Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Quantum Electronics and Laser Science Conference

Low power optical bistability in 1550 nm VCSOAs

Douglas R. Jorgesen, Christopher F. Marki, Haijiang Zhang, Pengyue Wen, Sadik C. Esener

Published May 1, 2007• 0 citations
Publisher

Abstract

Clockwise and counterclockwise bistability are demonstrated in 1550 nm VCSOAs at input powers two orders of magnitude lower than previously. Butterfly bistability is also observed for the first time in VCSOAs.
DOI
10.1109/qels.2007.4431439

Related papers

Low Power Optical Bistability in 1550 nm VCSOAs

Douglas R. Jorgesen, Christopher F. Marki, Haijiang Zhang +2 more

Clockwise and counterclockwise bistability are demonstrated in 1550 nm vertical-cavity semiconductor optical amplifiers (VCSOAs) at input powers two orders of magnitude lower than previously. Butterfly bistability is also observed for the first time in VCSOAs.

Conference on Lasers and Electro-Optics•May 1, 2007•0 citations

Optical bistability and nonlinear gain in 1.55 µm VCSOA

Antonio Hurtado, Ana Pilar Gonzalez-Marcos, Ian D. Henning +1 more

An experimental observation of power and wavelength optical bistability and nonlinear gain in a 1550 nm vertical-cavity semiconductor optical amplifier (VCSOA) operated in reflection and biased above and below threshold is reported. Two distinct types of optical bistability, clockwise and anticlockwise, are observed.

Electronics Letters•Apr 13, 2006•19 citations

Reflective optical bistability and nonlinear switching in a 1550-nm vertical-cavity semiconductor optical amplifier (VCSOA)

Antonio Hurtado, Ian D. Henning, M.J. Adams

We report experimental measurements of Optical Bistability (OB) and nonlinear switching in a 1550 nm-Vertical-Cavity Semiconductor Optical Amplifier (VCSOA) operated in reflection and biased below and above its threshold current. Two different types of OB and nonlinear switching, anticlockwise and clockwise, have been observed in both the optical power and wavelength domain. The influence of important parameters including the bias current, the initial wavelength detuning and the optical input power has also been studied. The existence of diverse forms of OB and nonlinear switching in a VCSOA operated in reflection opens the door for the development of inverting and non-inverting logic gates, using, respectively, the anticlockwise or the clockwise nonlinear switching transitions appearing in the VCSOA under external optical injection.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•May 18, 2007•0 citations

Low-power vertical cavity NAND gate

Antonio Hurtado, Ana Pilar Gonzalez-Marcos, José A. Martín-Pereda

The study of the Vertical-Cavity Semiconductor Optical Amplifiers (VCSOAs) for optical signal processing applications is increasing his interest. Due to their particular structure, the VCSOAs present some advantages when compared to their edge-emitting counterparts including low manufacturing costs, high coupling efficiency to optical fibers and the ease to fabricate 2-D arrays of this kind of devices. As a consequence, all-optical logic gates based on VCSOAs may be very promising devices for their use in optical computing and optical switching in communications. Moreover, since all the boolean logic functions can be implemented by combining NAND logic gates, the development of a Vertical-Cavity NAND gate would be of particular interest. In this paper, the characteristics of the dispersive optical bistability appearing on a VCSOA operated in reflection are studied. A progressive increment of the number of layers compounding the top Distributed Bragg Reflector (DBR) of the VCSOA results on a change on the shape of the appearing bistability from an S-shape to a clockwise bistable loop. This resulting clockwise bistability has high on-off contrast ratio and input power requirements one order of magnitude lower than those needed for edge-emitting devices. Based on these results, an all-optical vertical-cavity NAND gate with high on-off contrast ratio and an input power for operation of only 10W will be reported in this paper.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Jul 7, 2005•3 citations

Low-power optical bistability using bound excitons (A)

M. Dagenais

Journal of the Optical Society of America A•Dec 1, 1982•3 citations

A power and wavelength detuning-dependent hysteresis loop in a single mode Fabry—Pérot laser diode

Jian-Wei Wu, Bikash Nakarmi

In this paper, we observe experimentally the optical bistability induced by the side-mode injection power and wavelength detuning in a single mode Fabry—Pérot laser diode (SMFP-LD). Results show that the bistability characteristics of the dominant and injected modes are strongly dependent on the injected input optical power and wavelength detuning in an SMFP-LD. We observe three types of hysteresis loops: counterclockwise, clockwise, and butterfly hysteresis with various loop widths. In the case of a bistability loop caused by injection power, the transition from counterclockwise to clockwise in the hysteresis direction with the wavelength detuning from 0.028 nm to 0.112 nm is observed in a way of butterfly hysteresis for the dominant mode by increasing the wavelength detuning. The width of hysteresis loop, induced by wavelength detuning is also changed while the injection power is enhanced from −7 dBm to −5 dBm.

Chinese Physics B•Aug 1, 2013•2 citations
We report experimental measurements of Optical Bistability (OB) and nonlinear switching in a 1550 nm-Vertical-Cavity Semiconductor Optical Amplifier (VCSOA) operated in reflection and biased below and above its threshold current. Two different types of OB and nonlinear switching, anticlockwise and clockwise, have been observed in both the optical power and wavelength domain. The influence of important parameters including the bias current, the initial wavelength detuning and the optical input power has also been studied. The existence of diverse forms of OB and nonlinear switching in a VCSOA operated in reflection opens the door for the development of inverting and non-inverting logic gates, using, respectively, the anticlockwise or the clockwise nonlinear switching transitions appearing in the VCSOA under external optical injection.
The study of the Vertical-Cavity Semiconductor Optical Amplifiers (VCSOAs) for optical signal processing applications is increasing his interest. Due to their particular structure, the VCSOAs present some advantages when compared to their edge-emitting counterparts including low manufacturing costs, high coupling efficiency to optical fibers and the ease to fabricate 2-D arrays of this kind of devices. As a consequence, all-optical logic gates based on VCSOAs may be very promising devices for their use in optical computing and optical switching in communications. Moreover, since all the boolean logic functions can be implemented by combining NAND logic gates, the development of a Vertical-Cavity NAND gate would be of particular interest. In this paper, the characteristics of the dispersive optical bistability appearing on a VCSOA operated in reflection are studied. A progressive increment of the number of layers compounding the top Distributed Bragg Reflector (DBR) of the VCSOA results on a change on the shape of the appearing bistability from an S-shape to a clockwise bistable loop. This resulting clockwise bistability has high on-off contrast ratio and input power requirements one order of magnitude lower than those needed for edge-emitting devices. Based on these results, an all-optical vertical-cavity NAND gate with high on-off contrast ratio and an input power for operation of only 10W will be reported in this paper.
In this paper, we observe experimentally the optical bistability induced by the side-mode injection power and wavelength detuning in a single mode Fabry—Pérot laser diode (SMFP-LD). Results show that the bistability characteristics of the dominant and injected modes are strongly dependent on the injected input optical power and wavelength detuning in an SMFP-LD. We observe three types of hysteresis loops: counterclockwise, clockwise, and butterfly hysteresis with various loop widths. In the case of a bistability loop caused by injection power, the transition from counterclockwise to clockwise in the hysteresis direction with the wavelength detuning from 0.028 nm to 0.112 nm is observed in a way of butterfly hysteresis for the dominant mode by increasing the wavelength detuning. The width of hysteresis loop, induced by wavelength detuning is also changed while the injection power is enhanced from −7 dBm to −5 dBm.