© 2026 Aqora Quantum S.A.S.

Terms Privacy Legal Notice

Quantum Optics and Photon Counting

Design of integrated SSPD-SFQ two-photon coincidence correlator

I. Komissarov, Amir Jafari Salim, Oleg A. Mukhanov, Timothy M. Rambo, Aaron Miller, Roman Sobolewski

Published Jun 6, 2023• 2 citations

Abstract

We present a single-flux-quantum (SFQ) based digital correlator to trace independent signals from two superconducting single-photon detectors (SSPDs) triggering its inputs. In our design two SSPDs are magnetically coupled to inputs of a readout system where direct current (DC)-to-SFQ converters are used to convert transient SSPD output pulses, triggered by detection of single-photon events, to SFQ pulses. The coincidence verification of SFQ pulses, generated by the two DC-to-SFQ converters, is performed with a modified SFQ coincidence buffer. The coincidence buffer is designed to generate an SFQ output pulse only when its both inputs are triggered simultaneously, or within a preset margin time. The output of the coincidence buffer is connected via, this time, an SFQ-to-DC converter, to a pulse counter operated at room temperature. We performed extensive simulations of both the SSPD equivalent circuit and correlator redout elements for the proposed coincidence scheme, using a WRSpice and PSCAN2 simulation platforms that are specifically designated to model Josephson junctions and widely used to simulate operation of the SFQ circuitry. In particular, we investigated our coincidence correlator scheme for measurements of the second-order correlation function, used to demonstrate the antibunching effect in the single-photon detection of non-classical light.

DOI: 10.1117/12.2670241

Related papers

Modelling of a Two-Signal SFQ Detection Scheme for the Readout of Superconducting Nanowire Single Photon Detectors

Connor D. Shelly, Patrick See, Edward J. Romans +4 more

We present a two-signal single flux quantum (SFQ) detection scheme for the purpose of reading out two pixels of a superconducting nanowire single photon detector (SNSPD). The circuit is based on a coincidence buffer element which is able to output a signal when both of its input lines are triggered. The circuit model for the SNSPD element is simulated in SPICE and optimized to match the experimental SNSPD response data. The two-signal detection scheme is simulated using JSIM which allows for the simulation of Josephson junction elements in a circuit. We demonstrate a model of the two-signal circuit operating with two simulated SNSPD pixel inputs and investigate the response of the scheme when a phase shift is applied to one of the inputs. The scheme shows potential as a useful coincidence detector of single photons. We also present preliminary experimental results of nanobridge-based Josephson junctions to be used in the realization of the coincidence detector circuit. Evidence of the nanobridges exhibiting Josephson behavior (SQUID modulation) are presented.

IEEE International Superconductive Electronics Conference (ISEC)•Jun 1, 2017•2 citations

Readout Electronics Using Single-Flux-Quantum Circuit Technology for Superconducting Single-Photon Detector Array

Hirotaka Terai, Shigehito Miki, Zhen Wang

Superconducting single-photon detectors (SSPDs) based on NbN nanowires possess properties such as high counting rate, low dark count rate and small timing jitter, which are promising characteristics for a quantum key distribution system. An SSPD array has recently attracted attention, because it can provide a higher counting rate, and spatial and photon-number resolutions. We propose readout electronics using single-flux-quantum (SFQ) circuits to process a large number of output signals from an SSPD array. We designed and tested an interface circuit between an SSPD and SFQ circuit, and successfully observed SFQ pulse generation for an input pulse with a current amplitude of 17.4 ~ 36.4 muA , which is comparable with an output current amplitude of the SSPD. The interface circuit was also operational for an input pulse duration of 1.6 ns, which is shorter than the typical recovery time of the SSPD.

IEEE Transactions on Applied Superconductivity•Jun 1, 2009•63 citations

Superconducting single photon detectors integrated with single flux quantum readout circuits in a cryocooler

Shigehito Miki, Hirotaka Terai, Taro Yamashita +4 more

We report the operation of superconducting single photon detectors (SSPDs) with integrated readout electronics based on a single-flux-quantum (SFQ) circuit. The SSPDs were connected to a SFQ readout circuit without bias tee in a cryocooler system, and detection efficiencies (DEs) were measured to verify their correct operation. The DE curves matched well with those measured by conventional readout electronics, and the maximum bias current for normal operation was increased. In addition, we confirmed that the SFQ circuit correctly merged the input signals from two SSPDs. SSPDs with a SFQ readout circuit demonstrated a favorable timing jitter of 50 ps.

Applied Physics Letters•Sep 12, 2011•55 citations

Demonstration of single-flux-quantum readout operation for superconducting single-photon detectors

Hirotaka Terai, Shigehito Miki, Taro Yamashita +2 more

A readout circuit using superconducting single-flux-quantum (SFQ) circuits has been developed to realize an independently addressable array of superconducting single-photon detectors (SSPDs). We tested the SFQ readout circuits by connecting with SSPDs. The error rates of readout circuits were below 10−5 for input signal amplitude of greater than 18.2 μA. Detection efficiencies (DEs) for single-photon incidents were measured both with and without the connection of a readout circuit. The observed DEs traced almost the same curves regardless of the connection of the readout circuit, except that the SSPD is likely to latch by connecting the readout circuit.

Applied Physics Letters•Sep 13, 2010•43 citations

Modified Superconducting Single-Flux Quantum Two-Photon Coincidence Correlator for Single-Photon Measurements

I. Komissarov, Amir Jafari Salim, Oleg A. Mukhanov +3 more

A design and performance of a single-flux-quantum–based digital correlator is presented to trace independent signals from two superconducting single-photon detectors, triggering its inputs.

