International Conference on Photonics Solutions (ICPS)

Characteristic of single Cooper pair transistor used as sensitive supercurrent sensor

Jutarat Tanarom, Ploybussara Gomasang

Published Feb 19, 2025• 0 citations

Abstract

The characteristics of the single Cooper pair transistor, a key component of single-charge electronics that manipulates single or Cooper pair electrons via the Coulomb blockade phenomenon, are discussed in this article. Due to these characteristics, the single Cooper pair transistor plays an important role in metrology such as sensitive electrometry and quantum computing. Electron beam lithography and electron gun evaporation are used to fabricate the single Cooper pair transistor. The measurement is performed at lower temperatures than 100 mK by using a dilution refrigerator. It has been found that only the tunneling of Cooper pairs of electrons is shown by the relationship between the gate voltage and the supercurrent. It indicates that a single Cooper pair transistor can be used as a sensitive sensor when integrated into other devices, exhibiting the tunneling properties of Cooper pairs at 16 GHz.

DOI: 10.1117/12.3058348

Related papers

The simulation of single cooper pair trasistor for megnetic flux detector

Jutarat Tanarom

This article presents a study on the characteristics of single Cooper-pair transistors when integrated into a Superconducting Quantum Interface Device (SQUID) circuit. SQUID is a highly sensitive magnetometer that uses phase balance checks through single Cooper-pair transistors when Josephson currents flow. The study explores the tuning of the supercurrent of the single Cooper-pair transistors in a circuit with a loop coupled to gate voltage. Understanding the behavior of single Cooper-pair transistors in this loop structure is crucial for integrating them with other superconducting electronic circuits. The research includes simulations of the single Cooper-pair transistor in one branch of a SQUID loop circuit. The simulation results indicate that single Cooper-pair transistors can be used as superconducting current switches.

Thailand Electrical Engineering Journal (TEEJ)Nov 13, 20240 citations

Cooper-pair resonances and subgap Coulomb blockade in a superconducting single-electron transistor

J. Jussi Toppari, Thomas Kühn, Ari Halvari +3 more

We have fabricated and measured superconducting single-electron transistors with Al leads and Nb islands. At bias voltages below the gap of Nb we observe clear signatures of resonant tunneling of Cooper pairs, and of Coulomb blockade of the subgap currents due to linewidth broadening of the energy levels in the superconducting density of states of Nb. The experimental results are in good agreement with numerical simulations.

arXiv:cond-mat/0311148Physical Review BNov 21, 200720 citations

The single Cooper pair transistor: a macroscopic quantum system

P. Joyez

In a system where two small-area (100 nm x 100 nm) superconducting tunnel junctions are connected in series, the Josephson effect which tends to impose the phase competes with the charging effects in the central electrode (the of the device) which tend to set the charge of the island. By applying a voltage on an electrode capacitively coupled to the island (the electrode) one can arbitrate this competition in favour of either effect. This is can be seen in particular on the supercurrent which can flow through the junctions : it is modulated periodically by the gate voltage (hence the name of given to the system). This modulation shows sharp peaks when two charge states of the island are degenerate with respect to the electrostatic energy. The system is then in a state which has no classical description : it is in a coherent superposition of states. In this thesis we demonstrate experimentally the behaviour of this transistor and we analyse the theoretical and practical problems which can prevent the observation of the coherent superposition of states through the modulation of the supercurrent. In particular we show that the parity of the electron number in the island must be rigorously controlled and that the impedance connected to the circuit plays a crucial role in setting the magnitude of the measured supercurrent.

