Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optics Letters

Control of the VCSEL spectrum by dual microwave frequency modulation

Alexander P. Bogatov, Alexander E. Drakin, Maria I. Vaskovskaya, Dmitry S. Chuchelov, Kirill M. Sabakar, Eugene A. Tsygankov, Vitali V. Vassiliev, Vladimir L Velichansky, Sergey A. Zibrov

Published Nov 10, 2022• 9 citations
Publisher

Abstract

We propose and investigate a method for controlling the spectrum of the vertical-cavity surface-emitting laser by simultaneous modulation of the injection current at single and doubled frequencies. We experimentally demonstrate the ability to control the power asymmetry of the first-order sidebands and to suppress the carrier by the proposed method. These possibilities are beneficial to improve frequency stability of atomic clocks based on the effect of coherent population trapping.

DOI
10.1364/ol.476838

Related papers

Dual microwave frequency modulation of the VCSEL injection current for a CPT-based atomic clock

Maria I. Vaskovskaya, Dmitry S. Chuchelov, Eugene A. Tsygankov +3 more

Previously, we have proposed a method to control the emission spectrum of the vertical-cavity surface-emitting laser (VCSEL) with the synchronized modulation of the injection current at single and doubled frequencies. In this work, the above method is used to improve the metrological characteristics of the coherent population trapping (CPT) resonance in 87 Rb. The dual-frequency (DF) modulation reduces the carrier power and suppresses the light shift of the resonance frequency, if it is unattainable with the single-frequency modulation. In addition, a higher resonance contrast is achieved by equalizing the powers of the resonant components of the spectrum.

Optics Letters•Jul 31, 2024•5 citations

Nonlinear spectroscopy using a current-modulated VCSEL

C. Affolderbach, W. Kemp, Svenja A. Knappe +2 more

We have performed a series of experiments demonstrating the use of a vertical-cavity surface-emitting laser for nonlinear spectroscopy on the cesium D2 transition at 852 nm wavelength. Due to the high modulation efficiency of the VCSEL sufficiently strong modulation sidebands at 9.2 GHz frequency can be produced by direct modulation of the laser injection current. Using, the carrier and one of the modulation sidebands coherent population trapping (CPT) resonances in a buffered cesium vapor can be prepared with linewidths of only 60 Hz. For application of these narrow resonances to precision magnetometry we find a sensitivity of 10 pT in 0.3 s integration time. For the use of our setup as a frequency reference a relative stability of 1 • 10 − 11 / τ is predicted. In both applications of CPT resonances the use of VCSELs as light sources helps to build compact and reliable devices.

Advanced Semiconductor Lasers and Their Applications•Jan 1, 1999•0 citations

Enhancement in microwave modulation efficiency of vertical cavity surface-emitting laser by optical feedback

Nemi Gavra, Valentina R. Ruseva, M. Rosenbluh

We investigate a versatile vertical cavity surface-emitting laser (VCSEL) with a slight optical feedback from a simple wedge positioned at a well determined distance from the VCSEL. We use such a laser in conjunction with a miniature Rb atomic cell to detect coherent population trapping (CPT) when the external cavity mode spacing frequency corresponds to half the hyperfine frequency of Rb. The feedback greatly enhances the rf modulation efficiency of the VCSEL and as a result we obtain high contrast CPT signals at an input of −16dBm of rf modulation power compared to +1.25dBm needed in the absence of the external cavity.

Applied Physics Letters•Jun 2, 2008•11 citations

Features of a CPT-based atomic clock with pumping by different-order sidebands of a VCSEL's frequency

Daba A. Radnatarov, Sergey M Kobtsev, Valeriy Andryushkov +1 more

Presented for the first time is our research into reduction of energy consumption of miniaturised Rb atomic clocks based on coherent population trapping (CPT) effect at lowered microwave modulation frequency. We studied properties of a CPT-based atomic frequency standard pumped with multi-frequency radiation from sidebands of a single-frequency semiconductor laser whose injection current was modulated at subharmonics (1/2–1/6) of the frequency of Rb hyperfine ground state splitting. Pumping by third-order sidebands is the optimum when the atomic clock stability drops only slightly (by 11%), whereas energy consumption of the microwave components is reduced by a factor of 1.5.

•Nov 19, 2019•1 citation

A chip scale lin⊥lin quasi-bichromatic laser scheme

Bozhong Tan, Peter Yun, Jing Yang +2 more

We present a chip scale lin⊥lin quasi-bichromatic laser beam generator scheme and our experimental study results. Through modulating two vertical-cavity surface-emitting lasers (VCSELs) with the same microwave, both VCSELs output multichromatic lasers and every frequency component in their outputs contributes for the frequency mutual injection locking between VCSELs. The system outputs a lin⊥lin quasi-bichromatic laser beam in which the two wanted frequency components share more than 90% of the total laser power. It is promising to apply the chip device in the chip scale coherent population trapping (CPT) atomic clock and the chip scale CPT magnetometer.

