstrate that, via the design of a low filling factor (1/3) and active area (Φ = 10 μm), the system reaches a detection efficiency of ∼60% with a dark count rate of 10 Hz, a recovery time <12 ns, and a timing jitter of ∼50 ps.
We evaluate experimentally the intrinsic detection efficiency (IDE) of superconducting NbN nanowire single-photon detectors in the range of wire thicknesses from 4 to 12 nm. The study is performed in the broad spectral interval between near-ultraviolet (wavelength 400 nm) and near-infrared (wavelength 2000 nm) light with plane waves at normal incidence. For visible light the IDE of the thinnest detectors reaches 70%. We use numerically computed absorptance of the nanowire-structures for the analysis of the experimental data. Variations in the detection efficiency with both the wire thickness and the wavelength evidence the red boundary of the hot-spot photon-detection mechanism. We explain the detection at larger wavelengths invoking thermal excitation of magnetic Pearl vortices over the potential barrier at the edges of the wire.
We present thorough measurements of the intrinsic detection efficiency in the wavelength range from 350 to 2500 nm for meander-type TaN and NbN superconducting nanowire single-photon detectors with different widths of the nanowire. The width varied from 70 nm to 130 nm. The open-beam configuration allowed us to accurately normalize measured spectra and to extract the intrinsic detection efficiency. For detectors from both materials the intrinsic detection efficiency at short wavelengths amounts at 100% and gradually decreases at wavelengths larger than the specific cut-off wavelengths, which decreases with the width of the nanowire. Furthermore, we show that applying weak magnetic fields perpendicular to the meander plane decreases the smallest detectable photon flux.