Matter-wave interferometers show great a potential for improving inertial sensing. The absence of drifts recommends them for a variety of applications in geodesy, navigation, or fundamental physics. Here, ultracold atomic ensembles, featuring a velocity distribution well below the photon recoil velocity, open up new perspectives. In contrast to standard laser cooling methods, they allow to reach better beam-splitting efficiencies and, hence, a higher contrast as well as to reduce systematic uncertainties and biases. Presently, Bose-Einstein condensates (BECs) provide the means to achieve the lowest expansion energies of few picokelvin. Indeed, the momentum distribution of a BEC can be further narrowed after reaching the regime of ballistic expansion, where all mean field energy is converted to kinetic energy, by the application of the delta-kick collimation technique. With such ensembles, Bragg processes can be driven with an efficiency of above 95% as well as Bloch oscillations performed without large atomic losses or dephasing. Both enable efficient large momentum transfer in interferometers to enhance their sensitivity for inertial effects. In a so-called twin-lattice atom interferometers more than thousand photon recoils are used to form compact but sensitive atom interferometers. These methods not only bring in reach extremely accurate gravimeters and accelerometers but also gyroscopes. Like the Sagnac effect in ring laser or fiber gyroscopes, the sensitivity of atom interferometers to rotations increases with the space-time area enclosed by the interferometer. In the case of light interferometers, the latter can be enlarged by forming multiple fiber loops. However, the equivalent for matter-wave interferometers remains an experimental challenge. An atom interferometer with scalable area may be formed in a twin lattice combined with a relaunch mechanism to obtain multi loops as well. Due to this scalability, it offers the perspective of reaching unprecedented sensitivities for rotations in comparably compact sensor head setups. Moreover, atom-chip technologies offer the possibility to generate a BEC and perform delta-kick collimation in a fast and reliable away, paving the way for field-deployable miniaturized atomic devices. Last but not least, the extremely low expansion energies of BECs open up to extend the time atoms spend in the interferometer to tens of seconds. This brings in reach unprecedented sensitivities in space-borne applications such as satellite geodesy.
Matter-wave interferometers show great a potential for improving inertial sensing. The absence of drifts recommends them for a variety of applications in geodesy, navigation, or fundamental physics. Here, ultracold atomic ensembles, featuring a velocity distribution well below the photon recoil velocity, open up new perspectives. In contrast to standard laser cooling methods, they allow to reach better beam-splitting efficiencies and, hence, a higher contrast as well as to reduce systematic uncertainties and biases. Presently, Bose-Einstein condensates (BECs) provide the means to achieve the lowest expansion energies of few picokelvin. Indeed, the momentum distribution of a BEC can be further narrowed after reaching the regime of ballistic expansion, where all mean field energy is converted to kinetic energy, by the application of the delta-kick collimation technique. With such ensembles, Bragg processes can be driven with an efficiency of above 95% as well as Bloch oscillations performed without large atomic losses or dephasing. Both enable efficient large momentum transfer in interferometers to enhance their sensitivity for inertial effects. In a so-called twin-lattice atom interferometers more than thousand photon recoils are used to form compact but sensitive atom interferometers. These methods not only bring in reach extremely accurate gravimeters and accelerometers but also gyroscopes. Like the Sagnac effect in ring laser or fiber gyroscopes, the sensitivity of atom interferometers to rotations increases with the space-time area enclosed by the interferometer. In the case of light interferometers, the latter can be enlarged by forming multiple fiber loops. However, the equivalent for matter-wave interferometers remains an experimental challenge. An atom interferometer with scalable area may be formed in a twin lattice combined with a relaunch mechanism to obtain multi loops as well. Due to this scalability, it offers the perspective of reaching unprecedented sensitivities for rotations in comparably compact sensor head setups. Moreover, atom-chip technologies offer the possibility to generate a BEC and perform delta-kick collimation in a fast and reliable away, paving the way for field-deployable miniaturized atomic devices. Last but not least, the extremely low expansion energies of BECs open up to extend the time atoms spend in the interferometer to tens of seconds. This brings in reach unprecedented sensitivities in space-borne applications such as satellite geodesy.
