IEEE Transactions on Applied Superconductivity

Development of an SIS Mixer-Based Low-Noise Amplifier Amenable to Josephson Oscillator Pumping

Yoshinori Uzawa, Takafumi Kojima, Kazumasa Makise, Akira Kawakami, Yuto Kozuki, Sho Masui, Wenlei Shan

Published Mar 8, 2023• 5 citations

Abstract

We propose a low-noise and low-power-consumption microwave amplifier using superconductor-insulator-superconductor (SIS) mixers as quasi-particle frequency up- and down-converters pumped by a Josephson array oscillator in the millimeter-wave band. A proof-of-concept study of an amplifier with two W-band waveguide mixers using Nb/Al-AlOx/Nb junctions in a cascade connection demonstrated an average gain of 6 dB and a noise temperature of 12 K from nearly DC to 5 GHz. We also designed and fabricated a Josephson array oscillator at 100 GHz, which consisted of 31 overdamped Josephson junctions placed at each half-wavelength in an Nb microstrip line. The estimated output power of the oscillator was 0.2 μW at 100 GHz, which can be increased by increasing the number of the oscillator junctions. These results suggest that the proposed SIS mixer-based amplifier is suitable for on-chip integrated circuits to be implemented in large-scale multipixel SIS receivers and quantum computers.

DOI: 10.1109/tasc.2023.3254496

Related papers

Fabrication and Evaluation of Waveguide Josephson Array Oscillators at Millimeter-Wave Lengths for SIS Mixer-Based Amplifiers

Yosuke Murayama, Akira Kawakami, Wenlei Shan +5 more

In this study, a 150 GHz waveguide Josephson array oscillator was designed, fabricated, and evaluated as a local oscillator (LO) source for superconductor-insulator-superconductor (SIS) mixer-based amplifiers. These amplifiers aim to reduce the power consumption of microwave amplifiers used in large-scale multi-pixel heterodyne receivers for radio astronomy and superconducting quantum computers. We fabricated a Josephson array oscillator of 11 Nb/Al–AlOx/Nb Josephson junctions with Cu shunt resistors, each of which is placed on the center of a half-wavelength microstrip line resonator. When the LO signal from the oscillator was introduced into the balanced SIS mixers via a waveguide, the oscillator successfully pumped four SIS mixers simultaneously, delivering a total estimated LO power of 0.22 µW at 146.7 GHz. The SIS mixers operated without a millimeter-wave isolator at an LO noise temperature of 4–6 K. These results indicate the Josephson array oscillator's potential as an LO source for SIS mixer-based amplifiers.

IEEE Transactions on Applied SuperconductivityDec 12, 20243 citations

An SIS-mixer-based amplifier for multi-pixel heterodyne receivers

Yoshinori Uzawa, Takafumi Kojima, Yuto Kozuki +5 more

We are investigating a possible microwave amplifier with low noise and low power consumption at cryogenic temperature for large scale multi-pixel heterodyne superconductor-insulator-superconductor (SIS) receivers at millimeter and submillimeter wavelengths. We propose the use of SIS junctions as amplifier elements based on quasi-particle mixing. By connecting an SIS up-converter and an SIS down-converter in series with gain in both converters, a lownoise and low-power-consumption high-frequency amplifier can be obtained in principle. A proof-of-concept study has been made by configuring an amplifier with two Nb/Al-AlOx/Nb mixers in the 150-GHz band in a standard noise and gain measurement setup at 4 K with a microwave noise source as an input signal. We observed a maximum gain of more than 10 dB and a minimum noise temperature of less than 10 K, which suggests that our proposed SIS amplifier is capable for multi-pixel SIS receivers. On the other hand, we also observed a periodical behavior in frequency dependence of the measured noise temperature and gain due to a standing-wave effect between the two SIS mixers, which is a problem to be solved.

Millimeter, Submillimeter, and Far-Infrared Detectors and Instrumentation for Astronomy XIDec 12, 20208 citations

Development of an SIS mixer-based amplifier for large-scale multipixel heterodyne receivers

Yoshinori Uzawa, Akira Kawakami, Takafumi Kojima +5 more

This paper introduces a potential low-power-consumption and low-noise microwave amplifier operated at cryogenic temperature, essential for large-scale multi-pixel heterodyne receivers and fault-tolerant quantum computers. The amplifier employs two millimeter-wave superconductor-insulator-superconductor (SIS) mixers as amplifying elements and a millimeter-wave Josephson array oscillator as the local oscillator source. A proof-of-concept experiment utilizing waveguide SIS mixer modules demonstrated an average gain of approximately 7.5 dB and a noise temperature of around 10 K at microwave frequencies. Additionally, a waveguide Josephson array oscillator module, developed to validate the design, exhibited an output power of roughly 52 nW, estimated from the response of a waveguide SIS detector connected to the oscillator module. These findings indicate the feasibility of realizing a monolithically integrated amplifier chip incorporating SIS mixers and a Josephson array oscillator.

