We have measured the plasma resonances of an array of Josephson junctions in the regime E(J)>>E(C), up to the ninth harmonic by incorporating it as part of a resonator capacitively coupled to a coplanar waveguide. From the characteristics of the resonances, we infer the successful implementation of a superinductance, an electrical element with a nondissipative impedance greater than the resistance quantum [R(Q)=h/(2e)(2) is approximately equal to 6.5 kΩ] at microwave frequencies. Such an element is crucial for preserving the quantum coherence in circuits exploiting large fluctuations of the superconducting phase. Our results show internal losses less than 20 ppm, self-resonant frequencies greater than 10 GHz, and phase-slip rates less than 1 mHz, enabling direct application of such arrays for quantum information and metrology. Arrays with a loop geometry also demonstrate a new manifestation of flux quantization in a dispersive analog of the Little-Parks effect.
We have measured the plasma resonances of an array of Josephson junctions in the regime E(J)>>E(C), up to the ninth harmonic by incorporating it as part of a resonator capacitively coupled to a coplanar waveguide. From the characteristics of the resonances, we infer the successful implementation of a superinductance, an electrical element with a nondissipative impedance greater than the resistance quantum [R(Q)=h/(2e)(2) is approximately equal to 6.5 kΩ] at microwave frequencies. Such an element is crucial for preserving the quantum coherence in circuits exploiting large fluctuations of the superconducting phase. Our results show internal losses less than 20 ppm, self-resonant frequencies greater than 10 GHz, and phase-slip rates less than 1 mHz, enabling direct application of such arrays for quantum information and metrology. Arrays with a loop geometry also demonstrate a new manifestation of flux quantization in a dispersive analog of the Little-Parks effect.
We report microwave spectroscopy of Josephson junctions chains made from an epitaxial Al/InAs heterostructure. The chains exhibit superinductance, with characteristic wave impedance exceeding RQ=ℏ/(2e)2. The planar nature of the junctions results in a large plasma frequency, with no measurable deviations from ideal dispersion up to 12GHz. Internal quality factors decrease sharply with frequency, which we describe with a simple loss model. The possibility of a loss mechanism intrinsic to the superconductor-semiconductor junction is considered.
This work is concerned with two fascinating circuit quantum electrodynamics components, the Josephson junction and the geometric superinductor, and the interesting experiments that can be done by combining the two. The Josephson junction has revolutionized the field of superconducting circuits as a non-linear dissipation-less circuit element and is used in almost all superconducting qubit implementations since the 90s. On the other hand, the superinductor is a relatively new circuit element introduced as a key component of the fluxonium qubit in 2009. This is an inductor with characteristic impedance larger than the resistance quantum and self-resonance frequency in the GHz regime. The combination of these two elements can occur in two fundamental ways: in parallel and in series. When connected in parallel the two create the fluxonium qubit, a loop with large inductance and a rich energy spectrum reliant on quantum tunneling. On the other hand placing the two elements in series aids with the measurement of the IV curve of a single Josephson junction in a high impedance environment. In this limit theory predicts that the junction will behave as its dual element: the phase-slip junction. While the Josephson junction acts as a non-linear inductor the phase-slip junction has the behavior of a non-linear capacitance and can be used to measure new Josephson junction phenomena, namely Coulomb blockade of Cooper pairs and phase-locked Bloch oscillations. The latter experiment allows for a direct link between frequency and current which is an elusive connection in quantum metrology. This work introduces the geometric superinductor, a superconducting circuit element where the high inductance is due to the geometry rather than the material properties of the superconductor, realized from a highly miniaturized superconducting planar coil. These structures will be described and characterized as resonators and qubit inductors and progress towards the measurement of phase-locked Bloch oscillations will be presented.
Superinductors are inductors whose microwave characteristic impedances are greater than the resistance quantum, RQ=h/(2e)2approx6.5kOmega. They can be implemented using Josephson junction chains and high kinetic inductance nanowires. In this dissertation, we explore applications of superinductors in both implementations in superconducting quantum circuits. The dissertation consists of three parts. In the first part, we discuss the fluxon-parity-protected qubit consisting of a Cooper-pair box (CPB) shunted by a superinductor made of a chain of coupled asymmetric Superconducting Quantum Interference Devices (CASQUIDs). The spectroscopic measurement of a prototype of the fluxon-parity-protected qubit was performed. We observed almost complete suppression of the single fluxon tunneling across the CPB due to the destructive Aharonov-Casher interference when the offset charge on the CPB island was set to e mod(2e). A fluxon-parity-protected qubit with a higher superinductance can potentially be used to perform fault-tolerant Clifford gates. In the second part, we studied the microwave losses in high-kinetic-inductance granular Aluminum films using superconducting coplanar-waveguide (CPW) resonators made of the films. We observed that the intrinsic losses in these resonators at low temperatures were limited by resonator coupling to the two-level systems (TLS) in the environment. The demonstrated internal quality factors are comparable with those for CPW resonators made of conventional superconductors. The characterized granular Aluminum films can be used to fabricate superinductors for a wide range of applications in quantum metrology and quantum information processing. In the third part, we discuss the one-dimensional Josephson metamaterial made of a similar structure as the superinductor used in the fluxon-parity-protected qubit. The metamaterial demonstrated strong Kerr nonlinearity with the Kerr constant tunable over a wide range from positive to negative values by the magnetic field. The metamaterial is promising for use as an active medium for quantum-limited Josephson traveling-wave parametric amplifiers.
