Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:quant-ph/0402017 · Physical Review A

Practical scheme for error control using feedback

Mohan Sarovar, Charlene Ahn, Kurt A. Jacobs, Gerard J Milburn

Published May 19, 2004• 89 citations
arXivHTMLPDF

Abstract

We describe a scheme for quantum-error correction that employs feedback and weak measurement rather than the standard tools of projective measurement and fast controlled unitary gates. The advantage of this scheme over previous protocols [for example, Ahn et al. Phys. Rev. A 65, 042301 (2001)], is that it requires little side processing while remaining robust to measurement inefficiency, and is therefore considerably more practical. We evaluate the performance of our scheme by simulating the correction of bit flips. We also consider implementation in a solid-state quantum-computation architecture and estimate the maximal error rate that could be corrected with current technology.

DOI
10.1103/physreva.69.052324

Related papers

Quantum control and quantum error correction

Gerard J Milburn, Mohan Sarovar, Charlene Ahn

We describe a scheme for quantum error correction that employs feedback and weak measurement. This provides a method of protecting an unknown quantum state against errors that does not use the standard tools of quantum error correction – projective measurements and fast controlled unitary gates – and is practicably implementable because of the little side processing required. We evaluate the performance of our scheme by simulating a simple scenario of protection against bit-flips.

Australian Journal of Electrical & Electronics Engineering•Jan 1, 2005•0 citations

Quantum error correction for continuously detected errors with any number of error channels per qubit

Charlene Ahn, Howard M. Wiseman, Kurt A. Jacobs

It was shown by Ahn, Wiseman, and Milburn [Phys. Rev. A 67, 052310 (2003)] that feedback control could be used as a quantum error correction process for errors induced by weak continuous measurement, given one perfectly measured error channel per qubit. Here we point out that this method can be easily extended to an arbitrary number of error channels per qubit. We show that the feedback protocols generated by our method encode $n\ensuremath{-}2$ logical qubits in $n$ physical qubits, thus requiring just one more physical qubit than in the previous case.

arXiv:quant-ph/0402067•Physical Review A•Aug 20, 2004•25 citations

Quantum error correction for continuously detected errors

Charlene Ahn, Howard M. Wiseman, Gerard J Milburn

We show that quantum feedback control can be used as a quantum-error-correction process for errors induced by a weak continuous measurement. In particular, when the error model is restricted to one, perfectly measured, error channel per physical qubit, quantum feedback can act to perfectly protect a stabilizer codespace. Using the stabilizer formalism we derive an explicit scheme, involving feedback and an additional constant Hamiltonian, to protect an $(n\ensuremath{-}1)$-qubit logical state encoded in n physical qubits. This works for both Poisson (jump) and white-noise (diffusion) measurement processes. Universal quantum computation is also possible in this scheme. As an example, we show that detected-spontaneous emission error correction with a driving Hamiltonian can greatly reduce the amount of redundancy required to protect a state from that which has been previously postulated [e.g., Alber et al., Phys. Rev. Lett. 86, 4402 (2001)].

arXiv:quant-ph/0302006•Physical Review A•May 27, 2003•92 citations

Extending quantum error correction: new continuous measurement protocols and improved fault-tolerant overhead

John P. Preskill, Charlene Ahn

Quantum mechanical applications range from quantum computers to quantum key distribution to teleportation. In these applications, quantum error correction is extremely important for protecting quantum states against decoherence. Here I present two main results regarding quantum error correction protocols. The first main topic I address is the development of continuous-time quantum error correction protocols via combination with techniques from quantum control. These protocols rely on weak measurement and Hamiltonian feedback instead of the projective measurements and unitary gates usually assumed by canonical quantum error correction. I show that a subclass of these protocols can be understood as a quantum feedback protocol, and analytically analyze the general case using the stabilizer formalism; I show that in this case perfect feedback can perfectly protect a stabilizer subspace. I also show through numerical simulations that another subclass of these protocols does better than canonical quantum error correction when the time between corrections is limited. The second main topic is development of improved overhead results for fault-tolerant computation. In particular, through analysis of topological quantum error correcting codes, it will be shown that the required blowup in depth of a noisy circuit performing a fault-tolerant computation can be reduced to a factor of O(log log L), an improvement over previous results. Showing this requires investigation into a local method of performing fault-tolerant correction on a topological code of arbitrary dimension.