Applied Physics Letters•Apr 22, 2013•10 citations

VCSELs for atomic clocks

Darwin K. Serkland, Gregory M. Peake, K.M. Geib +4 more

The spectroscopic technique of coherent population trapping (CPT) enables an all-optical interrogation of the groundstate hyperfine splitting of cesium (or rubidium), compared to the optical-microwave double resonance technique conventionally employed in atomic frequency standards. All-optical interrogation enables the reduction of the size and power consumption of an atomic clock by two orders of magnitude, and vertical-cavity surface-emitting lasers (VCSELs) are preferred optical sources due to their low power consumption and circular output beam. Several research teams are currently using VCSELs for DARPA's chip-scale atomic clock (CSAC) program with the goal of producing an atomic clock having a volume < 1 cm^3, a power consumption < 30 mW, and an instability (Allan deviation) < 1x10^-11 during a 1-hour averaging interval. This paper describes the VCSEL requirements for CPT-based atomic clocks, which include single mode operation, single polarization operation, modulation bandwidth > 4 GHz, low power consumption (for the CSAC), narrow linewidth, and low relative intensity noise (RIN). A significant manufacturing challenge is to reproducibly obtain the required wavelength at the specified VCSEL operating temperature and drive current. Data are presented that show the advantage of operating at the D1 (rather than D2) resonance of the alkali atoms. Measurements of VCSEL linewidth will be discussed in particular, since atomic clock performance is especially sensitive to this parameter.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Feb 9, 2006•60 citations
We propose and investigate a method for controlling the spectrum of the vertical-cavity surface-emitting laser by simultaneous modulation of the injection current at single and doubled frequencies. We experimentally demonstrate the ability to control the power asymmetry of the first-order sidebands and to suppress the carrier by the proposed method. These possibilities are beneficial to improve frequency stability of atomic clocks based on the effect of coherent population trapping.
Previously, we have proposed a method to control the emission spectrum of the vertical-cavity surface-emitting laser (VCSEL) with the synchronized modulation of the injection current at single and doubled frequencies. In this work, the above method is used to improve the metrological characteristics of the coherent population trapping (CPT) resonance in 87 Rb. The dual-frequency (DF) modulation reduces the carrier power and suppresses the light shift of the resonance frequency, if it is unattainable with the single-frequency modulation. In addition, a higher resonance contrast is achieved by equalizing the powers of the resonant components of the spectrum.
We have performed a series of experiments demonstrating the use of a vertical-cavity surface-emitting laser for nonlinear spectroscopy on the cesium D2 transition at 852 nm wavelength. Due to the high modulation efficiency of the VCSEL sufficiently strong modulation sidebands at 9.2 GHz frequency can be produced by direct modulation of the laser injection current. Using, the carrier and one of the modulation sidebands coherent population trapping (CPT) resonances in a buffered cesium vapor can be prepared with linewidths of only 60 Hz. For application of these narrow resonances to precision magnetometry we find a sensitivity of 10 pT in 0.3 s integration time. For the use of our setup as a frequency reference a relative stability of 1 • 10 − 11 / τ is predicted. In both applications of CPT resonances the use of VCSELs as light sources helps to build compact and reliable devices.
We investigate a versatile vertical cavity surface-emitting laser (VCSEL) with a slight optical feedback from a simple wedge positioned at a well determined distance from the VCSEL. We use such a laser in conjunction with a miniature Rb atomic cell to detect coherent population trapping (CPT) when the external cavity mode spacing frequency corresponds to half the hyperfine frequency of Rb. The feedback greatly enhances the rf modulation efficiency of the VCSEL and as a result we obtain high contrast CPT signals at an input of −16dBm of rf modulation power compared to +1.25dBm needed in the absence of the external cavity.
Presented for the first time is our research into reduction of energy consumption of miniaturised Rb atomic clocks based on coherent population trapping (CPT) effect at lowered microwave modulation frequency. We studied properties of a CPT-based atomic frequency standard pumped with multi-frequency radiation from sidebands of a single-frequency semiconductor laser whose injection current was modulated at subharmonics (1/2–1/6) of the frequency of Rb hyperfine ground state splitting. Pumping by third-order sidebands is the optimum when the atomic clock stability drops only slightly (by 11%), whereas energy consumption of the microwave components is reduced by a factor of 1.5.
We present a chip scale lin⊥lin quasi-bichromatic laser beam generator scheme and our experimental study results. Through modulating two vertical-cavity surface-emitting lasers (VCSELs) with the same microwave, both VCSELs output multichromatic lasers and every frequency component in their outputs contributes for the frequency mutual injection locking between VCSELs. The system outputs a lin⊥lin quasi-bichromatic laser beam in which the two wanted frequency components share more than 90% of the total laser power. It is promising to apply the chip device in the chip scale coherent population trapping (CPT) atomic clock and the chip scale CPT magnetometer.
The spectroscopic technique of coherent population trapping (CPT) enables an all-optical interrogation of the groundstate hyperfine splitting of cesium (or rubidium), compared to the optical-microwave double resonance technique conventionally employed in atomic frequency standards. All-optical interrogation enables the reduction of the size and power consumption of an atomic clock by two orders of magnitude, and vertical-cavity surface-emitting lasers (VCSELs) are preferred optical sources due to their low power consumption and circular output beam. Several research teams are currently using VCSELs for DARPA's chip-scale atomic clock (CSAC) program with the goal of producing an atomic clock having a volume < 1 cm^3, a power consumption < 30 mW, and an instability (Allan deviation) < 1x10^-11 during a 1-hour averaging interval. This paper describes the VCSEL requirements for CPT-based atomic clocks, which include single mode operation, single polarization operation, modulation bandwidth > 4 GHz, low power consumption (for the CSAC), narrow linewidth, and low relative intensity noise (RIN). A significant manufacturing challenge is to reproducibly obtain the required wavelength at the specified VCSEL operating temperature and drive current. Data are presented that show the advantage of operating at the D1 (rather than D2) resonance of the alkali atoms. Measurements of VCSEL linewidth will be discussed in particular, since atomic clock performance is especially sensitive to this parameter.