This thesis describes production of and experiments with a Bose-Einstein condensate of approximately 2 × 10[superscript 4] [superscript 87]Rb atoms, trapped at the surface of an atom chip. In the first half of this thesis I describe the process of trapping and cooling the atomic vapour close to the surface of an atom chip. This process, which cools the vapour by over 9 orders of magnitude, involves a highly complex sequence of events which I implemented and optimised over the first two years of my PhD. In the early stages of this process, the atomic vapour is laser cooled and magneto-optically trapped. The vapour is then transferred to a highly elongated magnetic trap produced by high field gradients a few hundred microns from the surface of the atom chip. Here the vapour is evaporatively cooled to below the transition temperature where a Bose-Einstein condensate emerges. A simple existing analytic model of evaporative cooling is extended in this work to account for the shape of our highly elongated trap. Predictions of this model are presented here along with experimental observations with which it has good agreement. The second part of my thesis investigates some of the characteristics of the condensate, and dynamics of its low energy collective oscillations in the trap, based on experimental measurements taken in the final 18 months of my PhD. In particular, measurements taken of the centre of mass oscillations of the condensate along the long axis of the trap are presented. In the zero temperature limit the condensate is expected to behave as a perfect superfluid, and these low energy oscillations should go undamped. However, at finite temperature where not all atoms in the gas are condensed, damping is observed. In our experiment significant damping is found with an 1/e decay rate which varies between 2s[superscript -1] and 8s[superscript -1], depending on the fraction of non-condensed atoms in the gas. A finite temperature formalism is then used to describe the likely damping mechanism - Landau damping. We use a simple model of this formalism which estimates the temperature dependence of the damping rate γ(T), but find this gives a significant overestimation of the rates we measure. However, we argue that a straightforward adaptation to this model reduces the predicted damping rate significantly, and suggests a functional form of γ(T) that is in much better agreement with our experimental measurements.
This thesis describes production of and experiments with a Bose-Einstein condensate of approximately 2 × 10[superscript 4] [superscript 87]Rb atoms, trapped at the surface of an atom chip. In the first half of this thesis I describe the process of trapping and cooling the atomic vapour close to the surface of an atom chip. This process, which cools the vapour by over 9 orders of magnitude, involves a highly complex sequence of events which I implemented and optimised over the first two years of my PhD. In the early stages of this process, the atomic vapour is laser cooled and magneto-optically trapped. The vapour is then transferred to a highly elongated magnetic trap produced by high field gradients a few hundred microns from the surface of the atom chip. Here the vapour is evaporatively cooled to below the transition temperature where a Bose-Einstein condensate emerges. A simple existing analytic model of evaporative cooling is extended in this work to account for the shape of our highly elongated trap. Predictions of this model are presented here along with experimental observations with which it has good agreement. The second part of my thesis investigates some of the characteristics of the condensate, and dynamics of its low energy collective oscillations in the trap, based on experimental measurements taken in the final 18 months of my PhD. In particular, measurements taken of the centre of mass oscillations of the condensate along the long axis of the trap are presented. In the zero temperature limit the condensate is expected to behave as a perfect superfluid, and these low energy oscillations should go undamped. However, at finite temperature where not all atoms in the gas are condensed, damping is observed. In our experiment significant damping is found with an 1/e decay rate which varies between 2s[superscript -1] and 8s[superscript -1], depending on the fraction of non-condensed atoms in the gas. A finite temperature formalism is then used to describe the likely damping mechanism - Landau damping. We use a simple model of this formalism which estimates the temperature dependence of the damping rate γ(T), but find this gives a significant overestimation of the rates we measure. However, we argue that a straightforward adaptation to this model reduces the predicted damping rate significantly, and suggests a functional form of γ(T) that is in much better agreement with our experimental measurements.
