Modern Physics Letters B

Combined magnetic field system for atom chips

Xuemei Jia, Bowen Xu, Shuyu Zhou, Ying Wang

Published Dec 20, 2022• 0 citations

Abstract

In this paper, we have developed a combined magnetic field system to explore an alternative technical route for the generation of Bose–Einstein condensates containing numerous atoms on an atom chip. The system is characterized by the fact that the quadrupole magnetic field required by the magneto-optic trap is generated by U-shaped current-carrying wires combined with bias magnetic fields, whereas the quadrupole magnetic field adopted for the magnetic trap is generated by anti-Helmholtz coils. By fine-tuning the bias magnetic fields, the collection of atoms in the mirror MOT and the loading of the quadrupole magnetic trap can be optimized. The initial number of [Formula: see text]Rb atoms in the magnetic trap is approximately [Formula: see text], and the lifetime of the atoms is over 30 s. This scheme can facilitate the chip-surface design and is suitable for the precise manipulation of Bose–Einstein condensates near the chip surface.

DOI: 10.1142/s0217984922501846

Related papers

Practical scheme to realize 2D array of BECs on an atom chip: novel 2D magneto-optical and magnetic lattices

Min Yun, Jianping Yin

An array of square current-carrying wires is proposed to construct a two-dimensional (2D) array of surface magneto-optical traps and Ioffe magnetic ones for realizing a 2D lattice of Bose-Einstein condensations (BECs) on an atom chip. Our study shows that when a vertical homogeneous bias magnetic field is only used, the wires will form a 2D array of quadrupole magnetic traps, which can be used to construct 2D lattice of surface magneto-optical micro-traps. While another horizontal homogeneous bias field is added simultaneously, the above 2D array of quadrupole micro-traps will be changed as an array of surface Ioffe micro-traps, which can be used to form a 2D magnetic lattice and then realize a 2D array of BECs. The dynamic loading process of cold (87)Rb atoms from each micro-MOT into Ioffe micro-trap is studied by using Monte-Carlo simulations, and our results show that the scheme can be used to realize a natural and effective loading of cold atoms from 2D array of micro-MOTs into 2D array of Ioffe micro-traps, and the loading efficiency can be reach ~ 65%. Moreover, the positions of each BEC (or MOT) in 2D array of magnetic micro-traps can be controlled by adjusting the currents in the wires or by changing the additional vertical bias field.

Optics ExpressJan 1, 20069 citations

Bose-Einstein condensates on a magnetic film atom chip

S. Whitlock

Atom chips are devices used to magnetically trap and manipulate ultracold atoms and Bose-Einstein condensates near a surface. In particular, permanent magnetic film atom chips can allow very tight confinement and intricate magnetic field designs while circumventing technical current noise. Research described in this thesis is focused on the development of a magnetic film atom chip, the production of Bose-Einstein condensates near the film surface, the characterisation of the associated magnetic potentials using rf spectroscopy of ultracold atoms and the realisation of a precision sensor based on splitting Bose-Einstein condensates in a double-well potential. The atom chip itself combines the edge of a perpendicularly magnetised GdTbFeCo film with a machined silver wire structure. A mirror magneto-optical trap collects up to 5 x 108 87Rb atoms beneath the chip surface. The current-carrying wires are then used to transfer the cloud of atoms to the magnetic film microtrap and radio frequency evaporative cooling is applied to produce Bose-Einstein condensates consisting of 1 x 105 atoms. We have identified small spatial magnetic field variations near the film surface that fragment the ultracold atom cloud. These variations originate from inhomogeneity in the film magnetisation and are characterised using a novel technique based on spatially resolved radio frequency spectroscopy of the atoms to map the magnetic field landscape over a large area. The observations agree with an analytic model for the spatial decay of random magnetic fields from the film surface. Bose-Einstein condensates in our unique potential landscape have been used as a precision sensor for potential gradients. We transfer the atoms to the central region of the chip which produces a double-well potential. A single BEC is formed far from the surface and is then dynamically split in two by moving the trap closer to the surface. After splitting, the population of atoms in each well is extremely sensitive to the asymmetry of the potential and can be used to sense tiny magnetic field gradients or changes in gravity on a small spatial scale.

