We present theoretical schemes for performing high-fidelity one- and two-qubit pulsed gates for a superconducting flux qubit. The 'IBM qubit' consists of three Josephson junctions, three loops and a superconducting transmission line. Assuming a fixed inductive qubit–qubit coupling, we show that the effective qubit–qubit interaction is tunable by changing the applied fluxes, and can be made negligible, allowing one to perform high-fidelity single qubit gates. Our schemes are tailored to alleviate errors due to 1/ f noise; we find gates with only 1% loss of fidelity due to this source, for pulse times in the range of 20–30 ns for one-qubit gates ( Z rotations, Hadamard) and 60 ns for a two-qubit gate (controlled- Z ). Our relaxation and dephasing time estimates indicate a comparable loss of fidelity from this source. The control of leakage plays an important role in the design of our shaped pulses, preventing shorter pulse times. However, we have found that imprecision in the control of the quantum phase plays a major role in the limitation of the fidelity of our gates.
We apply the quantum optimal control theory based on the Krotov method to implement single-qubit
X and
Z gates and two-qubit cnot gates for inductively coupled superconducting flux qubits with fixed qubit transition frequencies and fixed off-diagonal qubit-qubit coupling. Our scheme shares an advantage with other direct-coupling schemes in that it requires no additional coupler subcircuit and control lines. The control lines needed are only for the manipulation of individual qubits (e.g., a time-dependent magnetic flux or field applied on each qubit). The qubits are operated at the optimal coherence points and the gate operation times (less than 1 ns for single-qubit gates and $\ensuremath{\sim}2$ ns for cnotgates) are much shorter than the corresponding qubit decoherence time. A cnot gate or other general quantum gates can be implemented in a single run of the pulse sequence rather than being decomposed into several single-qubit and several entangled two-qubit operations in series by composite pulse sequences. Quantum gates constructed via our scheme are all with very high fidelity (very low error) as our optimal control scheme takes into account the fixed qubit detuning and fixed two-qubit interaction as well as all other time-dependent magnetic-field-induced single-qubit interactions and two-qubit couplings. The effect of leakage to higher-energy-level states and the effect of qubit decoherence on the quantum-gate operations are also discussed.
High-fidelity two-qubit gates are essential for scalable quantum computing. We present a scheme based on superconducting transmon qubits and a control pulse delivery protocol that enables arbitrary controlled-phase gates modulated solely by an independent arbitrary waveform generator pulse. We combined a tunable coupler design with bipolar flux-pulsing to demonstrate a high-fidelity gate with a peak performance of
99.5%. Our gates inherit the advantages of both approaches: minimal residual ZZ coupling, built-in echo-like low-frequency noise protection, and time-scale control pulse reproducibility, while remaining easy to calibrate. We optimize the system energy levels to mitigate leakage to the coupler and suppress residual interactions. Numerical simulations of the scheme as three qutrits indicate that an error below
1×10−3 is achievable. We confirm the scalability potential of the proposed scheme on high-fidelity 4-qubit and 8-qubit quantum processors
We present a gradient-based method to construct memory-efficient, high-fidelity, single-qubit gates for fluxonium qubits. These gates are constructed using a sequence of single-flux quantum (SFQ) pulses that are sent to the qubit through either capacitive or inductive coupling. The schedule of SFQ pulses is constructed with an on-ramp and an off-ramp applied prior to and after a pulse train, where the pulses are spaced at intervals equal to the qubit period. We reduce the optimization problem to the scheduling of a fixed number of SFQ pulses in the on-ramp and solve it by relaxing the discretization constraint of the SFQ clock as an intermediate step, allowing the use of the Broyden-Fletcher-Goldfarb-Shanno optimizer. Using this approach, gate fidelities of 99.99 % can be achieved for inductive coupling and 99.9 % for capacitive coupling, with leakage being the main source of coherent errors for both approaches.
