Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Conference on Lasers and Electro-Optics

Impedance-matched differential SNSPDs for practical photon counting with sub-10 ps timing jitter

Marco Colangelo, Andrew D. Beyer, Boris A. Korzh, Jason P. Allmaras, Andrew Mueller, Ryan M. Briggs, Bruce Bumble, Marcus C. Runyan, Martin J. Stevens, Adam N. McCaughan, Di Zhu, Steve Smith, Wolfgang H. Becker, Lautaro Narváez, Joshua C. Bienfang, Simone Frasca, Angel E. Velasco, Edward Ramirez, Alexander B. Walter, Ekkehart Schmidt, Emma E. Wollman, Cristián Peña, M. Spiropulu, Richard P. Mirin, Sae Woo Nam, Karl K. Berggren, Matthew D. Shaw

Published Jan 1, 2021• 1 citation
Publisher

Abstract

We demonstrate large-area superconducting nanowire single-photon detectors (SNSPDs) with simultaneous high system detection efficiency and low system jitter. We describe the device architecture and discuss optimal readout setup for practical applications.
DOI
10.1364/cleo_qels.2021.fw2p.1

Related papers

Impedance-Matched Differential Superconducting Nanowire Detectors

Marco Colangelo, Boris A. Korzh, Jason P. Allmaras +23 more

Superconducting nanowire single-photon detectors (SNSPDs) are the highest-performance photon-counting technology in the near infrared, but traditional designs typically trade off between timing resolution and detection efficiency. The authors utilize transmission-line engineering and differential readout to achieve a design with high detection efficiency and low jitter simultaneously. This design also enables imaging capabilities and photon-number resolution, and is compatible with commercial time taggers. The device is a versatile solution for photon counting in various applications, including quantum computing, quantum communication, biomedicine, and ranging.

arXiv:2108.07962•Physical Review Applied•Apr 28, 2023•39 citations

High-efficiency 8 × 8 superconducting nanowire single-photon detector array coupled with a 105-μm multimode fiber

Zhen Wan, Jia Huang, You Xiao +8 more

We present an 8 × 8 superconducting nanowire single-photon detector (SNSPD) array that addresses the trade-off between detection efficiency and count rates in large-area devices.The SNSPD array employs a distributed nanowire architecture and a polarization-insensitive optical cavity, when coupled with a 105-μm multimode fiber, achieves a system detection efficiency of 75% at 1064 nm with a count rate of 945 MHz at 3 dB compression and an average timing jitter of <100 ps.This design offers a scalable solution for high-speed photon counting with large-area detection and multimode compatibility.

Chinese Optics Letters•Jan 1, 2025•0 citations

Improving the timing jitter of a superconducting nanowire single-photon detection system

Junjie Wu, Lixing You, Sijing Chen +5 more

Low timing jitter is a unique merit of superconducting nanowire single-photon detectors (SNSPDs) for time-correlated applications. Quantitative analysis was performed for the SNSPD system. Aided by an oscilloscope with an optimal signal amplitude, we were able to measure a full width at half-maximum system timing jitter as low as 14.2 ps for a high-switching-current SNSPD using a room-temperature low-noise amplifier. When using a time-correlated single-photon counting module, the system timing jitter was 17.3 ps. The detector's intrinsic timing jitter was estimated at ∼12.0 ps.

Applied Optics•Mar 6, 2017•96 citations

50 µm diameter superconducting nanowire single-photon detector with sub-17 ps timing jitter and high efficiency for visible wavelengths (Conference Presentation)

Jin Chang, Iman Esmaeil Zadeh

Superconducting nanowire single photon detectors (SNSPDs) have demonstrated advantages over traditional detectors in many fields [1]. Most fiber-coupled SNSPDs are coupled to single mode fibers, limiting their usability for applications where large surface area detectors are needed, for example fluorescence detection and satellite-based quantum communication [2][3]. Other important requirements for many applications are broadband detection efficiency, and low timing jitter [4]. So far, the increased meander length of multimode detectors, and the therefore increased kinetic inductance and number of imperfections due to film inhomogeneities have limited the timing jitter [5]. Moreover, combining low timing jitter with high detection efficiency and low dark count rate in one device is challenging due to the tradeoffs between different properties of SNSPDs [6]. In this paper, we achieved high efficiency and strong saturation over a broad wavelength range with a low timing jitter of 16.99 ps while maintaining a low dark count rate of < 0.2 Hz for an SNSPD coupled to a 50 µm core multimode fiber. To enhance the broadband absorption from 405 nm to 830 nm, detectors were fabricated on an optimized SiO2 cavity and Aluminum mirror. The geometry of the nanowire was also tuned to reach a good internal saturation of efficiency over the visible/NIR range but also to carry high current to get a large signal. Furthermore, a cryogenic readout amplifier was optimized to improve the signal to noise ratio and thus lead to high time resolution. Our devices can be readily used to enable higher resolution and faster quantum optics, bio-imaging, laser ranging and other optical experiments.

