Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Beilstein Journal of Nanotechnology

Terahertz-range on-chip local oscillator based on Josephson junction arrays for superconducting quantum-limited receivers

Fedor V. Khan, Lyudmila V. Filippenko, Andrey B. Ermakov, M. Yu. Fominsky, V. P. Koshelets

Published Dec 22, 2025• 3 citations
Publisher

Abstract

In this paper we present the results of the development, fabrication, measurements, and analysis of terahertz-range oscillators based on Josephson junction arrays embedded into the central electrode of a coplanar line. The influence of array geometry, the presence of a matched load at the nonradiating edge, and the magnitude of the tunneling current density of Josephson junctions on such oscillator characteristics as radiation power, linewidth, and operating range are discussed. Various options are suggested for further improvement of the oscillator performance.

DOI
10.3762/bjnano.16.158

Related papers

Towards Continuously Tunable Superconductor Terahertz Range Local Oscillators based on JJ Arrays

Fedor V. Khan, Lyudmila V. Filippenko, Maria A. Markina +3 more

Superconductor terahertz oscillators based on Josephson junction arrays have attracted scientific interest for many decades. We recently reported an array with a new topology, in which the junctions are connected in series and embedded into the central electrode of a coplanar line, that operates successfully at frequencies up to 700 GHz. Here we continue this work and report on our efforts to achieve higher radiation power and higher frequencies using junctions with a higher critical current density. We have achieved an operating frequency above 700 GHz with a maximum power exceeding 0.6μW, which is sufficient for the operation of integrated SIS mixer. However, we found that as the critical current density increased, the operating frequency range narrowed because of synchronization problems accompanied by a rise in the noise level. Calculations within the RLCSJ model show that, at certain operating points on the current–voltage characteristic of a shunted Josephson junction, subharmonics of the fundamental frequencyf = 2eV/hwith very broad spectra emerge; these may be responsible for desynchronizing the junctions in the array. Possible ways of mitigating these effects are discussed.

IEEE Transactions on Terahertz Science and Technology•Jan 1, 2026•0 citations

Towards local oscillators based on arrays of niobium Josephson junctions

Mikhail A. Galin, Alexander M. Klushin, Vladislav V. Kurin +6 more

Abstract Various applications in the field of terahertz technology are in urgent need of compact, wide-tunable solid-state continuous wave radiation sources with a moderate power. However, satisfactory solutions for the THz frequency range are scarce yet. Here we report on coherent radiation from a large planar array of Josephson junctions (JJs) in the frequency range between 0.1 and 0.3 THz. The external resonator providing the synchronization of JJ array is identified as a straight fragment of a single-strip-line containing the junctions themselves. We demonstrate a prototype of the quasioptical heterodyne receiver with the JJ array as a local oscillator and a hot-electron bolometer mixer.

Superconductor Science and Technology•Mar 19, 2015•14 citations

NbN Josephson tunnel junctions for terahertz local oscillators

R. P. Robertazzi, Robert A. Buhrman

Rugged, high current density NbN1−xCx/MgO/NḃN1−xCx tunnel junctions have been fabricated and tested as voltage tunable Josephson junction terahertz oscillators. The emitted radiation from these junctions is detected on chip by a second junction which is capacitively coupled to the first. For oscillator junctions with a critical current density of Jc∼3.5×104 A/cm2 we find that the junction oscillates with a voltage amplitude of ∼1.5 mV. The detected rf voltage level remains essentially constant from 300 GHz to above 1 THz. The oscillator junction produces 0.5 μW of terahertz radiation of which, due to impedance mismatch, 0.01 μW is coupled into the detector junction.

