Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Design Blueprint: A Spin-Polarisation Magnetometer: Computed Sensitivity of a Dense Polarised Alkali Ensemble

William Alexander Aldred

Published Nov 11, 2026• 0 citations
Publisher

Abstract

Design blueprint derived from the source paper (DOI 10.5281/zenodo.24129593): A dense, highly polarised alkali vapour is a magnetic sensor whose fundamental noise limits lie far below what practical instruments achieve, and the gap between the two is where magnetometer design actually happens. Status: DESIGN BLUEPRINT — SIMULATED, NOT MEASURED — NOT BUILT. All numbers are simulated values from the source paper's computation, deposited with this blueprint as compute.py and results.json. AI-use disclosure: Dave, an AI research system, assisted with the computation and drafting under the author's direction; author of record William Alexander Aldred.

DOI
10.5281/zenodo.24130330

Related papers

Design Blueprint: A Superconducting Qubit Sensor for Shear-Coupled Dephasing

William Alexander Aldred

Design blueprint derived from the source paper (DOI 10.5281/zenodo.24138603): A superconducting qubit is an exquisitely sensitive detector of its own decoherence: anything in its environment that shifts its transition frequency shortens its coherence in a measurable way. Status: DESIGN BLUEPRINT — SIMULATED, NOT MEASURED — NOT BUILT. All numbers are simulated values from the source paper's computation, deposited with this blueprint as compute.py and results.json. AI-use disclosure: Dave, an AI research system, assisted with the computation and drafting under the author's direction; author of record William Alexander Aldred.

•Nov 11, 2026•0 citations

A Spin-Polarisation Magnetometer: Computed Sensitivity of a Dense Polarised Alkali Ensemble

William Alexander Aldred

A dense, highly polarised alkali vapour is a magnetic sensor whose fundamental noise limits lie far below what practical instruments achieve, and the gap between the two is where magnetometer design actually happens. This paper specifies a spin-polarisation magnetometer on such an ensemble, 7.20e+14 atoms at a polarisation of 0.85 with a coherence time of twelve milliseconds, and computes each limit separately: spin projection noise at 0.0019 femtotesla per root hertz, photon shot noise at 0.0031 femtotesla per root hertz, and a technical floor of 0.55 femtotesla per root hertz that dominates the total of 0.55 femtotesla per root hertz. The measurement bandwidth is 13 hertz and the operating range is plus or minus five nanotesla around a compensated zero, requiring a shielding and compensation factor of 1e+04 against the ambient geomagnetic field. SIMULATED, NOT MEASURED: the figures are computed from the stated assumptions and no instrument has been operated.

•Nov 11, 2026•1 citation

High-Sensitivity Atomic Magnetometer Unaffected by Spin-Exchange Relaxation

J. C. Allred, ROBERT LYMAN, Thomas W. Kornack +1 more

Alkali-metal magnetometers compete with SQUID detectors as the most sensitive magnetic field sensors. Their sensitivity is limited by relaxation due to spin-exchange collisions. We demonstrate a K magnetometer in which spin-exchange relaxation is completely eliminated by operating at high K density and low magnetic field. Direct measurements of the signal-to-noise ratio give a magnetometer sensitivity of $10\text{ }\mathrm{f}\mathrm{T}\text{ }\mathrm{H}{\mathrm{z}}^{\mathrm{\ensuremath{-}}\mathrm{1}\mathrm{/}\mathrm{2}}$, limited by magnetic noise produced by Johnson currents in the magnetic shields. We extend a previous theoretical analysis of spin exchange in low magnetic fields to arbitrary spin polarizations and estimate the shot-noise limit of the magnetometer to be $2\ifmmode\times\else\texttimes\fi{}{10}^{\ensuremath{-}18}\text{ }\mathrm{T}\text{ }\mathrm{H}{\mathrm{z}}^{\mathrm{\ensuremath{-}}\mathrm{1}\mathrm{/}\mathrm{2}}$.

Physical Review Letters•Sep 9, 2002•1,078 citations

Design Blueprint: A Quantum Illumination Ranging Head for Navigation in Clutter

William Alexander Aldred

Design blueprint derived from the source paper (DOI 10.5281/zenodo.24138585): Detecting and ranging a weakly reflecting object in bright background clutter is a problem where classical signals struggle, because the background overwhelms the return. Status: DESIGN BLUEPRINT — SIMULATED, NOT MEASURED — NOT BUILT. All numbers are simulated values from the source paper's computation, deposited with this blueprint as compute.py and results.json. AI-use disclosure: Dave, an AI research system, assisted with the computation and drafting under the author's direction; author of record William Alexander Aldred.

