Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Applied Superconductivity

Study on Mid-Infrared Photon Detector Using Hot Electron Bolometer With Phased Array Antenna

Akira Kawakami, Hisashi Shimakage, Junsei Horikawa, Shingo Saito, Norihiko Sekine, Shukichi Tanaka

Published Nov 19, 2024• 0 citations
Publisher

Abstract

As a high-speed and sensitive mid-infrared (MIR) photon detector, we have studied an MIR superconducting hot electron bolometer (MIR-HEB) with a twin slot-antenna. MIR HEBs have been fabricated; it has been demonstrated that HEBs respond to MIR photons with a response time of a few nanoseconds. However, the effective area of the twin slot-antenna was measured as only approximately 6.3 µm2at 66 THz. Therefore, we attempted to expand the area by making it a phased array. The fabricated antenna consists of multiple slot-antennas, MSL circuits, and a load resistor of niobium nitride (NbN) thin film, and the antenna effective areas were evaluated from the absorption rate in the reflection spectrum using an FTIR microscope. The effective area of the antenna consisting of 4 × 4 slot-antennas was estimated to be approximately 48 µm2at 66 THz. We also fabricated prototype MIR-HEBs equipped with a phased array antenna and evaluated its dc-characteristics.

DOI
10.1109/tasc.2024.3502318

Related papers

Examination of Mid-Infrared Photon Detection by Hot Electron Bolometer With Twin Slot Antenna

Akira Kawakami, Junsei Horikawa, Hisashi Shimakage +2 more

As a high-speed and sensitive mid-infrared (MIR) photon detector, we developed a MIR superconducting hot electron bolometer (MIR-HEB). The MIR-HEB consists of a twin-slot MIR-wavelength antenna and a small Nb/NbN superconducting strip located at the antenna's feeding point. To prevent the HEB from latching, a parallel shunt resistor was added. For detector evaluation, a continuous-wave quantum cascade laser with a wavelength of 4.57 μm was used as the source of MIR light. A constant bias current was applied near the HEB critical current during the detector operation. Upon illumination with MIR light, numerous voltage pulses with a width of approximately 4 ns were observed. Furthermore, it was demonstrated that the pulse count rates were nearly proportional to the incident power over a two-order magnitude range. We conclude that MIR-HEB achieved MIR photon detection based on this result. Also confirmed were the polarization dependences attributed to the antenna's operation.

IEEE Transactions on Applied Superconductivity•Feb 28, 2023•1 citation

Fast response of superconducting hot-electron bolometers with a twin-slot nano-antenna for mid-infrared operation

Akira Kawakami, Hisashi Shimakage, Junsei Horikawa +4 more

In this study, the use of nano-antennas to improve the response performance of infrared detectors is proposed, and the design and fabrication of antennas that operate in the infrared range is demonstrated. Prototypes of a mid-infrared superconducting hot-electron bolometer (HEB) formed by a twin-slot antenna with a niobium nitride strip were fabricated. When the bolometer was irradiated with mid-infrared (λ = 4.89 μm) pulsed light, responses with clear polarization dependency were observed. When the HEB was biased close to the critical current under mid-infrared pulsed light irradiation, the detector output synchronized with the trigger signal was observed. The output waveforms comprised voltage pulse trains, and the full width at half maximum of the pulse was evaluated to be approximately 0.3 ns.

AIP Advances•Dec 1, 2016•4 citations

Design and Fabrication for the Construction of MIR HEB Mixers

Akira Kawakami, Hisashi Shimakage, Junsei Horikawa +4 more

In order to design antennas for mid-infrared (MIR) hot electron bolometers (HEBs), the surface impedance of Au thin films at cryogenic temperatures was evaluated using Fourier transform infrared spectroscopy with a sample cooling system. We fabricated resonator arrays that were constructed by gold thin film strips. The length, width, and thickness of the resonators were set at 1300, 200, and 55 nm, respectively. As the temperature was lowered, the resonant frequency was shifted to the low-frequency side. By fitting the resonant frequency to simulated results, the corrected surface reactance was established for designing MIR nano-antennas. MIR HEBs with a twin-slot antenna were designed and fabricated using the corrected surface impedance. The design frequency was 61 THz. The HEBs were formed as a superconducting strip with Au antennas and electrodes. Here, the superconductivity under the Au electrodes was suppressed by a Ni thin film. For evaluating the mixer properties of the MIR HEBs, measurement setup without beam splitter was constructed. In this setup, local oscillator power was applied directly to the HEB, and we confirmed that the critical current of the HEB can be reduced to be almost zero by the LO irradiation. The HEB responses with clear polarization dependencies were also observed.