Matter-wave interferometers show great a potential for improving inertial sensing. The absence of drifts recommends them for a variety of applications in geodesy, navigation, or fundamental physics. Atom interferometry offers an interesting perspective for the detection of gravitational waves in the frequency band between eLISA and Advanced LIGO. A key feature to reach the targeted sensitivities for these devices is large momentum transfer. Optical lattices are ideal tools to transfer large number of photon recoils onto atoms for interferometry. We demonstrate twin-lattice atom interferometers with up to 1632 photon recoils at a maximum splitting of 408 photon recoils. To reach these large momentum splittings while maintaining interferometric contrast, we utilize delta-kick collimated Bose-Einstein condensates generated on an atom-chip. Twin-lattice interferometers might open up new perspective for a variety of applications using compact atom interferometer geometries.
Inertial sensors based on cold atoms have great potential for navigation, geodesy, or fundamental physics. Similar to the Sagnac effect, their sensitivity increases with the space-time area enclosed by the interferometer. Here, we introduce twin-lattice atom interferometry exploiting Bose-Einstein condensates of rubidium-87. Our method provides symmetric momentum transfer and large areas offering a perspective for future palm-sized sensor heads with sensitivities on par with present meter-scale Sagnac devices. Our theoretical model of the impact of beam splitters on the spatial coherence is highly instrumental for designing future sensors.
Ultra-cold atoms have become indispensable in quantum sensing, quantum computing, and quantum communication applications, as well as in fundamental sciences. In quantum sensing, they enable precision measurements with outstanding sensitivities that can be of great benefit in navigation, geodesy, and fundamental physics applications. The sensitivity of the atom interferometers used herefore typically scales with the square of the interrogation time. Therefore, in atom interferometric measurements, one seeks ensembles that feature a particularly low internal kinetic energy and can thus be detected after a long time-of-flight. The lowest values are achieved using Bose-Einstein condensates in conjunction with delta-kick collimation, a technique for the collimation of the atomic wave function. Bose-Einstein condensation can be achieved using a multi-stage laser cooling scheme, followed by evaporative cooling, which finally brings the temperature down to the critical temperature, typically in the nanokelvin regime. In addition to the low thermal spread, microgravity enables particularly long observation times, as it avoids limitations of the interrogation time due to vacuum chamber constraints, which are present when falling freely under the influence of gravity. Additionally, microgravity enables measurements that are not possible under normal gravity conditions, such as buoyancy-free miscibility studies, truly uniform potentials, and advanced cold atom quantum memories, which are projected to feature unprecedented time-bandwidth products. For the preparation of a Bose-Einstein condensate, two techniques are widely used in science, namely magnetic traps and optical dipole traps. For microgravity missions, magnetic traps on atom chips have been used in nearly all setups so far due to their particularly low SWAP budget and high cold atom flux. In contrast, ground-based experiments often prefer optical traps due to their higher versatility, full optical access, and the absence of surfaces in proximity to the atoms, which is fundamental for precision measurements. Additionally, optical traps enable the manipulation of intra- and inter-species scattering lengths using Feshbach resonances. Compared to atom chip traps, they also feature an intrinsically better symmetry of the trapping potential, in theory leading to fewer aberrations in matter-wave optics. The latter could enable the generation of ensembles in the yet unreached femtokelvin regime using delta-kick collimation with fewer perturbations. This thesis is about the realization of a 1064nm optical dipole trap set up for the microgravity environment of the Bremen Drop Tower. It aims to highlight the advantages of optical traps in conjunction with microgravity and prepare optical trapping technology for use in future microgravity and space missions. The thesis describes the experimental setup, the direct loading process, the characterization of the optical potential, and the optimization and investigation of the evaporative cooling in the optical dipole trap. For the evaporation process, the influence of gravity is comprehensively investigated through analytical calculations and microgravity tests. Bose-Einstein condensation is demonstrated, proving the achievement of condensation through absorption imaging of the spatial distribution, tests on the free evolution of the ensemble, and investigation of the phase-space densities achieved. Up to (74 ± 4)% condensation of an ensemble featuring (30 000 ± 13 000) atoms at a kinetic temperature of (37 ± 3) nK is demonstrated. The evaporation shows high efficiency down to a 3 s evaporation time, while a critical phase-space density can be achieved within (1.29 ± 0.07) s using an even faster evaporation ramp. This opens the door to fundamental physics experiments on Bose-Einstein condensates in microgravity, as well as applications pursuing atomic ensembles with exceptionally low expansion velocities.
