Cryogenic CMOS (cryo-CMOS) support of quantum processors is becoming a necessity to ensure the continuous growth of qubit count, so as to achieve scalable, fault-tolerant quantum computers. The first paper of the session describes an integrated controller for spin qubits that performs state manipulation, readout, and gate pulsing fabricated in 22nm FinFET CMOS technology. The second paper presents a fully integrated SoC for spin qubit interface based on RF reflectometry of quantum dots, all implemented in 40nm CMOS technology, for scalable quantum systems operating at 3.5K. The third paper also focuses on scalable RF based readout of spin qubits for a record 0.17mW/qubit power requirement, operating at 4.2K. The fourth paper proposes a 1GS/s A/D converter for low-power digitization of the signal measured from a qubit readout that achieves a FOM of 15fJ/conv.-step at 4K.
Cryogenic CMOS (cryo-CMOS) support of quantum processors is becoming a necessity to ensure the continuous growth of qubit count, so as to achieve scalable, fault-tolerant quantum computers. The first paper of the session describes an integrated controller for spin qubits that performs state manipulation, readout, and gate pulsing fabricated in 22nm FinFET CMOS technology. The second paper presents a fully integrated SoC for spin qubit interface based on RF reflectometry of quantum dots, all implemented in 40nm CMOS technology, for scalable quantum systems operating at 3.5K. The third paper also focuses on scalable RF based readout of spin qubits for a record 0.17mW/qubit power requirement, operating at 4.2K. The fourth paper proposes a 1GS/s A/D converter for low-power digitization of the signal measured from a qubit readout that achieves a FOM of 15fJ/conv.-step at 4K.
A fault-tolerant quantum computer with millions of quantum bits (qubits) requires massive yet very precise control electronics for the manipulation and readout of individual qubits. CMOS operating at cryogenic temperatures down to 4 K (cryo-CMOS) allows for closer system integration, thus promising a scalable solution to enable future quantum computers. In this paper, a cryogenic control system is proposed, along with the required specifications, for the interface of the classical electronics with the quantum processor. To prove the advantages of such a system, the functionality of key circuit blocks is experimentally demonstrated. The characteristic properties of cryo-CMOS are exploited to design a noise-canceling low-noise amplifier for spin-qubit RF-reflectometry readout and a class-F2,3digitally controlled oscillator required to manipulate the state of qubits.
Quantum computing promises to revolutionize our lives, achieving unprecedented computational powers and unlocking new possibilities in drug discovery, chemical simulations and cryptography. The fundamental unit of computation of a quantum computer is the quantum bit (qubit). It can be implemented in a number of technologies, such as superconducting qubits, spin qubits, photonic systems, trapped ions and NV-centers. Solid-state superconducting qubits and spin qubits seem to be the most promising ones, as shown by the recent demonstration of quantum supremacy with a superconducting qubit processor. Such quantum processors, to operate in the quantum regime, require very low temperatures around 10 mK, and they are hence kept inside dilution fridges. The electronics required to read out and control such processors is typically realized by discrete components or bulky scientific instruments at room temperature wired into the dilution fridge. Such approach is only feasible until few (< 100) qubits are handled, but it is not scalable for million-qubit processors required for fault-tolerant operation. In this thesis, readout and control electronics is proposed to be integrated and operated directly at cryogenic temperatures, in close proximity with the qubits and potentially even co-integrated. CMOS technology is advocated for its scalability, compactness and low prototyping cost, to create a comprehensive cryo-CMOS class of fully-integrated transceivers to read out and control solid-state qubits. In particular, the thesis focuses on cryo-CMOS radio-frequency integrated circuits for the readout of silicon quantum computers, looking to integrate the whole readout system, from the quantum layer to the room temperature user interface. Cryogenic CMOS devices are explored first, to lay the foundations of integrated circuit design. The realization of quantum dots in standard CMOS technology is explored as a platform to realize solid-state qubit arrays, demonstrating functionality at 50 mK and good reproducibility. Moreover, the operation of integrated transistors at 50 mK and 4.2 K is explored to understand their basic cryogenic functionality, through characterization and modeling. Then also integrated passives, such as capacitors, inductors and transformers, are studied and modeled at cryogenic temperatures. Then, a fully-integrated readout platform spanning across all the blocks needed for dispersive readout is proposed. A fully-integrated matrix of quantum dots with radio-frequency gate-based readout capabilities is demonstrated along with time- and frequency-multiplexing. This quantum-classical circuit shows all the features for a scalable approach and is the core of the platform following it. A cryogenic CMOS circulator based on a new all-pass filter architecture is demonstrated, to be used as integrated replacement for current bulky counterparts; it allows power reduction, insertion loss and bandwidth enhancement with respect to state-of-the-art integrated circulators. The rest of the front-end is also explored with dedicated test multiplexers, a low noise-amplifier and an oscillator, that are finally merged in a single fully-integrated low-noise receiver with frequency synthesizer operating at 3.5 K for scalable multiplexed readout of silicon qubits. The platform presented in this thesis, across temperature boundaries, carries all the features required for future scalable silicon quantum computing platforms and could therefore form their core.
