Softwaretechnik-Trends

A Superconducting Planar Integrated Receiver for the Frequency Range 430-480 GHz

S. V. Shitov, V. P. Koshelets, I.L. Lapitskaya, Lyudmila V. Filippenko, A. M. Baryshev, Th. de Graauw, Harald Schaefer, Herman van de Stadt, Willem Luinge

Published Mar 1, 1995• 1 citation

OpenAlex

Abstract

A planar receiver comprising a Josephson flux-flow oscillator (FF0), a double dipole antenna and a SIS mixer integrated on a single chip within an area of 3 x 3 mm has been realised in the frequency range of 400-500 GHz. RF tests have been performed at temperatures between 2 K and 4.2 K. A best DSB noise temperature of 595 K 20 K at 465 GHz was obtained for the receiver with the mixer pumped by the FFO. The width of the antenna beam has been measured referred to the input window of the cryostat and was about ± 4 degrees at the power level of about 20 dB. The power consumption of the whole device is estimated to be 20 p.W.

Related papers

An integrated 500 GHz receiver with superconducting local oscillator

V. P. Koshelets, S. V. Shitov, Lyudmila V. Filippenko +6 more

An integrated quasioptical receiver consisting of a planar double-dipole antenna, SIS mixer and superconducting Flux-Flow Oscillator (FFO) with matching circuits has been designed, fabricated and tested in the frequency range 420-530 GHz. The integrated receiver is very suitable for space applications because of its low size, mass and power consumption. All components of the receiver are integrated on a 4 mm/spl times/4 mm/spl times/0.2 mm crystalline quartz substrate using a single Nb-AlO/sub x/-Nb trilayer. The successful operation of the integrated receiver comprising a number of new crucial elements has been demonstrated. A DSB noise temperature as low as 140 K at 500 GHz and a tuning range of more than 100 GHz have been obtained. A comparison of the FFO with conventional external LO has been performed.

IEEE Transactions on Applied SuperconductivityJun 1, 199727 citations

Superconducting Integrated Sub-mm Wave Receivers

V. P. Koshelets, S. V. Shitov, An. B. Ermakov +5 more

The concept of the fully Superconducting Integrated Receiver (SIR) has been developed and experimentally demonstrated. The single-chip submm wave receiver includes a planar antenna integrated with a SIS mixer, which is pumped by an internal superconducting Flux Flow Oscillator (FFO) as local oscillator (LO). A DSB noise temperature below 100 K has been demonstrated around 500 GHz. Heterodyne measurements have shown that the instantaneous bandwidth of the receiver is 15 – 20 % which meets the requirements of practical applications. The double-dipole lens-antenna SIS mixer has an antenna beam ≈ f/9 with sidelobes below- 16 dB. This enables an efficient coupling of the SIR to the telescope antenna. With the FFO phase locked in the frequency range 270- 440 GHz a linewidth as low as 1 Hz has been measured relative to a reference oscillator. A compact array of 9 SIRs has been developed and tested. Each pixel contains an internally pumped receiver chip, which is mounted on the back of an elliptical silicon lens. A noise temperature of about 150 K has been measured at 500 GHz using the internal FFO for the imaging array of Integrated Receivers.

Jan 1, 19990 citations

Integrated superconducting receivers

V. P. Koshelets, S. V. Shitov

The concept of a fully superconducting integrated receiver is developed and experimentally tested. This single-chip sub-mm wave receiver includes a planar antenna integrated with a SIS mixer and an internal superconducting Josephson-type local oscillator (flux-flow oscillator, FFO). The receiver is tested with a DSB noise temperature below 100 K around 500 GHz being pumped by its internal local oscillator (LO). The instantaneous bandwidth of 15-20% is estimated via FTS and heterodyne measurements that meet the requirements of most practical applications. The far field antenna beam is measured as ≈ f /10 with sidelobes below -16 dB that is suitable for coupling to a real telescope antenna. A nine-pixel imaging array receiver with each pixel containing an internally pumped receiver chip is developed and tested. A linewidth of the phase locked FFO as low as 1 Hz is measured relative to a reference oscillator in the frequency range 270-440 GHz. An rf amplifier on the base of a dc SQUID is developed and tested showing a noise figure below 10 K at 4 GHz and a bandwidth of about 300 MHz. This amplifier can be included as a part of an integrated receiver that is valuable for array applications.

Superconductor Science and TechnologyMay 1, 2000238 citations

First implementation of a superconducting integrated receiver at 450 GHz

V. P. Koshelets, S. V. Shitov, Lyudmila V. Filippenko +6 more

An integrated quasioptical receiver consisting of a planar double dipole antenna, superconductor-insulator-superconductor mixer and a superconducting local oscillator (LO) with matching circuits has been designed, fabricated and tested in the frequency range 360–490 GHz. A flux-flow oscillator (FFO) based on unidirectional and viscous flow of magnetic vortexes in a long Josephson tunnel junction, is employed as a local oscillator. All components of the receiver are integrated on a 4 mm×4 mm×0.2 mm crystalline quartz substrate using a single Nb–AlOx–Nb trilayer. The lowest DSB noise temperature of 470–560 K has been achieved within a frequency range of 425–455 GHz.

Applied Physics LettersFeb 26, 199678 citations

Integrated submm wave receiver with superconductive local oscillator

V. P. Koshelets, S. V. Shitov, Lyudmila V. Filippenko +4 more

A fully superconductive integrated receiver is very promising for submm space astronomy where low weight, low power consumption, and limited volume are required. The new versions of the integrated quasioptical submm wave receiver have been designed, fabricated and tested in the frequency range of 450-700 GHz. The integrated receiver chip comprises a planar double dipole antenna, SIS-mixer and on-chip superconductive Flux-Flow Oscillator (FFO) with matching circuits. The receiver noise temperature (DSB) as low as 140 K at 500 GHz has been obtained. A light-weight and low power consuming submm imaging array is under development. Each of 9 pixels of the array is realized by an all-Nb single-chip superconductive receiver, mounted on an elliptical silicon lens with anti-reflection coating. The experimental test results of one pixel receiver are presented. A computer based system is developed to control the operation of the integrated receiver.

Jan 1, 19970 citations

Integrated sub-MM wave receivers

V. P. Koshelets, S. V. Shitov, Andrey M. Baryshev +6 more

The concept of a fully integrated superconducting receiver looks very attractive for sub-mm space astronomy where low weight, power consumption and volume are required. The possibility to integrate on a few chips the different planar components: a SIS mixer, a superconducting local oscillator (LO), an intermediate frequency amplifier followed by superconducting circuits for digitizing and processing of down converted signals, is discussed. A first implementation of a real integrated quasioptical receiver for frequencies up to 500 GHz is described. The one-chip receiver comprises a double dipole antenna, parallel biased SIS array mixer and Josephson Flux Flow Oscillator (FFO) with matching circuits. The results of extensive investigations of the integrated receiver as well as design and investigation of novel superconducting elements are presented.>

IEEE Transactions on Applied SuperconductivityJun 1, 199528 citations