Millimeter, Submillimeter, and Far-Infrared Detectors and Instrumentation for Astronomy XIAug 16, 20240 citations

Development of a Waveguide Josephson Oscillator for SIS Mixer-Based Amplifiers

Yoshinori Uzawa, Akira Kawakami, Takafumi Kojima +6 more

A waveguide Josephson array oscillator operating at a frequency of 100 GHz was designed and fabricated to evaluate its pumping capability as a local oscillator (LO) for our proposed SIS mixer-based amplifier, which incorporates SIS up- and down-converters. The LO power requirement was estimated by simulation to be several nanowatts when the SIS up-converter is optimized for noise temperature and conversion gain under the condition that the input port at the microwave frequencies is connected to a practical 50-W system. The fabricated waveguide Josephson array oscillator module has 31 Nb Josephson junctions placed at the center of a half-wavelength resonator of an Nb microstripline. The output power from the waveguide oscillator module was evaluated by connecting it to the waveguide SIS detector module in a 4-K cryostat. Photon-assisted tunneling steps were clearly observed, from which the detected power was estimated to be approximately 17 nW at 106 GHz. These results suggest that the Josephson array oscillator is capable of being used in the SIS mixer-based amplifier as the LO.

IEEE Transactions on Applied SuperconductivityJan 26, 20243 citations

Optimization and Validation of the Design of Superconductor-Insulator-Superconductor Mixer-Based Amplifier Circuits

Yoshinori Uzawa, Wenlei Shan, Akira KAWAKAMI +5 more

We propose an optimization method for a superconductor-insulator-superconductor (SIS) mixer-based amplifier circuit that employs SIS up- and down-converters. Such a novel amplifier configuration could enable superior low-noise performance for future broadband amplifier systems, such as those for large arrays of superconducting sensors or qubits. Optimization was achieved by identifying a solution in which the mutually dependent impedances of the SIS mixers converge under given conditions. A circuit design using this method predicted an amplifier gain of approximately 20 dB and a noise temperature of approximately 2 K at 4 K operation when practical current-voltage characteristics of Nb SIS junctions are used in the simulation. To verify the validity of this method, an amplifier circuit was prepared using waveguide Nb/AlOx/Nb mixer modules. By varying the phase delay between the two SIS mixers, changes in gain were observed, resulting from different convergence conditions of their mutually dependent impedances, which closely matched the predictions made using this method. These results are promising for the development of an integrated circuit including SIS amplifiers and superconducting detector arrays, with bandwidths of 10 GHz or above. This may also enable novel nonreciprocal microwave circuits such as gyrators, isolators, and circulators.

IEEE Transactions on Applied SuperconductivityDec 23, 20250 citations

Superconducting millimeter wave oscillators and SIS mixers integrated on a chip

V. P. Koshelets, А. В. Щукин, S. V. Shitov +1 more

All-refractory material superconducting millimeter-wave oscillators have been designed and investigated experimentally with different superconductor-insulator-superconductor (SIS) mixers integrated on the same chip. Tested structures include a flux-flow oscillator (FFO) based on a long Josephson junction, a coupling section, and an SIS detector with tuned out junction capacitance. Coupling sections were designed as multistep microstrip quarter-wave impedance transformers. All junctions have been fabricated on the basis of a high-quality trilayer Nb-AlO/sub x/-Nb process. Microwave oscillations in the frequency range 75-500 GHz have been detected experimentally. The level of delivered power was estimated from the pumped I-V curve of the strongly coupled single junction detector. Coupled power levels higher than 0.1 mu W at 256 GHz were achieved. A spectral linewidth of the FFO of less than 1 MHz has been estimated experimentally. The first attempt to create an integrated receiver based on an FFO and an SIS array mixer integrated on the same chip was made in the 2-mm wavelength band.>

IEEE Transactions on Applied SuperconductivityMar 1, 199367 citations