Atom chips are an excellent tool for studying ultracold degenerate quantum gases, due to the high degree of controllability afforded by the precise potentials generated from the current-carrying microfabricated wires on the chip surface. The geometries of the trapping potentials are inherently capable of realising extreme aspect ratios, and therefore creating model systems with effectively reduced dimensionality, particularly the theoretically-tractable one-dimensional Bose gas. In addition, the temporal tunability makes it possible to impart non-adiabatic changes on the trapping potentials, allowing experimental investigation of samples which have been brought out of equilibrium - a situation which is not fully theoretically understood. This thesis describes the implementation, development and characterisation of an experimental system for producing the first Bose-Einstein condensates of atomic rubidium 87 gas trapped on the surface of an atom chip in Nottingham. Such an apparatus is very complex and requires careful characterisation in order to run in a stable and reliable way. Details of the experimental setup are thoroughly outlined, including the vacuum system, lasers, electronics, computer control and timing, and the optical imaging system. A newly installed compact two-dimensional magneto-optical trap provides an loading rate of 5e7 atoms per second for loading a three-dimensional mirror-magneto-optical trap with 1.5e8 atoms, at a temperature of 300uK within 10s. The cloud is then sub-Doppler cooled to 50uK, and spin-polarised with 96% purity into the |F=2,mF=+2> ground state within 5ms, in preparation for loading a purely magnetic trap. A millimeter sized copper Z-shaped conductor located beneath the atom chip surface creates a Ioffe-Pritchard magnetic trap, into which the laser cooled cloud is loaded with 70% efficiency, and can be held with a vacuum-limited lifetime of 40s. Evaporative cooling then pre-cools the sample to below 20uK within 10s, to allow the subsequent loading into potentials created by the atom chip with 100% efficiency. A final evaporation stage then cools the cloud below the phase transition temperature of 800nK, resulting finally in pure BECs with 105 atoms confined using the atom chip. Key measurements of various properties of the trapped condensates are presented, which are important in order to characterise the system fully, and to compare with theoretical expectations. In particular, included are the variation of condensate fraction with temperature, the BEC expansion dynamics, and the condensate lifetime in the trap, for example. Finally, it is demonstrated how BECs can be produced on the atom chip without the use of external macroscopic coils, achieved by using novel, integrated sheet structures located beneath the chip surface - unique to this experimental system - to create the necessary bias fields.
In this thesis I discuss work that has been carried out on the dynamics of a Bose Einstein condensate of Rb 87 produced near an atom chip. A Bose Einstein Condensate (BEC) is a quantum state of matter where a single quantum state becomes occupied by a macroscopic number of identical Bosons. In our case this is achieved by cooling a system of trapped identical rubidium 87 atoms to its ground state. To reach temperatures of condensation we initially laser cool atoms from room temperature, before loading them into a magnetic trap. The magnetic trap is produced through a combination of uniform magnetic fields from coils outside our vacuum chamber and currents running through wires on an atom chip. The atom chip is a microfabricated device, produced by a coating a silicon chip with a thin layer of gold and etching wires into it. Together, these fields create a magnetic field minimum 120μm from the surface of the chip which can be used to confine low field seeking hyperfine states of the atom in an elongated harmonic trap. Once the atoms are confined in the magnetic trap we used force evaporative cooling out to reach the phase space densities required for Bose Einstein condensation. The BEC is used to investigate the relative dynamics between the fraction of the atoms in the condensate to those not in the condensate. Our atom chip provided a suitable environment to investigate this due to fragmentation of the magnetic potential close to the chip. Small imperfections in the wires on our atom chip mean that the trapping potential isn’t smooth. Small regions of higher trapping frequency - or fragments - are formed. Due to the small size of these fragments it is possible to find a position where a condensate can form in the fragment, and see a potential of high frequency, whereas a non-condensed atom will see a lower frequency potential. We exploit this to set the condensed fraction moving relative to the non condensed part and investigate the subsequent damping of their motion relative to each other.
In this thesis a number of aspects on possible manipulation of Bose-Einstein condensate in trapped atomic gases is investigated. First, a model for atom optical experiments involving Bose condensates is proposed and numerical simulations are presented to illustrate its characteristics. We demonstrate ways of focusing and splitting the condensate by modifying experimentally adjustable parameters. We show that there are at least two ways of implementing atom optical elements: one may modulate the interatomic scattering length in space, or alternatively, use a sinusoidal, externally applied potential. The temporal evolution of quasiparticle excitations is studied via the Gross-Pitaevskii Equation. Nonlinear mode mixing of quasiparticles is introduced, and is observed using a quasiparticle projection method. This is used as a basis of time-dependent finite temperature simulations, which we argue to be valid under regimes of high occupation number. An illustration via a closely related evaporative cooling simulation is provided. A phenomenological damping formalism for superfluidity near the λ point is adopted to describe the damping of excitations in a Bose-Einstein condensate. An estimate for the damping parameter is found. The damping formalism as a numerical tool to calculate the ground eigenstate of the condensate is explored. A novel, experimentally realisable interferometry for Bose-Einstein condensates using near-field diffraction is proposed. The scheme is based on the phenomenon of intermode traces or quantum carpets; we demonstrate the structured spatio-temporal pattern for the dilute, atomic Bose-Einstein condensate. The pattern is found to change with temperature, which allows us to perform interferometric temperature measurements. Finally, an output coupler for Bose-Einstein Condensates based on stimulated Raman transition is investigated. The spectrum and coherence are calculated for an atomic beam slowly coupled out of a trap containing a partially condensed Bose gas at finite temperatures. A number conserving Hartree-Fock-Bogliubov formalism has been used to incorporate finite temperature effects. Various different processes are found to become dominant for a suitable choice of the coupling parameters.
