Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1108.2693 · Physical Review A

Optimized heralding schemes for single photons

Yu-Ping Huang, Joseph B. Altepeter, Prem Kumar

Published Sep 20, 2011• 17 citations
arXivHTMLPDF

Abstract

A major obstacle to a practical, heralded source of single photons is the fundamental trade-off between high purity and high production rate. To overcome this difficulty, we propose applying sequential spectral and temporal filtering on the signal photons before they are detected for heralding. Based on a multimode theory that takes into account the effect of simultaneous multiple photon-pair emission, we find that these filters can be optimized to yield both high purity and a high production rate. While the optimization conditions vary depending on the underlying photon-pair spectral correlations, all correlation profiles can lead to similarly high performance levels when optimized filters are employed. This suggests that a better strategy for improving the performance of heralded single-photon sources is to adopt an appropriate measurement scheme for the signal photons, rather than tailoring the properties of the photon-pair generation medium.

DOI
10.1103/physreva.84.033844

Related papers

Limits on the heralding efficiencies and spectral purities of spectrally filtered single photons from photon-pair sources

Evan Meyer-Scott, Nicola Montaut, Johannes Tiedau +4 more

Photon pairs produced by parametric down-conversion or four-wave mixing can interfere with each other in multiport interferometers or carry entanglement between distant nodes for use in entanglement swapping. This requires the photons to be spectrally pure to ensure good interference and have high heralding efficiency to know accurately the number of photons involved and to maintain high rates as the number of photons grows. Spectral filtering is often used to remove noise and define spectral properties. For heralded single photons high purity and heralding efficiency are possible by filtering the heralding arm, but when both photons in typical pair sources are filtered, we show that the heralding efficiency of one or both of the photons is strongly reduced even by ideal spectral filters with 100% transmission in the passband: any improvement in reduced-state spectral purity from filtering comes at the cost of lowered heralding efficiency. We consider the fidelity to a pure, lossless single photon, symmetrize it to include both photons of the pair, and show this quantity is intrinsically limited for sources with spectral correlation. We then provide a framework for this effect for benchmarking common photon-pair sources and present an experiment where we vary the photon filter bandwidths and measure the increase in purity and corresponding reduction in heralding efficiency.

arXiv:1702.05501•Physical Review A•Jun 26, 2017•107 citations

Effects of filtering on the purity of heralded single photons from parametric sources

Daniel R. Blay, Michael J. Steel, L. G. Helt

Optical quantum protocols are reliant on the production of highly pure single photons. However, most parametric heralded single-photon sources possess spectral correlations, limiting the purity of the produced photon. The most common method for restoring the purity is with narrowband spectral filtering, which comes at the cost of reducing the rate of heralding detection. Here, we characterize this trade-off analytically for a large class of parametric sources. It is possible to achieve up to 20% heralding success probabilities with 90% heralded photon purities.

arXiv:1705.10953•Physical Review A•Nov 20, 2017•22 citations

Heralding single photons without spectral factorability

Yu-Ping Huang, Joseph B. Altepeter, Prem Kumar

Recent efforts to produce single photons via heralding have relied on creating spectrally factorable two-photon states in order to achieve both high purity and high production rate. Through a careful multimode analysis, we find, however, that spectral factorability is not necessary. Utilizing single-mode detection, a similar or better performance can be achieved with nonfactorable states. This conclusion rides on the fact that even when using a broadband filter, a single-mode measurement can still be realized, as long as the coherence time of the triggering photons exceeds the measurement window of the on-off detector.

arXiv:1008.2792•Physical Review A•Oct 18, 2010•29 citations

High-Performance Single-Photon Sources via Spatial Multiplexing

Kevin T. McCusker, Yu‐Ping Huang, Gregory S. Kanter

Abstract : Single photons sources are desired for many potential quantum information applications. One common method to produce single photons is based on a heralding protocol, which involves generating a pair of photons in an optical nonlinear medium and then detecting one photon in the pair to announce the existence of the other photon of the pair. Compared to other schemes, such a method offers several significant advantages. A major challenge to overcome which is inherent to this method, however, is that the photon pairs are created stochastically in the optical nonlinear medium. Thus, in order to ensure high purity levels for the single photons generated via heralding, sources of this type must be operated at low photon-pair production rates in order to keep the probability for simultaneous creation of multiple photon-pairs to an acceptably low level. A direct result of this restriction is a low heralding rate of single photons. A potential solution for achieving high-rate, high-purity, single-photon generation combines several heralding single-photon sources which are actively multiplexed to act as one source. The overall goal of this project is to develop methods to perform such multiplexing based on the use of a low loss high speed fiber optical switch.

•Jan 1, 2014•0 citations

Characterization of spectrally filtered heralded single photons

John F. Suárez-Pérez, Alejandra Valencia, Mayerlin Núñez Portela

One method to produce pure heralded single photons (HSP) when using the optical process of spontaneous parametric down-conversion (SPDC) is by modifying the joint spectrum of the photon pairs by means of spectral filters. In this work, we characterize the dependence, with the bandwidth of such filters, of the spectral purity and heralding efficiency of the HSP generated in a bulk SPDC. The values we report for the purity and heralding efficiency are obtained from measurements of the joint spectrum. Our results are in agreement with the theoretical model that predicts a trade-off between the purity and heralding efficiency, and they complement similar measurements that have been done for HSP produced by other types of sources.

