Physical layer key generation is an important handshaking step for establishing secure wireless communication in wireless networks. Existing methods based on fine-grained Channel State Information (CSI) have seen significant limitations. Reciprocity, the theoretical basis of physical layer key generation, is sensitive to factors such as noise, interference and hardware level variations. Feedback-based Channel Gain Complement is designed to conquer the imperfect reciprocity between two communication parties in actual environments. In addition, we have found that the adjacent subcarriers are strongly correlated. Quantizing all 30 subcarriers without discrimination will reduce the randomness and strength of the secret key while discarding some carriers will lose important information. We propose a cluster-based quantization method, which balances between the generation speed and consistency in initial key bits. Evaluation results in static and mobile scenarios have shown that under the sampling rate of 5 packet/sec, Bit Generation Rate can reach 20~ 26 bps, and the generated key sequence can pass the NIST standard randomness test.
Physical layer key generation is an important handshaking step for establishing secure wireless communication in wireless networks. Existing methods based on fine-grained Channel State Information (CSI) have seen significant limitations. Reciprocity, the theoretical basis of physical layer key generation, is sensitive to factors such as noise, interference and hardware level variations. Feedback-based Channel Gain Complement is designed to conquer the imperfect reciprocity between two communication parties in actual environments. In addition, we have found that the adjacent subcarriers are strongly correlated. Quantizing all 30 subcarriers without discrimination will reduce the randomness and strength of the secret key while discarding some carriers will lose important information. We propose a cluster-based quantization method, which balances between the generation speed and consistency in initial key bits. Evaluation results in static and mobile scenarios have shown that under the sampling rate of 5 packet/sec, Bit Generation Rate can reach 20~ 26 bps, and the generated key sequence can pass the NIST standard randomness test.
As an alternative and appealing approach to providing information security in wireless communication systems, secret key generation at physical layer has demonstrated its potential in terms of efficiency and reliability over traditional cryptographic methods. Without the necessity of a management centre for key distribution or reliance on computational complexity, physical layer key generation protocols enable two wireless entities to extract identical and dynamic keys from the randomness of the wireless channels associated with them.\nIn this thesis, the reliability of secret key generation at the physical layer is examined in practical wireless channels with imperfect channel state information (CSI). Theoretical analyses are provided to relate key match rate with channel's signal-to-noise ratio (SNR), degrees of channel reciprocity, and iterations of information reconciliation.\nIn order to increase key match rate of physical layer secret key generation, improved schemes in the steps of channel estimation and sample quantization are proposed respectively. In the channel estimation step, multiple observations of the wireless channels are integrated with a linear processor to provide a synthesized and more accurate estimation of the wireless channel. In the sample quantization step, a magnitude based quantization method with two thresholds is proposed to quantize partial samples, where specific quantization areas are selected to reduce cross-over errors. Significant improvements in key match rate are proven for both schemes in theoretical analysis and numerical simulations. Key match rate can even achieve 100% in both schemes with the assistance of information reconciliation process.\nIn the end, a practical application of physical layer secret key generation is presented, where dynamic keys extracted from the wireless channels are utilized for securing secret data transmission and providing efficient access control.
Device-to-device communication is increasingly important for emerging wireless applications, including the Internet of Things and industry mobile networks. To establish a secure communication channel between multiple legitimate devices, key agreement is an essential first step. Physical layer channel information is a promising technology for achieving communication security by generating a shared channel key. In this paper, we propose an efficient and random method for generating channel keys based on channel state information (CSI). Firstly, we preprocess the available subcarriers to reduce the correlation of adjacent subcarriers. Secondly, we propose a novel quantization process to generate random and secure channel keys. The part consists of two phases: the quantization phase and the inconsistency removal phase. In the quantization stage, CSI sub carriers are grouped into small blocks, and appropriate thresholds are generated. Then, wireless users quantize the CSI subcarriers into initial bit streams of 0 and 1 with different thresholds. In the inconsistency removal phase, we design an error correction mechanism where wireless users exchange the discarded index sequences in the initial bit streams to achieve key sequence consistency. We implement the proposed scheme using off-the-shelf wireless devices and evaluate its performance. The experimental results show that each CSI packet can produce 30 bits, which have passed the NIST randomness tests.
