arXiv:cond-mat/0012314 · Physical Review Letters

Radio-Frequency Bloch-Transistor Electrometer

Alexander B Zorin

Published Apr 9, 2001• 36 citations

Abstract

A quantum electrometer is proposed which is based on charge modulation of the Josephson supercurrent in the Bloch transistor inserted in a superconducting ring. As this ring is inductively coupled to a high- Q resonance tank circuit, the variations of the charge on the transistor island are converted into variations of amplitude and phase of oscillations in the tank. These variations are amplified and then detected. At sufficiently low temperature of the tank the device sensitivity is determined by the energy resolution of the amplifier, that can be reduced down to the standard quantum limit of 1 / 2Planck's over 2pi. A "back-action-evading" scheme of subquantum limit measurements is proposed.

DOI: 10.1103/physrevlett.86.3388

Related papers

The Radio-Frequency Single-Electron Transistor (RF-SET): A Fast and Ultrasensitive Electrometer

R. J. Schoelkopf, Paula Wahlgren, A. A. Kozhevnikov +2 more

A new type of electrometer is described that uses a single-electron transistor (SET) and that allows large operating speeds and extremely high charge sensitivity. The SET readout was accomplished by measuring the damping of a 1.7-gigahertz resonant circuit in which the device is embedded, and in some ways is the electrostatic "dual" of the well-known radio-frequency superconducting quantum interference device. The device is more than two orders of magnitude faster than previous single-electron devices, with a constant gain from dc to greater than 100 megahertz. For a still-unoptimized device, a charge sensitivity of 1.2 x 10(-5) e/hertz was obtained at a frequency of 1.1 megahertz, which is about an order of magnitude better than a typical, 1/f-noise-limited SET, and corresponds to an energy sensitivity (in joules per hertz) of about 41 Planck's over 2pi.

ScienceMay 22, 1998776 citations

Josephson charge-phase qubit with radio frequency readout: Coupling and decoherence

Alexander B Zorin

The Josephson qubit based on a superconducting single charge transistor inserted in a low-inductance superconducting loop is considered. The loop is inductively coupled to a radio-frequency driven tank circuit enabling the readout of the qubit states by measuring the effective Josephson inductance of the transistor. The effect of qubit dephasing and relaxation due to electric and magnetic control lines, as well as the measuring system, is evaluated. Recommendations for qubit operation with minimum decoherence are given.

arXiv:cond-mat/0312225Journal of Experimental and Theoretical PhysicsJun 1, 200421 citations

Superconducting electrometer based on the resistively shunted Bloch transistor

S.V. Lotkhov, H. Zangerle, A.B. Zorin +3 more

We have fabricated the Bloch transistor shunted on-chip by a small-sized Cr resistor with R/sub s/=1 k/spl Omega/. The Bloch transistor normally consists of two small Josephson junctions connected in series, which in our case have been replaced by two superconducting interferometer loops, each with two junctions in parallel. A capacitively coupled gate is supplied to control the induced charge of the small intermediate electrode (island) of the transistor. The measured I-V curves show no hysteresis and correspond to the operation of a effective Josephson junction at the high-damping and strong-noise limits. The critical current of the system was found to be close to its nominal value, that is in accordance with the electromagnetic environment theory. The I-V curves were modulated by the gate with a period of e and a maximum swing of about 2 /spl mu/V. Such rather moderate modulation results from the Josephson-to-charging energies ratio, E/sub J//E/sub C//spl ap/9, in our sample being far from its optimum value (/spl ap/0.3+1).

arXiv:cond-mat/9901118IEEE Transactions on Applied SuperconductivityJun 1, 19995 citations

Superconducting Electrometer Based on the Resistively Shunted Bloch Transistor

S. V. Lotkhov, H. Zangerle, Alexander B Zorin +3 more

Abstract⎯We have fabricated the Bloch transistor shunted on-chip by a small-sized Cr resistor with Rs ≈ 1 kΩ. The Bloch transistor normally consists of two small Josephson junctions connected in series, which in our case have been replaced by two superconducting interferometer loops, each with two junctions in parallel. A capacitively coupled gate is supplied to control the induced charge of the small intermediate electrode (island) of the transistor. The measured I-V curves show no hysteresis and correspond to the operation of a effective Josephson junction at the high-damping and strong-noise limits. The critical current of the system was found to be close to its nominal value, that is in accordance with the electromagnetic environment theory. The I-V curves were modulated by the gate with a period of e and a maximum swing of about 2 µV. Such rather moderate modulation results from the Josephson-tocharging energies ratio, EJ/EC ≈ 9, in our sample being far from its optimum value ( ≈ 0.3÷1). I.

Jan 1, 19992 citations

Inductive Single-Electron Transistor

Mika A. Sillanpää, Leif Roschier, Pertti Juhani Hakonen

We demonstrate a sensitive method of charge detection based on radio-frequency readout of the Josephson inductance of a superconducting single-electron transistor. Charge sensitivity 1.4 x 10(-4) e/square root Hz, limited by a preamplifier, is achieved in an operation mode which takes advantage of the nonlinearity of the Josephson potential. Owing to reactive readout, our setup has more than 2 orders of magnitude lower dissipation than the existing method of radio-frequency electrometry. With an optimized sample, we expect uncoupled energy sensitivity below variant Planck's over h in the same experimental scheme.

arXiv:cond-mat/0402045Physical Review LettersAug 6, 200445 citations

Quantum device applications of mesoscopic superconductivity

Mika E. T. Sillanpää

The work involves a study of physical phenomena that take place at very small length scales, below one micro-meter. At temperatures roughly below one degree Kelvin, quantum-mechanical effects may rule in electronic transport. Macroscopic quantum-coherent effects that occur in metallic superconducting microstructures, are particularly intriguing. Large-scale quantum information processing is widely believed to be attainable utilizing such physical systems. This work concentrates on answering the question of how the described quantum-mechanical systems may be used as sensitive measuring devices. Considerable attention is paid to energy-storing metallic microstructures whose electrical properties resemble those of the familiar inductor or capacitor. This research involves primarily experimental investigations conducted around temperatures of 0.1 Kelvin. Methods both at low and at radio frequencies have been used. The experimental findings have been modelled theoretically, and theoretical concepts for new physical phenomena have been introduced. An inductively measured radio-frequency Cooper-pair transistor, the L-SET, has been developed and experimentally verified in this work. Being highly sensitive, fast, and non-invasive, the L-SET appears to be the most promising method for measuring electric charge. Sensitivity in charge measurements of 20 millionths of the electron charge (micro-e) within one second, and an input bandwidth of 100 MHz, have been demonstrated. It has been shown theoretically that the ultimate measurement accuracy is about 0.1 micro-e within a second. A new phase detector based on the Cooper-pair transistor has been proposed. This system has also been shown to be potentially usable as a quantum bit. A new type of radio-frequency single-electron transistor built using a multi-walled carbon nanotube has been fabricated and operated. Technologies have been developed in order to make the physical nano- or microstructures. A method has been presented to fabricate non-superconducting tunnel junctions. Consequences of the inverse superconducting proximity effect on the studied superconducting structures were considered. Measurement procedures were investigated for a new low-noise nanoamplifier, the Bloch-oscillating transistor. Single superconducting tunnel junctions were tested as detectors of energy states of the environment, or of noise.

Apr 1, 20052 citations