- Cryogenic data transfer has numerous applications at 4.2 K for extracting data from supercomputers and quantum computers to address interface bottlenecks. The external modulation of data transmission across temperature zones is achieved through the use of electro-optic modulators. The performance of a thin-film lithium niobate (TFLN) Mach-Zehnder modulator was examined at cryogenic temperatures. Low-frequency measurements indicate that the Vπ (voltage needed for π phase shift) of the modulator increases as the temperature decreases from 298 K to 4.2 K. A comparison was conducted between the readout performance of the electrical wire link and the optical fiber link, spanning from 4.2 K to 298 K. Additionally, high-speed data transmission was successfully demonstrated in a 4.2 K environment without the need for cryogenic electric amplifiers, achieving signals of up to 30 Gbps. The proposed solution holds potential benefits for both classical and quantum computers in alleviating interface bottlenecks.
Cryogenic data transfer has numerous applications at 4.2 K for extracting data from supercomputers and quantum computers to address interface bottlenecks. The external modulation of data transmission across temperature zones is achieved through the use of electro-optic modulators. The performance of a thin-film lithium niobate (TFLN) Mach-Zehnder modulator was examined at cryogenic temperatures. Low-frequency measurements indicate that the Vπ (voltage needed for π phase shift) of the modulator increases as the temperature decreases from 298 K to 4.2 K. A comparison was conducted between the readout performance of the electrical wire link and the optical fiber link, spanning from 4.2 K to 298 K. Additionally, high-speed data transmission was successfully demonstrated in a 4.2 K environment without the need for cryogenic electric amplifiers, achieving signals of up to 30 Gbps. The proposed solution holds potential benefits for both classical and quantum computers in alleviating interface bottlenecks.
Photonic integrated circuits operating at cryogenic temperatures are necessary for many quantum technologies such as quantum transduction, integrated single-photon emitters and detectors, as well as deep-space communication and sensing devices. Thin-film lithium niobate (TFLN) is an emerging platform that is a strong candidate for fully integrated quantum photonics, offering low loss, fast electro-optic reconfigurability, nonlinear quantum light sources, and the ability to host quantum emitters and single-photon detectors. To interface TFLN with technologies that require cryogenic operation, like superconducting single-photon detectors, microwave-to-optical transducers, and solid-state quantum emitters, it is important to study its optical and electrical properties from room temperature down to cryogenic temperatures. Here, we investigate linear and nonlinear photonic devices, including racetrack resonators, Mach-Zehnder modulators and periodically poled waveguides in TFLN using a cryogenic fiber probe station with full temperature control down to 5 K. We quantify a shift in resonances, a 22% increase in electro-optic modulator half-wave voltage, a blue shift of 18 nm for Type-0 phase-matching as well as a red shift of 64 nm for Type-II phase-matching as the sample temperature decreases. Our study of nonlinear processes in a cryogenic environment will contribute towards developing novel devices for inter-platform quantum information processing, secure communication, and enhanced sensing.
As photonic integrated circuits (PICs) gain prominence in quantum communication and quantum computation, the development of efficient and stable cryogenic packaging technologies becomes paramount. This paper presents a robust and scalable cryogenic packaging method for thin-film lithium niobate (TFLN) photonic chips. The packaged fiber-to-chip interface shows a coupling efficiency of 15.7% ± 0.3%, with minimal variation of ±0.5% as the temperature cools down from 295 K to 1.5 K. Furthermore, the packaged chip exhibits outstanding stability over multiple thermal cycling, highlighting its potential for practical applications in cryogenic environments.
Photonic integration in quantum communication holds significant potential for miniaturization and enabling commercial applications. Among various platforms, thin-film lithium niobate (TFLN) stands out due to its exceptional combination of high electro-optical efficiency, low propagation loss, and compact footprint. Here, we demonstrate a 2.5 GHz chip-to-chip fully integrated quantum key distribution (QKD) system based on a TFLN platform, which incorporates high-speed dual-polarization time-bin phase encoding and decoding functionalities. We achieve an extremely low quantum bit error rate of 0.53% and a secret key rate exceeding 10 Mbps over 25 km fiber spools. The design of cascaded Mach–Zehnder modulators effectively suppresses the patterning effect in high speed QKD. Notably, the TFLN chips used in both the transmitter and receiver share a similar architecture, highlighting the potential for creating a homogeneous transceiver. This work paves the way for high-speed, miniaturized QKD systems based on the lithium niobate integrated platform.
