Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Optics

Frequency-multiplexed on-demand storage in five modes of atomic frequency comb through simultaneous application of control pulses

Taihei Masuko, Daisuke Yoshida, Ayaka Aida, Feng-Lei Hong, Tomoyuki Horikiri

Published Feb 7, 2024• 2 citations
Publisher

Abstract

In quantum communication with quantum repeaters, multiplexed quantum memory is expected to enhance communication rates. When using an atomic frequency comb (AFC) for on-demand storage, the frequency mode number is often limited by the optical power of the control pulses. Here, using a space-coupled waveguide electro-optic modulator, we increased the output power, allowing us to apply control pulses to multiple modes simultaneously. Further, through enhancement of an experimental setup that increases power density, we increased the number of modes. Consequently, we pioneered, to the best of our knowledge, on-demand storage using five modes of AFC. This technology is a significant achievement toward frequency-multiplexed on-demand quantum memory.

DOI
10.1364/ao.514004

Related papers

Multimode capacity of atomic-frequency comb quantum memories

Antonio Ortu, Jelena V. Rakonjac, Adrian Holzäpfel +5 more

Abstract Ensemble-based quantum memories are key to developing multiplexed quantum repeaters, able to overcome the intrinsic rate limitation imposed by finite communication times over long distances. Rare-earth ion doped crystals are main candidates for highly multimode quantum memories, where time, frequency and spatial multiplexing can be exploited to store multiple modes. In this context the atomic frequency comb (AFC) quantum memory provides large temporal multimode capacity, which can readily be combined with multiplexing in frequency and space. In this article, we derive theoretical formulas for quantifying the temporal multimode capacity of AFC-based memories, for both optical memories with fixed storage time and spin-wave memories with longer storage times and on-demand read out. The temporal multimode capacity is expressed in key memory parameters, such as AFC bandwidth, fixed-delay storage time, memory efficiency, and control field Rabi frequency. Current experiments in europium- and praseodymium-doped Y2SiO5 are analyzed within this theoretical framework, which is also tested with newly acquired data, as prospects for higher temporal capacity in these materials are considered. In addition we consider the possibility of spectral and spatial multiplexing to further increase the mode capacity, with examples given for praseodymium doped Y2SiO5.

arXiv:2202.12383•Quantum Science and Technology•May 26, 2022•53 citations

Multimode quantum memory based on atomic frequency combs

Mikael Afzelius, Christoph Simon, Hugues de Riedmatten +1 more

An efficient multimode quantum memory is a crucial resource for long-distance quantum communication based on quantum repeaters. We propose a quantum memory based on spectral shaping of an inhomogeneously broadened optical transition into an atomic frequency comb (AFC). The spectral width of the AFC allows efficient storage of multiple temporal modes without the need to increase the absorption depth of the storage material, in contrast to previously known quantum memories. Efficient readout is possible thanks to rephasing of the atomic dipoles due to the AFC structure. Long-time storage and on-demand readout is achieved by use of spin states in a lambda-type configuration. We show that an AFC quantum memory realized in solids doped with rare-earth-metal ions could store hundreds of modes or more with close to unit efficiency, for material parameters achievable today.

arXiv:0805.4164•Physical Review A•May 21, 2009•642 citations

Spectral Multiplexing for Scalable Quantum Photonics using an Atomic Frequency Comb Quantum Memory and Feed-Forward Control

Neil E. Sinclair, Erhan Sağlamyürek, Hassan Mallahzadeh +8 more

Future multiphoton applications of quantum optics and quantum information science require quantum memories that simultaneously store many photon states, each encoded into a different optical mode, and enable one to select the mapping between any input and a specific retrieved mode during storage. Here we show, with the example of a quantum repeater, how to employ spectrally multiplexed states and memories with fixed storage times that allow such mapping between spectral modes. Furthermore, using a Ti:Tm:LiNbO_{3} waveguide cooled to 3 K, a phase modulator, and a spectral filter, we demonstrate storage followed by the required feed-forward-controlled frequency manipulation with time-bin qubits encoded into up to 26 multiplexed spectral modes and 97% fidelity.

arXiv:1309.3202•Physical Review Letters•Jul 29, 2014•331 citations

Multiplexed and broadband quantum storage of single-photons at telecom C-band

Shihai Wei, Bo Jing, Xue-Ying Zhang +10 more

We prepare five separated 10-GHz atomic frequency combs (AFCs) simultaneously in Er3+-doped fiber, then demonstrate temporally- and spectrally-multiplexed storage of telecom-band single-photons up to 1650 modes. Our results pave the way for quantum repeaters with multiplexed and broadband quantum memory.