Compared to traditional semiconductor control electronics (TSCE) located at room temperature, cryogenic single flux quantum (SFQ) electronics can provide qubit measurement and control alternatives that address critical issues related to scalability of cryogenic quantum processors. Single-qubit control and readout have been demonstrated recently using SFQ circuits coupled to superconducting qubits. Experiments where the SFQ electronics are co-located with the qubit have suffered from excess decoherence and loss due to quasiparticle poisoning of the qubit. A previous experiment by our group showed that moving the control electronics to the 3 K stage of the dilution refrigerator avoided this source of decoherence in a high-coherence 3D transmon geometry. In this paper, we also generate the pulses at the 3 K stage but have optimized the qubit design and control lines for scalable 2D transmon devices. We directly compare the qubit lifetime
T1, coherence time
T2∗ and gate fidelity when the qubit is controlled by the Josephson pulse generator (JPG) circuit versus the TSCE setup. We find agreement to within the daily fluctuations for
T1 and
T2∗, and agreement to within 10% for randomized benchmarking. We also performed interleaved randomized benchmarking on individual JPG gates demonstrating an average error per gate of
0.46% showing good agreement with what is expected based on the qubit coherence and higher-state leakage. These results are an order of magnitude improvement in gate fidelity over our previous work and demonstrate that a Josephson microwave source operated at 3 K is a promising component for scalable qubit control.
Achieving fast and high-fidelity qubit operations is crucial for unlocking the potential of quantum computers. In particular, reaching low gate errors in two-qubit gates has been a long-standing challenge in the field of superconducting qubits due to their typically long duration relative to coherence times. To realize fast gates, we use the hybridization between fixed-frequency superconducting qubits with a strongly interacting coupler mode that is tunable in frequency. To reduce population leakage during required adiabatic passages through avoided level crossings, we employ a sensitivity-adaptive closed-loop optimization method to design complex pulse shapes. We compare the performance of Gaussian-square, Fourier-series, and piecewise-constant-slope pulse parametrizations and are able to reach 99.9% controlled- Z -gate fidelity using a 64-ns-long Fourier-series pulse defined by only seven parameters. These high-fidelity values are achieved by analyzing the optimized pulse shapes to identify and systematically mitigate signal-line distortions in the experiment. To improve the convergence speed of the optimization, we implement an adaptive cost function, which continuously maximizes the sensitivity. The demonstrated method can be used for tune-up and recalibration of superconducting quantum processors.
The main source of error for superconducting quantum processors today is two-qubit gates, so understanding what limits their fidelity is central to improving these devices. This thesis studies the controlled-Z (CZ) gate between two transmon qubits, realized by tuning the
∣11⟩ and
∣20⟩ states through an avoided crossing with a flux pulse. There are two primary errors inherent to this approach. The first is leakage into non-computational states like
∣20⟩; the second is an exchange error from population transferring between the single-excitation states
∣01⟩ and
∣10⟩. Using a closed-system simulation, this work compares four flux-pulse shapes (unipolar, net-zero bipolar, Gaussian-filtered bipolar, and adiabatic) and constructs a CNOT from each CZ. The central question is which error channel sets the gate fidelity, and whether the widely used net-zero pulse, known to protect neighboring qubits, also helps inside the gate itself. An important finding of this research is that every type of flux pulse has an average gate fidelity limited by exchange error rather than leakage. While the exchange error is not apparent in the return of the
∣11⟩ population, because excitation-number conservation prevents
∣11⟩ from entering the single-excitation sector, it does appear as an off-diagonal term in the CZ unitary, and subsequently in the CNOT. A second finding concerns the net-zero pulse: although its zero net flux integral cancels the first-order phase imprinted on neighboring qubits, it does not suppress the exchange error. The strong suppression observed in the analytic bipolar gate happens because its idle time leaves the exchange oscillation near a cancellation point at the end of the gate, not because the pulse is net-zero. The flux operating point predicted by the simulation was tested on a physical transmon device accessed remotely, where a square pulse produced a
180∘ conditional phase close to the simulated flux and duration. Because the model is closed-system, the reported fidelities describe the coherent error of each pulse rather than the total infidelity of a physical device.