Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Development and study of charge sensors for fast charge detection in quantum dots

Madhu Thalakulam

Published Jan 1, 2007• 0 citations
OpenAlex

Abstract

Charge detection at microsecond time-scales has far reaching consequences in both technology and in our understanding of electron dynamics in nanoscale devices such as quantum dots. Radio-frequency superconducting single electron transistors (RF-SET) and quantum point contacts (QPC) are ultra sensitive charge sensors operating near the quantum limit. The operation of RF-SETs outside the superconducting gap has been a topic of study; the sub-gap operation, especially in the presence of large quantum fluctuations of quasiparticles remains largely unexplored, both theoretically and experimentally. We have investigated the effects of quantum fluctuations of quasiparticles on the operation of RF-SETs for large values of the quasiparticle cotunneling parameter alpha = 8EJ/Ec, where EJ and Ec are the Josephson and charging energies. We find that, for alpha > 1, sub-gap RF-SET operation is still feasible despite quantum fluctuations that wash out quasiparticle tunneling thresholds. Such RF-SETs show linearity and signal-to-noise ratio superior to those obtained when quantum fluctuations are weak, while still demonstrating excellent charge sensitivity.\nWe have operated a QPC charge detector in a radio frequency mode that allows fast charge detection in a bandwidth of several megahertz. The noise limiting the sensitivity of the charge detector is not the noise of a secondary amplifier, but the non-equilibrium device noise of the QPC itself. The noise power averaged over a measurement bandwidth of about 10MHz around the carrier frequency is in agreement with the theory of photon-assisted shot noise. Frequency-resolved measurements, however show several significant discrepancies with the theoretical predictions. The measurement techniques developed can also be used to investigate the noise of other semiconductor nanostructures such as quantum dots in the Kondo regime.\nA study of the noise characteristics alone can not determine whether the device is operating at the quantum limit; a characterization of back action is also necessary. The inelastic current through a double quantum dot system (DQD) is sensitive to the spectral density of voltage fluctuations in its electromagnetic environment. Electrical transport studies on a DQD system electrostatically coupled to an SET shows qualitative evidence of back-action of SET. The design and fabrication of a few electron DQD device with integrated RF-SET and QPC charge sensors for the study of back action of the sensors and real-time electron dynamics in the DQD are also discussed.

Related papers

Sensitivity and Linearity of Superconducting Radio-Frequency Single-Electron Transistors: Effects of Quantum Charge Fluctuations

Madhu Thalakulam, Zhongqing Ji, A. J. Rimberg

We have investigated the effects of quantum fluctuations of quasiparticles on the operation of superconducting radio-frequency single-electron transistors (rf-SETs) for large values of the quasiparticle cotunneling parameter alpha = 8EJ/Ec, where EJ and Ec are the Josephson and charging energies. We find that, for alpha > 1, subgap rf-SET operation is still feasible despite quantum fluctuations that wash out quasiparticle tunneling thresholds. Surprisingly, such rf-SETs show linearity and signal-to-noise ratio superior to those obtained when quantum fluctuations are weak, while still demonstrating excellent charge sensitivity.

arXiv:cond-mat/0310346•Physical Review Letters•Aug 5, 2004•13 citations

Double quantum dot coupled to a radio-frequency single-electron transistor: Quantum measurement and back action

Madhu Thalakulam

The radio-frequency superconducting single electron transistor (RF-SET) is a highly sensitive and fast electrometer operating near the quantum limit. The back-action current noise of the SET induces voltage fluctuations on the system it is coupled to, dephasing its charge states. Here we propose to study the back action of the RF-SET by means of a double quantum dot (DQD) and, an RF-SET electrostatically coupled to one of the two dots. The inelastic current through the DQD is very sensitive to the spectral density of the voltage fluctuations in the nearby environment. By properly choosing the dot size and inter-dot tunnel barrier thickness, one can cause inelastic process to dominate the transport processes. A measurement of the inelastic current through the double dot system can then be used to calculate the spectral density of noise associated with the RF-SET and hence its back action. The design, fabrication and characterization of an RF-SET/DQD system is discussed in this work. Real-time studies of electron dynamics in coupled dots are also addressed.

