We present a comprehensive theoretical study of light drag effect in an optomechanical system incorporating Kerr non-linearity. The ability to dynamically control the speed and direction of light propagation is a well-established goal in optics, with applications ranging from all-optical routing to quantum information processing. We determine that an intensity-dependent refractive index, resulting from the Kerr limit [Formula: see text], provides exceptional control over the optomechanically induced transparency (OMIT) response. Our study shows that Kerr non-linearity changes the transparency condition of the OMIT to [Formula: see text], allowing for power-tunable control of the transparency frequency. Remarkably, we found that when the Kerr shift exceeds the critical value [Formula: see text], the dispersion slope reverses from normal to anomalous, resulting in a reversal of the light-dragging effect signal. This Kerr shift reversal enables complete optical switching between superluminal propagation (fast light) and subluminal propagation (slow light) exclusively by changing the power of the control laser. We systematically investigate the dependence of the light-drag on the probe detuning, laser detuning, mechanical damping rate, angular velocity and cavity decay rate. Our results show that the drag signal exhibits a linear dependence on the angular velocity, is maximal under the OMIT transparency condition and is significantly enhanced at low mechanical damping rates due to increased mechanical coherence and stronger optomechanical interaction. The drag signal enhancement factor is inversely proportional to the mechanical damping rate, demonstrating that high-quality mechanical resonators are essential for achieving strong optical drag effects.We demonstrate that the drag magnitude reaches [Formula: see text] [Formula: see text] for [Formula: see text] versus [Formula: see text] [Formula: see text] for [Formula: see text] when plotted versus probe detuning [Formula: see text] and laser detuning [Formula: see text], with linewidth broadening from FWHM [Formula: see text] to [Formula: see text] with increasing [Formula: see text]. Versus angular velocity [Formula: see text], the drag is antisymmetric [Formula: see text], zero at [Formula: see text], and saturates to [Formula: see text] versus [Formula: see text] for [Formula: see text], with low damping requiring smaller [Formula: see text] for saturation. Most importantly, Kerr non-linearity provides an all-optical knob to switch drag sign: below critical power [Formula: see text] OMIT dominates with positive drag up to [Formula: see text] [Formula: see text], at [Formula: see text] rad/s drag vanishes ([Formula: see text]) rad, and above critical power Kerr dominates giving negative drag down to [Formula: see text] [Formula: see text], with subsequent switching to [Formula: see text] [Formula: see text] at high [Formula: see text]. This demonstrates controllable fast-to-slow light switching and positive-to-negative rotary drag switching via pump intensity, crucial for non-reciprocal light propagation and rotational sensing. For experimentally achievable coefficients in silicon nitride cavities of [Formula: see text] radian/s and [Formula: see text], the required switching power is on the order of milliwatts, which is within current experimental possibilities. This work opens new avenues for fully optical control of light propagation in on-chip mechanical optoelectronic devices, with potential applications in quantum information processing, micro-sensing and optical buffering.
We present a comprehensive theoretical study of light drag effect in an optomechanical system incorporating Kerr non-linearity. The ability to dynamically control the speed and direction of light propagation is a well-established goal in optics, with applications ranging from all-optical routing to quantum information processing. We determine that an intensity-dependent refractive index, resulting from the Kerr limit [Formula: see text], provides exceptional control over the optomechanically induced transparency (OMIT) response. Our study shows that Kerr non-linearity changes the transparency condition of the OMIT to [Formula: see text], allowing for power-tunable control of the transparency frequency. Remarkably, we found that when the Kerr shift exceeds the critical value [Formula: see text], the dispersion slope reverses from normal to anomalous, resulting in a reversal of the light-dragging effect signal. This Kerr shift reversal enables complete optical switching between superluminal propagation (fast light) and subluminal propagation (slow light) exclusively by changing the power of the control laser. We systematically investigate the dependence of the light-drag on the probe detuning, laser detuning, mechanical damping rate, angular velocity and cavity decay rate. Our results show that the drag signal exhibits a linear dependence on the angular velocity, is maximal under the OMIT transparency condition and is significantly enhanced at low mechanical damping rates due to increased mechanical coherence and stronger optomechanical interaction. The drag signal enhancement factor is inversely proportional to the mechanical damping rate, demonstrating that high-quality mechanical resonators are essential for achieving strong