Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

SINGLE-PHOTON DETECTION AND RECONSTRUCTION (TOMOGRAPHY) OF OPTICAL-FIELD STATES

Masahiro Takeoka

Published Jan 1, 2007• 0 citations
OpenAlex

Abstract

The possibility of implementing a given photonic projective measurement with linear optics and photon detectors is discussed. This problem can be viewed as a single-shot discrimination of orthogonal pure quantum states. It is particularly shown that any two orthogonal states can be perfectly discriminated using only linear optics, photon counting, coherent ancillary states, and feedforward. This means that one can construct any binary projective measurement with these means, but without any nonclassical ancillary state . The state- ment holds in the asymptotic limit of a large number of these physical resources. To extend this result, we also address the problem of discriminating a simple set of three orthogonal states.

Related papers

Projective measurements via linear optics and photon detectors

Masahiro Takeoka

The possibility of implementing a given photonic projective measurement with linear optics and photon detectors is discussed. This problem can be viewed as a single-shot discrimination of orthogonal pure quantum states. It is particularly shown that any two orthogonal states can be perfectly discriminated using only linear optics, photon counting, coherent ancillary states, and feedforward. This means that one can construct any binary projective measurement with these means, but without any nonclassical ancillary state. The statement holds in the asymptotic limit of a large number of these physical resources. To extend this result, we also address the problem of discriminating a simple set of three orthogonal states.

Optics and Spectroscopy•Jul 1, 2007•2 citations

Binary Projective Measurement via Linear Optics and Photon Counting

Masahiro Takeoka, Masahide Sasaki, Norbert Lütkenhaus

We investigate the implementation of binary projective measurements with linear optics. This problem can be viewed as a single-shot discrimination of two orthogonal pure quantum states. We show that any two orthogonal states can be perfectly discriminated using only linear optics, photon counting, coherent ancillary states, and feedforward. The statement holds in the asymptotic limit of a large number of these physical resources.

arXiv:quant-ph/0603074•Physical Review Letters•Jul 26, 2006•44 citations

Simple criteria for the implementation of projective measurements with linear optics

Peter van Loock, Norbert Lütkenhaus

We derive a set of criteria to decide whether a given projection measurement can be, in principle, exactly implemented solely by means of linear optics. The derivation can be adapted to various detection methods, including photon counting and homodyne detection. These criteria enable one to obtain no-go theorems easily for the exact distinguishability of orthogonal quantum states with linear optics, including the use of auxiliary photons and conditional dynamics.

arXiv:quant-ph/0304057•Physical Review A•Jan 9, 2004•39 citations

Implementation of projective measurements with linear optics and continuous photon counting

Masahiro Takeoka, Masahide Sasaki, Peter van Loock +1 more

We investigate the possibility of implementing a given projection measurement using linear optics and arbitrarily fast feedforward based on the continuous detection of photons. In particular, we systematically derive the so-called Dolinar scheme that achieves the minimum-error discrimination of binary coherent states. Moreover, we show that the Dolinar-type approach can also be applied to projection measurements in the regime of photonic-qubit signals. Our results demonstrate that for implementing a projection measurement with linear optics, in principle, unit success probability may be approached even without the use of expensive entangled auxiliary states, as they are needed in all known (near-)deterministic linear-optics proposals.

arXiv:quant-ph/0410133•Physical Review A•Feb 23, 2005•60 citations

Limitations on building single-photon-resolution detection devices

Pieter Kok

Single-photon resolution (SPR) detectors can tell the difference between incoming wave packets of n and n+1 photons. Such devices are especially important for linear optical quantum computing with projective measurements. However, in this paper I show that it is impossible to construct a photodetector with single-photon resolution when we are restricted to single-photon sources, linear optical elements and projective measurements with standard (non-photon-number discriminating) photodetectors. These devices include SPR detectors that sometimes fail to distinguish one- and two-photon inputs, but at the same time indicate this failure.

arXiv:quant-ph/0303102•Mar 17, 2003•0 citations

Quantum state discrimination via linear optics and continuous photon counting

Masahiro Takeoka, Masahide Sasaki, Peter van Loock +1 more

In this paper, an expansion of the formulae to check whether one can implement a step via linear optics and photon counting was derived, to the limit of continuous photon counting, The limit that the coupling between the signal and measurement apparatus is infinitesimal at each step and the number of the step is infinitely large was discussed. As an example, a specific case where the states to be discriminated are single-mode states and any nonclassical ancillas are excluded.

European Quantum Electronics Conference (EQEC)•Jan 18, 2006•0 citations
The possibility of implementing a given photonic projective measurement with linear optics and photon detectors is discussed. This problem can be viewed as a single-shot discrimination of orthogonal pure quantum states. It is particularly shown that any two orthogonal states can be perfectly discriminated using only linear optics, photon counting, coherent ancillary states, and feedforward. This means that one can construct any binary projective measurement with these means, but without any nonclassical ancillary state . The state- ment holds in the asymptotic limit of a large number of these physical resources. To extend this result, we also address the problem of discriminating a simple set of three orthogonal states.
The possibility of implementing a given photonic projective measurement with linear optics and photon detectors is discussed. This problem can be viewed as a single-shot discrimination of orthogonal pure quantum states. It is particularly shown that any two orthogonal states can be perfectly discriminated using only linear optics, photon counting, coherent ancillary states, and feedforward. This means that one can construct any binary projective measurement with these means, but without any nonclassical ancillary state. The statement holds in the asymptotic limit of a large number of these physical resources. To extend this result, we also address the problem of discriminating a simple set of three orthogonal states.
We investigate the possibility of implementing a given projection measurement using linear optics and arbitrarily fast feedforward based on the continuous detection of photons. In particular, we systematically derive the so-called Dolinar scheme that achieves the minimum-error discrimination of binary coherent states. Moreover, we show that the Dolinar-type approach can also be applied to projection measurements in the regime of photonic-qubit signals. Our results demonstrate that for implementing a projection measurement with linear optics, in principle, unit success probability may be approached even without the use of expensive entangled auxiliary states, as they are needed in all known (near-)deterministic linear-optics proposals.
Single-photon resolution (SPR) detectors can tell the difference between incoming wave packets of n and n+1 photons. Such devices are especially important for linear optical quantum computing with projective measurements. However, in this paper I show that it is impossible to construct a photodetector with single-photon resolution when we are restricted to single-photon sources, linear optical elements and projective measurements with standard (non-photon-number discriminating) photodetectors. These devices include SPR detectors that sometimes fail to distinguish one- and two-photon inputs, but at the same time indicate this failure.