Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1012.4149 · Nano Letters

Single-Photon Detectors Based on Ultranarrow Superconducting Nanowires

Francesco Marsili, Faraz Najafi, Eric A. Dauler, Francesco Bellei, Xiaolong Hu, Mária Csete, R. J. Molnar, Karl K. Berggren

Published Apr 1, 2011• 194 citations
arXivHTMLPDF

Abstract

We report efficient single-photon detection (η = 20% at 1550 nm wavelength) with ultranarrow (20 and 30 nm wide) superconducting nanowires, which were shown to be more robust to constrictions and more responsive to 1550 nm wavelength photons than standard superconducting nanowire single-photon detectors, based on 90 nm wide nanowires. We also improved our understanding of the physics of superconducting nanowire avalanche photodetectors, which we used to increase the signal-to-noise ratio of ultranarrow-nanowire detectors by a factor of 4, thus relaxing the requirements on the read-out circuitry and making the devices suitable for a broader range of applications.

DOI
10.1021/nl2005143

Related papers

Efficient Single Photon Detection from 500 nm to 5 μm Wavelength

Francesco Marsili, Francesco Bellei, Faraz Najafi +4 more

We report on superconducting nanowire single photon detectors (SNSPDs) based on 30 nm wide nanowires with detection efficiency η ∼ 2.6-5.5% in the wavelength range λ = 0.5-5 μm. We compared the sensitivity of 30 nm wide SNSPDs with the sensitivity of SNSPDs based on wider (85 and 50 nm wide) nanowires for λ = 0.5-5 μm. The detection efficiency of the detectors based on the wider nanowires became negligible at shorter wavelengths than the 30 nm wide SNSPDs. Our 30 nm wide SNSPDs showed 2 orders of magnitude higher detection efficiency (η ∼ 2%) up to longer wavelength (λ = 5 μm) than previously reported. On the basis of our simulations, we expect that by changing the optical coupling scheme and by integrating the detectors in an optical cavity, the detection efficiency of our detectors could be increased by a factor of ∼6.

Nano Letters•Aug 13, 2012•197 citations

Superconducting Nanowire Single Photon Detector With Efficiency Over 60% for 2-μm-Wavelength

Hui Zhou, Yiming Pan, Lixing You +6 more

We demonstrate superconducting nanowire single photon detector (SNSPD) for the wavelength at around 2 μm. The linewidth of the NbN nanowire is squeezed to 56 nm to increase the intrinsic response efficiencies at longer wavelengths such as 2 μm. Serially connecting avalanche architecture is applied to increase the signal-to-noise ratio (SNR) of the response signal. Further, the optical cavity is optimized to improve the absorption of the device. A silica single-mode fiber is adopted to introduce photons to the SNSPD at a temperature of 2.25 K using a Gifford-McMahon cryocooler. The SNSPD exhibits detection efficiencies of 58%, 67%, and 63% at wavelengths of 1550, 1700, and 2000 nm, respectively, with dark count rate of ~12 kcps, which is reduced to 2 cps when the attached fiber pigtail is all placed inside the 40-K cryostat. The detection efficiency at 2000 nm is 2.5 times greater than that of the best previously developed detector with an efficiency of 25%. Our SNSPD is promising for practical applications in molecular science and earth meteorology.

IEEE photonics journal•Nov 29, 2019•11 citations

Development and Evaluation of Superconducting Nanowire Single-Photon Detectors for 900-1100 nm Photon Detection

Fumihiro China, Shigehito Miki, Masahiro Yabuno +2 more

Superconducting nanowire single-photon detectors(SSPDs or SNSPDs) can detect single photons in a wide spectrum range from ultraviolet to mid-infrared wavelengths. We developed SSPDs for the light wavelength of 900-1100 nm, where it is difficult to achieve high detection efficiency by either Si or InGaAs avalanche photodiodes. We designed and fabricated the SSPD with non-periodic dielectric multilayers (DMLs) composed of SiO2 and TiO2 to enhance the optical absorptance in the wavelength range of 900-1100 nm. We measured the detection efficiency (DE) in the wavelength range of 800-1360 nm using a supercontinuum light source and found that the wavelength dependence of DE was in good agreement with the simulated spectrum of the optical absorptance of the nanowire device on the designed DML. The highest system DE was 81.0% for the wavelength of 980 nm.

