Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physical Review Applied

Bridging gaps in Rydberg rf receivers using modulation-transfer bandwidth enhancement

Anonymous, K. V. Adwaith, Gabriel Boccara, Duc-Anh Trinh, Sacha Welinski, Perrine Berger, Fabienne Goldfarb, Fabien Bretenaker

Published Jun 15, 2026• 0 citations
Publisher

Abstract

We optimize theoretically and experimentally the performances of the recently demonstrated modulation transfer protocol [D.-A. Trinh , Modulation transfer protocol for Rydberg rf receivers, ] aiming at extending the bandwidth of quantum rf receivers based on hot Rydberg atoms. This optimization relies on tuning the parameters of the phase modulation of the coupling beam, which is converted by the nonlinear response of the atoms into an amplitude modulation of the probe beam. We develop a theoretical model to optimize both the modulation frequency and the modulation amplitude of the coupling beam, thereby maximizing the atomic response. Once optimized, the sensitivity to detuned rf fields of this modulation transfer protocol is measured and compared with that of the conventional protocol. This comparison shows that the new protocol permits a strong increase in the detection bandwidth. Indeed, it outperforms the usual one as soon as the rf signal to be measured is detuned by more than a few MHz. We illustrate the capability of this modulation transfer protocol to enhance the detection bandwidth by showing experimentally how it permits bridging the gap between two Rydberg transitions separated by 166 MHz. In all cases, the experimental results are in good agreement with the simulations.

DOI
10.1103/y9dt-gs85

Related papers

Bridging gaps in Rydberg RF receivers using modulation transfer bandwidth enhancement

Mickael Branco, K V Adwaith, Gabriel Boccara +5 more

We optimize theoretically and experimentally the performances of the recently demonstrated modulation transfer protocol [D.-A. Trinh, K. V. Adwaith, M. Branco, A. Rouxel, S. Welinski, P. Berger, F. Goldfarb, and F. Bretenaker, Applied Physics Letters 125, 154001 (2024)] aiming at extending the bandwidth of quantum RF receivers based on hot Rydberg atoms. This optimization relies on tuning the parameters of the phase modulation of the coupling beam, which is converted by the nonlinear response of the atoms into an amplitude modulation of the probe beam. We develop a theoretical model to optimize both the modulation frequency and the modulation amplitude of the coupling beam, thereby maximizing the atomic response. Once optimized, the sensitivity to detuned RF fields of this modulation transfer protocol is measured and compared with that of the conventional protocol. This comparison shows that the new protocol permits a strong increase in the detection bandwidth. Indeed, it outperforms the usual one as soon as the RF signal to be measured is detuned by more than a few MHz. We illustrate the capability of this modulation transfer protocol to enhance the detection bandwidth by showing experimentally how it permits to bridge the gap between two Rydberg transitions separated by 166 MHz. In all cases, the experimental results are in good agreement with the simulations.

quant-pharXiv:2601.02070•Jan 6, 2026•0 citations

Modulation transfer protocol for Rydberg RF receivers

Duc-Anh Trinh, K. V. Adwaith, Mickael Branco +5 more

We propose and demonstrate a modulation transfer protocol to increase the detection sensitivity of a Rydberg RF receiver to fields out of resonance from the transition between Rydberg levels. This protocol is based on a phase modulation of the control field used to create the Electromagnetically Induced Transparency signal. The nonlinear wave mixing of the multi-component coupling laser and the probe laser transfers the modulation to the probe laser, which is used for the RF-field detection. The measurements compare well with semi-classical simulations of atom–light interaction and show an improvement in the RF bandwidth of the sensor and an improved sensitivity of the response to weak fields.

arXiv:2405.03618•Applied Physics Letters•Oct 7, 2024•3 citations

Modulation transfer protocol for Rydberg RF receivers: theory and experiments

Duc-Anh Trinh, Mickael Branco, K. V. Adwaith +5 more

We present a modulation-transfer method to in- crease the detection bandwidth of the Rydberg RF receivers based on three-level Electromagnetically Induced Transparency (EIT) in Rubidium vapor. In this scheme, we phase-modulate the coupling laser to generate sidebands. The nonlinear wave- mixing in the atomic ensemble transfers the modulation from the coupling to the probe laser. The beat note detected in the probe laser intensity provides a new detection response to the RF field. The recorded results show a higher detection sensitivity to the detuned RF field, thus extending the bandwidth of the detector.

