Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

A Study of Ramsey Interference and Spectral Line Locking Technique Based on Rubidium-87 Cold Atoms

Wangyuan Gao, Ji Wang, Yuhua Xiao, Jiongyang Zhang

Published Oct 31, 2023• 0 citations
Publisher

Abstract

In this paper, a study was conducted on the Ramsey interference and spectral line locking techniques based on rubidium-87 cold atoms. Using sequential control technique, the timing design of a three-dimensional magneto-optical trap (MOT), cold atoms’ free fall, Ramsey microwave interference, and two-level fluorescence detection was realized, achieving the state preparation of cold atoms and clock transitions. By designing an automatic peak-finding algorithm, numerical integration was performed on the time-of-flying (TOF) signal, and narrow linewidth cold atom Ramsey interference fringes were obtained. Based on this, a frequency-hopping method was used to lock the frequency of the 10MHz oven-controlled crystal oscillator (OCXO) in a closed loop, achieving a linewidth of 38Hz. This preliminary result verifies the feasibility of the system design.

DOI
10.20944/preprints202310.1947.v1

Related papers

Preliminary Results of the Portable Cold 87Rb Atomic Clock in NIM

Fasong Zheng, Kun Liu, Weiliang Chen +2 more

A portable cold87Rb atomic clock is under development at NIM. The clock uses87Rb atoms which are trapped and cooled in a small three-dimensional magneto-optical trap (3D-MOT) chamber. Within the 3D-MOT chamber, the free-falling atoms are prepared in$\vert F=2, m_{F}=0\rangle$clock state with optical pumping (OP) directly after post cooling by$2-2^{\prime}$OP light and repumping. Following optical state selection, the free-falling atoms enter a microwave cavity where they undergo microwave interrogation. Eventually, the number of atoms in two clock states are detected individually by the fluorescence detection method in the detection chamber. The preliminary results show that, the selected atom number has been improved about 3 times with the optical state selection compared to the microwave state selection method. And a Ramsey fringe has been obtained experimentally, and the contrast of the central Ramsey fringe exceeds 88% with a full width half maximum (FWHM) of less than 9 Hz.

European Frequency and Time Forum•Jun 25, 2024•1 citation

Free expanding cloud of cold atoms as an atomic standard: Ramsey fringes contrast

Stella Müller, Daniel Varela Magalhães, Aida Bebeachibuli +3 more

A compact frequency standard based on an expanding cold Cs133 cloud is under development in our laboratory. In a first experiment, Cs cold atoms were prepared by a magneto-optical trap in a vapor cell, and a microwave antenna was used to transmit the radiation for the clock transition. The signal obtained from fluorescence of the expanding cold atoms cloud is used to lock a microwave chain. In this way the overall system stability is evaluated. A theoretical model based on a two-level system interacting with the two microwave pulses enables interpretation for the observed features, especially the poor Ramsey fringes contrast.

Journal of the Optical Society of America B•May 14, 2008•8 citations

Initial Tests of a Rubidium Space Cold Atom Clock

Lin Li, Qiuzhi Qu, Bin Wang +9 more

We report the initial test results of a rubidium ( 87 Rb) space cold atom clock (SCAC). The space-qualified 87 Rb SCAC is composed of the physical package, the optical bench, the microwave synthesizer and the control electronics. After the system is integrated, about 10 8 87 Rb cold atoms are captured by magneto-optical trap. The linewidth of the Ramsey fringe is about 10 Hz for the free evolution time of 50 ms on the ground, and the signal-to-noise ratio is measured to be larger than 300. We demonstrate a good medium-term fractional frequency stability of 1.5 × 10 −14 @1000 s in the closed-loop operation on the ground. The main effects of the noise on the stability are also presented, and the optimized operating parameter is analyzed for the operation of SCAC in the microgravity environment.

Chinese Physics Letters•Jun 1, 2016•9 citations

Optical Ramsey interference and its performance in D1 line excitation in rubidium vapor for implementation of a vapor cell clock

G. S. Pati, Fredrik K. Fatemi, Mark Bashkansky +1 more

Pulsed coherent population trapping in atomic vapor provides a convenient method for generating frequency narrowed atomic resonance using Ramsey interference. Here, we present our experimental results showing high-contrast and sub-kilohertz Ramsey interference fringes produced by coherently prepared 85Rb atoms using Raman excitation formed in D1 line transitions. A test system for atomic clock has been constructed to measure light shift for both continuous and pulsed Raman excitation cases. Our measurements show that light shift measured using pulsed Raman excitation, is reduced compared to the continuous excitation case. Our ability to measure light shift is currently limited by the resolution of the frequency counter, and performance of the locking electronics used.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Feb 10, 2011•6 citations

Atomic Clock Using Microwave Pulse-Coherent Techniques

Maurice Arditi, T. R. Carver

In order to eliminate the light shifts and to increase the stability of gas-cell atomic clocks using optical pumping of the alkali atoms, the detection of a microwave pulse-induced coherent emission is used as the correction signal to lock a crystal oscillator to the atomic transition. Also, the line width of the O-O hyperfine transition is artificially narrowed by subjecting the atoms in the cell to two phase-coherent microwave pulses. In this case the resonance line has a width characteristic of the pulse-repetition frequency which can be made several times smaller than the natural line width in the cell. Proper timing of the sequence of microwave pulses and light pulses for optical pumping is necessary to conserve phase coherence and to obtain a well-defined Ramsey pattern. Results of the tests on a laboratory model using Rubidium-87 atoms show the elimination of the light shifts and an improvement of the short-term stability of the crystal oscillator by one order of magnitude.