Journal of the Optical Society of America B•Mar 3, 2020•2 citations

How filtering affects photon-pairs produced by parametric processes

Daniel R. Blay, Michael J. Steel, L. G. Helt

Many quantum information protocols require the high rate production of individual photons with near unit purity. The most mature platform for producing these photons is nonlinear optical sources, which exploit parametric processes to produce photon pairs, one of which is subsequently detected to “herald” the presence of its partner. The photon pairs produced in such sources often have strong frequency correlations, which adversely affect the purity of the heralded single photons, and so such sources are spectrally filtered to restore the purity. Because this process throws away photons, the rate of photon production is reduced - filtering increases purity at the cost of efficiency. This relationship has been explored extensively numerically [1-3], but has not been well understood analytically. As the demand for multi-photon experiments increases, it is becoming necessary to precisely quantify the trade-off between purity and efficiency. We believe our work enables this.

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•Jun 1, 2017•0 citations
A major obstacle to a practical, heralded source of single photons is the fundamental trade-off between high purity and high production rate. To overcome this difficulty, we propose applying sequential spectral and temporal filtering on the signal photons before they are detected for heralding. Based on a multimode theory that takes into account the effect of simultaneous multiple photon-pair emission, we find that these filters can be optimized to yield both high purity and a high production rate. While the optimization conditions vary depending on the underlying photon-pair spectral correlations, all correlation profiles can lead to similarly high performance levels when optimized filters are employed. This suggests that a better strategy for improving the performance of heralded single-photon sources is to adopt an appropriate measurement scheme for the signal photons, rather than tailoring the properties of the photon-pair generation medium.
Photon pairs produced by parametric down-conversion or four-wave mixing can interfere with each other in multiport interferometers or carry entanglement between distant nodes for use in entanglement swapping. This requires the photons to be spectrally pure to ensure good interference and have high heralding efficiency to know accurately the number of photons involved and to maintain high rates as the number of photons grows. Spectral filtering is often used to remove noise and define spectral properties. For heralded single photons high purity and heralding efficiency are possible by filtering the heralding arm, but when both photons in typical pair sources are filtered, we show that the heralding efficiency of one or both of the photons is strongly reduced even by ideal spectral filters with 100% transmission in the passband: any improvement in reduced-state spectral purity from filtering comes at the cost of lowered heralding efficiency. We consider the fidelity to a pure, lossless single photon, symmetrize it to include both photons of the pair, and show this quantity is intrinsically limited for sources with spectral correlation. We then provide a framework for this effect for benchmarking common photon-pair sources and present an experiment where we vary the photon filter bandwidths and measure the increase in purity and corresponding reduction in heralding efficiency.
Optical quantum protocols are reliant on the production of highly pure single photons. However, most parametric heralded single-photon sources possess spectral correlations, limiting the purity of the produced photon. The most common method for restoring the purity is with narrowband spectral filtering, which comes at the cost of reducing the rate of heralding detection. Here, we characterize this trade-off analytically for a large class of parametric sources. It is possible to achieve up to 20% heralding success probabilities with 90% heralded photon purities.
Recent efforts to produce single photons via heralding have relied on creating spectrally factorable two-photon states in order to achieve both high purity and high production rate. Through a careful multimode analysis, we find, however, that spectral factorability is not necessary. Utilizing single-mode detection, a similar or better performance can be achieved with nonfactorable states. This conclusion rides on the fact that even when using a broadband filter, a single-mode measurement can still be realized, as long as the coherence time of the triggering photons exceeds the measurement window of the on-off detector.
Abstract : Single photons sources are desired for many potential quantum information applications. One common method to produce single photons is based on a heralding protocol, which involves generating a pair of photons in an optical nonlinear medium and then detecting one photon in the pair to announce the existence of the other photon of the pair. Compared to other schemes, such a method offers several significant advantages. A major challenge to overcome which is inherent to this method, however, is that the photon pairs are created stochastically in the optical nonlinear medium. Thus, in order to ensure high purity levels for the single photons generated via heralding, sources of this type must be operated at low photon-pair production rates in order to keep the probability for simultaneous creation of multiple photon-pairs to an acceptably low level. A direct result of this restriction is a low heralding rate of single photons. A potential solution for achieving high-rate, high-purity, single-photon generation combines several heralding single-photon sources which are actively multiplexed to act as one source. The overall goal of this project is to develop methods to perform such multiplexing based on the use of a low loss high speed fiber optical switch.
One method to produce pure heralded single photons (HSP) when using the optical process of spontaneous parametric down-conversion (SPDC) is by modifying the joint spectrum of the photon pairs by means of spectral filters. In this work, we characterize the dependence, with the bandwidth of such filters, of the spectral purity and heralding efficiency of the HSP generated in a bulk SPDC. The values we report for the purity and heralding efficiency are obtained from measurements of the joint spectrum. Our results are in agreement with the theoretical model that predicts a trade-off between the purity and heralding efficiency, and they complement similar measurements that have been done for HSP produced by other types of sources.
Many quantum information protocols require the high rate production of individual photons with near unit purity. The most mature platform for producing these photons is nonlinear optical sources, which exploit parametric processes to produce photon pairs, one of which is subsequently detected to “herald” the presence of its partner. The photon pairs produced in such sources often have strong frequency correlations, which adversely affect the purity of the heralded single photons, and so such sources are spectrally filtered to restore the purity. Because this process throws away photons, the rate of photon production is reduced - filtering increases purity at the cost of efficiency. This relationship has been explored extensively numerically [1-3], but has not been well understood analytically. As the demand for multi-photon experiments increases, it is becoming necessary to precisely quantify the trade-off between purity and efficiency. We believe our work enables this.