Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Physics Letters

Enhancement of photon detection in superconducting nanowire single photon detector exposed to oscillating magnetic field

Ilan Hakimi, Naor Vardi, Amos Sharoni, M. Rosenbluh, Yosef Yeshurun

Published Jun 7, 2021• 3 citations
Publisher

Abstract

We measured the photon count rate (PCR) and dark count rate (DCR) of a superconducting nanowire single photon detector (SNSPD) exposed to either a DC magnetic field (up to 60 mT) or to a low-amplitude oscillating field (0.12–0.48 mT, up to 50 kHz). In both cases, the results show an increase in the PCR and the DCR as the DC field or the frequency of the AC field increase. However, the ratio DCR/(PCR + DCR) increases significantly with an increasing DC field, whereas this ratio is approximately constant as the frequency of the AC field increases up to frequencies in the kHz regime. The results suggest a more favorable effect of AC fields on the operation of the SNSPD.

DOI
10.1063/5.0046262

Related papers

Superconducting nanowire single photon detector under AC-bias with self-differential readout

Luyao Ma, Xing-Yu Zhang, Zhi-Yun Shu +4 more

Superconducting nanowire single photon detector (SNSPD) has been widely used in many fields such as quantum computing, quantum key distribution and laser radar, due to its high detection efficiency, low dark count rate, high counting rate, and low timing jitter. In most cases, the SNSPD works under the DC-bias mode that can detect single photons arrived at any time. In some cases such as satellite laser ranging and single-photon laser radar where the light pulses arrive regularly, the AC-bias mode enables the SNSPD to work with higher counting rates and lower background dark counts, which however requires complicated readout due to the low signal-to-noise ratio of the photon response. In this work, we report on an AC-biased SNSPD system with a self-differential readout circuit. The system includes a 2-pixel SNSPD consisting of two parallel nanowires, which are biased with 100 MHz sinusoidal current. The output signals of these two nanowires are amplified and combined for the differential readout of the photon response. The resulting response pulse possesses a signal-to-noise ratio ten times higher than that extracted before self-differential readout. In addition, the dark counts are reduced by a factor of 4, and the count rates are increased by a factor of 1.5, in comparison with those under the DC-bias mode. This work provides a specific method to read out the AC-biased SNSPD.

Acta Physica Sinica•Jan 1, 2022•4 citations

Dark counts of superconducting nanowire single-photon detector under illumination

Sijing Chen, Lixing You, Weijun Zhang +5 more

An abnormal increase in the SDE was observed for superconducting nanowire single-photon detectors (SNSPDs) when the bias current (I(b)) was close to the switching current (I(sw)). By introducing the time-correlated single-photon counting technique, we investigated the temporal histogram of the detection counts of an SNSPD under illumination. The temporal information helps us to distinguish photon counts from dark counts in the time domain. In this manner, the dark count rate (DCR) under illumination and the accurate SDE can be determined. The DCR under moderate illumination may be significantly larger than the conventional DCR measured without illumination under a high I(b), which causes the abnormal increase in the SDE. The increased DCR may be explained by the suppression of I(sw) under illumination.

arXiv:1504.04713•Optics Express•Apr 17, 2015•30 citations

Effect of temperature on superconducting nanowire single-photon detector noise

A. Bahgat Shehata, Alessandro Ruggeri, Franco Stellari +6 more

Today Superconducting Nanowire Single-Photon Detectors (SNSPDs) are commonly used in different photon-starved applications, including testing and diagnostics of VLSI circuits. Detecting very faint signals in the near-infrared wavelength range requires not only good detection efficiency, but also very low Dark Count Rate (DCR) and jitter. For example, low noise is crucial to enable ultra-low voltage optical testing of integrated circuits. The effect of detector temperature and background thermal radiation on the noise of superconducting single-photon detectors made of NbN meanders is studied in this paper. It is shown that two different regimes can be identified in the DCR vs. bias current characteristics. At high bias, the dark count rate is dominated by the intrinsic noise of the detector, while at low bias current it is dominated by the detection of stray photons that get onto the SNSPD. Changing the detector temperature changes its switching current and only affects the high bias branch of the characteristics: a reduction of the DCR can be achieved by lowering the SNSPD base temperature. On the other hand, changing the temperature of the single-photon light source (e.g. the VLSI circuit under test) only affects the low bias regime: a lower target temperature leads to a smaller DCR.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Aug 28, 2015•1 citation

Investigation of the Performance of an Ultralow-Dark-Count Superconducting Nanowire Single-Photon Detector