Physical layer encryption is a promising solution to provide transmission security for Internet-of-Things (IoT). To realize physical layer encryption, channel state information (CSI) as a random source to generate secret keys should be exploited. The reciprocity of wireless channel between legitimate communication nodes which is typically assumed for time division duplex (TDD) systems, is of critical importance to ensure the consistency in generated keys at two nodes. However, in practical TDD systems, due to the asynchronous measurement of CSI, the receiver noise and the the difference in hardware, etc., the reciprocity of channel measurements between legitimate parties is hard to be guaranteed, which makes physical layer key generation approach infeasible. To address this issue, we propose a wireless key generation scheme based on deep learning techniques. Firstly, a feature extraction network, which consists of two auto-encoders trained jointly, is developed to extract the common feature from the different yet correlated channel observations at two legitimate nodes, which will be used as the source to generate keys. Then a quantizer with an adaptive guard band width is devised to output a binary secret-key sequence from the feature vector. Numerical results show that the proposed scheme achieves remarkable improvement in terms of key disagreement rate (KDR) and key generation rate (KGR) compared existing counterparts in the literature.
The traditional wireless communication security technology is based on cryptography at the network layer, which exploits computational complexity to make it difficult to crack to achieve encryption. With the ongoing advancement of computing power, computational security may be difficult to maintain. From the viewpoint of information theory, physical layer security technology is an essential instrument for integrating security and communication. This paper mainly studies the quantization steps in the key generation technology of wireless communication physical layer. In this paper, a quantization scheme with extremely low implementation complexity is proposed for key generation. Firstly, utilizing the reciprocity and randomness of the wireless channel, the communication parties conduct channel measurements to collect channel state information (CSI) and study the improvement of CSI extraction by incorporating intelligent reflection surfaces. Then, the proposed hybrid quantization scheme makes full use of CSI and quantizes the CSI and its phase information to obtain key bits. Numerical results show that the proposed scheme improves the quality of key generation and avoids information leakage during transmission, and passes the NIST randomness test.
Due to the reciprocity of wireless channels, the communication parties can directly extract the shared key from channel. This solution were verified through several schemes. However, in real situations, channel sampling of legitimate transceivers might be impacted by noises and other interferences, which makes the channel states obtained by initiator and responder might be obvious different. The efficiency and even availability of physical layer key generation are thus reduced. In this paper, we propose a lightweight and efficient physical layer key generation scheme, which extract shared secret keys from channel state information (CSI). To improve the key generation process, the discrete cosine transform (DCT) is employed to reduce differences of channel states of legitimate transceivers. Then, these outputs are quantified and encoded through multi-bit adaptive quantization(MAQ) quantizer and gray code to generate binary bit sequence, which can greatly reduce the bit error rate. Moreover, the low density parity check (LDPC) code and universal hashing functions are used to achieve information reconciliation and privacy amplifification. By adding preprocessing methods in the key generation process and using the rich information of CSI, the security of communications can be increased on the basis of improving the key generation rate. To evaluate this scheme, a number of experiments in various real environments are conducted. The experimental results show that the proposed scheme can effificiently generate shared secret keys for nodes and protect their communication.
The use of wireless networks for communication has grown significantly in recent times, and continues to develop further. The broadcast nature of wireless communications makes them susceptible to a wide variety of security attacks. Unlike traditional solutions, which usually handle security at the application layer, the primary concern of this dissertation is to analyse and develop solutions for secure communication using channel coding techniques at the physical-layer. \nThe topic of physical layer authenticated encryption using high rate key generation through shared randomness is investigated in this work. First, a physical layer secret key generation scheme is discussed exploiting channel reciprocity in wireless systems. In order to address the susceptibility of this family of schemes to active attacks, a novel physical layer authentication encryption protocol is presented along with its extension to multi-node networks in the presence of active adversaries. Unlike previous work in the area of generating secret keys through shared randomness, it is demonstrated that the proposed scheme is semantically secure with respect to chosen plaintext and chosen cipher text attacks. \nSecondly, in order to increase the rate in bits per seconds at which agreed cryptographic keys are been generated, a multi-level quantization algorithm with public feedback is discussed. It is demonstrated that the proposed scheme is superior to direct information distillation approaches and can substantially increase the key generation rates even at low and medium SNRs. Furthermore, the employment of this low-overhead feedback at the information distillation process can largely simplify the information reconciliation process. \nThe proposed secret key generation schemes are tested for randomness such as required for cryptographic keys. The validation test is perfomed with the aid of National Institute of Standards and Technology (NIST) statistical test suite. The P-values obtained in each of the test carried out indicates that the key sequence generated by our algorithm is random.