Conference on Lasers and Electro-Optics•Jan 1, 2021•1 citation

An integrated processor for photonic quantum states using a broadband light–matter interface

E Saglamyurek, N Sinclair, Joshua A. Slater +3 more

Faithful storage and coherent manipulation of quantum optical pulses are key for long distance quantum communications and quantum computing. Combining these functions in a light–matter interface that can be integrated on-chip with other photonic quantum technologies, e.g. sources of entangled photons, is an important step towards these applications. To date there have only been a few demonstrations of coherent pulse manipulation utilizing optical storage devices compatible with quantum states, and that only in atomic gas media (making integration difficult) and with limited capabilities. Here we describe how a broadband waveguide quantum memory based on the atomic frequency comb (AFC) protocol can be used as a programmable processor for essentially arbitrary spectral and temporal manipulations of individual quantum optical pulses. Using weak coherent optical pulses at the few photon level, we experimentally demonstrate sequencing, time-to-frequency multiplexing and demultiplexing, splitting, interfering, temporal and spectral filtering, compressing and stretching as well as selective delaying. Our integrated light–matter interface offers high-rate, robust and easily configurable manipulation of quantum optical pulses and brings fully practical optical quantum devices one step closer to reality. Furthermore, as the AFC protocol is suitable for storage of intense light pulses, our processor may also find applications in classical communications.

arXiv:1402.0481•New Journal of Physics•Jun 26, 2014•64 citations

On-demand multimode optical storage in a laser-written on-chip waveguide

Ming-Xu Su, Tian-Xiang Zhu, Chao Liu +3 more

Quantum memory is a fundamental building block for large-scale quantum networks. On-demand optical storage with a large bandwidth, a high multimode capacity, and an integrated structure simultaneously is crucial for practical application. However, this has not been demonstrated yet. Here, we fabricate an on-chip waveguide in a $^{151}\mathrm{Eu}^{3+}:{\mathrm{Y}}_{2}{\mathrm{SiO}}_{5}$ crystal with insertion losses of 0.2 dB, and propose a pumping scheme to enable spin-wave atomic frequency comb (AFC) storage with a bandwidth of 11 MHz inside the waveguide. Based on this, we demonstrate the storage of 200 temporal modes using the AFC scheme and conditional on-demand storage of 100 temporal modes using the spin-wave AFC scheme. The interference visibility between the readout light field and the reference light field is $99.0%\ifmmode\pm\else\textpm\fi{}0.6%$ and $97%\ifmmode\pm\else\textpm\fi{}3%$ for AFC and spin-wave AFC storage, respectively, indicating the coherent nature of this low-loss, multimode, and integrated storage device.