IEICE Transactions on Electronics•Apr 30, 2020•0 citations

Design of efficient superconducting nanowire single photon detectors for near-infrared wavelengths

M. J. A. de Dood

Superconducting single photon detectors consist of a narrow and thin wire of superconductor and can detect single photons with high efficiency and high speed. Simultaneous optimization of the detection efficiency and detector response time is difficult because the response time is set by the dimensions of the wire (cross section and length) while the detection efficiency is determined by both the internal detection mechanism and the dimensions of the wire. Wider and shorter wires are easier to fabricate, are more robust and lead to shorter detector reset time, but are generally less efficient. Experiments employing detector tomography provide important insights into the photon detection mechanism and indicate a detection mechanism where the edges of the wire are more efficient. This leads to a position dependent local detection efficiency that can be explained in the context of a photon-assisted-vortex-entry model and predicts an optimum wire width ~70 nm. A 50 nm wide silicon nanowire deposited on top of a 150 nm wide NbN nanowire directs light at 1550 nm wavelength to the edges and improves both the total absorption efficiency and the internal detection efficiency of the wire. The total absorption efficiency can be enhanced by 30% while the internal detection efficiency is increased by 70%. Assuming that the wire covers a similar area the detector response time is reduced 4-fold compared to the standard design using a 70 nm wide wire.

Advanced Photon Counting Techniques•May 14, 2018•0 citations

Superconducting nanowire single-photon detectors at a wavelength of 940 nm

W. J. Zhang, Hao Li, Lixing You +9 more

We develop single-photon detectors comprising single-mode fiber-coupled superconducting nanowires, with high system detection efficiencies at a wavelength of 940 nm. The detector comprises a 6.5-nm-thick, 110-nm-wide NbN nanowire meander fabricated onto a Si substrate with a distributed Bragg reflector for enhancing the optical absorptance. We demonstrate that, via the design of a low filling factor (1/3) and active area (Φ = 10 μm), the system reaches a detection efficiency of ∼60% with a dark count rate of 10 Hz, a recovery time <12 ns, and a timing jitter of ∼50 ps.

arXiv:1506.07921•AIP Advances•Jun 1, 2015•7 citations

Efficient Single Photon Detection From 0.5 To 5 Micron Wavelength

Francesco Marsili, Francesco Bellei, Faraz Najafi +4 more

We developed superconducting nanowire single-photon detectors (SNSPDs) based on 30-nm-wide nanowires, which showed 2.6 % detection efficiency at 5 μm wavelength.