•Jan 1, 2004•8 citations

Continuous quantum error correction

Mohan Sarovar, Gerard J Milburn

Quantum error correction is an essential ingredient for quantum computation. The standard descriptions of how to implement active error correction assume ideal resources such as projective measurements and instantaneous gate operations. Unfortunately in practice such resources are not realizable in most quantum computing architectures and it is not clear how such error correction implementations will perform under more realistic conditions. Motivated by this we examine schemes for implementing active error correction that use a more modest set of resources. This leads to new implementations of error correction that are continuous in time, and thus described by continuous dynamical maps. We evaluate the performance of such schemes using numerical simulations and comment on the applicability and effectiveness of continuous error correction for quantum computing.

arXiv:quant-ph/0501049•Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•May 23, 2005•9 citations

Measurement-based quantum feedback controls for quantum computation

Song Zhang

The advance of experimental techniques in circuit quantum electrodynamics over last decadehas made it possible to monitor the evolution of qubits under continuous measurements in\nreal time . This kind of measurements, as compared to the discrete ones, provides a stream\nof information for feedback to alter the system's quantum dynamics continuously in a desired\nmanner, thus allowing broader possibilities. We obtain the information at a cost, the backaction on the states. However, the back-action turns out not to be just something disturbing \nand harmful to the control but instead can be harnessed, together with the control, to steer the system to our targets. \nThis thesis discusses one such application, namely to use measurements to create entanglement from remote qubits under locally optimal control. It is illustrated that by carefully designing symmetric measurement and feedback operators, we can construct efficient Markovian or non-Markovian protocols which generate N-qubit W,\ngeneral Dicke and Greenberger-Horne-Zeilinger states with high fidelity above 94% up to\nN = 100. In some cases, the fidelity even approaches unity. Following that, we describe how\nto take advantages of the continuous stream of information to protect the unitary dynamics of\na quantum system subject to noises. We develop a practical protocol for continuous operation\nof a quantum error correcting code for protection of coherent evolution due to an encoded\nHamiltonian against environmental errors, using the three qubit bit-flip code and bit-flip\nerrors as a canonical example. We demonstrate, for both quantum memory and adiabatic\nHamiltonians, that the protocol, once optimized, can significantly reduce logical errors with\na performance which is close to the theoretical limit of the bit-flip code's capability. In the\nadiabatic Hamiltonian case, we also propose some novel correction operators instead of the\nconventional ones to further reduce the logical errors.