•Jan 1, 2004•0 citations

Shot-Noise-Limited Operation of a Fast Quantum-Point-Contact Charge Sensor

Madhu Thalakulam, W. W. Xue, Pan, Feng +5 more

We have operated a quantum point contact (QPC) charge detector in a radio frequency (RF) mode that allows fast charge detection in a bandwidth of tens of megahertz. We find that the charge sensitivity of the RF-QPC is limited not by the noise of a secondary amplifier, but by non-equilibrium noise f the QPC itself. We have performed frequency-resolved measurements of the noise within a 10 MHz bandwidth around our carrier wave. When averaged over our bandwidth, we find that the noise is in good agreement with the theory of photon-assisted shot noise. Our measurements also reveal strong frequency dependence of the noise, asymmetry with respect to the carrier wave, the appearance of sharp local maxima that are correlated with mechanical degrees of freedom in the sample, and noise suppression indicative of many-body physics near the 0.7 structure.

arXiv:0708.0861•Aug 7, 2007•3 citations

Fast single-charge sensing with a rf quantum point contact

D. J. Reilly, Charles M. Marcus, Micah P. Hanson +1 more

We report high-bandwidth charge sensing measurements using a GaAs quantum point contact embedded in a radio frequency impedance matching circuit (rf-QPC). With the rf-QPC biased near pinch-off where it is most sensitive to charge, we demonstrate a conductance sensitivity of 5×10−6e2∕hHz−1∕2 with a bandwidth of 8MHz. Single-shot readout of a proximal few-electron double quantum dot is investigated in a mode where the rf-QPC back action is rapidly switched.

arXiv:0707.2946•Applied Physics Letters•Oct 15, 2007•295 citations

Real-time electron counting in semiconductor nanostructures

A. J. Rimberg, Madhu Thalakulam, Wei Dong Lu +3 more

By coupling a radio-frequency single-electron transistor (RF-SET) to a quantum dot (QD) in a GaAs/AlGaAs heterostructure, we have succeeded in detecting the tunneling of individual electrons on and off the QD on time scales as short as one microsecond. Using charge detection to probe the state of the QD allows us to nearly isolate the dot from its leads, thereby minimizing decoherence-inducing effects of the environment. We have extended these charge detection techniques to double quantum dots (DQDs) that can simultaneously be used to characterize the backaction of the RF-SET. The combined RF-SET/DQD system is well-suited to the development of charge- or spin-based quantum bits, and to investigation of the quantum measurement problem.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•May 18, 2005•0 citations

Single shot charge detection using a radio-frequency quantum point contact

Maja C. Cassidy, Andrew S. Dzurak, R. G. Clark +4 more

We report on charge sensing measurements of a GaAs semiconductor quantum dot device using a radio frequency quantum point contact (rf-QPC). The rf-QPC is fully characterized at 4K and millikelvin temperatures and found to have a bandwidth exceeding 20MHz. For single shot charge sensing, we achieve a charge sensitivity of ∼2×10−4e∕Hz referred to the neighboring dot’s charge. The rf-QPC compares favorably with rf single electron transistor electrometers and promises to be an extremely useful tool for characterizing and measuring semiconductor quantum systems on fast time scales.

