Abstract We have systematically investigated the influence of the gas temperature (T), the Rabi frequencies of the probe laser (Ωp), the coupling laser (Ωc) and the radio-frequency (RF) (ΩRF) on the Rydberg electromagnetically induced transparency (EIT) and Autler–Townes (AT) splitting (Δf) by defining a general Doppler mismatch factor D g = ΩRF/Δf in the Rydberg atom-based microwave electrometry. The effect of T on D g is studied in detail from 0 to 1000 K, the results show that D g is insensitive to T when T < 10 μK or T > 10 K, while D g changes significantly with 10 K > T > 10 μ K . Then the effects of Ωp, Ωc and ΩRF on factor D g at T = 300 K (typical room temperature) and T = 10 μK (typical temperature of cold atom by laser cooling) are studied in detail, respectively. The results show that the linewidth of Rydberg EIT (ΓEIT) can be used as a key parameter to characterize the dependence of D g on Ωp and Ωc in both cases. D g is insensitive to T, Ωp and Ωc when ΩRF > 3ΓEIT which means that ΓEIT determines the lower limit of the linear region of the RF electric field strength measured by EIT–AT splitting. More interesting, the range where D g is insensitive to Ωp and Ωc can be greatly expanded by lowering the gas temperature to 10 μK. The ranges of parameters where D g is insensitive to T, Ωp, Ωc and ΩRF are given, and such relationship can be easily scaled to other atomic systems. The results can help the selection of various parameters in the experiments and specific applications to ensure the accuracy of measuring the RF electric field.
Abstract We have systematically investigated the influence of the gas temperature (T), the Rabi frequencies of the probe laser (Ωp), the coupling laser (Ωc) and the radio-frequency (RF) (ΩRF) on the Rydberg electromagnetically induced transparency (EIT) and Autler–Townes (AT) splitting (Δf) by defining a general Doppler mismatch factor D g = ΩRF/Δf in the Rydberg atom-based microwave electrometry. The effect of T on D g is studied in detail from 0 to 1000 K, the results show that D g is insensitive to T when T < 10 μK or T > 10 K, while D g changes significantly with 10 K > T > 10 μ K . Then the effects of Ωp, Ωc and ΩRF on factor D g at T = 300 K (typical room temperature) and T = 10 μK (typical temperature of cold atom by laser cooling) are studied in detail, respectively. The results show that the linewidth of Rydberg EIT (ΓEIT) can be used as a key parameter to characterize the dependence of D g on Ωp and Ωc in both cases. D g is insensitive to T, Ωp and Ωc when ΩRF > 3ΓEIT which means that ΓEIT determines the lower limit of the linear region of the RF electric field strength measured by EIT–AT splitting. More interesting, the range where D g is insensitive to Ωp and Ωc can be greatly expanded by lowering the gas temperature to 10 μK. The ranges of parameters where D g is insensitive to T, Ωp, Ωc and ΩRF are given, and such relationship can be easily scaled to other atomic systems. The results can help the selection of various parameters in the experiments and specific applications to ensure the accuracy of measuring the RF electric field.
Abstract We theoretically and experimentally studied quantum microwave electrometry in a cold atomic system using Rydberg electromagnetic induction transparency (EIT) and Autler–Townes splitting (EIT-AT splitting). In cold atoms, a spectral linewidth of ∼500 kHz for EIT was achieved owing to a significant reduction in residual Doppler width, i.e. by at least an order of magnitude, compared to that in vapor cells at room temperature. Therefore, the minimum microwave electric field intensity (E MW) that can be measured is 430 µV cm−1, which is one order higher sensitivity in the EIT-AT regime than that in vapor cells at room temperature. Unlike microwave electrometry in atomic vapor cells, EIT-AT splitting cannot be observed if E MW is so large that the EIT-AT splitting interval Δ f m exceeds the absorption peak width of the cold atom while scanning the frequency of the probe laser (ω p ). Moreover, EIT-AT splitting can be observed if Δ f m exceeds the natural linewidth Γ eg of the intermediate states while scanning the coupling laser (ω c ) and maintains a high spectral resolution with a high signal-to-noise ratio. While scanning ω c , the upper microwave electric field intensity is limited by the scanning range of our setup. Using our system, we measure the maximum field to be 21.6 mV cm−1, nearly three times higher than that of 6.8 mV cm−1 while scanning ω p . The results indicate that the linear range of E MW measured using EIT-AT splitting considerably improves in cold Rydberg atoms.
Abstract We utilize an electromagnetically induced transparency (EIT) of a three-level cascade system involving Rydberg state in a room-temperature cell, formed with a cesium 6S1/2–6P3/2–66S1/2 scheme, to investigate the Autler–Townes (AT) splitting resulting from a 15.21-GHz radio-frequency (RF) field that couples the | 66 S 1 / 2 〉 → | 65 P 1 / 2 〉 Rydberg transition. The radio-frequency electric field induced AT splitting, γ AT, is defined as the peak-to-peak distance of an EIT-AT spectrum. The dependence of AT splitting γ AT on the probe and coupling Rabi frequency, Ωp and Ωc, is investigated. It is found that the EIT-AT splitting strongly depends on the EIT linewidth that is related to the probe and coupling Rabi frequency in a weak RF-field regime. Using a narrow linewidth EIT spectrum would decrease the uncertainty of the RF field measurements. This work provides new experimental evidence for the theoretical framework in [J. Appl. Phys. 121, 233106 (2017)].