Conference on Lasers and Electro-Optics•Jan 1, 2012•2 citations
We report efficient single-photon detection (η = 20% at 1550 nm wavelength) with ultranarrow (20 and 30 nm wide) superconducting nanowires, which were shown to be more robust to constrictions and more responsive to 1550 nm wavelength photons than standard superconducting nanowire single-photon detectors, based on 90 nm wide nanowires. We also improved our understanding of the physics of superconducting nanowire avalanche photodetectors, which we used to increase the signal-to-noise ratio of ultranarrow-nanowire detectors by a factor of 4, thus relaxing the requirements on the read-out circuitry and making the devices suitable for a broader range of applications.
We report on superconducting nanowire single photon detectors (SNSPDs) based on 30 nm wide nanowires with detection efficiency η ∼ 2.6-5.5% in the wavelength range λ = 0.5-5 μm. We compared the sensitivity of 30 nm wide SNSPDs with the sensitivity of SNSPDs based on wider (85 and 50 nm wide) nanowires for λ = 0.5-5 μm. The detection efficiency of the detectors based on the wider nanowires became negligible at shorter wavelengths than the 30 nm wide SNSPDs. Our 30 nm wide SNSPDs showed 2 orders of magnitude higher detection efficiency (η ∼ 2%) up to longer wavelength (λ = 5 μm) than previously reported. On the basis of our simulations, we expect that by changing the optical coupling scheme and by integrating the detectors in an optical cavity, the detection efficiency of our detectors could be increased by a factor of ∼6.
We demonstrate superconducting nanowire single photon detector (SNSPD) for the wavelength at around 2 μm. The linewidth of the NbN nanowire is squeezed to 56 nm to increase the intrinsic response efficiencies at longer wavelengths such as 2 μm. Serially connecting avalanche architecture is applied to increase the signal-to-noise ratio (SNR) of the response signal. Further, the optical cavity is optimized to improve the absorption of the device. A silica single-mode fiber is adopted to introduce photons to the SNSPD at a temperature of 2.25 K using a Gifford-McMahon cryocooler. The SNSPD exhibits detection efficiencies of 58%, 67%, and 63% at wavelengths of 1550, 1700, and 2000 nm, respectively, with dark count rate of ~12 kcps, which is reduced to 2 cps when the attached fiber pigtail is all placed inside the 40-K cryostat. The detection efficiency at 2000 nm is 2.5 times greater than that of the best previously developed detector with an efficiency of 25%. Our SNSPD is promising for practical applications in molecular science and earth meteorology.
Superconducting nanowire single-photon detectors(SSPDs or SNSPDs) can detect single photons in a wide spectrum range from ultraviolet to mid-infrared wavelengths. We developed SSPDs for the light wavelength of 900-1100 nm, where it is difficult to achieve high detection efficiency by either Si or InGaAs avalanche photodiodes. We designed and fabricated the SSPD with non-periodic dielectric multilayers (DMLs) composed of SiO2 and TiO2 to enhance the optical absorptance in the wavelength range of 900-1100 nm. We measured the detection efficiency (DE) in the wavelength range of 800-1360 nm using a supercontinuum light source and found that the wavelength dependence of DE was in good agreement with the simulated spectrum of the optical absorptance of the nanowire device on the designed DML. The highest system DE was 81.0% for the wavelength of 980 nm.
Superconducting single photon detectors consist of a narrow and thin wire of superconductor and can detect single photons with high efficiency and high speed. Simultaneous optimization of the detection efficiency and detector response time is difficult because the response time is set by the dimensions of the wire (cross section and length) while the detection efficiency is determined by both the internal detection mechanism and the dimensions of the wire. Wider and shorter wires are easier to fabricate, are more robust and lead to shorter detector reset time, but are generally less efficient. Experiments employing detector tomography provide important insights into the photon detection mechanism and indicate a detection mechanism where the edges of the wire are more efficient. This leads to a position dependent local detection efficiency that can be explained in the context of a photon-assisted-vortex-entry model and predicts an optimum wire width ~70 nm. A 50 nm wide silicon nanowire deposited on top of a 150 nm wide NbN nanowire directs light at 1550 nm wavelength to the edges and improves both the total absorption efficiency and the internal detection efficiency of the wire. The total absorption efficiency can be enhanced by 30% while the internal detection efficiency is increased by 70%. Assuming that the wire covers a similar area the detector response time is reduced 4-fold compared to the standard design using a 70 nm wide wire.
We develop single-photon detectors comprising single-mode fiber-coupled superconducting nanowires, with high system detection efficiencies at a wavelength of 940 nm. The detector comprises a 6.5-nm-thick, 110-nm-wide NbN nanowire meander fabricated onto a Si substrate with a distributed Bragg reflector for enhancing the optical absorptance. We demonstrate that, via the design of a low filling factor (1/3) and active area (Φ = 10 μm), the system reaches a detection efficiency of ∼60% with a dark count rate of 10 Hz, a recovery time <12 ns, and a timing jitter of ∼50 ps.