Applied Physics Letters•Dec 12, 1988•15 citations

Properties of Josephson array oscillators at the submillimeter wave region

Akira Kawakami, Yoshinori Uzawa, Z. Wang

We have developed resistively shunted tunnel junctions with a small parasitic inductance (/spl equiv/100 fH) to improve the high-frequency performance of Josephson array oscillators. Josephson array oscillators with 11 such junctions and Nb microstrip resonators were designed and fabricated to operate at 690 GHz. Shapiro steps induced by Josephson oscillation were clearly observed at the submillimeter frequency region. By comparing the step height with the numerical simulation, we estimated the power of the Josephson oscillator delivered to the load resistor to be about 10 /spl mu/W at 625 GHz. The linewidth of the Josephson array oscillator was also measured using an integrated receiver consisting of two Josephson array oscillators and an SIS mixer. The designed frequency of the receiver was set at 550 GHz. IF output power spectrum was observed when both the oscillators were biased at about 1.17 mV which corresponds to 566 GHz. The composite linewidth of Josephson oscillation was measured about 8 MHz at 4.2 K.

IEEE Transactions on Applied Superconductivity•Jun 1, 1999•12 citations

Superconducting Sub-Terahertz Oscillator with Continuous Frequency Tuning

Maxim E. Paramonov, Lyudmila V. Filippenko, Fedor V. Khan +2 more

The development and approbation of a superconducting local oscillator based on a long Josephson junction made it possible to create a fully superconducting integrated receiver in sub-terahertz frequency range, which was successfully tested both on board a high-altitude balloon and in the laboratory. In order to expand the frequency range of a superconducting integrated local oscillator, it is necessary to ensure the continuous tuning of its frequency at an arbitrary bias current, including a so-called resonant mode regime. The resonant mode regime takes place for high-quality tunnel junctions with low leakage; in this regime, stable generation is possible only at Fiske steps, the distance in frequency between which is tens of GHz. A method for suppressing resonances has been proposed and implemented; this method is based on the introduction of normal metal layers into the region near the long Josephson junction. Modeling of the propagation of electromagnetic waves in the proposed integrated structure was carried out; experimental samples were fabricated, and their comprehensive study was performed. The complete suppression of resonances and the possibility of the continuous tuning of the frequency of a superconducting local oscillator in the range of 200–700 GHz have been demonstrated. The linewidth of the FFO radiation does not exceed 15 MHz over the entire frequency range, which makes it possible to implement the phase locked loop mode in an integrated receiver intended for spectral studies.

Applied Sciences•Sep 5, 2022•2 citations

Submillimeter wave generation using Josephson junction arrays

K. L. Wan, A. K. Jain, James E. Lukens

A submillimeter-wave oscillator using a phase-locked array of Josephson junctions is demonstrated. With an array of 40 shunted tunnel junctions, the oscillator delivers 1 mu W of power at 350 GHz into a 60- Omega load on the chip. The operating frequency of the oscillator is tunable over a range of about 10%. Experiments on two coupled lead alloy tunnel junctions show that Josephson oscillations exist to about 1 THz. Using a similar design and a higher gap superconductor such as NbN for the transmission lines, arrays operating at 1 THz with power outputs of 1 mW should be feasible.>