•Jan 1, 2020•1 citation
We describe a scheme for quantum-error correction that employs feedback and weak measurement rather than the standard tools of projective measurement and fast controlled unitary gates. The advantage of this scheme over previous protocols [for example, Ahn et al. Phys. Rev. A 65, 042301 (2001)], is that it requires little side processing while remaining robust to measurement inefficiency, and is therefore considerably more practical. We evaluate the performance of our scheme by simulating the correction of bit flips. We also consider implementation in a solid-state quantum-computation architecture and estimate the maximal error rate that could be corrected with current technology.
It was shown by Ahn, Wiseman, and Milburn [Phys. Rev. A 67, 052310 (2003)] that feedback control could be used as a quantum error correction process for errors induced by weak continuous measurement, given one perfectly measured error channel per qubit. Here we point out that this method can be easily extended to an arbitrary number of error channels per qubit. We show that the feedback protocols generated by our method encode $n\ensuremath{-}2$ logical qubits in nnn physical qubits, thus requiring just one more physical qubit than in the previous case.
We show that quantum feedback control can be used as a quantum-error-correction process for errors induced by a weak continuous measurement. In particular, when the error model is restricted to one, perfectly measured, error channel per physical qubit, quantum feedback can act to perfectly protect a stabilizer codespace. Using the stabilizer formalism we derive an explicit scheme, involving feedback and an additional constant Hamiltonian, to protect an $(n\ensuremath{-}1)$-qubit logical state encoded in n physical qubits. This works for both Poisson (jump) and white-noise (diffusion) measurement processes. Universal quantum computation is also possible in this scheme. As an example, we show that detected-spontaneous emission error correction with a driving Hamiltonian can greatly reduce the amount of redundancy required to protect a state from that which has been previously postulated [e.g., Alber et al., Phys. Rev. Lett. 86, 4402 (2001)].
Quantum mechanical applications range from quantum computers to quantum key distribution to teleportation. In these applications, quantum error correction is extremely important for protecting quantum states against decoherence. Here I present two main results regarding quantum error correction protocols. The first main topic I address is the development of continuous-time quantum error correction protocols via combination with techniques from quantum control. These protocols rely on weak measurement and Hamiltonian feedback instead of the projective measurements and unitary gates usually assumed by canonical quantum error correction. I show that a subclass of these protocols can be understood as a quantum feedback protocol, and analytically analyze the general case using the stabilizer formalism; I show that in this case perfect feedback can perfectly protect a stabilizer subspace. I also show through numerical simulations that another subclass of these protocols does better than canonical quantum error correction when the time between corrections is limited. The second main topic is development of improved overhead results for fault-tolerant computation. In particular, through analysis of topological quantum error correcting codes, it will be shown that the required blowup in depth of a noisy circuit performing a fault-tolerant computation can be reduced to a factor of O(log log L), an improvement over previous results. Showing this requires investigation into a local method of performing fault-tolerant correction on a topological code of arbitrary dimension.
Quantum error correction is an essential ingredient for quantum computation. The standard descriptions of how to implement active error correction assume ideal resources such as projective measurements and instantaneous gate operations. Unfortunately in practice such resources are not realizable in most quantum computing architectures and it is not clear how such error correction implementations will perform under more realistic conditions. Motivated by this we examine schemes for implementing active error correction that use a more modest set of resources. This leads to new implementations of error correction that are continuous in time, and thus described by continuous dynamical maps. We evaluate the performance of such schemes using numerical simulations and comment on the applicability and effectiveness of continuous error correction for quantum computing.
The advance of experimental techniques in circuit quantum electrodynamics over last decadehas made it possible to monitor the evolution of qubits under continuous measurements in\nreal time . This kind of measurements, as compared to the discrete ones, provides a stream\nof information for feedback to alter the system's quantum dynamics continuously in a desired\nmanner, thus allowing broader possibilities. We obtain the information at a cost, the backaction on the states. However, the back-action turns out not to be just something disturbing \nand harmful to the control but instead can be harnessed, together with the control, to steer the system to our targets. \nThis thesis discusses one such application, namely to use measurements to create entanglement from remote qubits under locally optimal control. It is illustrated that by carefully designing symmetric measurement and feedback operators, we can construct efficient Markovian or non-Markovian protocols which generate N-qubit W,\ngeneral Dicke and Greenberger-Horne-Zeilinger states with high fidelity above 94% up to\nN = 100. In some cases, the fidelity even approaches unity. Following that, we describe how\nto take advantages of the continuous stream of information to protect the unitary dynamics of\na quantum system subject to noises. We develop a practical protocol for continuous operation\nof a quantum error correcting code for protection of coherent evolution due to an encoded\nHamiltonian against environmental errors, using the three qubit bit-flip code and bit-flip\nerrors as a canonical example. We demonstrate, for both quantum memory and adiabatic\nHamiltonians, that the protocol, once optimized, can significantly reduce logical errors with\na performance which is close to the theoretical limit of the bit-flip code's capability. In the\nadiabatic Hamiltonian case, we also propose some novel correction operators instead of the\nconventional ones to further reduce the logical errors.