Quantum phase transitions occur at zero temperature driven by quantum fluctuations instead of thermal fluctuations. They take place due to competing ground state phases that are accessible for different values of certain non-thermal parameters such as coupling constants, pressure or magnetic field. The chapter starts with a discussion of the main phenomenological features of this class of non-thermal transitions. In particular, it is argued that traces of these transitions can be detected at finite (but low) temperature. Then, examples of materials that show this behaviour are provided. Finally, the quantum Ising model is discussed and it is shown that a quantum model in d dimensions can be mapped to a classical model in d+1 dimensions.
Quantum phase transitions occur at zero temperature driven by quantum fluctuations instead of thermal fluctuations. They take place due to competing ground state phases that are accessible for different values of certain non-thermal parameters such as coupling constants, pressure or magnetic field. The chapter starts with a discussion of the main phenomenological features of this class of non-thermal transitions. In particular, it is argued that traces of these transitions can be detected at finite (but low) temperature. Then, examples of materials that show this behaviour are provided. Finally, the quantum Ising model is discussed and it is shown that a quantum model in d dimensions can be mapped to a classical model in d+1 dimensions.
In recent years, quantum phase transitions have attracted the interest of both theorists and experimentalists in condensed matter physics. These transitions, which are accessed at zero temperature by variation of a non-thermal control parameter, can influence the behaviour of electronic systems over a wide range of the phase diagram. Quantum phase transitions occur as a result of competing ground state phases. The cuprate superconductors which can be tuned from a Mott insulating to a d -wave superconducting phase by carrier doping are a paradigmatic example. This review introduces important concepts of phase transitions and discusses the interplay of quantum and classical fluctuations near criticality. The main part of the article is devoted to bulk quantum phase transitions in condensed matter systems. Several classes of transitions will be briefly reviewed, pointing out, e.g., conceptual differences between ordering transitions in metallic and insulating systems. An interesting separate class of transitions is boundary phase transitions where only degrees of freedom of a subsystem become critical; this will be illustrated in a few examples. The article is aimed at bridging the gap between high-level theoretical presentations and research papers specialized in certain classes of materials. It will give an overview on a variety of different quantum transitions, critically discuss open theoretical questions, and frequently make contact with recent experiments in condensed matter physics.
Introduction In the limit of zero temperature, the partition function is dominated by the ground state of the system, the free energy becomes equivalent to the ground state energy, and the central object of interest is the Hamiltonian of the system H (λ), dependent in general on one or more parameters λ. A ‘quantum’ Hamiltonian, as noted previously, is one which contains non-commuting operators. Here we concentrate on quantum spin Hamiltonians, of which the prime example is the Heisenberg model. Of particular interest is the possibility of a quantum phase transition , i.e. nonanalytic behaviour as a function of coupling λ. A quantum phase transition may exert a dominating influence on the system over a range of low temperatures above T = 0. Such phenomena have figured prominently in theoretical discussions of experiments on the cuprate superconductors, the heavy fermion materials, organic conductors, and related materials (e.g. Sachdev, 1999). In some cases, a correspondence can be found between a quantum system at zero temperature in 1 time and ( d – 1) space dimensions, and an equivalent classical system at finite temperature in d space dimensions, based on the Feynman path integral formalism – see Chapter 9 and Appendix 8 for further discussions. Under this mapping, the temperature kT in the classical system corresponds to a coupling λ in the equivalent quantum system. If a phase transition occurs, the same universal critical exponents are expected to apply in both cases.
At a quantum critical point the ground state of a many-particle quantum system undergoes a phase transition when some control parameters such as pressure, magnetic field, or chemical composition is varied. The universal behaviour characteristic for such quantum phase transitions often affects a wide temperature range and gives rise to novel material properties. This chapter gives a short overview over five lectures held during the Les Houches summer school ‘Quantum theory from small to large scales’ in 2010. After an introductory chapter, field driven magnetic quantum phase transitions of insulators are used as an example to discuss some of the concepts underlying quantum phase transitions. Both experimentally and theoretically, quantum phase transitions in metals are much less understood compared to insulating systems. After a brief review of the standard approach to describe those systems, the importance of multiple time scales and associated multiple critical exponents z are discussed. Finally, emergent gauge theories close to critical points are investigated. As an example, it discusses why a gauge theory describes the (classical) phase transitions of a nematic, if topological defects are suppressed.