Quantum Optics and Photon Counting•May 13, 2019•0 citations

Nano-optical measurements of novel superconducting single photon detector designs

Robert M. Heath, Michael G. Tanner, L. San Emeterio Alvarez +4 more

Superconducting nanowire single photon detectors (SNSPDs) are a highly promising emerging photon counting technology, offering infrared sensitivity combined with low dark count rates and sub-100 ps timing jitter [1]. These devices are under consideration for a wide variety of photon counting applications, from quantum cryptography to remote sensing. Next generation device designs based on optical cavities, ultra narrow wires, parallel wire arrays and nano-antenna enhanced devices are being evaluated to meet the demands of advanced photon counting applications.

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•May 1, 2013•0 citations

Superconducting Nanowire Single-photon Detector

Taro Yamashita, Shigehito Miki, Zhen Wang +1 more

We present our recent progress in development of a superconducting nanowire single-photon detector (SSPD) system. Our practical SSPD system with a compactGifford-McMahon cryocooler successfully achieved the high system detection efficiency of 74%, low dark count of 100 cps, and small timing jitter of 68 ps in one device simultaneously, which is useful for actual applications. Furthermore, we propose and demonstrate a new strategy to resolve a trade-off problem between the system detection efficiency and counting rate (speed) in the SSPD.

TEION KOGAKU (Journal of Cryogenics and Superconductivity Society of Japan)•Jan 1, 2014•3 citations
Superconducting nanowire single-photon detectors (SNSPDs) are the highest-performance photon-counting technology in the near infrared, but traditional designs typically trade off between timing resolution and detection efficiency. The authors utilize transmission-line engineering and differential readout to achieve a design with high detection efficiency and low jitter simultaneously. This design also enables imaging capabilities and photon-number resolution, and is compatible with commercial time taggers. The device is a versatile solution for photon counting in various applications, including quantum computing, quantum communication, biomedicine, and ranging.
We present an 8 × 8 superconducting nanowire single-photon detector (SNSPD) array that addresses the trade-off between detection efficiency and count rates in large-area devices.The SNSPD array employs a distributed nanowire architecture and a polarization-insensitive optical cavity, when coupled with a 105-μm multimode fiber, achieves a system detection efficiency of 75% at 1064 nm with a count rate of 945 MHz at 3 dB compression and an average timing jitter of <100 ps.This design offers a scalable solution for high-speed photon counting with large-area detection and multimode compatibility.
Low timing jitter is a unique merit of superconducting nanowire single-photon detectors (SNSPDs) for time-correlated applications. Quantitative analysis was performed for the SNSPD system. Aided by an oscilloscope with an optimal signal amplitude, we were able to measure a full width at half-maximum system timing jitter as low as 14.2 ps for a high-switching-current SNSPD using a room-temperature low-noise amplifier. When using a time-correlated single-photon counting module, the system timing jitter was 17.3 ps. The detector's intrinsic timing jitter was estimated at ∼12.0 ps.
Superconducting nanowire single photon detectors (SNSPDs) have demonstrated advantages over traditional detectors in many fields [1]. Most fiber-coupled SNSPDs are coupled to single mode fibers, limiting their usability for applications where large surface area detectors are needed, for example fluorescence detection and satellite-based quantum communication [2][3]. Other important requirements for many applications are broadband detection efficiency, and low timing jitter [4]. So far, the increased meander length of multimode detectors, and the therefore increased kinetic inductance and number of imperfections due to film inhomogeneities have limited the timing jitter [5]. Moreover, combining low timing jitter with high detection efficiency and low dark count rate in one device is challenging due to the tradeoffs between different properties of SNSPDs [6]. In this paper, we achieved high efficiency and strong saturation over a broad wavelength range with a low timing jitter of 16.99 ps while maintaining a low dark count rate of < 0.2 Hz for an SNSPD coupled to a 50 µm core multimode fiber. To enhance the broadband absorption from 405 nm to 830 nm, detectors were fabricated on an optimized SiO2 cavity and Aluminum mirror. The geometry of the nanowire was also tuned to reach a good internal saturation of efficiency over the visible/NIR range but also to carry high current to get a large signal. Furthermore, a cryogenic readout amplifier was optimized to improve the signal to noise ratio and thus lead to high time resolution. Our devices can be readily used to enable higher resolution and faster quantum optics, bio-imaging, laser ranging and other optical experiments.
Superconducting nanowire single photon detectors (SNSPDs) are a highly promising emerging photon counting technology, offering infrared sensitivity combined with low dark count rates and sub-100 ps timing jitter [1]. These devices are under consideration for a wide variety of photon counting applications, from quantum cryptography to remote sensing. Next generation device designs based on optical cavities, ultra narrow wires, parallel wire arrays and nano-antenna enhanced devices are being evaluated to meet the demands of advanced photon counting applications.
We present our recent progress in development of a superconducting nanowire single-photon detector (SSPD) system. Our practical SSPD system with a compactGifford-McMahon cryocooler successfully achieved the high system detection efficiency of 74%, low dark count of 100 cps, and small timing jitter of 68 ps in one device simultaneously, which is useful for actual applications. Furthermore, we propose and demonstrate a new strategy to resolve a trade-off problem between the system detection efficiency and counting rate (speed) in the SSPD.