Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1207.4645 · Oxford University Press eBooks

Nonlinear oscillators and high fidelity qubit state measurement in circuit quantum electrodynamics

Eran Ginossar, Lev S. Bishop, S. M. Girvin

Published Jul 26, 2012• 0 citations
arXivHTMLPDF

Abstract

This chapter analyzes the high excitation nonlinear response of the Jaynes–Cummings model in quantum optics when the qubit and cavity are strongly coupled. It studies the response in the parameter ranges appropriate for transmon qubits in the circuit quantum electrodynamics architecture. It focuses on the situation where the system behaves essentially as a nonlinear quantum oscillator and explores quantum and semi-classical dynamics. One of the central motivations is that under strong excitation tones, the nonlinear response can lead to qubit quantum state discrimination and the chapter then presents results for the cases when the qubit and cavity are on resonance or far off-resonance (dispersive).

DOI
10.1093/acprof:oso/9780199691388.003.0008

Related papers

Circuit quantum electrodynamics with a nonlinear resonator

Patrice Bertet, Florian R. Ong, Maxime Boissonneault +6 more

This chapter investigates the coupling of a two-level system to a nonlinear resonator, one of the simplest extensions to the well-known Jaynes–Cummings model. In the experiment, the two-level system is a superconducting transmon qubit, and the resonator is a coplanar resonator with a Kerr nonlinearity induced by a Josephson junction. Effects arising from the resonator nonlinearity (bistability, parametric amplification, squeezing) qualitatively modify the dispersive qubit-resonator coupling. This makes it possible to design a qubit readout which has both a high fidelity and the potential of being QND. Motivated by fundamental and practical issues concerning the quantum limit of such a measurement, the chapter also studies spectroscopically the quantum back action exerted by the intraresonator field onto the qubit. Qualitative agreement is obtained with analytical results and quantitative agreement with numerical simulations.

Oxford University Press eBooks•Jul 26, 2012•7 citations

Circuit quantum electrodynamics with a nonlinear resonator

Patrice Bertet, Florian R. Ong, M. Boissonneault +6 more

One of the most studied model systems in quantum optics is a two-level atom strongly coupled to a single mode of the electromagnetic field stored in a cavity, a research field named cavity quantum electrodynamics or CQED. CQED has recently received renewed attention due to its implementation with superconducting artificial atoms and coplanar resonators in the so-called circuit quantum electrodynamics (cQED) architecture. In cQED, the couplings can be much stronger than in CQED due to the design flexibility of superconducting circuits and to the enhanced field confinement in one-dimensional cavities. This enabled the realization of fundamental quantum physics and quantum information processing experiments with a degree of control comparable to that obtained in CQED. The purpose of this chapter is to investigate the situation where the resonator to which the atom is coupled is made nonlinear with a Kerr-type nonlinearity, causing its energy levels to be nonequidistant. The system is then described by a nonlinear Jaynes-Cummings Hamiltonian. This considerably enriches the physics since a pumped nonlinear resonator displays bistability, parametric amplification, and squeezing. The interplay of strong coupling and these nonlinear effects constitutes a novel model system for quantum optics that can be implemented experimentally with superconducting circuits. This chapter is organized as follows. In a first section we present the system consisting of a superconducting Kerr nonlinear resonator strongly coupled to a transmon qubit. In the second section, we describe the response of the sole nonlinear resonator to an external drive. In the third section, we show how the resonator bistability can be used to perform a high-fidelity readout of the transmon qubit. In the last section, we investigate the quantum backaction exerted by the intracavity field on the qubit.

arXiv:1111.0501•Nov 2, 2011•2 citations

High-Fidelity Readout in Circuit Quantum Electrodynamics Using the Jaynes-Cummings Nonlinearity

M. D. Reed, L. DiCarlo, Blake Johnson +4 more

We demonstrate a qubit readout scheme that exploits the Jaynes-Cummings nonlinearity of a superconducting cavity coupled to transmon qubits. We find that, in the strongly driven dispersive regime of this system, there is the unexpected onset of a high-transmission "bright" state at a critical power which depends sensitively on the initial qubit state. A simple and robust measurement protocol exploiting this effect achieves a single-shot fidelity of 87% using a conventional sample design and experimental setup, and at least 61% fidelity to joint correlations of three qubits.