Optical and Quantum Sensing and Precision Metrology II•Mar 19, 2025•0 citations

Quantum-Based Amplitude Modulation Radio Receiver Using Rydberg Atoms

Zhenfei Song, Wanfeng Zhang, Xiaochi Liu +4 more

The highly-excited Rydberg states are with a unique property of radio-frequency (RF) resonance, and Rydberg atoms at room temperature are promising for developing a broadband RF electric field sensor and relevant metrology standards. In this paper, the working mechanism of an atomic amplitude-modulation(AM) radio receiver is investigated in detail, and various factors affecting the communication quality are discussed. The modulation RF signal can be directly retrieved by measuring the transmission of a probe laser at resonance of rubidium D2 transition using a fast photo-diode detector, without any conventional demodulation process. Various communication experiments are tested at a 10.22 GHz carrier, and a modulation bandwidth of 1 MHz and an acceptable data transfer rate of about 1 Mbps have been achieved using current detection techniques. Owing to a potential high sensitivity and ultra-broadband capability of free-space RF field sensing, the quantum receiver has great significance compared with conventional electronics-based receivers, including but not limited to a weak signal, long-distance, and broadband communication in free space or via a fiber link.

IEEE Globecom Workshops (GC Wkshps)•Dec 1, 2018•8 citations

Sensitivity of a Rydberg-atom receiver to frequency and amplitude modulation of microwaves

Sebastian Borówka, Uliana Pylypenko, Mateusz Mazelanik +1 more

Electromagnetically induced transparency in atomic systems involving Rydberg states is known to be a sensitive probe of incident microwave (MW) fields, in particular those resonant with Rydberg-to-Rydberg transitions. Here we propose an intelligible analytical model of a Rydberg atomic receiver's response to amplitude- (AM) and frequency-modulated (FM) signals and compare it with experimental results, presenting a setup that allows sending signals with either AM or FM and evaluating their efficiency with demodulation. Additionally, the setup reveals a detection configuration using all circular polarizations for optical fields and allowing detection of a circularly polarized MW field, propagating colinearly with optical beams. In our measurements, we systematically show that several parameters exhibit local optimum characteristics and then estimate these optimal parameters and working ranges, addressing the need to devise a robust Rydberg MW sensor and its operational protocol.

arXiv:2206.11829•Applied Optics•Sep 15, 2022•27 citations

Probing bandwidth and sensitivity in Rydberg atom sensing via optical homodyne and rf heterodyne detection

Dixith Manchaiah, Stone Oliver, Samuel Berweger +2 more

Rydberg atom based sensors allow for SI traceable measurements and show promise for applications in the field of communication and radar technologies. In this article, we investigate the bandwidth and sensitivity of a Rydberg atom-based sensor in a rubidium vapor cell using Rydberg electromagnetically induced transparency (EIT) spectroscopy. We employ a radio-frequency (RF) heterodyne measurement technique in combination with an optical homodyne setup to extend the achievable range between sensitivity and bandwidth in a Rydberg sensor. While the bandwidth of Rydberg sensors are limited by the transit time of atoms and the Rabi frequency of the coupling field, achieving higher bandwidth through smaller beam sizes is thought to compromise sensitivity due to reduced EIT signal strength. Using optical homodyne detection, we demonstrate that sensitivity is preserved while achieving a response bandwidth of 8 MHz. In addition, using the Rydberg sensor, we receive digital communication signals and present error vector magnitude (EVM) measurements as a function of varying symbol rates and bandwidth of the Rydberg sensor. Furthermore, the sensor's performance is compared with a conventional RF mixer. We establish that the bandwidth of a Rydberg sensor when receiving a pure tone is not the same as the bandwidth of the sensor when receiving a modulated signal. This difference results from the spreading of symbols in the frequency domain, leading to a reduction of the signal to noise ratio (SNR) and an accumulation of noise over the total span of the modulated signal.

