A high imaging resolution or a tight focus of a laser beam imposes a certain minimal numerical aperture (NA) of the optical system. Macroscopic high NA lenses constraint strongly the spatial organization of experiments, in particular when imaging or trapping cold atoms inside a vacuum chamber. Multimode fibers, in conjunction with spatial light modulators, offer an interesting alternative to high NA lenses. Indeed, they are flexible optical waveguides with very small transverse dimensions (∼ 100 μm), and reasonably high NA (up to 0.5). For those reasons, the use of multimode fibers for imaging or laser manipulation purposes has been widely studied in the past years. Here, we transfer these techniques to the field of cold atoms with a multimode fiber forming a compact optical bridge between the inside and the outside of an ultra-high vacuum chamber. We manipulate atoms with laser beams produced through the fiber by digital optical phase conjugation with a spatial light modulator. We are able to transport a small cloud of cold rubidium atoms with a moving optical lattice at about 200 μm from the fiber tip. We can then load them in small optical tweezers with a waist of 1.2 μm. By characterizing the propagation of light modes inside the fiber, we numerically invert its transformation and we reconstruct absorption images of the trapped atoms with a resolution of approximately 1 μm. These results pave the way towards the efficient use of multimode fibers in spatially constrained quantum technology platforms relying on cold atoms.
A high imaging resolution or a tight focus of a laser beam imposes a certain minimal numerical aperture (NA) of the optical system. Macroscopic high NA lenses constraint strongly the spatial organization of experiments, in particular when imaging or trapping cold atoms inside a vacuum chamber. Multimode fibers, in conjunction with spatial light modulators, offer an interesting alternative to high NA lenses. Indeed, they are flexible optical waveguides with very small transverse dimensions (∼ 100 μm), and reasonably high NA (up to 0.5). For those reasons, the use of multimode fibers for imaging or laser manipulation purposes has been widely studied in the past years. Here, we transfer these techniques to the field of cold atoms with a multimode fiber forming a compact optical bridge between the inside and the outside of an ultra-high vacuum chamber. We manipulate atoms with laser beams produced through the fiber by digital optical phase conjugation with a spatial light modulator. We are able to transport a small cloud of cold rubidium atoms with a moving optical lattice at about 200 μm from the fiber tip. We can then load them in small optical tweezers with a waist of 1.2 μm. By characterizing the propagation of light modes inside the fiber, we numerically invert its transformation and we reconstruct absorption images of the trapped atoms with a resolution of approximately 1 μm. These results pave the way towards the efficient use of multimode fibers in spatially constrained quantum technology platforms relying on cold atoms.
We show that a standard multimode optical fiber can act as a high-resolution ultra-compact tool to manipulate cold atoms in setups with limited optical access. Spatial light modulators allow us to generate control beams at the in-vacuum fiber end by digital optical phase conjugation. With no additional in-vacuum optics, this system reaches a $ \sim 1\;{\unicode{x00B5}{\rm m}} $∼1µm resolution for a transverse size of only 225 µm. As a demonstration, we use it to optically transport cold atoms towards the in-vacuum fiber end, to load them in optical microtraps, and to re-cool them in optical molasses. This work shows that the rapid progress of optics in complex media opens new, to the best of our knowledge, perspectives for spatially constrained quantum technology platforms combining cold atoms with other optical, electronic, or opto-mechanical systems.
We develop an ultracompact high-resolution imaging system for cold atoms. Its only in-vacuum element is a multimode optical fiber with a diameter of 230 $\ensuremath{\mu}\mathrm{m}$, which simultaneously collects light and guides it out of the vacuum chamber. External adaptive optics allow us to image cold Rb atoms with approximately 1-$\ensuremath{\mu}\mathrm{m}$ resolution over a $100\ifmmode\times\else\texttimes\fi{}100\phantom{\rule{0.2em}{0ex}}\ensuremath{\mu}{\mathrm{m}}^{2}$ field of view. These optics can be easily rearranged to switch between fast absorption imaging and high-sensitivity fluorescence imaging. This system is particularly suited for hybrid quantum-engineering platforms where cold atoms are combined with optical cavities, superconducting circuits, or optomechanical devices restricting optical access.
Transporting cold atoms between interconnected vacuum chambers is an important technique for increasing the versatility of cold atom setups, particularly for those that couple atoms to photonic devices. In this report, we introduce a method where we are able to image the atoms at all points during transport via moving optical dipole trap. Cooled 87Rb atoms are transported ∼50 cm into an auxiliary vacuum chamber while being monitored with a moving-frame imaging system for which in-situ characterization of the atom transport is demonstrated. Precise positioning of the atoms near photonic devices is also tested across several tapered fibers showing an axial positioning resolution of ∼450 μm.