•Jan 1, 2024•0 citations

Low-jitter single flux quantum signal readout from superconducting single photon detector

Hirotaka Terai, Taro Yamashita, Shigehito Miki +2 more

We developed a single-flux-quantum (SFQ) readout technology for superconducting single-photon detectors (SSPDs) to achieve low-jitter signal readout. By optimizing circuit parameters of the SFQ readout circuit, the input current sensitivity was improved below 10 μA, which is smaller than a typical critical current of SSPD. The experiment using a pulse-pattern generator as an input pulse source revealed that the measured jitter of the SFQ readout circuit is well below the system jitter of our measurement setup for the input current level above 15 μA. The measured jitter of the SSPD connected to the SFQ readout circuit was 37 ps full width at half maximum (FWHM) for an SSPD bias current of around 18 μA, which is a significant improvement on 67 ps FWHM jitter observed in conventional readout without an SFQ readout circuit.

Optics Express•Aug 17, 2012•41 citations

We present a single-flux-quantum (SFQ) based digital correlator to trace independent signals from two superconducting single-photon detectors (SSPDs) triggering its inputs. In our design two SSPDs are magnetically coupled to inputs of a readout system where direct current (DC)-to-SFQ converters are used to convert transient SSPD output pulses, triggered by detection of single-photon events, to SFQ pulses. The coincidence verification of SFQ pulses, generated by the two DC-to-SFQ converters, is performed with a modified SFQ coincidence buffer. The coincidence buffer is designed to generate an SFQ output pulse only when its both inputs are triggered simultaneously, or within a preset margin time. The output of the coincidence buffer is connected via, this time, an SFQ-to-DC converter, to a pulse counter operated at room temperature. We performed extensive simulations of both the SSPD equivalent circuit and correlator redout elements for the proposed coincidence scheme, using a WRSpice and PSCAN2 simulation platforms that are specifically designated to model Josephson junctions and widely used to simulate operation of the SFQ circuitry. In particular, we investigated our coincidence correlator scheme for measurements of the second-order correlation function, used to demonstrate the antibunching effect in the single-photon detection of non-classical light.

We present a two-signal single flux quantum (SFQ) detection scheme for the purpose of reading out two pixels of a superconducting nanowire single photon detector (SNSPD). The circuit is based on a coincidence buffer element which is able to output a signal when both of its input lines are triggered. The circuit model for the SNSPD element is simulated in SPICE and optimized to match the experimental SNSPD response data. The two-signal detection scheme is simulated using JSIM which allows for the simulation of Josephson junction elements in a circuit. We demonstrate a model of the two-signal circuit operating with two simulated SNSPD pixel inputs and investigate the response of the scheme when a phase shift is applied to one of the inputs. The scheme shows potential as a useful coincidence detector of single photons. We also present preliminary experimental results of nanobridge-based Josephson junctions to be used in the realization of the coincidence detector circuit. Evidence of the nanobridges exhibiting Josephson behavior (SQUID modulation) are presented.

Superconducting single-photon detectors (SSPDs) based on NbN nanowires possess properties such as high counting rate, low dark count rate and small timing jitter, which are promising characteristics for a quantum key distribution system. An SSPD array has recently attracted attention, because it can provide a higher counting rate, and spatial and photon-number resolutions. We propose readout electronics using single-flux-quantum (SFQ) circuits to process a large number of output signals from an SSPD array. We designed and tested an interface circuit between an SSPD and SFQ circuit, and successfully observed SFQ pulse generation for an input pulse with a current amplitude of 17.4 ~ 36.4 muA , which is comparable with an output current amplitude of the SSPD. The interface circuit was also operational for an input pulse duration of 1.6 ns, which is shorter than the typical recovery time of the SSPD.

We report the operation of superconducting single photon detectors (SSPDs) with integrated readout electronics based on a single-flux-quantum (SFQ) circuit. The SSPDs were connected to a SFQ readout circuit without bias tee in a cryocooler system, and detection efficiencies (DEs) were measured to verify their correct operation. The DE curves matched well with those measured by conventional readout electronics, and the maximum bias current for normal operation was increased. In addition, we confirmed that the SFQ circuit correctly merged the input signals from two SSPDs. SSPDs with a SFQ readout circuit demonstrated a favorable timing jitter of 50 ps.

A readout circuit using superconducting single-flux-quantum (SFQ) circuits has been developed to realize an independently addressable array of superconducting single-photon detectors (SSPDs). We tested the SFQ readout circuits by connecting with SSPDs. The error rates of readout circuits were below 10−5 for input signal amplitude of greater than 18.2 μA. Detection efficiencies (DEs) for single-photon incidents were measured both with and without the connection of a readout circuit. The observed DEs traced almost the same curves regardless of the connection of the readout circuit, except that the SSPD is likely to latch by connecting the readout circuit.

We developed a single-flux-quantum (SFQ) readout technology for superconducting single-photon detectors (SSPDs) to achieve low-jitter signal readout. By optimizing circuit parameters of the SFQ readout circuit, the input current sensitivity was improved below 10 μA, which is smaller than a typical critical current of SSPD. The experiment using a pulse-pattern generator as an input pulse source revealed that the measured jitter of the SFQ readout circuit is well below the system jitter of our measurement setup for the input current level above 15 μA. The measured jitter of the SSPD connected to the SFQ readout circuit was 37 ps full width at half maximum (FWHM) for an SSPD bias current of around 18 μA, which is a significant improvement on 67 ps FWHM jitter observed in conventional readout without an SFQ readout circuit.