IEEE Transactions on Magnetics•Mar 1, 1989•25 citations
In this paper we present the results of the development, fabrication, measurements, and analysis of terahertz-range oscillators based on Josephson junction arrays embedded into the central electrode of a coplanar line. The influence of array geometry, the presence of a matched load at the nonradiating edge, and the magnitude of the tunneling current density of Josephson junctions on such oscillator characteristics as radiation power, linewidth, and operating range are discussed. Various options are suggested for further improvement of the oscillator performance.
Superconductor terahertz oscillators based on Josephson junction arrays have attracted scientific interest for many decades. We recently reported an array with a new topology, in which the junctions are connected in series and embedded into the central electrode of a coplanar line, that operates successfully at frequencies up to 700 GHz. Here we continue this work and report on our efforts to achieve higher radiation power and higher frequencies using junctions with a higher critical current density. We have achieved an operating frequency above 700 GHz with a maximum power exceeding 0.6μW, which is sufficient for the operation of integrated SIS mixer. However, we found that as the critical current density increased, the operating frequency range narrowed because of synchronization problems accompanied by a rise in the noise level. Calculations within the RLCSJ model show that, at certain operating points on the current–voltage characteristic of a shunted Josephson junction, subharmonics of the fundamental frequencyf = 2eV/hwith very broad spectra emerge; these may be responsible for desynchronizing the junctions in the array. Possible ways of mitigating these effects are discussed.
Abstract Various applications in the field of terahertz technology are in urgent need of compact, wide-tunable solid-state continuous wave radiation sources with a moderate power. However, satisfactory solutions for the THz frequency range are scarce yet. Here we report on coherent radiation from a large planar array of Josephson junctions (JJs) in the frequency range between 0.1 and 0.3 THz. The external resonator providing the synchronization of JJ array is identified as a straight fragment of a single-strip-line containing the junctions themselves. We demonstrate a prototype of the quasioptical heterodyne receiver with the JJ array as a local oscillator and a hot-electron bolometer mixer.
Rugged, high current density NbN1−xCx/MgO/NḃN1−xCx tunnel junctions have been fabricated and tested as voltage tunable Josephson junction terahertz oscillators. The emitted radiation from these junctions is detected on chip by a second junction which is capacitively coupled to the first. For oscillator junctions with a critical current density of Jc∼3.5×104 A/cm2 we find that the junction oscillates with a voltage amplitude of ∼1.5 mV. The detected rf voltage level remains essentially constant from 300 GHz to above 1 THz. The oscillator junction produces 0.5 μW of terahertz radiation of which, due to impedance mismatch, 0.01 μW is coupled into the detector junction.
We have developed resistively shunted tunnel junctions with a small parasitic inductance (/spl equiv/100 fH) to improve the high-frequency performance of Josephson array oscillators. Josephson array oscillators with 11 such junctions and Nb microstrip resonators were designed and fabricated to operate at 690 GHz. Shapiro steps induced by Josephson oscillation were clearly observed at the submillimeter frequency region. By comparing the step height with the numerical simulation, we estimated the power of the Josephson oscillator delivered to the load resistor to be about 10 /spl mu/W at 625 GHz. The linewidth of the Josephson array oscillator was also measured using an integrated receiver consisting of two Josephson array oscillators and an SIS mixer. The designed frequency of the receiver was set at 550 GHz. IF output power spectrum was observed when both the oscillators were biased at about 1.17 mV which corresponds to 566 GHz. The composite linewidth of Josephson oscillation was measured about 8 MHz at 4.2 K.
The development and approbation of a superconducting local oscillator based on a long Josephson junction made it possible to create a fully superconducting integrated receiver in sub-terahertz frequency range, which was successfully tested both on board a high-altitude balloon and in the laboratory. In order to expand the frequency range of a superconducting integrated local oscillator, it is necessary to ensure the continuous tuning of its frequency at an arbitrary bias current, including a so-called resonant mode regime. The resonant mode regime takes place for high-quality tunnel junctions with low leakage; in this regime, stable generation is possible only at Fiske steps, the distance in frequency between which is tens of GHz. A method for suppressing resonances has been proposed and implemented; this method is based on the introduction of normal metal layers into the region near the long Josephson junction. Modeling of the propagation of electromagnetic waves in the proposed integrated structure was carried out; experimental samples were fabricated, and their comprehensive study was performed. The complete suppression of resonances and the possibility of the continuous tuning of the frequency of a superconducting local oscillator in the range of 200–700 GHz have been demonstrated. The linewidth of the FFO radiation does not exceed 15 MHz over the entire frequency range, which makes it possible to implement the phase locked loop mode in an integrated receiver intended for spectral studies.
A submillimeter-wave oscillator using a phase-locked array of Josephson junctions is demonstrated. With an array of 40 shunted tunnel junctions, the oscillator delivers 1 mu W of power at 350 GHz into a 60- Omega load on the chip. The operating frequency of the oscillator is tunable over a range of about 10%. Experiments on two coupled lead alloy tunnel junctions show that Josephson oscillations exist to about 1 THz. Using a similar design and a higher gap superconductor such as NbN for the transmission lines, arrays operating at 1 THz with power outputs of 1 mW should be feasible.>