Inertial sensors based on matter-wave interferometry are currently approaching the precision and accuracy of state-of-the-art classical sensors. While these devices are often realised with ultracold but not Bose-condensed atoms as matter waves, employing Bose-Einstein Condensates (BEC) promises to overcome certain limitations, especially those related to the ensemble's expansion. The point-source like character of BECs also enables utilising spatial interference patterns to measure e.g. rotation rates in single-shot experiments. Matter wave-based inertial sensors are considered for experiments ranging from Gravitational Wave detection to tests of the Universality of Free Fall (UFF) to gain insight into the joint between Quantum Mechanics and General Relativity. In the scope of this thesis, matter-wave interferometry with BECs was demonstrated for the first time in a microgravity environment with the QUANTUS-1 apparatus. The same instrument was then employed as a quantum tiltmeter utilising a novel beam-splitting mechanism known as Bragg Double Diffraction. To this end, the QUANTUS-1 apparatus designed as a BEC instrument to be operated in the drop tower at ZARM at University of Bremen was equipped with optics and laser systems required for performing matter-wave interferometry based on Bragg Diffraction. The apparatus employs an atom chip to create BECs of around 10000 Rubidium 87 atoms within 15 s. With a Mach-Zehnder like interferometer scheme, spatial interference fringes were observed after a free evolution time in the interferometer of up to 677 ms. To achieve these long time scales, a method known as Delta-Kick Collimation (DKC) was adapted to slow the expansion of the BEC to a kinetic energy equivalent below 1 nK, and the atoms were transferred to a non-magnetic Zeeman state via an adiabatic rapid passage (ARP). A similar interferometer scheme with a newly developed beam-splitter mechanism known as Bragg Double Diffraction was used to measure the tilt of the instrument on ground with a precision of up to 4.4 AA rad. This thesis presents an overview of the apparatus including ground-based characterisations of all required experimental steps. Results from over 400 free fall experiments are evaluated for expansion studies of the BEC and matter-wave interferometry in microgravity. The time-evolution of first and second order Bragg Double Diffraction beam splitters is studied, and an interferometer sensitive to the tilt of the instrument is implemented. Based on this work, a gravimeter with a new launch mechanism comprising Bragg beam splitters and Bloch oscillations to enable atomic fountains in atom-chip based devices was developed. The microgravity experiments were adapted for the MAIUS-1 sounding-rocket instrument to create the first man-made BEC in outer space and study the feasibility of operating matter-wave interferometers on space-borne platforms. The results of this thesis lay the groundwork for future space-borne missions using matter-wave interferometry for precision measurements of inertial forces.
Interferometers based on ultracold atoms enable an absolute measurement of inertial forces with unprecedented precision. However, their resolution is fundamentally restricted by quantum fluctuations. Improved resolutions with entangled or squeezed atoms were demonstrated in internal-state measurements for thermal and quantum-degenerate atoms and, recently, for momentum-state interferometers with laser-cooled atoms. Here, we present a gravimeter based on Bose-Einstein condensates with a sensitivity of − 1.7 − 0.5 + 0.4 dB beyond the standard quantum limit. Interferometry with Bose-Einstein condensates combined with delta-kick collimation minimizes atom loss in and improves scalability of the interferometer to very-long-baseline atom interferometers.
Matter-wave interferometry with atoms propagating in a guiding potential is expected to provide compact, scalable and precise inertial sensing. However, a rotation sensing device based on the Sagnac effect with atoms guided in a ring has not yet been implemented despite continuous efforts during the last two decades. Here we discuss some intrinsic effects that limit the coherence in such a device and propose a scheme that overcomes these limitations and enables a multi-pass guiding Sagnac interferometer with a Bose-Einstein condensate (BEC) on a chip in a ring potential. We analyze crucial dephasing effects: potential roughness, phase diffusion due to atom-atom interactions and number uncertainty, and phase fluctuations. Owing to the recent progress in achieving high momentum beam splitting, creating smooth guides, and manipulating the matter-wavepacket propagation, guided interferometry can be implemented within the coherence time allowed by phase diffusion. Despite the lower particle flux in a guided Sagnac ring and the miniaturization of the interferometer, the estimated sensitivity, for reasonable and practical realizations of an atom chip-based gyroscope, is comparable to that of free-space interferometers, reaching 45 nrads^{-1}Hz^{-1/2}. A significant improvement over state-of-the-art free-space gyrocope sensitivities can be envisioned by using thermal atoms instead of a BEC, whereby the interferometer can be operated in a continuous fashion with the coherence limited by the scattering rate of the atoms with the background gas. Taking into account the sensitivity times length of the interferometer as the figure of merit which takes into account compactness, our configuration is expected to deliver a potential improvement of 2-4 orders of magnitude over state-of-the-art free-space gyroscopes for a BEC, and 4-6 orders of magnitude for thermal atoms.