arXiv:2509.20632•Physical Review A•Dec 22, 2025•5 citations
We optimize theoretically and experimentally the performances of the recently demonstrated modulation transfer protocol [D.-A. Trinh , Modulation transfer protocol for Rydberg rf receivers, ] aiming at extending the bandwidth of quantum rf receivers based on hot Rydberg atoms. This optimization relies on tuning the parameters of the phase modulation of the coupling beam, which is converted by the nonlinear response of the atoms into an amplitude modulation of the probe beam. We develop a theoretical model to optimize both the modulation frequency and the modulation amplitude of the coupling beam, thereby maximizing the atomic response. Once optimized, the sensitivity to detuned rf fields of this modulation transfer protocol is measured and compared with that of the conventional protocol. This comparison shows that the new protocol permits a strong increase in the detection bandwidth. Indeed, it outperforms the usual one as soon as the rf signal to be measured is detuned by more than a few MHz. We illustrate the capability of this modulation transfer protocol to enhance the detection bandwidth by showing experimentally how it permits bridging the gap between two Rydberg transitions separated by 166 MHz. In all cases, the experimental results are in good agreement with the simulations.
We optimize theoretically and experimentally the performances of the recently demonstrated modulation transfer protocol [D.-A. Trinh, K. V. Adwaith, M. Branco, A. Rouxel, S. Welinski, P. Berger, F. Goldfarb, and F. Bretenaker, Applied Physics Letters 125, 154001 (2024)] aiming at extending the bandwidth of quantum RF receivers based on hot Rydberg atoms. This optimization relies on tuning the parameters of the phase modulation of the coupling beam, which is converted by the nonlinear response of the atoms into an amplitude modulation of the probe beam. We develop a theoretical model to optimize both the modulation frequency and the modulation amplitude of the coupling beam, thereby maximizing the atomic response. Once optimized, the sensitivity to detuned RF fields of this modulation transfer protocol is measured and compared with that of the conventional protocol. This comparison shows that the new protocol permits a strong increase in the detection bandwidth. Indeed, it outperforms the usual one as soon as the RF signal to be measured is detuned by more than a few MHz. We illustrate the capability of this modulation transfer protocol to enhance the detection bandwidth by showing experimentally how it permits to bridge the gap between two Rydberg transitions separated by 166 MHz. In all cases, the experimental results are in good agreement with the simulations.
We propose and demonstrate a modulation transfer protocol to increase the detection sensitivity of a Rydberg RF receiver to fields out of resonance from the transition between Rydberg levels. This protocol is based on a phase modulation of the control field used to create the Electromagnetically Induced Transparency signal. The nonlinear wave mixing of the multi-component coupling laser and the probe laser transfers the modulation to the probe laser, which is used for the RF-field detection. The measurements compare well with semi-classical simulations of atom–light interaction and show an improvement in the RF bandwidth of the sensor and an improved sensitivity of the response to weak fields.
We present a modulation-transfer method to in- crease the detection bandwidth of the Rydberg RF receivers based on three-level Electromagnetically Induced Transparency (EIT) in Rubidium vapor. In this scheme, we phase-modulate the coupling laser to generate sidebands. The nonlinear wave- mixing in the atomic ensemble transfers the modulation from the coupling to the probe laser. The beat note detected in the probe laser intensity provides a new detection response to the RF field. The recorded results show a higher detection sensitivity to the detuned RF field, thus extending the bandwidth of the detector.
The highly-excited Rydberg states are with a unique property of radio-frequency (RF) resonance, and Rydberg atoms at room temperature are promising for developing a broadband RF electric field sensor and relevant metrology standards. In this paper, the working mechanism of an atomic amplitude-modulation(AM) radio receiver is investigated in detail, and various factors affecting the communication quality are discussed. The modulation RF signal can be directly retrieved by measuring the transmission of a probe laser at resonance of rubidium D2 transition using a fast photo-diode detector, without any conventional demodulation process. Various communication experiments are tested at a 10.22 GHz carrier, and a modulation bandwidth of 1 MHz and an acceptable data transfer rate of about 1 Mbps have been achieved using current detection techniques. Owing to a potential high sensitivity and ultra-broadband capability of free-space RF field sensing, the quantum receiver has great significance compared with conventional electronics-based receivers, including but not limited to a weak signal, long-distance, and broadband communication in free space or via a fiber link.
Electromagnetically induced transparency in atomic systems involving Rydberg states is known to be a sensitive probe of incident microwave (MW) fields, in particular those resonant with Rydberg-to-Rydberg transitions. Here we propose an intelligible analytical model of a Rydberg atomic receiver's response to amplitude- (AM) and frequency-modulated (FM) signals and compare it with experimental results, presenting a setup that allows sending signals with either AM or FM and evaluating their efficiency with demodulation. Additionally, the setup reveals a detection configuration using all circular polarizations for optical fields and allowing detection of a circularly polarized MW field, propagating colinearly with optical beams. In our measurements, we systematically show that several parameters exhibit local optimum characteristics and then estimate these optimal parameters and working ranges, addressing the need to devise a robust Rydberg MW sensor and its operational protocol.
Rydberg atom based sensors allow for SI traceable measurements and show promise for applications in the field of communication and radar technologies. In this article, we investigate the bandwidth and sensitivity of a Rydberg atom-based sensor in a rubidium vapor cell using Rydberg electromagnetically induced transparency (EIT) spectroscopy. We employ a radio-frequency (RF) heterodyne measurement technique in combination with an optical homodyne setup to extend the achievable range between sensitivity and bandwidth in a Rydberg sensor. While the bandwidth of Rydberg sensors are limited by the transit time of atoms and the Rabi frequency of the coupling field, achieving higher bandwidth through smaller beam sizes is thought to compromise sensitivity due to reduced EIT signal strength. Using optical homodyne detection, we demonstrate that sensitivity is preserved while achieving a response bandwidth of 8 MHz. In addition, using the Rydberg sensor, we receive digital communication signals and present error vector magnitude (EVM) measurements as a function of varying symbol rates and bandwidth of the Rydberg sensor. Furthermore, the sensor's performance is compared with a conventional RF mixer. We establish that the bandwidth of a Rydberg sensor when receiving a pure tone is not the same as the bandwidth of the sensor when receiving a modulated signal. This difference results from the spreading of symbols in the frequency domain, leading to a reduction of the signal to noise ratio (SNR) and an accumulation of noise over the total span of the modulated signal.