Jan 1, 20075 citations

On loading of a magneto-optical trap on an atom-chip with U-wire quadrupole field

Vivek Singh, Vibhuti Bhushan Tiwari, K. A. P. Singh +1 more

The role of U-wire generated quadrupole-like magnetic field profile on loading of cold 87Rb atoms in a magneto-optical trap (MOT) on atom-chip has been investigated. It is shown by simulations that the quadrupole field profile and the centre of the quadrupole field vary depending upon the U-wire current and bias field values. Moreover, the resemblance of generated field profile to the ideal quadrupole field critically depends on the values of current in U-wire and bias magnetic field. The observed number of trapped atoms in the MOT and its position has also been found to depend on the quadrupole field profile. The number of trapped atoms in the MOT reaches maximum when the field profile approaches close to an ideal quadrupole field. These studies are, in general, useful in optimizing the number in the MOT before transfer of these cold atoms to the microtraps of an atom-chip.

arXiv:1801.09461Journal of Modern OpticsAug 21, 201814 citations

From MOT to BEC using a single crossed-wire pair

Joshua M. Wilson, James A. Stickney, Francisco Fonta +4 more

We demonstrate a new magneto-optical trap (MOT) configuration using a simple pair of crossed wires rotated at 45 deg and an appropriate bias field to generate a MOT of >10^8 atoms. The same pair of wires, with slightly adjusted control parameters, is then used to magnetically trap the atoms and cool them via forced evaporative cooling into a Bose-Einstein condensate (BEC) with >10^4 atoms. We present the theoretical framework for generating a quadrupole field using a pair of crossed wires with arbitrary rotation angle, along with the atom chip design and fabrication. Finally, we describe the experimental protocols required for BEC production using only a single crossed-wire atom chip.

physics.atom-phCross-listedarXiv:2603.17119Mar 19, 20260 citations

Miniature Bose–Einstein condensate system design based on a transparent atom chip

Jun Jie Cheng, Xiaolin Li, Jingfang Zhang +4 more

Abstract We propose a new miniature Bose–Einstein condensate (BEC) system based on a transparent atom chip with a compact external coil structure. A standard six-beam macroscopic magneto-optical trap (MOT) is able to be created near the chip surface due to the chip’s transparency. A novel wire pattern consisting of a double-z wire and a z-shaped wire is designed on the transparent atom chip. With a vertical bias magnetic field, the double-z wire can create the quadrupole magnetic field of an intermediate chip MOT, which is suitable for transporting atoms from the macroscopic MOT to the chip z-wire trap efficiently. The compact external coil structure is designed with a rectangular frameless geometry consisting of only four coil pairs and its volume is less than 0.3 liters. The maximum system power consumption during the BEC generation procedure is about 45 W. The miniature system is evaluated, and about 3 × 10 6 atoms can be loaded into the chip z-wire trap. The miniature chip BEC system has the advantages of small volume and low power consumption, and it has great potential for practical applications of BEC.

Journal of Physics B Atomic Molecular and Optical PhysicsJul 22, 20163 citations

Characterization of magnetic field for loading, trapping and transferring cold atom close to the atom chip’s surface

Nuttida Kaewart, Nithiwadee Thaicharoen, Pimonpan Sompet +1 more

Abstract Atom chips provide flexible technologies for implementing modern concepts in quantum optics, quantum measurement, and quantum information processing. Atom chips are miniature devices that confine, control and manipulate cold atoms using electric, magnetic, and light fields. Due to the shrinkage of scale, arbitrary magnetic traps can be generated from current sources outside the chip’s vacuum compartment, in contrast to a traditional setup. This makes it easy to change trap configurations in an experiment that involves rapid prototyping of quantum states and quantum trajectory designs in free space. In this work, we show relevant parameters needed for transferring a cold atom cloud at the recoil limit from a magneto-optical trap (MOT) to an area close to the atom chip. To create a movable magnetic potential for this transfer, we used the MOT coils and an additional pair of coils in an anti-Helmholtz configuration. The properties of the movable potential were obtained by performing the Computer Simulation Tool (CST EM Studio suite®). Furthermore, an appropriate magnetic trap on a chip is developed, based on the simulation from COMSOL Multiphysics. We used a magnetic field gradient of around 20 G/cm to transport the cold atom with a distance over 20 mm with a temperature gain below 100 micro-Kelvin. The simulation results are based on an atom chip with a size of 2×2 cm2 and a copper wire thickness of 2 mm. The atom chip consists of Z, U and I-shaped wires that generate a quadrupole magnetic field. The resulting field minimum can be made at least 7 mm away from the chip surface.

Journal of Physics Conference SeriesDec 1, 20231 citation