Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:quant-ph/0410133 · Physical Review A

Implementation of projective measurements with linear optics and continuous photon counting

Masahiro Takeoka, Masahide Sasaki, Peter van Loock, Norbert Lütkenhaus

Published Feb 23, 2005• 60 citations
arXivHTMLPDF

Abstract

We investigate the possibility of implementing a given projection measurement using linear optics and arbitrarily fast feedforward based on the continuous detection of photons. In particular, we systematically derive the so-called Dolinar scheme that achieves the minimum-error discrimination of binary coherent states. Moreover, we show that the Dolinar-type approach can also be applied to projection measurements in the regime of photonic-qubit signals. Our results demonstrate that for implementing a projection measurement with linear optics, in principle, unit success probability may be approached even without the use of expensive entangled auxiliary states, as they are needed in all known (near-)deterministic linear-optics proposals.

DOI
10.1103/physreva.71.022318

Related papers

Quantum State Discrimination with Linear Optics and Continuous Measurement

Masahiro Takeoka

We investigate the possibility of implementing a given measurement using linear optics and continuous measurement. In particular, we revisit the so‐called Dolinar receiver, a quasi‐physical model attaining the minimum error discrimination of binary coherent states, to give an alternative derivation for the optimal discrimination scheme. Our approach is rather simple and can be applied to various kinds of measurements such as projection measurements in the regime of photonic‐qubit signals.

AIP conference proceedings•Jan 1, 2004•0 citations

Discrimination of quantum states with linear optics and continuous photon counting

Masahiro Takeoka

We investigate a systematic method of implementation of given measurements with linear optics and continuous measurement. We revisit the so-called Dolinar receiver, which is a quasi-physical model attaining the minimum error discrimination of binary coherent states, and show that it can be derived without heuristic assumptions. Our approach also can be applied to various kinds of measurements.

Optics and Spectroscopy•Sep 1, 2005•2 citations

Design of POVMs with linear optics and continuous measurement

Masahiro Takeoka, Masahide Sasaki, Peter van Loock

We investigate the possibility of implementing a given measurement using linear optics and continuous measurement. In particular, we revisit the so-called Dolinar receiver, a quasi-physical model attaining the minimum error discrimination of binary coherent states, to give an alternative derivation for the optimal discrimination scheme. Our approach is rather simple and can be applied to various kinds of measurements such as projection measurements in the regime of photonic-qubit signals.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Jan 11, 2005•4 citations

Projective measurements via linear optics and photon detectors

Masahiro Takeoka

The possibility of implementing a given photonic projective measurement with linear optics and photon detectors is discussed. This problem can be viewed as a single-shot discrimination of orthogonal pure quantum states. It is particularly shown that any two orthogonal states can be perfectly discriminated using only linear optics, photon counting, coherent ancillary states, and feedforward. This means that one can construct any binary projective measurement with these means, but without any nonclassical ancillary state. The statement holds in the asymptotic limit of a large number of these physical resources. To extend this result, we also address the problem of discriminating a simple set of three orthogonal states.

Optics and Spectroscopy•Jul 1, 2007•2 citations

Binary Projective Measurement via Linear Optics and Photon Counting

Masahiro Takeoka, Masahide Sasaki, Norbert Lütkenhaus

We investigate the implementation of binary projective measurements with linear optics. This problem can be viewed as a single-shot discrimination of two orthogonal pure quantum states. We show that any two orthogonal states can be perfectly discriminated using only linear optics, photon counting, coherent ancillary states, and feedforward. The statement holds in the asymptotic limit of a large number of these physical resources.

arXiv:quant-ph/0603074•Physical Review Letters•Jul 26, 2006•44 citations

SINGLE-PHOTON DETECTION AND RECONSTRUCTION (TOMOGRAPHY) OF OPTICAL-FIELD STATES

Masahiro Takeoka

The possibility of implementing a given photonic projective measurement with linear optics and photon detectors is discussed. This problem can be viewed as a single-shot discrimination of orthogonal pure quantum states. It is particularly shown that any two orthogonal states can be perfectly discriminated using only linear optics, photon counting, coherent ancillary states, and feedforward. This means that one can construct any binary projective measurement with these means, but without any nonclassical ancillary state . The state- ment holds in the asymptotic limit of a large number of these physical resources. To extend this result, we also address the problem of discriminating a simple set of three orthogonal states.

•Jan 1, 2007•0 citations
We investigate the possibility of implementing a given projection measurement using linear optics and arbitrarily fast feedforward based on the continuous detection of photons. In particular, we systematically derive the so-called Dolinar scheme that achieves the minimum-error discrimination of binary coherent states. Moreover, we show that the Dolinar-type approach can also be applied to projection measurements in the regime of photonic-qubit signals. Our results demonstrate that for implementing a projection measurement with linear optics, in principle, unit success probability may be approached even without the use of expensive entangled auxiliary states, as they are needed in all known (near-)deterministic linear-optics proposals.
The possibility of implementing a given photonic projective measurement with linear optics and photon detectors is discussed. This problem can be viewed as a single-shot discrimination of orthogonal pure quantum states. It is particularly shown that any two orthogonal states can be perfectly discriminated using only linear optics, photon counting, coherent ancillary states, and feedforward. This means that one can construct any binary projective measurement with these means, but without any nonclassical ancillary state. The statement holds in the asymptotic limit of a large number of these physical resources. To extend this result, we also address the problem of discriminating a simple set of three orthogonal states.
The possibility of implementing a given photonic projective measurement with linear optics and photon detectors is discussed. This problem can be viewed as a single-shot discrimination of orthogonal pure quantum states. It is particularly shown that any two orthogonal states can be perfectly discriminated using only linear optics, photon counting, coherent ancillary states, and feedforward. This means that one can construct any binary projective measurement with these means, but without any nonclassical ancillary state . The state- ment holds in the asymptotic limit of a large number of these physical resources. To extend this result, we also address the problem of discriminating a simple set of three orthogonal states.