Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Institute of Physics eBooks

Spontaneous emission and optical gain

A F J Levi

Published May 1, 2025• 0 citations
Publisher
DOI
10.1088/978-0-7503-6417-1ch2

Related papers

Spontaneous emission and optical gain

A F J Levi

Morgan & Claypool Publishers eBooks•Jul 19, 2018•0 citations

Optical Amplification and Spontaneous Emission in an Ar + Discharge

Michael Harris, R. Loudon, Terence J. Shepherd +1 more

The relationship between optical amplification and spontaneous emission noise has been studied in an argon ion travelling wave amplifier by beat spectrum analysis. Different optical arrangements have been examined with both single and double pass amplification. The results establish that when coherent light travels through a gain tube, the amplified beam acquires intensity fluctuation noise which is greater than that of a Poissonian distribution (shot noise). The noise power is shown to be the same as that of an equivalent unamplified beam mixed with the amplified spontaneous emission from the gain tube. It is shown that such measurements provide a practical technique for the otherwise difficult determination of the degree of population inversion in the gain medium. They also give insight into the potential of optical amplifiers for enhancement of lidar and system performance.

Journal of Modern Optics•Jun 1, 1992•11 citations

Theory of optical-gain measurements

Peter S. Cross, William G. Oldham

The widely used technique for determining optical gain and absorption from single-pass, amplified spontaneous emission (ASE) is analyzed with particular attention given to active-volume saturation and three-dimensional effects. The results for homogeneously broadened media show that the population inversion and hence the gain in the active region is diminished by high levels of spontaneous and ASE. The externally measured gain is further reduced for large output collection apertures that admit incompletely amplified off-axis rays. Criteria are given for the excitation and detection geometries required to ensure accurate (∼10-percent) gain measurement. The simultaneous measurement of the equilibrium absorption coefficient can be made under less restrictive conditions.

IEEE Journal of Quantum Electronics•May 1, 1975•66 citations

Classical Aspects of Spontaneous Emission

ALBERT ROSE

WORLD SCIENTIFIC eBooks•Apr 1, 1989•0 citations

Spontaneous emission in microcavities

R. Loudon, M.J. Adams

The transverse distributions of intensity inside and outside an optical cavity produced by spontaneous emission from atoms inside the cavity are reviewed. The mode properties inside a closed passive one-dimensional cavity are summarised and the spatial distributions of emitted light for a passive cavity with partially transmitting mirrors are discussed. A qualitative theory describes the effects of an amplifying medium inside the cavity, covering the regimes both below and above the lasing threshold. Expressions are derived for the angular spread of the output light in the presence of gain. A theory based on rigorous general relations between gain and noise provides more complete results for the spontaneous emission noise from an amplifying slab within an optical cavity.

IET Optoelectronics•Dec 10, 2007•1 citation

Enhancement and inhibition of spontaneous emission

Geert L. J. A. Rikken

Physica B Condensed Matter•Jan 1, 1995•7 citations
The relationship between optical amplification and spontaneous emission noise has been studied in an argon ion travelling wave amplifier by beat spectrum analysis. Different optical arrangements have been examined with both single and double pass amplification. The results establish that when coherent light travels through a gain tube, the amplified beam acquires intensity fluctuation noise which is greater than that of a Poissonian distribution (shot noise). The noise power is shown to be the same as that of an equivalent unamplified beam mixed with the amplified spontaneous emission from the gain tube. It is shown that such measurements provide a practical technique for the otherwise difficult determination of the degree of population inversion in the gain medium. They also give insight into the potential of optical amplifiers for enhancement of lidar and system performance.
The widely used technique for determining optical gain and absorption from single-pass, amplified spontaneous emission (ASE) is analyzed with particular attention given to active-volume saturation and three-dimensional effects. The results for homogeneously broadened media show that the population inversion and hence the gain in the active region is diminished by high levels of spontaneous and ASE. The externally measured gain is further reduced for large output collection apertures that admit incompletely amplified off-axis rays. Criteria are given for the excitation and detection geometries required to ensure accurate (∼10-percent) gain measurement. The simultaneous measurement of the equilibrium absorption coefficient can be made under less restrictive conditions.
The transverse distributions of intensity inside and outside an optical cavity produced by spontaneous emission from atoms inside the cavity are reviewed. The mode properties inside a closed passive one-dimensional cavity are summarised and the spatial distributions of emitted light for a passive cavity with partially transmitting mirrors are discussed. A qualitative theory describes the effects of an amplifying medium inside the cavity, covering the regimes both below and above the lasing threshold. Expressions are derived for the angular spread of the output light in the presence of gain. A theory based on rigorous general relations between gain and noise provides more complete results for the spontaneous emission noise from an amplifying slab within an optical cavity.