This thesis describes and characterizes a setup to conduct experiments combining the fields of cold atoms and nanophotonics. Furthermore, a series of numerical simulations is employed to deepen of atom transport under experimentally realistic conditions. The study of cold atoms is usually fundamental in nature and a very clean approach to investigate the laws of physics. High purity samples of atoms are cooled down to millikelvins or microkelvins. The potential landscape for the atoms can be carefully controlled using lasers and/or magnetic fields. Since the atoms' responses to electric, magnetic or electromagnetic fields are known with very high fidelity, any deviations to the state the atoms are prepared in can be precisely measured. Nanophotonics is the study of light close to or beyond the diffraction limit. In this region the field-like nature of light starts to play a role. By confining light in sub-wavelength-sized structures, high peak intensities can be achieved, giving rise to exciting non-linear optics phenomena. The strong field gradient that can be created allows, for instance, precise spectroscopy measurements, phase-sensitive sub-wavelength microscopy, as well as producing highly receptive sensing devices. Combining cold atoms and nanophotonics creates strong synergy effects. It gives access to strong coupling of light and matter. The scalability of nanophotonics now extends to atomic physics. Atoms can be trapped, coupled and manipulated at very small length scales, and in large numbers. Moreover, the potential landscape for atoms is highly customizable. The rubidium isotope 87 is used in this setup. A cloud of rubidium atoms is gathered and cooled in a two dimensional magneto-optical trap (MOT). Since the atoms are only cooled in two dimensions, they are free to escape in the third dimension and load a following three dimensional MOT. The atoms are now cooled further, compressed and loaded into an optical dipole trap. This dipole trap transports the atoms close to a sample inside the vacuum chamber. A moving optical lattice, or optical conveyor belt, brings the atoms then close to the sample surface. Now experiments can be conducted, studying the interaction of cold atoms and strongly confined light. The atom transport down to the sample surface shows some unexpected behaviour: the atoms seem to spread through the optical lattice during transport. A combination of microscopic and macroscopic numerical simulations, including genetic algorithms, are used to deepen our understanding of the underlying physics. This also allows us to get access to experimental variables that cannot be directly obtained.
This thesis covers experimental work conducted within two distinct fields of cold-atom physics. The first part describes an experiment capable of spatially-selective dispersive measurements of a cold-atomic system in part or in whole, by virtue of a digital micromirror device (DMD). Atom clouds are trapped in optical tweezers made and controlled by an acousto-optical deflector. Two types of high-precision magnetometers are realised. One is vectorial and reaches a single-shot precision of dB = (100, 200) µG for the field components parallel and transversal to the probe light, exceeding a previous realisation by two orders of magnitude. The other is a scalar magnetometer based on Larmor precession and reaches dB = 30 µG, putting it on equal footing with other state-of-the-art cold-atom magnetometers. The second part is devoted to the characterisation and the first results of a new quantum gas microscope experiment. It features a 0.69 NA microscope objective for high-resolution fluorescence imaging of individual atoms trapped in deep optical lattices. The imaging system is shown to perform near the diffraction limit. By means of DMD-generated off-resonant tight optical tweezers, projected through the high-resolution optics, we can load only a few planes of a co-propagating 1D lattice. In a single realisation of the experiment we acquire multiple fluorescence images, where the objective is translated between images, bringing different planes of the optical lattices in focus. In this way we can tomographically reconstruct the atom distribution in 3D.
Atom optics has been a highly active field of research with many scientific breakthroughs over the past two decades, largely due to successful advances in laser technology, microfabrication techniques, and the development of laser cooling and trapping of neutral atoms. This dissertation details several atom optics experiments with the motivation to develop tools and techniques for precision atom wave interferometry. It provides background information about atom optics and the fundamentals behind laser cooling and trapping, including basic techniques for cold gas thermometry and absorptive detection of atoms. A brief overview of magnetic trapping and guiding in tight wire-based traps is also provided before the experimental details are presented. ❧ We developed a novel laser source of 780 nm light using frequency-doubled 1560 nm fiber amplifier. This laser system provided up to a Watt of tunable frequency stabilized light for two Rb laser cooling and trapping experiments. One system generates Bose-Einstein condensates in an optical trap while the second is based on atom chip magnetic traps. The atom chip system, detailed in this thesis, was designed and built to develop the tools necessary for transport and loading large numbers of cold atoms and explore the potential for guided atom interferometry. Techniques and results from this experiment are presented, including an efficient magnetic transport and loading method to deliver cold atom to atom chip traps. We also developed a modeling tool for the magnetic fields formed by coiled wire geometries, as well as planar wire patterns. These models helped us design traps and determine adiabatic transportation of cold atoms between macro-scale traps and micro-traps formed on atom chips. Having achieved near unity transfer efficiency, we demonstrated that this approach promises to be a consistent method for loading large numbers of atoms into micro-traps. Furthermore, we discuss an in situ imaging technique to investigate magnetic field contours of the traps and the dynamics of atoms within those confining potentials. We also controlled the propagation along the atom chip guides by accelerating atoms with longitudinal magnetic gradients, and investigated an atom focusing scheme. ❧ While the atom chip wire guides perform a role analogous to optical fibers guiding light waves, ""free space"" cold atoms offer great opportunity for precision interferometry. We describe a second on-going atom optics experiment that measures gravity gradients using a pair of atom fountain interferometers separated by one meter. We have demonstrated Gravity Gradiometer resolution down to 4x10⁻⁹ g/m using a 40 kg test mass. The atomic physics subsystem is described in detail, including the vacuum, cold atom source, optics, magnetic coils and shields, and vibration isolation and compensation. The system is designed to be a compact, robust, transportable instrument, taking strides towards future gravity gradient measurements in the field. In the realm of space applications, there has been interest for micro-gravity science experiments aboard the International Space Station, along with instrument development for gravity mapping of Earth and planetary bodies with satellite-based instruments. Furthermore, there are ground-based applications for gravity imaging of local density distributions, precision measurement of gravity, as well as proposals for redefining the kilogram, detecting gravitational waves and determining the Gravitational constant.