We investigate the relationship between the Rabi frequency (ΩRF, related to the applied electric field) and Autler-Townes (AT) splitting, when performing atom-based radio-frequency (RF) electric (E) field strength measurements using Rydberg states and electromagnetically induced transparency (EIT) in an atomic vapor. The AT splitting satisfies, under certain conditions, a well-defined linear relationship with the applied RF field amplitude. The EIT/AT-based E-field measurement approach derived from these principles is currently being investigated by several groups around the world as a means to develop a new SI-traceable RF E-field measurement technique. We establish conditions under which the measured AT-splitting is an approximately linear function of the RF electric field. A quantitative description of systematic deviations from the linear relationship is key to exploiting EIT/AT-based atomic-vapor spectroscopy for SI-traceable field measurement. We show that the linear relationship is valid and can be used to determine the E-field strength, with minimal error, as long as the EIT linewidth is small compared to the AT-splitting. We also discuss interesting aspects of the thermal dependence (i.e., hot- versus cold-atom) of this EIT-AT technique. An analysis of the transition from cold- to hot-atom EIT in a Doppler-mismatched cascade system reveals a significant change of the dependence of the EIT linewidth on the optical Rabi frequencies and of the AT-splitting on ΩRF.
Microwave electric fields are measured by using cold Rydberg atoms. We obtain spindle-shaped cold atomic clouds in a magneto-optical trap and then pump the cold atoms to quantum state 5S1/2, F = 2, mF = 2 by using an optical-pump laser. We obtain the Rydberg electromagnetic induction transparency (EIT) spectrum peak with narrow linewidth by the low temperature and small residual Doppler broadening. The results show that the typical EIT linewidth with 16 μK cold atoms is about 460 kHz which is 15 times narrower than that of 7 MHz obtained in the thermal vapor cell. The microwave electric field amplitude is measured by Autler-Townes splitting (EIT-AT splitting) in the cold atoms at frequencies of 9.2, 14.2 and 22.1 GHz, receptively. The results show that there is a good linear relationship between the EIT-AT splitting interval and the microwave electric field amplitude. The lower limit of the microwave electric field amplitude that can be measured in the linear region can reach as low as 222 μV/cm, which is about 22 times larger than the lower limit in the traditional thermal vapor cell about of 5 mV/cm. The improvement of the lower limit by EIT-AT splitting method is roughly proportional to the narrowing EIT line width by cold atom samples. This demonstrates that benefiting from the smaller residual Doppler effect and the narrower EIT linewidth in cold atoms, the cold atom system is more advantageous in the experimental measuring of the weak microwave electric field amplitude by using the EIT-AT splitting method. This is of great benefit to the absolute calibration of very weak microwave electric fields. Furthermore, the lower limit of the microwave electric field amplitude that can be measured is smaller than 1 μV/cm by using the change of transmittance of the prober laser at the EIT resonance, and the corresponding sensitivity can reach 1 μV·cm–1·Hz–1/2. These results demonstrate the advantages of cold atomic sample in microwave electric field measurement and its absolute calibration.
An electromagnetically induced transparency (EIT) of a cascade-three-level atom involving Rydberg level in a room-temperature cell, formed with a cesium 6S 1 / 2-6P 3 / 2-66 S 1 / 2 scheme, is employed to detect the Autler-Townes (AT) splitting resulted with a 15.21-GHz microwave field coupling the 66 S 1 / 2 → 65 P 1 / 2 transition. Microwave field induced AT splitting, f A T, is characterized by the distance of peak-to-peak of an EIT-AT spectrum. The f A T dependence on the microwave Rabi frequency, Ω M W , demonstrates two regions, the strong-coupling linear region, f A T ≈ Ω M W and the weak-coupling nonlinear region, f A T ≲ Ω M W. The f A T dependencies on the probe and coupling Rabi frequency are also investigated. Using small probe- and coupling-laser, the Rabi frequency is found to enlarge the linear regime and decrease the uncertainty of the microwave field measurements. The measurements agree with the calculations based on a four-level atomic model.
Significant progress has been made in atom-based measurements of length, time, gravity and electromagnetic fields in recently years. Rydberg atom-based microwave electric field measurement, using electromagnetically induced transparency (EIT) in room temperature alkali-metal vapors, has been extensively investigated and aroused the broad interest. This approach may establish a new standard for the measurements of microwave (MW) and radio frequency (RF) electric fields.In this review, we describe the work on a new method of measuring electric fields based on quantum interference by using either cesium or rubidium atoms contained in a dielectric vapor cell. Rydberg atoms with principal quantum number n >>1 have large direct current (DC) polarizabilities and microwave transition dipole moments, thereby making them extremely sensitive to external electric fields. Using the Rydberg three-level EIT to detect the level splitting and shift that is induced by the external field, we can realize a rapid and robust self-calibration method of measuring the electric field in a frequency range from 0.01 GHz to 1000 GHz. For the MW electric field (frequency range > 1 GHz), the MW field causes the Rydberg states to split, known as an Autler-Townes splitting (A-T) effect when the applied microwave can resonate with adjacent Rydberg states. The MW coupled A-T splitting is proportional to the applied electric field strength, from which the field strength is measured. Using the EIT window, a high sensitivity of 3 μV·cm-1·Hz-1/2 and small electric field of 1 μV/cm are expected to be achieved with a modest setup, and the limitations of the sensitivity are also addressed in the review. For the RF field at frequency mj EIT lines, and avoided crossings formed with the fine-structure levels of equal mj and different J's, which is used to calibrate and measure the RF field amplitude. On the other hand, the dependence of the EIT-line strength on the RF field polarization provides a fast and robust polarization measurement of RF fields based on matching experimental data with a theoretical simulation. The measurements of minimum strengths and sensitivity of RF fields based on Rydberg atoms are one order magnitude below the values obtained by traditional antenna methods. The atom-based field measurement paves the way for determining fields through calibration-free, invariable atomic properties and miniaturization. We also propose its various potential applications in the future.