We propose and demonstrate a modulation transfer protocol to increase the detection sensitivity of a Rydberg RF receiver to fields out of resonance from the transition between Rydberg levels. This protocol is based on a phase modulation of the control field used to create the Electromagnetically Induced Transparency signal. The nonlinear wave mixing of the multi-component coupling laser and the probe laser transfers the modulation to the probe laser, which is used for the RF-field detection. The measurements compare well with semi-classical simulations of atom–light interaction and show an improvement in the RF bandwidth of the sensor and an improved sensitivity of the response to weak fields.
We propose and demonstrate a modulation transfer protocol to increase the detection sensitivity of a Rydberg RF receiver to fields out of resonance from the transition between Rydberg levels. This protocol is based on a phase modulation of the control field used to create the Electromagnetically Induced Transparency signal. The nonlinear wave mixing of the multi-component coupling laser and the probe laser transfers the modulation to the probe laser, which is used for the RF-field detection. The measurements compare well with semi-classical simulations of atom–light interaction and show an improvement in the RF bandwidth of the sensor and an improved sensitivity of the response to weak fields.
We present a modulation-transfer method to in- crease the detection bandwidth of the Rydberg RF receivers based on three-level Electromagnetically Induced Transparency (EIT) in Rubidium vapor. In this scheme, we phase-modulate the coupling laser to generate sidebands. The nonlinear wave- mixing in the atomic ensemble transfers the modulation from the coupling to the probe laser. The beat note detected in the probe laser intensity provides a new detection response to the RF field. The recorded results show a higher detection sensitivity to the detuned RF field, thus extending the bandwidth of the detector.
We optimize theoretically and experimentally the performances of the recently demonstrated modulation transfer protocol [D.-A. Trinh, K. V. Adwaith, M. Branco, A. Rouxel, S. Welinski, P. Berger, F. Goldfarb, and F. Bretenaker, Applied Physics Letters 125, 154001 (2024)] aiming at extending the bandwidth of quantum RF receivers based on hot Rydberg atoms. This optimization relies on tuning the parameters of the phase modulation of the coupling beam, which is converted by the nonlinear response of the atoms into an amplitude modulation of the probe beam. We develop a theoretical model to optimize both the modulation frequency and the modulation amplitude of the coupling beam, thereby maximizing the atomic response. Once optimized, the sensitivity to detuned RF fields of this modulation transfer protocol is measured and compared with that of the conventional protocol. This comparison shows that the new protocol permits a strong increase in the detection bandwidth. Indeed, it outperforms the usual one as soon as the RF signal to be measured is detuned by more than a few MHz. We illustrate the capability of this modulation transfer protocol to enhance the detection bandwidth by showing experimentally how it permits to bridge the gap between two Rydberg transitions separated by 166 MHz. In all cases, the experimental results are in good agreement with the simulations.
We optimize theoretically and experimentally the performances of the recently demonstrated modulation transfer protocol [D.-A. Trinh , Modulation transfer protocol for Rydberg rf receivers, ] aiming at extending the bandwidth of quantum rf receivers based on hot Rydberg atoms. This optimization relies on tuning the parameters of the phase modulation of the coupling beam, which is converted by the nonlinear response of the atoms into an amplitude modulation of the probe beam. We develop a theoretical model to optimize both the modulation frequency and the modulation amplitude of the coupling beam, thereby maximizing the atomic response. Once optimized, the sensitivity to detuned rf fields of this modulation transfer protocol is measured and compared with that of the conventional protocol. This comparison shows that the new protocol permits a strong increase in the detection bandwidth. Indeed, it outperforms the usual one as soon as the rf signal to be measured is detuned by more than a few MHz. We illustrate the capability of this modulation transfer protocol to enhance the detection bandwidth by showing experimentally how it permits bridging the gap between two Rydberg transitions separated by 166 MHz. In all cases, the experimental results are in good agreement with the simulations.
The highly-excited Rydberg states are with a unique property of radio-frequency (RF) resonance, and Rydberg atoms at room temperature are promising for developing a broadband RF electric field sensor and relevant metrology standards. In this paper, the working mechanism of an atomic amplitude-modulation(AM) radio receiver is investigated in detail, and various factors affecting the communication quality are discussed. The modulation RF signal can be directly retrieved by measuring the transmission of a probe laser at resonance of rubidium D2 transition using a fast photo-diode detector, without any conventional demodulation process. Various communication experiments are tested at a 10.22 GHz carrier, and a modulation bandwidth of 1 MHz and an acceptable data transfer rate of about 1 Mbps have been achieved using current detection techniques. Owing to a potential high sensitivity and ultra-broadband capability of free-space RF field sensing, the quantum receiver has great significance compared with conventional electronics-based receivers, including but not limited to a weak signal, long-distance, and broadband communication in free space or via a fiber link.
Electromagnetically induced transparency in atomic systems involving Rydberg states is known to be a sensitive probe of incident microwave (MW) fields, in particular those resonant with Rydberg-to-Rydberg transitions. Here we propose an intelligible analytical model of a Rydberg atomic receiver's response to amplitude- (AM) and frequency-modulated (FM) signals and compare it with experimental results, presenting a setup that allows sending signals with either AM or FM and evaluating their efficiency with demodulation. Additionally, the setup reveals a detection configuration using all circular polarizations for optical fields and allowing detection of a circularly polarized MW field, propagating colinearly with optical beams. In our measurements, we systematically show that several parameters exhibit local optimum characteristics and then estimate these optimal parameters and working ranges, addressing the need to devise a robust Rydberg MW sensor and its operational protocol.
Abstract We study electromagnetically induced transparency (EIT) in a room-temperature cesium vapor cell using wavelength-modulated probe laser light. In the utilized cascade level scheme, the probe laser drives the lower transition 6 S 1 / 2 ( F = 4) → 6 P 3 / 2 ( F ’ = 5), while the coupling laser drives the Rydberg transition 6 P 3 / 2 → 57 S 1 / 2 . The probe laser has a fixed average frequency and is modulated at a frequency of a few kHz, with a variable modulation amplitude in the range of tens of MHz. The probe transmission is measured as a function of the detuning of the coupling laser from the Rydberg resonance. The first-harmonic demodulated EIT signal has two peaks that are, in the case of large modulation amplitude, separated by the peak-to-peak modulation amplitude of the probe laser times a scaling factor λ p / λ c , where λ p and λ c are the probe- and coupling-laser wavelengths. The scaling factor is due to Doppler shifts in the EIT geometry. Second-harmonic demodulated EIT signals, obtained with small modulation amplitudes, yield spectral lines that are much narrower than corresponding lines in the modulation-free EIT spectra. The resultant spectroscopic resolution enhancement is conducive to improved measurements of radio-frequency (RF) fields based on Rydberg-atom EIT, an approach in which the response of Rydberg atoms to RF fields is exploited to characterize RF fields. Here, we employ wavelength modulation spectroscopy to reduce the uncertainty of atom-based frequency and field measurement of an RF field in the VHF radio band.