optical drag effects.We demonstrate that the drag magnitude reaches [Formula: see text] [Formula: see text] for [Formula: see text] versus [Formula: see text] [Formula: see text] for [Formula: see text] when plotted versus probe detuning [Formula: see text] and laser detuning [Formula: see text], with linewidth broadening from FWHM [Formula: see text] to [Formula: see text] with increasing [Formula: see text]. Versus angular velocity [Formula: see text], the drag is antisymmetric [Formula: see text], zero at [Formula: see text], and saturates to [Formula: see text] versus [Formula: see text] for [Formula: see text], with low damping requiring smaller [Formula: see text] for saturation. Most importantly, Kerr non-linearity provides an all-optical knob to switch drag sign: below critical power [Formula: see text] OMIT dominates with positive drag up to [Formula: see text] [Formula: see text], at [Formula: see text] rad/s drag vanishes ([Formula: see text]) rad, and above critical power Kerr dominates giving negative drag down to [Formula: see text] [Formula: see text], with subsequent switching to [Formula: see text] [Formula: see text] at high [Formula: see text]. This demonstrates controllable fast-to-slow light switching and positive-to-negative rotary drag switching via pump intensity, crucial for non-reciprocal light propagation and rotational sensing. For experimentally achievable coefficients in silicon nitride cavities of [Formula: see text] radian/s and [Formula: see text], the required switching power is on the order of milliwatts, which is within current experimental possibilities. This work opens new avenues for fully optical control of light propagation in on-chip mechanical optoelectronic devices, with potential applications in quantum information processing, micro-sensing and optical buffering.
Abstract Light dragging refers to the change in the path of light passing through a moving medium. This effect enables accurate detection of very slow speeds of light, which have prominent applications in state transfer, quantum gate operations, and quantum memory implementations. Here, to the best of our knowledge, we demonstrate the existence of the light-dragging effect in an optomechanical system (OMS) for the first time. The origin of this key factor arises from the nonlinear effects linked to optomechanical-induced transparency (OMIT). Hence, we observe prominent effects in the group and refractive indices profile spectra related to optomechanical parameters such as the decay rate of the cavity field, the mirror’s damping momentum rate, and mechanical frequency. We find that lateral light drag depends on the detuning by altering the amplitude and direction of the translational velocity. This allowed us to change the light’s propagation through the optomechanical cavity from superluminal to subluminal and vice versa by modifying the probe’s detuning. The ability to manipulate and control the light drag through an optomechanical system might be useful in designing novel optical devices and systems with enhanced performance.
We theoretically investigate the optomechanically induced transparency (OMIT) phenomenon and the fast and slow light effects of a four-mode optomechanical system with the Kerr medium. The optomechanical system is composed of an array of three single-mode cavities and a mechanical oscillator. The three cavities are a passive cavity, a no-loss-gain cavity and a gain optical cavity, respectively. A Kerr medium is inserted in the passive cavity. We study the influence of the Kerr medium on the stability of the optomechanical system, and find that the stable regime of the optomechanical system can be adjusted by changing the Kerr coefficient. We demonstrate that the phenomenon of optomechanically induced transparency will appear when the Kerr medium exists in the optomechanical system and find that the frequency position of the absorption peak on the left increases linearly with the Kerr coefficient. In addition, we also investigate the fast and slow light effects in this system. The results show that we can control the fast and slow light by adjusting the Kerr coefficient, tunneling strength, and driving field strength. This study has potential application prospects in the fields of quantum optical devices and quantum information processing.
We theoretically investigate the optomechanically induced transparency (OMIT) phenomenon in a hybrid optomechanical system composing of an optomechanical cavity and a traditional one. A Kerr medium is inserted in the optomechanical cavity and the other traps the atomic ensemble. We demonstrate the appearance of electromagnetically and optomechanically induced transparency when there is only Kerr medium or atoms in the system. We give an explicit explanation for the mechanism of the transparency. Moreover, we set up new scheme for the measurement of Kerr coefficient and the single atom-photon coupling strength. It is shown that Kerr nonlinearity can inhibit the normal mode splitting (NMS) when the tunnel strength is strong coupling. Furthermore, in the output field, slow light and fast light are converted to realize the tunable switch from slow light to fast light. This study has some important guiding significance in the fields of the high precision measurement and quantum information processing.