The construction of an apparatus capable of producing Bose-Einstein condensates marks a significant milestone in every experimental cold atom laboratory. In this thesis I describe the development of a system to create a Bose-Einstein condensate of 87Rb in a Time-Orbiting Potential trap.\n\nI review the optical and magnetic techniques required to trap and cool an atomic sample under vacuum, motivating our decision to build a double MOT system comprised of a high-pressure (10−9 torr) chamber to gather atoms and a low-pressure (10−11 torr) chamber to cool atoms to degeneracy.\n\nBy theoretically modeling the atom number and temperature inside the magnetic trap during evaporative cooling I demonstrate a simple approach to determining a cooling path that reaches the transition temperature. By making use of the condensates produced under these non-optimized conditions I determine the heating rate of the condensate in the TOP trap to be 300 nK/s. I further use the condensates to make a more precise measurement of the TOP trap bias field.\n\nI improve upon the conventional evaporation path used in TOP trap experiments by introducing and optimizing additional bias field compression stages in between RF evaporation ramps. I demonstrate how, by adding these additional stages, the system is capable of reaching the BEC phase transition with a final atom number of 2times105. In contrast, RF evaporation after only a single bias field ramp has yielded condensates with only 30times103 atoms.
Ultracold atomic gases have proven to be an excellent tool for research in quantum systems. A Bose gas can be trapped on an atom chip using very well defined and tunable spatially-dependent potentials. The proximity of the atoms to the chip permits the use of low currents allowing for highly accurate temporal changes. Excellent experimental apparatus is needed to achieve Bose-Einstein condensation with a sufficient atom number to study low-dimensional physics. The setup described in this document utilises a set of current-carrying structures on top of which an atom chip sits. For improved atom loading rate, a two-dimensional loading stage was added, extending the lifetime of the magnetic trap. From this loading stage to the atom chip, Bose-Einstein condensation of 105 Rubidium-87 atoms was achieved in less than 30 s, allowing for a large rate of experimental cycles. The high spatial and temporal tunability of this setup results in the ability to split the atomic cloud and quench the trapping potential geometry. Maximising the ratio between trapping frequencies for different spatial directions leads to the system presenting features of a one-dimensional gas. Manipulating the coherence dynamics of a one-dimensional Bose-Einstein condensate creates fluctuations in the phase properties of the wavefunction. These fluctuations are observed as atom density perturbations after releasing the trapping potentials, and are a tool for temperature measurements. When the cloud of atoms is positioned at a few tens of micrometres from the surface of the atom chip, corrugations in the microstructures of the chip affect the trapping potentials at very low temperatures 1 µK. This effect is simulated and quantified in the thesis, with the aim of improving future setups. Additionally, the effect is explored for microscopy purposes. The behaviour of a Bose-Einstein condensate, especially the expansion rate, has long been studied. In this thesis, the Gross-Pitaevskii Equation is introduced, finding its numerical solutions to the two-dimensional and three-dimensional forms, using the Split-Step Fourier Method. The results show very good agreement with the experimental results, as well as with other well- established theories of condensates. The creation of such a toolbox opens up the opportunity to further investigate the coherence dynamics of low-dimensional systems.
Research on degenerate quantum gases of dilute atomic gases has become a well established field in modern physics and revealed many astonishing phenomena. The first experiments on Bose and Fermi gases at low temperatures aimed to prove the predictions of quantum mechanics on a macroscopic scale. Since then we make use of Bose and Fermi gases and mixtures of any combination to model other many body systems. A property of Bose Einstein condensates is superfluidity which we want to investigate further in toroidal potentials with a new apparatus which can produce an all-optical BEC. This means trapping thermal atoms in an optical dipole trap and cooling the sample by evaporation into the quantum degenerate regime. This new technique was first successfully demonstrated by M.D. Barrett et al. in 2001 and promises to be faster and simpler than the well established and common way of evaporation in magnetic traps. A new apparatus was built by the author and we report on the experimental details of the trapping of 87Rb atoms from a hot vapour and cooling them in a magneto-optical trap, and further evaporation to quantum degeneracy in a crossed optical dipole trap operating at a wavelength of l = 1064nm, with accurate control of the power in both beams via a feedback loop. The evaporation of neutral atoms of 87Rb in far red detuned optical dipole traps using linearly polarised laser light is spin independent, and mixed spinor condensates of the F=1 manifold can be formed. As an empirical technique we found by applying a magnetic gradient field during the final evaporation that we can selectively populate mF spin states or prepare mixtures. This intriguing mechanism was found earlier as well by M. S. Chang, but is yet not fully understood and subject of our future research. We can now routinely prepare an almost pure condensate containing up to 7000 atoms in the condensed phase purely in the mF = 0 spin state. This thesis contains the theoretical framework of Bose-Einstein condensation with in mean-field theory, the concepts of cooling of atoms in magneto-optical traps, the trapping and evaporation in optical dipole traps and the experimental realisation. In the future this experiment will be extended by a fast scanning dipole trap to apply arbitrary time averaged potentials of more complex geometries, such as toroidal traps to study the effects of superfluidity in a periodic potential. The production of toroidal traps and cold atoms in such a trap are outlined in this thesis.