IEEE Transactions on Applied Superconductivity•Nov 30, 2016•7 citations

Response properties of superconducting mid-infrared detectors with a nano-antenna

Akira Kawakami, Hisashi Shimakage, Junsei Horikawa +4 more

We have proposed using nano-antennas to improve the response performance of infrared detectors. Prototypes of mid-infrared superconducting hot electron bolometer formed by a twin-slot-antenna with an NbN strip were fabricated. By the irradiation of mid-infrared (λ=4.89 μm) pulsed light, clear polarization dependency of responses was observed. When the HEB was biased close to the critical current, the detector output synchronized with the trigger signal was observed. The output waveforms were composed of voltage pulse trains, and the half width of the pulse was evaluated about 0.3 nsec.

International Conference on Infrared, Millimeter, and Terahertz Waves (IRMMW-THz)•Sep 1, 2016•0 citations

Performance of a 1.4 THz Twin-Slot Superconductivity Hot Electron Bolometer Mixer

Daowei Wang, Kangmin Zhou, Yuan Ren +3 more

Three observation bands are planned for the Dome A Terahertz Explorer (DATE5), with the superconducting hot-electron bolometer (HEB) served as the mixer for the H200 band ( 200 μm wavelength). In this paper, the performance of a twin-slot antenna coupled superconducting NbN HEB mixer is fully characterized at 1.34 THz. The measured uncorrected receiver noise temperature is 500 K and the intermediate frequency (IF) noise bandwidth is about 3 GHz. Moreover, the receiver stability is characterized by measuring the Allan variance time.

International Conference on Microwave and Millimeter Wave Technology (ICMMT)•May 1, 2018•0 citations

Terahertz Direct Detection Behavior of a Superconducting NbN bolometer by Noise Thermometry

Hao Gao, Wei Miao, Kangmin Zhou +1 more

In this paper, we report the investigation of direct detection behavior of a superconducting niobium nitride (NbN) hot electron bolometer (HEB) based on noise thermometry. The HEB consists of a microbridge made from 5.5 nm thick NbN film and a twin slot antenna for radiation coupling. In the microbridge, hot electron system is generated after radiation pumping and it creates extra noise at RF frequencies. We measured the response of the noise at 0.5-1.8 GHz and the noise equivalent power (NEP) of the superconducting NbN HEB at different bias voltages. The measurement result shows that the superconducting NbN HEB has a noise equivalent power of 1.24×10-12W/Hz1/2at its optimal bias point. We also compared the noise equivalent power measured by noise thermometry at two different readout bandwidths. The measured results are found to be in good agreement with the theoretical one.