arXiv:2205.12762•Physical Review A•May 23, 2022•11 citations
In quantum communication with quantum repeaters, multiplexed quantum memory is expected to enhance communication rates. When using an atomic frequency comb (AFC) for on-demand storage, the frequency mode number is often limited by the optical power of the control pulses. Here, using a space-coupled waveguide electro-optic modulator, we increased the output power, allowing us to apply control pulses to multiple modes simultaneously. Further, through enhancement of an experimental setup that increases power density, we increased the number of modes. Consequently, we pioneered, to the best of our knowledge, on-demand storage using five modes of AFC. This technology is a significant achievement toward frequency-multiplexed on-demand quantum memory.
Abstract Ensemble-based quantum memories are key to developing multiplexed quantum repeaters, able to overcome the intrinsic rate limitation imposed by finite communication times over long distances. Rare-earth ion doped crystals are main candidates for highly multimode quantum memories, where time, frequency and spatial multiplexing can be exploited to store multiple modes. In this context the atomic frequency comb (AFC) quantum memory provides large temporal multimode capacity, which can readily be combined with multiplexing in frequency and space. In this article, we derive theoretical formulas for quantifying the temporal multimode capacity of AFC-based memories, for both optical memories with fixed storage time and spin-wave memories with longer storage times and on-demand read out. The temporal multimode capacity is expressed in key memory parameters, such as AFC bandwidth, fixed-delay storage time, memory efficiency, and control field Rabi frequency. Current experiments in europium- and praseodymium-doped Y2SiO5 are analyzed within this theoretical framework, which is also tested with newly acquired data, as prospects for higher temporal capacity in these materials are considered. In addition we consider the possibility of spectral and spatial multiplexing to further increase the mode capacity, with examples given for praseodymium doped Y2SiO5.
An efficient multimode quantum memory is a crucial resource for long-distance quantum communication based on quantum repeaters. We propose a quantum memory based on spectral shaping of an inhomogeneously broadened optical transition into an atomic frequency comb (AFC). The spectral width of the AFC allows efficient storage of multiple temporal modes without the need to increase the absorption depth of the storage material, in contrast to previously known quantum memories. Efficient readout is possible thanks to rephasing of the atomic dipoles due to the AFC structure. Long-time storage and on-demand readout is achieved by use of spin states in a lambda-type configuration. We show that an AFC quantum memory realized in solids doped with rare-earth-metal ions could store hundreds of modes or more with close to unit efficiency, for material parameters achievable today.
Future multiphoton applications of quantum optics and quantum information science require quantum memories that simultaneously store many photon states, each encoded into a different optical mode, and enable one to select the mapping between any input and a specific retrieved mode during storage. Here we show, with the example of a quantum repeater, how to employ spectrally multiplexed states and memories with fixed storage times that allow such mapping between spectral modes. Furthermore, using a Ti:Tm:LiNbO_{3} waveguide cooled to 3 K, a phase modulator, and a spectral filter, we demonstrate storage followed by the required feed-forward-controlled frequency manipulation with time-bin qubits encoded into up to 26 multiplexed spectral modes and 97% fidelity.
Faithful storage and coherent manipulation of quantum optical pulses are key for long distance quantum communications and quantum computing. Combining these functions in a light–matter interface that can be integrated on-chip with other photonic quantum technologies, e.g. sources of entangled photons, is an important step towards these applications. To date there have only been a few demonstrations of coherent pulse manipulation utilizing optical storage devices compatible with quantum states, and that only in atomic gas media (making integration difficult) and with limited capabilities. Here we describe how a broadband waveguide quantum memory based on the atomic frequency comb (AFC) protocol can be used as a programmable processor for essentially arbitrary spectral and temporal manipulations of individual quantum optical pulses. Using weak coherent optical pulses at the few photon level, we experimentally demonstrate sequencing, time-to-frequency multiplexing and demultiplexing, splitting, interfering, temporal and spectral filtering, compressing and stretching as well as selective delaying. Our integrated light–matter interface offers high-rate, robust and easily configurable manipulation of quantum optical pulses and brings fully practical optical quantum devices one step closer to reality. Furthermore, as the AFC protocol is suitable for storage of intense light pulses, our processor may also find applications in classical communications.
Quantum memory is a fundamental building block for large-scale quantum networks. On-demand optical storage with a large bandwidth, a high multimode capacity, and an integrated structure simultaneously is crucial for practical application. However, this has not been demonstrated yet. Here, we fabricate an on-chip waveguide in a 151Eu3+:Y2SiO5^{151}\mathrm{Eu}^{3+}:{\mathrm{Y}}_{2}{\mathrm{SiO}}_{5}151Eu3+:Y2​SiO5​ crystal with insertion losses of 0.2 dB, and propose a pumping scheme to enable spin-wave atomic frequency comb (AFC) storage with a bandwidth of 11 MHz inside the waveguide. Based on this, we demonstrate the storage of 200 temporal modes using the AFC scheme and conditional on-demand storage of 100 temporal modes using the spin-wave AFC scheme. The interference visibility between the readout light field and the reference light field is 99.099.0%\ifmmode\pm\else\textpm\fi{}0.6%99.0 and 9797%\ifmmode\pm\else\textpm\fi{}3%97 for AFC and spin-wave AFC storage, respectively, indicating the coherent nature of this low-loss, multimode, and integrated storage device.