Superinductances are superconducting circuit elements that combine a large inductance with a low parasitic capacitance to ground, resulting in a characteristic impedance exceeding the resistance quantum RQ=h/(2e)2≃6.45kΩ. In recent years, these components have become key enablers for emerging quantum circuit architectures. However, achieving high characteristic impedance while maintaining scalability and fabrication robustness remains a major challenge. In this work, we present two fabrication techniques for realizing superinductances based on vertically stacked Josephson junctions. Using a multi-angle Manhattan (MAM) process and a zero-angle (ZA) evaporation technique -- in which junction stacks are connected pairwise using airbridges -- we fabricate one-dimensional chains of stacks that act as high-impedance superconducting transmission lines. Two-tone microwave spectroscopy reveals the expected n scaling of the impedance with the number of junctions per stack. The chain fabricated using the ZA process, with nine junctions per stack, achieves a characteristic impedance of ∼16kΩ, a total inductance of 5.9μH, and a maximum frequency-dependent impedance of 50kΩ at 1.4 GHz. Our results establish junction stacking as a scalable, robust, and flexible platform for next-generation quantum circuits requiring ultra-high impedance environments.
A high temperature superconducting YBa2Cu3Oy array of five Josephson junctions designed with additional coupling lines has been developed to demonstrate the effects of frequency locking and impedance matching for applications such as oscillators, mixers, and detectors. The Josephson self-radiation power was directly detected by a superheterodyne receiver, and Shapiro steps were also measured. The Josephson self-radiation properties reveal good quality of phase locking and microwave coupling with external circuits. The maximum self-radiation power of our array is about 50 pW which is several ten times higher than that of a single Josephson junction, and its peak point exactly satisfies the Josephson current-voltage relation. The Shapiro-step measurements show that the behavior of current-voltage curve depends on the effective inductance of coupling lines which affects the total impedance of Josephson junction array and microwave coupling. The Josephson oscillation frequency was obtained up to about 880 GHz which is 73% of the maximum available frequency calculated from the characteristic voltage of the Josephson junctions. Experimental results show that this type of Josephson junction array can improve the Josephson self-radiation power and increase the maximum detectable frequency.
In this thesis, we first demonstrate that a disordered superconductor with high kinetic inductance can realise a microwave low-loss, non-dissipative circuit element with impedance greater than the quantum resistance. This element, known as a superinductor, can suppress the fluctuations of charge in a quantum circuit.For this purpose, we fabricated and characterised 20 nm thick, 40 nm wide niobium-nitride nanowires and determined the impedance to 6.795 kΩ. We demonstrate internal quality factors Qi = 2.5e4 in nanowire resonators at single photon excitation, which is significantly higher than values reported in devices with similar materials and geometries. Moreover, we show that the dominant dissipation in our nanowires is not an intrinsic property of the disordered films, but can instead be fully understood within the framework of two-level systems.To further characterise these losses, we then explore the geometrical scaling, toward nanowire dimensions, of dielectric losses in superconducting microwave resonators fabricated with the same techniques and from the same NbN thin-film as the nanowire superinductors. For this purpose, we perform an experimental and numerical study of dielectric loss at low temperatures. Using 3D finite-element simulation of the Maxwell--London equations, we compute the geometric filling factors of the lossy regions in our resonator structures and fit the experimental data to determine the intrinsic loss tangents of its interfaces and dielectrics. Finally, we study the effect of two-level systems on the performance of various superconducting quantum circuits. For this purpose, we measure coherence-time fluctuations in qubits and frequency fluctuations in resonators. In all devices, through statistical analysis, we identify the signature of individual Lorentzian fluctuators in the noise. We find that fluctuations in qubit relaxation are local to the qubit and are caused by instabilities of near-resonant two-level-systems. Furthermore, when examining the low-frequency noise of three different types of superconducting resonator - one NbN nanowire, one Al coplanar waveguide, and one Al 3D cavity - we observe a similar power-law dependence of the Lorentzian switching time and amplitude on the circulating power in the resonators, suggesting a common noise mechanism in the three different types of devices.