Quantum computing promises exponential speed-up in solving certain complex problems that would be intractable by classical computers. However, thousands or millions of qubits might be required to solve useful problems. High-precision and low-noise electrical signals are required to manipulate and read the state of a qubit and to control qubit-to-qubit interactions. Current systems use room temperature electronics with many coax cables routed to the qubit chip inside a dilution refrigerator. This approach does not scale to large number of qubits, due to form factor, cost, power consumption and thermal load to the fridge. To address this challenge, a cryogenic qubit controller has been proposed [1]. The first integrated implementation of a cryogenic pulse modulator has been presented in [2], demonstrating the capability of manipulating (drive) the state of superconducting qubits. The work in [3] extends the capability of the controller with 3 main features: frequency-multiplexing to reduce the number of RF cables per qubit, an arbitrary I/Q pulse generation for improved control fidelity and a digitally-intensive architecture with integrated instruction set to enable integration in existing quantum control stacks. This work further advances the prior art by integrating the capability of reading the qubit state and generating the voltage pulses required for drive, readout, 2-qubit operations and qubit characterization. The SoC can drive up to 16 spin qubits by frequency multiplexing over a single RF line, read the state of up to 6 qubits simultaneously and control up to 22 gate potentials. The SoC also integrates a μ-controller for increased flexibility in implementing the control instruction set. The proposed cryogenic controller can replace all the high-speed control electronics used in conventional solutions today, paving the way towards scalable quantum computers.
Quantum computing requires scalable, energyefficient control electronics at cryogenic temperatures. Cryogenic CMOS (cryo-CMOS) enables integration with quantum processors, operating below 4 K while leveraging advanced CMOS processes. This paper reviews cryo-CMOS circuits and systems developed from 2016 to 2025, covering device behavior, analog, mixedsignal, and digital circuits, and system-level integration for largescale quantum control. Multiple implementations are compared, highlighting trade-offs in power, noise, scalability, and temperature operation. Key trends include fully integrated Cryo-SoCs, hybrid CMOS-III-V technologies, and machine-learning-assisted calibration. Remaining challenges in modeling, energy dissipation, and thermal management are discussed, outlining a roadmap for nextgeneration cryo-CMOS quantum architectures.
This article presents a fully integrated Cryo-CMOS system on chip (SoC) for quantum computing. The proposed SoC integrates a radio frequency (RF) pulse modulator for qubit state manipulation, a multi-tone signal generator and a coherent receiver for qubit state readout, and 22 DACs for high-speed voltage pulsing of qubit gates. By adopting frequency division multiplexing and direct digital synthesis (DDS), the RF pulse modulator can control up to 16 qubits over a single RF line, and the readout receiver can detect the state of up to six qubits simultaneously. The proposed SoC also integrates a microcontroller for low latency on-chip signal processing and increased flexibility in implementing quantum instruction sets. A detailed analysis of qubit-state readout fidelity and the impact of finite DAC resolution on two-qubit gate fidelity is also included in this article, together with an electrical specification summary. The SoC is implemented in Intel’s 22 nm FFL fin field-effect transistor (FinFET) process, and it is characterized both at room and 4 K temperatures. The performance of each specific block is measured, with the readout characterized in a loop-back configuration. Generation of the control signals required for a full Rabi oscillation experiment is also demonstrated. This article also describes the cryogenic thermalization techniques used to integrate the SoC in the dilution refrigerator and shows temperature measurements during operation.
A fault tolerant scalable quantum computer requires more than 1000 Qubits to perform real time state correction and to improve the Qubit coherence time. The dense wiring connections required between the quantum processor placed at a 100 mK temperature and the room temperature control and readout electronics serve as a limiting factor in this system. Qubit control and readout electronics operating at 4 K temperature, placed closer to a quantum processor inside the dilution refrigerator avoids the dense wiring connections to room temperature electronics, and hence, serve as a potential solution to realize a scalable quantum computer. However, with no CMOS process technology models available at cryogenic temperatures, the design of a fully integrated, ultra-low power Qubit control and readout electronics at a sub-1 mW power consumption proves to be extremely challenging. In recent years, there has been a huge rise in interest among the research communities to understand and solve the device and circuit level challenges at deep cryogenic temperatures. This paper presents an overview of the recently published active and passive device nonidealities, circuit design challenges and solutions, and the future research directions in the Qubit control and readout electronics operating at deep cryogenic temperatures.