In recent years, due to the rapid development of nano science and advanced semiconductor technology, one is able to observe more significant quantum optomechanical effects as optomechanical system turns smaller in size. Optomechanically induced transparency, fast and slow light, optical storage as well as other quantum optical and nonlinear optical effects have become the focus of research. On the other hand, the optomechanical systems coupled to other small subsystems (such as atoms, quantum dots, single electron transistors, etc.) also attract great attention in research. This is because the coupling system has not only provided more degrees of freedom for quantum manipulation, but also opened up more channels for classical and quantum information transfer. In this paper we study the optomechanically induced transparency and fast/slow light phase control in atom-assisted optomechanical cavity. Unlike the traditional systems, in this model the mechanical resonator is directly driven by a weak auxiliary driving field. We therefore find that with the change of amplitude ratio and phase difference between the auxiliary driving field and the probe field, the absorption and dispersion properties of the whole system and the group delay time vary accordingly. In the absence of auxiliary field, we observe the spectral features of the hybrid electromagnetically induced transparency and optomechanically induced transparency (OMIT) in an atom-cavity-oscillator tripartite optomechanical system. When there exists no phase difference between the auxiliary field and the probe field, we find that the membrane resonance absorption is enhanced with the increase of auxiliary field strength at resonance, causing the the optomechanically induced transparency to be suppressed, and therefore we can modify the amplitude of auxiliary field to control the depth of the OMIT window. When keeping amplitude ratio between the auxiliary field and the probe field unchanged, the modification of the phase difference between the auxiliary field and the probe field directly affects the we can not only realize the manipulation of OMIT window depth, but also control the transformation of tunable optical switch among "absorption", "transparent" and "gain" of the system. Therefore, through changing the phase of auxiliary field and probe field, we can not only realize the manipulation of OMIT window depth, but also control the transformation of tunable optical switch among "absorption" , "transparent" and "gain". In the meantime, we find that the system’s group delay time varies periodically with the change of phase difference. It is worth noting that by adjusting the phase difference and the atomic number, we can not only change the magnitude of the group delay, but also realize the conversion between slow light and fast light effect.
Abstract In this paper, we investigate the light drag in an optically dense negative refractive index medium. Our model is a four-level atomic system in which we demonstrate an enhancement of the light drag while keeping the negative refraction condition. Furthermore, we control the shift in the light drag by tuning both the strong coupling field and the detuning. Hence, we observe that the light drag in the negative refractive index material can be controlled to switch from subluminal to superluminal at various ranges of the detuning. Our system suggests a straightforward technique for realizing and controlling light dragging in materials with negative refractive indices, or ‘NRI,’ which might open the way for more efficient use of left-handedness in atomic systems.
Abstract Controlling the basic properties of light such as polarization, angular momentum, and speed through various optical media leads to interesting phenomena in various fields such as quantum optics, photonics, plasmonics, and quantum information technology. Few of the phenomenon include, for instance, light storage, ultra-slow and ultra-fast propagation, optical transparency, and quantum entanglement via quantum coherence or superposition. The understanding of these phenomenon of milestone implications paved the way for the invention of novel classical and quantum technology. In this article, we present detailed theoretical and numerical demonstration on the dispersion-dependent phenomenon of slow and fast light, optically induced transparency, and photon drag. For this, we employ a three-level scheme of an ensemble of GaAs\AlGaAs double quantum dot molecule in cascade configuration. In particular, by tuning the medium dispersion we predict interesting interplay between ultra-slow and ultra-fast light propagation with vanishing, infinite, ultra-positive and ultra-negative group velocities, and optical-assisted quantum transparency. The quantum coherence of the dressed states modifies considerably the optical properties of the system in view of dispersion, absorption, electron energy loss, transmission, and photon drag. An interesting interplay between ultra-slow to ultra-fast propagation is found by tuning various optical parameters. The calculated superluminal value of group velocity is ± 6 × 1 0 11 m s −1 . We also predict light propagation at vanishing and infinite group velocity. The calculated light drag is ± 6 × 10 − 6 rad/m.