arXiv:0907.1010•Applied Physics Letters•Nov 26, 2007•87 citations
Charge detection at microsecond time-scales has far reaching consequences in both technology and in our understanding of electron dynamics in nanoscale devices such as quantum dots. Radio-frequency superconducting single electron transistors (RF-SET) and quantum point contacts (QPC) are ultra sensitive charge sensors operating near the quantum limit. The operation of RF-SETs outside the superconducting gap has been a topic of study; the sub-gap operation, especially in the presence of large quantum fluctuations of quasiparticles remains largely unexplored, both theoretically and experimentally. We have investigated the effects of quantum fluctuations of quasiparticles on the operation of RF-SETs for large values of the quasiparticle cotunneling parameter alpha = 8EJ/Ec, where EJ and Ec are the Josephson and charging energies. We find that, for alpha > 1, sub-gap RF-SET operation is still feasible despite quantum fluctuations that wash out quasiparticle tunneling thresholds. Such RF-SETs show linearity and signal-to-noise ratio superior to those obtained when quantum fluctuations are weak, while still demonstrating excellent charge sensitivity.\nWe have operated a QPC charge detector in a radio frequency mode that allows fast charge detection in a bandwidth of several megahertz. The noise limiting the sensitivity of the charge detector is not the noise of a secondary amplifier, but the non-equilibrium device noise of the QPC itself. The noise power averaged over a measurement bandwidth of about 10MHz around the carrier frequency is in agreement with the theory of photon-assisted shot noise. Frequency-resolved measurements, however show several significant discrepancies with the theoretical predictions. The measurement techniques developed can also be used to investigate the noise of other semiconductor nanostructures such as quantum dots in the Kondo regime.\nA study of the noise characteristics alone can not determine whether the device is operating at the quantum limit; a characterization of back action is also necessary. The inelastic current through a double quantum dot system (DQD) is sensitive to the spectral density of voltage fluctuations in its electromagnetic environment. Electrical transport studies on a DQD system electrostatically coupled to an SET shows qualitative evidence of back-action of SET. The design and fabrication of a few electron DQD device with integrated RF-SET and QPC charge sensors for the study of back action of the sensors and real-time electron dynamics in the DQD are also discussed.
We have investigated the effects of quantum fluctuations of quasiparticles on the operation of superconducting radio-frequency single-electron transistors (rf-SETs) for large values of the quasiparticle cotunneling parameter alpha = 8EJ/Ec, where EJ and Ec are the Josephson and charging energies. We find that, for alpha > 1, subgap rf-SET operation is still feasible despite quantum fluctuations that wash out quasiparticle tunneling thresholds. Surprisingly, such rf-SETs show linearity and signal-to-noise ratio superior to those obtained when quantum fluctuations are weak, while still demonstrating excellent charge sensitivity.
The radio-frequency superconducting single electron transistor (RF-SET) is a highly sensitive and fast electrometer operating near the quantum limit. The back-action current noise of the SET induces voltage fluctuations on the system it is coupled to, dephasing its charge states. Here we propose to study the back action of the RF-SET by means of a double quantum dot (DQD) and, an RF-SET electrostatically coupled to one of the two dots. The inelastic current through the DQD is very sensitive to the spectral density of the voltage fluctuations in the nearby environment. By properly choosing the dot size and inter-dot tunnel barrier thickness, one can cause inelastic process to dominate the transport processes. A measurement of the inelastic current through the double dot system can then be used to calculate the spectral density of noise associated with the RF-SET and hence its back action. The design, fabrication and characterization of an RF-SET/DQD system is discussed in this work. Real-time studies of electron dynamics in coupled dots are also addressed.
We have operated a quantum point contact (QPC) charge detector in a radio frequency (RF) mode that allows fast charge detection in a bandwidth of tens of megahertz. We find that the charge sensitivity of the RF-QPC is limited not by the noise of a secondary amplifier, but by non-equilibrium noise f the QPC itself. We have performed frequency-resolved measurements of the noise within a 10 MHz bandwidth around our carrier wave. When averaged over our bandwidth, we find that the noise is in good agreement with the theory of photon-assisted shot noise. Our measurements also reveal strong frequency dependence of the noise, asymmetry with respect to the carrier wave, the appearance of sharp local maxima that are correlated with mechanical degrees of freedom in the sample, and noise suppression indicative of many-body physics near the 0.7 structure.
By coupling a radio-frequency single-electron transistor (RF-SET) to a quantum dot (QD) in a GaAs/AlGaAs heterostructure, we have succeeded in detecting the tunneling of individual electrons on and off the QD on time scales as short as one microsecond. Using charge detection to probe the state of the QD allows us to nearly isolate the dot from its leads, thereby minimizing decoherence-inducing effects of the environment. We have extended these charge detection techniques to double quantum dots (DQDs) that can simultaneously be used to characterize the backaction of the RF-SET. The combined RF-SET/DQD system is well-suited to the development of charge- or spin-based quantum bits, and to investigation of the quantum measurement problem.
We report on charge sensing measurements of a GaAs semiconductor quantum dot device using a radio frequency quantum point contact (rf-QPC). The rf-QPC is fully characterized at 4K and millikelvin temperatures and found to have a bandwidth exceeding 20MHz. For single shot charge sensing, we achieve a charge sensitivity of ∼2×10−4e∕Hz referred to the neighboring dot’s charge. The rf-QPC compares favorably with rf single electron transistor electrometers and promises to be an extremely useful tool for characterizing and measuring semiconductor quantum systems on fast time scales.