Shanthi Subashchandran, Ryo Okamoto, Labao Zhang +6 more

The realization of an ultralow-dark-count rate (DCR) along with the conservation of high detection efficiency (DE) is critical for many applications using single photon detectors in quantum information technologies, material sciences, and biological sensing. For this purpose, a fiber-coupled superconducting nanowire single-photon detector (SNSPD) with a meander-type niobium nitride nanowire (width: 50 nm) is studied. Precise measurements of the bias current dependence of DE are carried out for a wide spectral range (from 500 to 1650 nm in steps of 50 nm) using a white light source and a laser line Bragg tunable band-pass filter. An ultralow DCR (0.0015 cps) and high DE (32%) are simultaneously achieved by the SNSPD at a wavelength of 500 nm.

Japanese Journal of Applied Physics•Oct 1, 2013•11 citations

Effect of magnetic field on the photon detection in thin superconducting meander structures

R. Lusche, Alexej D. Semenov, Yu. P. Korneeva +4 more

We have studied the influence of an externally applied magnetic field on the photon and dark count rates of meander-type niobium nitride superconducting nanowire single-photon detectors. Measurements have been performed at a temperature of 4.2 K, and magnetic fields up to 250 mT have been applied perpendicularly to the meander plane. While photon count rates are field independent at weak applied fields, they show a strong dependence at fields starting from approximately \ifmmode\pm\else\textpm\fi{}25 mT. This behavior, as well as the magnetic field dependence of the dark count rates, is in good agreement with the recent theoretical model of vortex-assisted photon detection and spontaneous vortex crossing in narrow superconducting lines. However, the local reduction of the superconducting free energy due to photon absorption, which is the fitting parameter in the model, increases much slower with the photon energy than the model predicts. Furthermore, changes in the free-energy during photon counts and dark counts depend differently on the current that flows through the meander. This indicates that photon counts and dark counts occur in different parts of the meander.

Physical Review B•Mar 19, 2014•21 citations

Magnetic-Field Enhancement of Performance of Superconducting Nanowire Single-Photon Detector

Ilya Charaev, Alexei D. Semenov, K. Ilin +1 more

We present SNSPDs from NbN nanowires shaped after square-spiral, that allows an increase not only in critical currents, but also an extension of spectral detection efficiencies by just applying an external magnetic field. Using negative electron-beam lithography with the positive resist for shaping nanowires made it possible to reduce the inner bend radius. Consequently, the effect of critical-current enhancement in the magnetic field becomes stronger than it was demonstrated earlier. Here we achieved a 13% increase of the critical current in the magnetic field. We measured the spectra of the single-photon detection efficiency in the wavelength ranging from 400 to 1100 nm in the magnetic field. At zero field, the square-spiral has the spectrum similar to that of a meander. At the field providing the maximum of the critical current, the detection efficiency and the cutoff wavelength in the spectrum increase by 20% and by 54%, respectively. The magnetic-field dependence of the dark count rate is well described by the proposed analytical model.

