Probing the Atom

Mark P. Silverman

Yao Jin

An obstacle for precision improvement in quantum metrology is the information loss causing by the unavoidable interaction between probe system and environment. Quantum fluctuations are environment no system can be isolated from and it will make the precision of initial parameter estimation of the probe atom decrease with time. After the typical time of the spontaneous decay of the probe atom, the precision is greatly damaged. However, quantum fluctuations can be modified. Our results show that if we put several ancillary atoms beside the probe atom in symmetrical arrangement, the probe atom will be affected by the ancillary atoms indirectly and the information loss of the probe atom causing by the quantum fluctuations will be partially avoided. We find that the retained precision after long time evolution can approaches to [Formula: see text] times of the initial precision in condition that the probe atom and three ancillary atoms are located in the vertex of regular tetrahedron.

Christopher L. Holloway, Josh A. Gordon, Andrew Schwarzkopf +6 more

We present a significantly new approach for an electric (E) field probe design. The probe is based on the interaction of RF-fields with Rydberg atoms, where alkali atoms are excited optically to Rydberg states and the applied RF-field alters the resonant state of the atoms. For this probe, the Rydberg atoms are excited in a glass vapor cell. The Rydberg atoms act like an RF-to-optical transducer, converting an RF E-field to an optical-frequency response. The probe utilizes the concept of Electromagnetically Induced Transparency (EIT). The RF transition in the four-level atomic system causes a split of the EIT transmission spectrum for the probe laser. This splitting is easily measured and is directly proportional to the applied RF field amplitude. Therefore, by measuring this splitting we get a direct measurement of the RF E-field strength. The significant dipole response of Rydberg atoms over the GHz regime enables this technique to make traceable measurements over a large frequency band including 1-500 GHz. We will show that, with one probe, measurements can be made over a very large frequency range. This is a truly broadband probe/sensor. In this paper, we report on our results in the development of this probe.

Kalervo V. Laurikainen

Jianchun Wu, Bo Wu, Jiejian Mao

The behaviour of atom localization in an inverted-Y atomic system is theoretically investigated. For the atoms interacting with a weak probe field and several orthogonal standing-wave fields, their position information can be obtained by measuring the probe absorption. Compared with the traditional scheme, we couple the probe field to the transition between the middle and top levels. It is found that the probe absorption sensitively depends on the detuning and strength of the relevant light fields. Remarkably, the atom can be localized at a particular position in the standing-wave fields by coupling a microwave field to the transition between the two ground levels.