The dynamical critical exponent is introduced. The phase diagram and the phase transitions in the Bose–Hubbard model of interacting bosons on a lattice are determined. The concept of quantum fluctuations is introduced on the example of an interacting superfluid, and finally the special scaling of conductivity is discussed. Dynamical critical exponent The finite temperature phase transitions studied in previous chapters are the result of the competition between the entropy and the energy terms in the free energy: the weight of entropy increases with temperature, and ultimately destroys the order that may be existing in the system. A sharp phase transition between two phases exhibiting qualitatively different correlations may, however, occur even at zero temperature, by varying a coupling constant in the Hamiltonian. The transition then corresponds to a non-analyticity of the energy of the ground state. A simple example is provided by the interacting bosons, where the superfluid transition may be brought about by tuning the chemical potential at T = 0. Such T = 0 phase transitions are called quantum phase transitions , and will be the subject of the present chapter. In general, a quantum phase transition may lie at the end of a line of thermal phase transitions, as in the bosonic example mentioned above. It is possible, however, that the system may not even have an ordered state at finite temperatures, but still exhibits a quantum critical point. Two different situations are depicted in Fig. 8.1. Examples of such phase diagrams are provided by the system of interacting bosons which will be discussed in Sections 8.2 and 8.3.
Quantum phase transitions are sudden changes in the ground-state wavefunction of a many-body system that can occur as a control parameter such as a concentration or a field strength is varied. They are driven purely by the competition between quantum fluctuations and mutual interactions among constituents of the system, not by thermal fluctuations; hence they can occur even at zero temperature. Examples of quantum phase transitions in many-body physics may be found in systems ranging from high-temperature superconductors to topological insulators. A quantum phase transition usually can be characterized by nonanalyticity/discontinuity in certain order parameters or divergence of the ground state energy eigenvalue and/or its derivatives with respect to certain physical quantities. Here in a circular one-dimensional spin model with Heisenberg XY interaction and no magnetic field, we observe critical phenomena for the n0=1/N→0 Mott insulator caused by a qualitative change of the boundary condition. We demonstrate in the vicinity of the transition point a sudden change in ground-state properties accompanied by an avoided level-crossing between the ground and the first excited states. Notably, our result links conventional quantum phase transitions to microscopic boundary conditions, with significant implications for quantum information, quantum control, and quantum computing.
Quantum Phase Transitions Quantum phase transitions, in contrast to temperature-driven critical phenomena, occur due to a competition between different parameters describing the basic interactions of the system. Their specific feature is the quantum character of the critical fluctuations. This implies, through the uncertainty principle, that energy fluctuations and time are coupled. Then at zero temperature time plays a crucial and fundamental role, the static properties being entangled with the dynamics (Continentino, 1994a; Sondhi et al ., 1997; Sachdev, 1999). In this book we are mainly interested in quantum phase transitions that occur in electronic many-body systems and how scaling concepts can be useful to understand their properties close to these transitions (Continentino, 1994a). Even though a similar approach has been used in the case of interacting bosons (Fisher et al ., 1989) the fermionic problem has its own idiosyncrasies and difficulties. For example, there is no natural order parameter associated with the localisation transition in the electronic case, while bosons at zero temperature are either localised or superfluid so that the superfluid order parameter can be used to distinguish between both phases. If the results of the study of quantum phase transitions were restricted to zero temperature, this would be an interesting but purely academic area of research. What is really exciting about this subject is the effect of quantum critical points (QCP) in the finite temperature phase diagram of actual physical systems, even far away from the QCP (Freitas, 2015). As we will show, there is a special line in this phase diagram, the quantum critical trajectory , where the temperature dependence of the thermodynamic and transport properties is governed by the quantum critical exponents, i.e. those associated with the QCP. This and the observed crossover effects induced by temperature in the non-critical side of the phase diagram of a material with a QCP are sufficient to make the study of quantum phase transitions an inevitable subject. We start this chapter by introducing the scaling theory of quantum critical phenomena, since scaling concepts are used throughout this book.