•Nov 11, 2026•0 citations

Magnetic-field-independent spin-exchange relaxation-free magnetometer

Mark Dikopoltsev, Uriel Levy, Or Katz

Spin-exchange relaxation-free magnetometers based on dense ensembles of alkali-metal spins are precision quantum sensors that hold the record of measured and projected sensitivity to magnetic fields, in the microgauss to milligauss range. At geomagnetic fields however, these sensors quickly lose their magnetic sensitivity due to spin decoherence by random spin-exchange collisions. Here we discover that atoms with nuclear spin $I=\frac{1}{2}$ can operate in the spin-exchange relaxation-free regime even at high magnetic field. We counterintuitively show that frequent collisions between a dense and optically inaccessible $(I=\frac{1}{2})$ gas with another optically accessible spin gas ($I>\frac{1}{2}$) improve the fundamental magnetic sensitivity of the latter. We analyze the performance of a dual-species potassium and atomic hydrogen magnetometer and project a fundamental sensitivity of about $10\phantom{\rule{0.28em}{0ex}}\mathrm{aT}\phantom{\rule{0.16em}{0ex}}{({\mathrm{cm}}^{3}\text{/}\mathrm{Hz})}^{1/2}$ at geomagnetic fields for feasible experimental conditions.

arXiv:2209.13086•Physical Review A•Mar 3, 2025•9 citations

Research on the influence of alkali polarization on an all-optical atomic spin magnetometer based on hybrid pumping potassium and rubidium

Hong Zhang, Sheng Zou, Xiyuan Chen +1 more

An all-optical atomic spin magnetometer using a hybrid cell of K and Rb atoms is demonstrated in this paper. Via deriving and solving the Bloch equations, we established the models for the polarization rate of Rb and the magnetometer’s output signal, respectively. In order to achieve the maximum sensitivity, we carried out research on the influence of the pump power on the polarization rate and magnetometer’s output signal. The magnetometer’s sensitivity was found to be proportional to the polarization rate of Rb, which was confined by the pump power. In a certain context, theoretical predictions indicated that the larger the pump power was, the higher magnetometer’s sensitivity that could be realized. However, the theoretical estimate deviated from the experimental results. An analysis of the errors between the actual value and the theoretical value showed that the different molar ratio between the two species of alkali-metal atoms was the primary reason causing the deviation. By comparing the experimental measurement result with simulation result, we found the difference in the molar ratio to be approximate 4 times. After various parameters had been optimized, a sensitivity of 18 fT/Hz 1/2 was achieved by analyzing the signal-to-noise ratio.