IEEE Transactions on Instrumentation and Measurement•Jun 1, 1964•43 citations

Progress Toward an Atomic Clock Based on a Continuous Cold Rubidium Beam

Zhixin Meng, Peiqiang Yan, Xiaojie Li +1 more

We reported on the progress toward an atomic clock based on a continuous cold 87Rb atomic beam. The atomic beam source is generated directly from a 2D+Magneto-Optical Trapping (MOT) with the flux of about 3×109atoms/s and mean longitudinal velocity of 10 m/s. The beam had a free evolution time of 9 ms over the separated distance of 90 mm, producing a 54-Hz-wide Raman-Ramsey fringe. The Signal-to-Noise ratio (SNR) of Raman-Ramsey fringes is effectively increased by modulation and demodulation methods, which offer a promising approach to improving the frequency stability of the atomic clock.

IEEE International Instrumentation and Measurement Technology Conference•May 1, 2020•1 citation
In this paper, a study was conducted on the Ramsey interference and spectral line locking techniques based on rubidium-87 cold atoms. Using sequential control technique, the timing design of a three-dimensional magneto-optical trap (MOT), cold atoms’ free fall, Ramsey microwave interference, and two-level fluorescence detection was realized, achieving the state preparation of cold atoms and clock transitions. By designing an automatic peak-finding algorithm, numerical integration was performed on the time-of-flying (TOF) signal, and narrow linewidth cold atom Ramsey interference fringes were obtained. Based on this, a frequency-hopping method was used to lock the frequency of the 10MHz oven-controlled crystal oscillator (OCXO) in a closed loop, achieving a linewidth of 38Hz. This preliminary result verifies the feasibility of the system design.
A portable cold87Rb atomic clock is under development at NIM. The clock uses87Rb atoms which are trapped and cooled in a small three-dimensional magneto-optical trap (3D-MOT) chamber. Within the 3D-MOT chamber, the free-falling atoms are prepared in∣F=2,mF=0⟩\vert F=2, m_{F}=0\rangle∣F=2,mF​=0⟩clock state with optical pumping (OP) directly after post cooling by2−2′2-2^{\prime}2−2′OP light and repumping. Following optical state selection, the free-falling atoms enter a microwave cavity where they undergo microwave interrogation. Eventually, the number of atoms in two clock states are detected individually by the fluorescence detection method in the detection chamber. The preliminary results show that, the selected atom number has been improved about 3 times with the optical state selection compared to the microwave state selection method. And a Ramsey fringe has been obtained experimentally, and the contrast of the central Ramsey fringe exceeds 88% with a full width half maximum (FWHM) of less than 9 Hz.
A compact frequency standard based on an expanding cold Cs133 cloud is under development in our laboratory. In a first experiment, Cs cold atoms were prepared by a magneto-optical trap in a vapor cell, and a microwave antenna was used to transmit the radiation for the clock transition. The signal obtained from fluorescence of the expanding cold atoms cloud is used to lock a microwave chain. In this way the overall system stability is evaluated. A theoretical model based on a two-level system interacting with the two microwave pulses enables interpretation for the observed features, especially the poor Ramsey fringes contrast.
We report the initial test results of a rubidium ( 87 Rb) space cold atom clock (SCAC). The space-qualified 87 Rb SCAC is composed of the physical package, the optical bench, the microwave synthesizer and the control electronics. After the system is integrated, about 10 8 87 Rb cold atoms are captured by magneto-optical trap. The linewidth of the Ramsey fringe is about 10 Hz for the free evolution time of 50 ms on the ground, and the signal-to-noise ratio is measured to be larger than 300. We demonstrate a good medium-term fractional frequency stability of 1.5 × 10 −14 @1000 s in the closed-loop operation on the ground. The main effects of the noise on the stability are also presented, and the optimized operating parameter is analyzed for the operation of SCAC in the microgravity environment.
Pulsed coherent population trapping in atomic vapor provides a convenient method for generating frequency narrowed atomic resonance using Ramsey interference. Here, we present our experimental results showing high-contrast and sub-kilohertz Ramsey interference fringes produced by coherently prepared 85Rb atoms using Raman excitation formed in D1 line transitions. A test system for atomic clock has been constructed to measure light shift for both continuous and pulsed Raman excitation cases. Our measurements show that light shift measured using pulsed Raman excitation, is reduced compared to the continuous excitation case. Our ability to measure light shift is currently limited by the resolution of the frequency counter, and performance of the locking electronics used.
In order to eliminate the light shifts and to increase the stability of gas-cell atomic clocks using optical pumping of the alkali atoms, the detection of a microwave pulse-induced coherent emission is used as the correction signal to lock a crystal oscillator to the atomic transition. Also, the line width of the O-O hyperfine transition is artificially narrowed by subjecting the atoms in the cell to two phase-coherent microwave pulses. In this case the resonance line has a width characteristic of the pulse-repetition frequency which can be made several times smaller than the natural line width in the cell. Proper timing of the sequence of microwave pulses and light pulses for optical pumping is necessary to conserve phase coherence and to obtain a well-defined Ramsey pattern. Results of the tests on a laboratory model using Rubidium-87 atoms show the elimination of the light shifts and an improvement of the short-term stability of the crystal oscillator by one order of magnitude.
We reported on the progress toward an atomic clock based on a continuous cold 87Rb atomic beam. The atomic beam source is generated directly from a 2D+Magneto-Optical Trapping (MOT) with the flux of about 3×109atoms/s and mean longitudinal velocity of 10 m/s. The beam had a free evolution time of 9 ms over the separated distance of 90 mm, producing a 54-Hz-wide Raman-Ramsey fringe. The Signal-to-Noise ratio (SNR) of Raman-Ramsey fringes is effectively increased by modulation and demodulation methods, which offer a promising approach to improving the frequency stability of the atomic clock.