International Conference on Infrared, Millimeter, and Terahertz Waves (IRMMW-THz)•Sep 1, 2019•0 citations
As a high-speed and sensitive mid-infrared (MIR) photon detector, we have studied an MIR superconducting hot electron bolometer (MIR-HEB) with a twin slot-antenna. MIR HEBs have been fabricated; it has been demonstrated that HEBs respond to MIR photons with a response time of a few nanoseconds. However, the effective area of the twin slot-antenna was measured as only approximately 6.3 µm2at 66 THz. Therefore, we attempted to expand the area by making it a phased array. The fabricated antenna consists of multiple slot-antennas, MSL circuits, and a load resistor of niobium nitride (NbN) thin film, and the antenna effective areas were evaluated from the absorption rate in the reflection spectrum using an FTIR microscope. The effective area of the antenna consisting of 4 × 4 slot-antennas was estimated to be approximately 48 µm2at 66 THz. We also fabricated prototype MIR-HEBs equipped with a phased array antenna and evaluated its dc-characteristics.
As a high-speed and sensitive mid-infrared (MIR) photon detector, we developed a MIR superconducting hot electron bolometer (MIR-HEB). The MIR-HEB consists of a twin-slot MIR-wavelength antenna and a small Nb/NbN superconducting strip located at the antenna's feeding point. To prevent the HEB from latching, a parallel shunt resistor was added. For detector evaluation, a continuous-wave quantum cascade laser with a wavelength of 4.57 μm was used as the source of MIR light. A constant bias current was applied near the HEB critical current during the detector operation. Upon illumination with MIR light, numerous voltage pulses with a width of approximately 4 ns were observed. Furthermore, it was demonstrated that the pulse count rates were nearly proportional to the incident power over a two-order magnitude range. We conclude that MIR-HEB achieved MIR photon detection based on this result. Also confirmed were the polarization dependences attributed to the antenna's operation.
In this study, the use of nano-antennas to improve the response performance of infrared detectors is proposed, and the design and fabrication of antennas that operate in the infrared range is demonstrated. Prototypes of a mid-infrared superconducting hot-electron bolometer (HEB) formed by a twin-slot antenna with a niobium nitride strip were fabricated. When the bolometer was irradiated with mid-infrared (λ = 4.89 μm) pulsed light, responses with clear polarization dependency were observed. When the HEB was biased close to the critical current under mid-infrared pulsed light irradiation, the detector output synchronized with the trigger signal was observed. The output waveforms comprised voltage pulse trains, and the full width at half maximum of the pulse was evaluated to be approximately 0.3 ns.
In order to design antennas for mid-infrared (MIR) hot electron bolometers (HEBs), the surface impedance of Au thin films at cryogenic temperatures was evaluated using Fourier transform infrared spectroscopy with a sample cooling system. We fabricated resonator arrays that were constructed by gold thin film strips. The length, width, and thickness of the resonators were set at 1300, 200, and 55 nm, respectively. As the temperature was lowered, the resonant frequency was shifted to the low-frequency side. By fitting the resonant frequency to simulated results, the corrected surface reactance was established for designing MIR nano-antennas. MIR HEBs with a twin-slot antenna were designed and fabricated using the corrected surface impedance. The design frequency was 61 THz. The HEBs were formed as a superconducting strip with Au antennas and electrodes. Here, the superconductivity under the Au electrodes was suppressed by a Ni thin film. For evaluating the mixer properties of the MIR HEBs, measurement setup without beam splitter was constructed. In this setup, local oscillator power was applied directly to the HEB, and we confirmed that the critical current of the HEB can be reduced to be almost zero by the LO irradiation. The HEB responses with clear polarization dependencies were also observed.
We have proposed using nano-antennas to improve the response performance of infrared detectors. Prototypes of mid-infrared superconducting hot electron bolometer formed by a twin-slot-antenna with an NbN strip were fabricated. By the irradiation of mid-infrared (λ=4.89 μm) pulsed light, clear polarization dependency of responses was observed. When the HEB was biased close to the critical current, the detector output synchronized with the trigger signal was observed. The output waveforms were composed of voltage pulse trains, and the half width of the pulse was evaluated about 0.3 nsec.
Three observation bands are planned for the Dome A Terahertz Explorer (DATE5), with the superconducting hot-electron bolometer (HEB) served as the mixer for the H200 band ( 200 μm wavelength). In this paper, the performance of a twin-slot antenna coupled superconducting NbN HEB mixer is fully characterized at 1.34 THz. The measured uncorrected receiver noise temperature is 500 K and the intermediate frequency (IF) noise bandwidth is about 3 GHz. Moreover, the receiver stability is characterized by measuring the Allan variance time.
In this paper, we report the investigation of direct detection behavior of a superconducting niobium nitride (NbN) hot electron bolometer (HEB) based on noise thermometry. The HEB consists of a microbridge made from 5.5 nm thick NbN film and a twin slot antenna for radiation coupling. In the microbridge, hot electron system is generated after radiation pumping and it creates extra noise at RF frequencies. We measured the response of the noise at 0.5-1.8 GHz and the noise equivalent power (NEP) of the superconducting NbN HEB at different bias voltages. The measurement result shows that the superconducting NbN HEB has a noise equivalent power of 1.24×10-12W/Hz1/2at its optimal bias point. We also compared the noise equivalent power measured by noise thermometry at two different readout bandwidths. The measured results are found to be in good agreement with the theoretical one.