arXiv:1810.11897•IEEE Transactions on Applied Superconductivity•Feb 7, 2019•3 citations
We measured the photon count rate (PCR) and dark count rate (DCR) of a superconducting nanowire single photon detector (SNSPD) exposed to either a DC magnetic field (up to 60 mT) or to a low-amplitude oscillating field (0.12–0.48 mT, up to 50 kHz). In both cases, the results show an increase in the PCR and the DCR as the DC field or the frequency of the AC field increase. However, the ratio DCR/(PCR + DCR) increases significantly with an increasing DC field, whereas this ratio is approximately constant as the frequency of the AC field increases up to frequencies in the kHz regime. The results suggest a more favorable effect of AC fields on the operation of the SNSPD.
Superconducting nanowire single photon detector (SNSPD) has been widely used in many fields such as quantum computing, quantum key distribution and laser radar, due to its high detection efficiency, low dark count rate, high counting rate, and low timing jitter. In most cases, the SNSPD works under the DC-bias mode that can detect single photons arrived at any time. In some cases such as satellite laser ranging and single-photon laser radar where the light pulses arrive regularly, the AC-bias mode enables the SNSPD to work with higher counting rates and lower background dark counts, which however requires complicated readout due to the low signal-to-noise ratio of the photon response. In this work, we report on an AC-biased SNSPD system with a self-differential readout circuit. The system includes a 2-pixel SNSPD consisting of two parallel nanowires, which are biased with 100 MHz sinusoidal current. The output signals of these two nanowires are amplified and combined for the differential readout of the photon response. The resulting response pulse possesses a signal-to-noise ratio ten times higher than that extracted before self-differential readout. In addition, the dark counts are reduced by a factor of 4, and the count rates are increased by a factor of 1.5, in comparison with those under the DC-bias mode. This work provides a specific method to read out the AC-biased SNSPD.
An abnormal increase in the SDE was observed for superconducting nanowire single-photon detectors (SNSPDs) when the bias current (I(b)) was close to the switching current (I(sw)). By introducing the time-correlated single-photon counting technique, we investigated the temporal histogram of the detection counts of an SNSPD under illumination. The temporal information helps us to distinguish photon counts from dark counts in the time domain. In this manner, the dark count rate (DCR) under illumination and the accurate SDE can be determined. The DCR under moderate illumination may be significantly larger than the conventional DCR measured without illumination under a high I(b), which causes the abnormal increase in the SDE. The increased DCR may be explained by the suppression of I(sw) under illumination.
Today Superconducting Nanowire Single-Photon Detectors (SNSPDs) are commonly used in different photon-starved applications, including testing and diagnostics of VLSI circuits. Detecting very faint signals in the near-infrared wavelength range requires not only good detection efficiency, but also very low Dark Count Rate (DCR) and jitter. For example, low noise is crucial to enable ultra-low voltage optical testing of integrated circuits. The effect of detector temperature and background thermal radiation on the noise of superconducting single-photon detectors made of NbN meanders is studied in this paper. It is shown that two different regimes can be identified in the DCR vs. bias current characteristics. At high bias, the dark count rate is dominated by the intrinsic noise of the detector, while at low bias current it is dominated by the detection of stray photons that get onto the SNSPD. Changing the detector temperature changes its switching current and only affects the high bias branch of the characteristics: a reduction of the DCR can be achieved by lowering the SNSPD base temperature. On the other hand, changing the temperature of the single-photon light source (e.g. the VLSI circuit under test) only affects the low bias regime: a lower target temperature leads to a smaller DCR.
The realization of an ultralow-dark-count rate (DCR) along with the conservation of high detection efficiency (DE) is critical for many applications using single photon detectors in quantum information technologies, material sciences, and biological sensing. For this purpose, a fiber-coupled superconducting nanowire single-photon detector (SNSPD) with a meander-type niobium nitride nanowire (width: 50 nm) is studied. Precise measurements of the bias current dependence of DE are carried out for a wide spectral range (from 500 to 1650 nm in steps of 50 nm) using a white light source and a laser line Bragg tunable band-pass filter. An ultralow DCR (0.0015 cps) and high DE (32%) are simultaneously achieved by the SNSPD at a wavelength of 500 nm.
We have studied the influence of an externally applied magnetic field on the photon and dark count rates of meander-type niobium nitride superconducting nanowire single-photon detectors. Measurements have been performed at a temperature of 4.2 K, and magnetic fields up to 250 mT have been applied perpendicularly to the meander plane. While photon count rates are field independent at weak applied fields, they show a strong dependence at fields starting from approximately \ifmmode\pm\else\textpm\fi{}25 mT. This behavior, as well as the magnetic field dependence of the dark count rates, is in good agreement with the recent theoretical model of vortex-assisted photon detection and spontaneous vortex crossing in narrow superconducting lines. However, the local reduction of the superconducting free energy due to photon absorption, which is the fitting parameter in the model, increases much slower with the photon energy than the model predicts. Furthermore, changes in the free-energy during photon counts and dark counts depend differently on the current that flows through the meander. This indicates that photon counts and dark counts occur in different parts of the meander.
We present SNSPDs from NbN nanowires shaped after square-spiral, that allows an increase not only in critical currents, but also an extension of spectral detection efficiencies by just applying an external magnetic field. Using negative electron-beam lithography with the positive resist for shaping nanowires made it possible to reduce the inner bend radius. Consequently, the effect of critical-current enhancement in the magnetic field becomes stronger than it was demonstrated earlier. Here we achieved a 13% increase of the critical current in the magnetic field. We measured the spectra of the single-photon detection efficiency in the wavelength ranging from 400 to 1100 nm in the magnetic field. At zero field, the square-spiral has the spectrum similar to that of a meander. At the field providing the maximum of the critical current, the detection efficiency and the cutoff wavelength in the spectrum increase by 20% and by 54%, respectively. The magnetic-field dependence of the dark count rate is well described by the proposed analytical model.