arXiv:1004.4323•Physical Review Letters•Oct 19, 2010•270 citations

Response of the Strongly Driven Jaynes-Cummings Oscillator

Lev S. Bishop, Eran Ginossar, S. M. Girvin

We analyze the Jaynes-Cummings model of quantum optics, in the strong-dispersive regime. In the bad-cavity limit and on time scales short compared to the atomic coherence time, the dynamics are those of a nonlinear oscillator. A steady-state nonperturbative semiclassical analysis exhibits a finite region of bistability delimited by a pair of critical points, unlike the usual dispersive bistability from a Kerr nonlinearity. This analysis explains our quantum trajectory simulations that show qualitative agreement with recent experiments from the field of circuit quantum electrodynamics.

arXiv:1005.0377•Physical Review Letters•Sep 2, 2010•124 citations

Spectral response of a nonlinear Jaynes-Cummings model

L. Medina-Dozal, Alejandro R. Urzúa, D. Aranda-Lozano +3 more

The Jaynes-Cummings quantum optics model allows us to understand the dialogue between light and matter at its most fundamental level, which is crucial for advancements in quantum science and technology. Several generalizations of the model have been proposed, emphasizing their dynamic behavior but paying less attention to their spectroscopy. Here we obtain analytical expressions of the time-dependent spectral response of a nonlinear Jaynes-Cummings model based on deformed field operators. We show that the long-time response of the resulting nonlinear cavity field resembles the one experimentally obtained in the strong-dispersive regime of circuit quantum electrodynamics. The spectrum is intrinsically asymmetric with the nonlinear coupling, a signature of the impossibility of getting resonant conditions for finite field excitations.

arXiv:2408.09061•Physical Review A•Oct 3, 2024•6 citations

Microwave-induced amplitude- and phase-tunable qubit-resonator coupling in circuit quantum electrodynamics

Sina Zeytinoǧlu, Marek Pechal, S. Berger +3 more

In the circuit quantum electrodynamics architecture, both the resonance frequency and the coupling of superconducting qubits to microwave field modes can be controlled via external electric and magnetic fields to explore qubit-photon dynamics in a wide parameter range. Here, we experimentally demonstrate and analyze a scheme for tuning the coupling between a transmon qubit and a microwave resonator using a single coherent drive tone. We treat the transmon as a three-level system, with the qubit subspace defined by the ground and the second excited states. If the drive frequency matches the difference between the resonator and the qubit frequencies, a Jaynes-Cummings-type interaction is induced, which is tunable in both amplitude and phase. We show that coupling strengths of about 10 MHz can be achieved in our setup, limited only by the anharmonicity of the transmon qubit. This scheme has been successfully used to generate microwave photons with a controlled temporal shape [M. Pechal et al., Phys. Rev. X 4, 041010 (2014)] and can be directly implemented with superconducting quantum devices featuring larger anharmonicity for higher coupling strengths.