Abstract Encoding information onto optical fields using electro-optical modulation is the backbone of modern telecommunication networks, offering vast bandwidth and low-loss transport via optical fibers. For these reasons, optical fibers are also replacing electrical cables for short range communications within data centers. Compared to electrical coaxial cables, optical fibers also introduce two orders of magnitude smaller heat load from room to milli-Kelvin temperatures, making optical interconnects based on electro-optical modulation an attractive candidate for interfacing superconducting quantum circuits and hybrid superconducting devices. Yet, little is known about optical modulation at cryogenic temperatures. Here we demonstrate a proof-of-principle cryogenic electro-optical interconnect, showing that currently employed Ti-doped lithium niobate phase modulators are compatible with operation down to 800mK ---below the typical operation temperature of conventional microwave amplifiers based on high electron mobility transistors (HEMTs)---and maintain their room temperature Pockels coefficient. We utilize cryogenic electro-optical modulation to perform spectroscopy of a superconducting circuit optomechanical system, measuring optomechanically induced transparency (OMIT). In addition, we encode thermomechanical sidebands from the microwave domain onto an optical signal processed at room temperature. Although the currently achieved noise figure is significantly higher than that of a typical HEMT, substantial noise reduction should be attainable by harnessing recent advances in integrated modulators, by increasing the modulator length, or by using materials with a higher electro-optic coefficient, leading to noise levels on par with HEMTs. Our work highlights the potential of electro-optical modulators for massively parallel readout for emerging quantum computing or cryogenic classical computing platforms.
Cryogenic systems necessitate extensive data transmission between room-temperature and cryogenic environments, as well as within the cryogenic temperature domain. High-speed, low-power data transmission is pivotal to enabling the deployment of larger-scale cryogenic systems, including the scalable quantum computing systems and the high-performance cryogenic computing systems fully immersed in liquid nitrogen. In contrast to wireline and microwave links, optical communication links are emerging as a solution characterized by high data rates, high energy efficiency, low signal attenuation, absence of thermal conduction, and superior scalability. In this work, a 4K heat-insulated high-speed (56Gbps) low-power (1.6pJ/b) transceiver (TRX) that achieves a complete link between 4K systems and room temperature (RT) equipment is presented. Copackaged with a PIN photodiode (PD), the RX uses an inverter-based analog front-end and an analog half-rate clock data recovery loop. Connecting to a Mach-Zehnder modulator (MZM), the TX contains a voltage-mode driver with current-mode injection for low-power output-swing-boosting and 3-tap feed-forward equalization (FFE). This link has been demonstrated in the control and readout of a complete superconducting quantum computing system.
Radio frequency (RF) radiation is a powerful tool in computing, communication, and sensing due to the ability to engineer strong electrical interactions. Within cryogenic systems, in particular, microwave (MW) frequency superconducting qubits have demonstrated promise as a platform for quantum computing, and MW and millimeter-wave (mmW) systems have been valuable tools in sensing. However, owing to their low energy, the weak, single-photon level signals employed by these systems suffer high sensitivity to thermal noise when they exit the thermal bath, as well as short attenuation lengths due to absorption and scattering in cables. Telecommunication frequency optical photons, meanwhile, have long propagation lengths and can be supported by low-loss optical fibers. The high photon energy makes signals insensitive to thermal noise, and the high frequency can allow many RF signals to be multiplexed onto a single optical carrier. Interfacing RF and optical radiation to leverage both strong interactions with macroscopic systems characteristic of electrical interactions and low-loss propagation characteristic of optical photons has been critical to realizing our global communication system. Leveraging the infrastructure developed to support this industry, such as single photon detectors, is attractive for scaling cryogenic RF systems. Coherent conversion processes, especially, can benefit a wide range of applications, especially in computing and sensing, by preserving quantum states, and retaining phase information necessary for quantum gates, and enable the use of measurement techniques that can increase detection sensitivity. This dissertation focuses on using the electro-optic effect in thin-film lithium niobate to form an efficient, coherent interface between radio- and telecommunication-frequency photons. Lithium niobate is an attractive platform due to its high electro-optic coefficient (approx. 30 pm/V), wide transparency window (DC to 400 THz), and ability to support low-loss optical waveguides (.2 dB/m), all of which deviate little from room temperature down to near-zero Kelvin environments. First, I explore the development of low-loss lithium niobate optical cavities and operation of lithium niobate waveguides at low temperatures. While lithium niobate is an electro-optic material with a DC response, using the electro-optic response at room temperature for stable biasing and low-frequency operation has remained a challenge. A temperature- and frequency-dependent study is conducted to identify lithium charge migration as a potential screening mechanism suppressed at low temperatures. Next, I explore the use of RF-cavity enhanced, triply resonant photonic molecules (created from two coupled low-loss optical cavities) for forming efficient electro-optic interfaces with microwave (3-10 GHz) and millimeter wave (100 GHz) radiation. In the microwave regime, I explore microwave-optical transduction for forming optical interfaces with microwave qubits, specifically focusing on superconducting qubits. The characterization of one such transducer is demonstrated, and the device is used to optically synthesize microwave signals at low temperatures, bypassing the need for input microwave control lines. Outlook for other interfaces, including optical photon mediated quantum information transfer, is discussed. At mmW frequencies, the triply resonant photonic molecule is explored for low-power ( mW) optical-frequency shifting.