Mar 6, 19956 citations

The Single Cooper Pair Box - a Quantum-Mechanical Electronic Circuit

David Gunnarsson

In this thesis the single Cooper pair box (SCB) is investigated with a radio frequency single electron transistor (RF-SET). The RF-SET is used as an electrometer to detect the charge of the SCB. The SCB can be regarded as a quantum two-level system and could therefore be a possible qubit. Both the SCB and the RF-SET have been fabricated with e-beam lithography followed by two-angle shadow evaporation of aluminium. The system has been measured in a dilution refrigerator at temperatures of ~30 mK. A charge sensitivity of 2.3 μe/square root of Hz was measured for an optimized RF-SET with a bandwidth of 7 MHz, operated in the superconducting state. In a phase sensitive measurement of the RF-SET reflected signal, the gate dependence of the quantum capacitance, due to avoided level crossing, was detected in a superconducting SET. Coulomb staircases for the SCB were obtained by changing the charge of the SCB by ramping a gate voltage and continuously measuring the charge with the RF-SET. To prevent quasiparticle poisoning of the SCB island, we have used a method of graded gaps. Here we exploit the greater reduction of the superconducting gap for the connecting leads with an external magnetic field applied, resulting in a higher gap for the island. This creates an effective barrier against quasiparticle tunnelling. The charging energy and the Josephson coupling energy of the SCB were measured with microwave spectroscopy. The SCBs were fabricated in a SQUID geometry, which made it possible to tune the Josephson coupling energy of the box. This tuning was verified through microwave spectroscopy. The effect of tuning could also be seen in the pure 2e Coulomb staircase, as a predicted smearing of the staircase, which was in excellent agreement with the independent spectroscopy data. Coherent quantum oscillation of the SCB charge state was measured by applying nonadiabatic DC-pulses to the SCB gate. The measured amplitude of the charge oscillations was higher than 70%. The deviation from 100% can be explained by the initial charge state purity and the finite rise time of the pulses. The longest decoherence time of the charge oscillations was T2 = 9 ns at the charge degeneracy point. It was found to be limited by relaxation. Away from the degeneracy point the decoherence time was limited by pure dephasing, due to low frequency charge fluctuators.

Jan 1, 20050 citations

Sensitive phonon detection using a single Cooper-pair transistor

Jutarat Tanarom, Takuma Watanabe, Yoshinao Mizugaki +1 more

Abstract We demonstrate that the supercurrent branch of a single Cooper-pair transistor (SCPT) can be used for sensitive phonon detection. We built a theoretical model of phonon detection based on quasiparticle poisoning and demonstrated its operation with an SCPT and a superconducting quantum interference device as a phonon source both composed of mesoscopic Al/AlO x /Al junctions. The sensitivity of the SCPT detector turned out to be approximately 103 times as high as that of the traditional superconducting-tunnel-junction detector.

Applied Physics ExpressApr 21, 20224 citations

Towards Single Shot Measurements of a Cooper Pair Box Qubit Using an RF Single Electron Transistor

Carlos Alberto Sánchez

I report an investigation into using an rf Single Electron Transistor (rf-SET) to implement single shot readout of the quantum state of a Cooper pair box. I fabricated Al/AlOx/Al SETs and Cooper pair boxes using e-beam lithography and double-angle evaporation. The devices had typical charging energies of about 1 K and were measured at 30 mK in a dilution refrigerator. I built rf-SETs with an LC resonant circuit integrated on the chip and operating frequencies of 650 MHz and 1.5 GHz. The rf-SETs had a typical bandwidth of 30 MHz and the best achieved charge sensitivity was 8X10-6 erms/(Hz)1/2 at 1.5 GHz. The rf-SETs were used to measure the Coulomb staircase on the Cooper pair box. Measurements of the staircase show features due to quasiparticle poisoning that are dependent on temperature and SET bias. The data was compared to a theory I developed to extend existing theories of quasiparticle poisoning. My model is based on the calculation of tunneling rates to explain observations of parity effects in the Cooper pair box over a wide temperature range. Quantum state control of the Cooper pair box was demonstrated by using fast voltage pulses applied to the gate. Temporal oscillations of charge states and spectroscopy measurements reveal a dephasing time T2=200 ps at 30 mK, for a drive frequency of 30 GHz. The energy relaxation time T1=140 ns was determined from time domain measurements of the decay of the Cooper pair box charge. The fidelity of single shot measurements and the feasibility of this quantum readout scheme based on the results are discussed.

Dec 5, 20050 citations