arXiv:1502.03692•Physical Review A•Apr 30, 2015•97 citations
This chapter analyzes the high excitation nonlinear response of the Jaynes–Cummings model in quantum optics when the qubit and cavity are strongly coupled. It studies the response in the parameter ranges appropriate for transmon qubits in the circuit quantum electrodynamics architecture. It focuses on the situation where the system behaves essentially as a nonlinear quantum oscillator and explores quantum and semi-classical dynamics. One of the central motivations is that under strong excitation tones, the nonlinear response can lead to qubit quantum state discrimination and the chapter then presents results for the cases when the qubit and cavity are on resonance or far off-resonance (dispersive).
This chapter investigates the coupling of a two-level system to a nonlinear resonator, one of the simplest extensions to the well-known Jaynes–Cummings model. In the experiment, the two-level system is a superconducting transmon qubit, and the resonator is a coplanar resonator with a Kerr nonlinearity induced by a Josephson junction. Effects arising from the resonator nonlinearity (bistability, parametric amplification, squeezing) qualitatively modify the dispersive qubit-resonator coupling. This makes it possible to design a qubit readout which has both a high fidelity and the potential of being QND. Motivated by fundamental and practical issues concerning the quantum limit of such a measurement, the chapter also studies spectroscopically the quantum back action exerted by the intraresonator field onto the qubit. Qualitative agreement is obtained with analytical results and quantitative agreement with numerical simulations.
One of the most studied model systems in quantum optics is a two-level atom strongly coupled to a single mode of the electromagnetic field stored in a cavity, a research field named cavity quantum electrodynamics or CQED. CQED has recently received renewed attention due to its implementation with superconducting artificial atoms and coplanar resonators in the so-called circuit quantum electrodynamics (cQED) architecture. In cQED, the couplings can be much stronger than in CQED due to the design flexibility of superconducting circuits and to the enhanced field confinement in one-dimensional cavities. This enabled the realization of fundamental quantum physics and quantum information processing experiments with a degree of control comparable to that obtained in CQED. The purpose of this chapter is to investigate the situation where the resonator to which the atom is coupled is made nonlinear with a Kerr-type nonlinearity, causing its energy levels to be nonequidistant. The system is then described by a nonlinear Jaynes-Cummings Hamiltonian. This considerably enriches the physics since a pumped nonlinear resonator displays bistability, parametric amplification, and squeezing. The interplay of strong coupling and these nonlinear effects constitutes a novel model system for quantum optics that can be implemented experimentally with superconducting circuits. This chapter is organized as follows. In a first section we present the system consisting of a superconducting Kerr nonlinear resonator strongly coupled to a transmon qubit. In the second section, we describe the response of the sole nonlinear resonator to an external drive. In the third section, we show how the resonator bistability can be used to perform a high-fidelity readout of the transmon qubit. In the last section, we investigate the quantum backaction exerted by the intracavity field on the qubit.
We demonstrate a qubit readout scheme that exploits the Jaynes-Cummings nonlinearity of a superconducting cavity coupled to transmon qubits. We find that, in the strongly driven dispersive regime of this system, there is the unexpected onset of a high-transmission "bright" state at a critical power which depends sensitively on the initial qubit state. A simple and robust measurement protocol exploiting this effect achieves a single-shot fidelity of 87% using a conventional sample design and experimental setup, and at least 61% fidelity to joint correlations of three qubits.
We analyze the Jaynes-Cummings model of quantum optics, in the strong-dispersive regime. In the bad-cavity limit and on time scales short compared to the atomic coherence time, the dynamics are those of a nonlinear oscillator. A steady-state nonperturbative semiclassical analysis exhibits a finite region of bistability delimited by a pair of critical points, unlike the usual dispersive bistability from a Kerr nonlinearity. This analysis explains our quantum trajectory simulations that show qualitative agreement with recent experiments from the field of circuit quantum electrodynamics.
The Jaynes-Cummings quantum optics model allows us to understand the dialogue between light and matter at its most fundamental level, which is crucial for advancements in quantum science and technology. Several generalizations of the model have been proposed, emphasizing their dynamic behavior but paying less attention to their spectroscopy. Here we obtain analytical expressions of the time-dependent spectral response of a nonlinear Jaynes-Cummings model based on deformed field operators. We show that the long-time response of the resulting nonlinear cavity field resembles the one experimentally obtained in the strong-dispersive regime of circuit quantum electrodynamics. The spectrum is intrinsically asymmetric with the nonlinear coupling, a signature of the impossibility of getting resonant conditions for finite field excitations.
In the circuit quantum electrodynamics architecture, both the resonance frequency and the coupling of superconducting qubits to microwave field modes can be controlled via external electric and magnetic fields to explore qubit-photon dynamics in a wide parameter range. Here, we experimentally demonstrate and analyze a scheme for tuning the coupling between a transmon qubit and a microwave resonator using a single coherent drive tone. We treat the transmon as a three-level system, with the qubit subspace defined by the ground and the second excited states. If the drive frequency matches the difference between the resonator and the qubit frequencies, a Jaynes-Cummings-type interaction is induced, which is tunable in both amplitude and phase. We show that coupling strengths of about 10 MHz can be achieved in our setup, limited only by the anharmonicity of the transmon qubit. This scheme has been successfully used to generate microwave photons with a controlled temporal shape [M. Pechal et al., Phys. Rev. X 4, 041010 (2014)] and can be directly implemented with superconducting quantum devices featuring larger anharmonicity for higher coupling strengths.