Journal of the Korean Physical Society•Apr 1, 2015•9 citations
Design blueprint derived from the source paper (DOI 10.5281/zenodo.24129593): A dense, highly polarised alkali vapour is a magnetic sensor whose fundamental noise limits lie far below what practical instruments achieve, and the gap between the two is where magnetometer design actually happens. Status: DESIGN BLUEPRINT — SIMULATED, NOT MEASURED — NOT BUILT. All numbers are simulated values from the source paper's computation, deposited with this blueprint as compute.py and results.json. AI-use disclosure: Dave, an AI research system, assisted with the computation and drafting under the author's direction; author of record William Alexander Aldred.
Design blueprint derived from the source paper (DOI 10.5281/zenodo.24138603): A superconducting qubit is an exquisitely sensitive detector of its own decoherence: anything in its environment that shifts its transition frequency shortens its coherence in a measurable way. Status: DESIGN BLUEPRINT — SIMULATED, NOT MEASURED — NOT BUILT. All numbers are simulated values from the source paper's computation, deposited with this blueprint as compute.py and results.json. AI-use disclosure: Dave, an AI research system, assisted with the computation and drafting under the author's direction; author of record William Alexander Aldred.
A dense, highly polarised alkali vapour is a magnetic sensor whose fundamental noise limits lie far below what practical instruments achieve, and the gap between the two is where magnetometer design actually happens. This paper specifies a spin-polarisation magnetometer on such an ensemble, 7.20e+14 atoms at a polarisation of 0.85 with a coherence time of twelve milliseconds, and computes each limit separately: spin projection noise at 0.0019 femtotesla per root hertz, photon shot noise at 0.0031 femtotesla per root hertz, and a technical floor of 0.55 femtotesla per root hertz that dominates the total of 0.55 femtotesla per root hertz. The measurement bandwidth is 13 hertz and the operating range is plus or minus five nanotesla around a compensated zero, requiring a shielding and compensation factor of 1e+04 against the ambient geomagnetic field. SIMULATED, NOT MEASURED: the figures are computed from the stated assumptions and no instrument has been operated.
Alkali-metal magnetometers compete with SQUID detectors as the most sensitive magnetic field sensors. Their sensitivity is limited by relaxation due to spin-exchange collisions. We demonstrate a K magnetometer in which spin-exchange relaxation is completely eliminated by operating at high K density and low magnetic field. Direct measurements of the signal-to-noise ratio give a magnetometer sensitivity of $10\text{ }\mathrm{f}\mathrm{T}\text{ }\mathrm{H}{\mathrm{z}}^{\mathrm{\ensuremath{-}}\mathrm{1}\mathrm{/}\mathrm{2}}$, limited by magnetic noise produced by Johnson currents in the magnetic shields. We extend a previous theoretical analysis of spin exchange in low magnetic fields to arbitrary spin polarizations and estimate the shot-noise limit of the magnetometer to be $2\ifmmode\times\else\texttimes\fi{}{10}^{\ensuremath{-}18}\text{ }\mathrm{T}\text{ }\mathrm{H}{\mathrm{z}}^{\mathrm{\ensuremath{-}}\mathrm{1}\mathrm{/}\mathrm{2}}$.
Design blueprint derived from the source paper (DOI 10.5281/zenodo.24138585): Detecting and ranging a weakly reflecting object in bright background clutter is a problem where classical signals struggle, because the background overwhelms the return. Status: DESIGN BLUEPRINT — SIMULATED, NOT MEASURED — NOT BUILT. All numbers are simulated values from the source paper's computation, deposited with this blueprint as compute.py and results.json. AI-use disclosure: Dave, an AI research system, assisted with the computation and drafting under the author's direction; author of record William Alexander Aldred.
Spin-exchange relaxation-free magnetometers based on dense ensembles of alkali-metal spins are precision quantum sensors that hold the record of measured and projected sensitivity to magnetic fields, in the microgauss to milligauss range. At geomagnetic fields however, these sensors quickly lose their magnetic sensitivity due to spin decoherence by random spin-exchange collisions. Here we discover that atoms with nuclear spin I=12I=\frac{1}{2}I=21​ can operate in the spin-exchange relaxation-free regime even at high magnetic field. We counterintuitively show that frequent collisions between a dense and optically inaccessible (I=12)(I=\frac{1}{2})(I=21​) gas with another optically accessible spin gas (I>12I>\frac{1}{2}I>21​) improve the fundamental magnetic sensitivity of the latter. We analyze the performance of a dual-species potassium and atomic hydrogen magnetometer and project a fundamental sensitivity of about 10aT(cm3/Hz)1/210\phantom{\rule{0.28em}{0ex}}\mathrm{aT}\phantom{\rule{0.16em}{0ex}}{({\mathrm{cm}}^{3}\text{/}\mathrm{Hz})}^{1/2}10aT(cm3/Hz)1/2 at geomagnetic fields for feasible experimental conditions.
An all-optical atomic spin magnetometer using a hybrid cell of K and Rb atoms is demonstrated in this paper. Via deriving and solving the Bloch equations, we established the models for the polarization rate of Rb and the magnetometer’s output signal, respectively. In order to achieve the maximum sensitivity, we carried out research on the influence of the pump power on the polarization rate and magnetometer’s output signal. The magnetometer’s sensitivity was found to be proportional to the polarization rate of Rb, which was confined by the pump power. In a certain context, theoretical predictions indicated that the larger the pump power was, the higher magnetometer’s sensitivity that could be realized. However, the theoretical estimate deviated from the experimental results. An analysis of the errors between the actual value and the theoretical value showed that the different molar ratio between the two species of alkali-metal atoms was the primary reason causing the deviation. By comparing the experimental measurement result with simulation result, we found the difference in the molar ratio to be approximate 4 times. After various parameters had been optimized, a sensitivity of 18 fT/Hz 1/2 was achieved by analyzing the signal-to-noise ratio.