Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Performance of Sub-Harmonic Mixing With an SIS Junction

Shuai Shi, Wenlei Shan, Toshihiko Noguchi, K. C. Xiao

Published May 1, 2000• 0 citations
OpenAlex

Related papers

An experimental study of harmonic sis mixing at 205-235 ghz

Kecheng Xiao, Hideo Ogawa, Yasuo Fukui

A 230-GHz subharmonically pumped waveguide mixer employing superconducting tunnel junctions has been developed. We present, in this paper, an experimental study of harmonic superconductor-insulator-superconductor (SIS) mixing at 230 GHz, focusing mainly on its noise behavior. The mixer has a double-tuned waveguide structure and employs an array of four 1.7-/spl mu/m/sup 2/ Nb-AlOx-Nb SIS junctions in series, with /spl omega/R/sub n/C/sub j//spl sim/3 at 230 GHz. Harmonic quantum mixing occurred over an experimental frequency range of 205-235 GHz (local oscillator: 112.5-117.5 GHz), exhibiting corresponding double sideband noise temperatures of lower than 150 K, with a lowest value of 75 K at /spl sim/230 GHz. The measured mixer noise is believed to be the lowest yet reported for a mixer using subharmonic-pump configuration at this frequency. A phenomenon that we attribute to the third harmonic SIS mixing has also been observed.

IEEE Transactions on Applied Superconductivity•Dec 1, 2003•3 citations

Simulation of the sub-harmonic SIS mixer

Wenlei Shan, S. C. Shi, Yijun Feng +4 more

Physica C Superconductivity•Nov 1, 2000•0 citations

Microwave mixing and direct detection using SIS and SIS' quasiparticle tunnel junctions

A. D. Smith, William R. McGrath, P. L. Richards +4 more

Quasiparticle mixers have shown strong quantum effects, conversion gain, and noise levels approaching the quantum limit, but only in tunnel junctions with very low sub-gap "leakage" conductance. It has been suggested that SIS' tunnel junctions, made from two different conductors with unequal gaps, will function as high gain mixers since the dynamic conductance below the gap is negative. We report results of the first SIS' mixing and direct detection experiments. At 36 GHz, a conversion efficiency of -4 dB with a noise temperature of 33 K (SSB) has been obtained. A novel gain mechanism for SIS' direct detectors is predicted. A direct detector responsivity of 250 A/W was measured. We compare our results to quantum theory models. In addition, we demonstrate quasiparticle harmonic mixing of a 36 GHz signal with an 18 GHz local oscillator in tin SIS junctions. Harmonic mixers can have important advantages at high microwave frequencies where insufficient local oscillator power is available.

IEEE Transactions on Magnetics•May 1, 1983•15 citations

Measurements on frequency-scaled models of SIS-mixers

U. Pisani, Franco Rosso, L. Brunetti

Measurement•Sep 1, 1996•1 citation

Nb-based SIS mixer in the 800 GHz band

Takashi Noguchi, Hiroyuki Maezawa, Sheng‐Cai Shi +1 more

We have built a waveguide SIS mixer with Nb-based parallel-connected twin junctions at 800 GHz which is above the gap frequency of Nb (690 GHz). Heterodyne mixing was performed at 810 GHz and a receiver noise temperature of 580 K (DSB), which includes noise contributions due to a vacuum window and a beam splitter, was achieved using Nb/AlO/sub x//Nb junctions with Nb striplines. The performance of this mixer is quite good and it is shown that efficient mixing in Nb-based SIS junctions is still possible above the gap frequency, SIS mixers with Al striplines have also been fabricated and good DC I-V characteristics have been observed. Heterodyne measurements of these mixers are now under preparation.

IEEE Transactions on Applied Superconductivity•Mar 1, 2001•6 citations

Large conversion efficiency and dynamic range for sis mixers

T. C. L. G. Sollner

Physica B+C•Aug 1, 1981•5 citations
A 230-GHz subharmonically pumped waveguide mixer employing superconducting tunnel junctions has been developed. We present, in this paper, an experimental study of harmonic superconductor-insulator-superconductor (SIS) mixing at 230 GHz, focusing mainly on its noise behavior. The mixer has a double-tuned waveguide structure and employs an array of four 1.7-/spl mu/m/sup 2/ Nb-AlOx-Nb SIS junctions in series, with /spl omega/R/sub n/C/sub j//spl sim/3 at 230 GHz. Harmonic quantum mixing occurred over an experimental frequency range of 205-235 GHz (local oscillator: 112.5-117.5 GHz), exhibiting corresponding double sideband noise temperatures of lower than 150 K, with a lowest value of 75 K at /spl sim/230 GHz. The measured mixer noise is believed to be the lowest yet reported for a mixer using subharmonic-pump configuration at this frequency. A phenomenon that we attribute to the third harmonic SIS mixing has also been observed.
Quasiparticle mixers have shown strong quantum effects, conversion gain, and noise levels approaching the quantum limit, but only in tunnel junctions with very low sub-gap "leakage" conductance. It has been suggested that SIS' tunnel junctions, made from two different conductors with unequal gaps, will function as high gain mixers since the dynamic conductance below the gap is negative. We report results of the first SIS' mixing and direct detection experiments. At 36 GHz, a conversion efficiency of -4 dB with a noise temperature of 33 K (SSB) has been obtained. A novel gain mechanism for SIS' direct detectors is predicted. A direct detector responsivity of 250 A/W was measured. We compare our results to quantum theory models. In addition, we demonstrate quasiparticle harmonic mixing of a 36 GHz signal with an 18 GHz local oscillator in tin SIS junctions. Harmonic mixers can have important advantages at high microwave frequencies where insufficient local oscillator power is available.
We have built a waveguide SIS mixer with Nb-based parallel-connected twin junctions at 800 GHz which is above the gap frequency of Nb (690 GHz). Heterodyne mixing was performed at 810 GHz and a receiver noise temperature of 580 K (DSB), which includes noise contributions due to a vacuum window and a beam splitter, was achieved using Nb/AlO/sub x//Nb junctions with Nb striplines. The performance of this mixer is quite good and it is shown that efficient mixing in Nb-based SIS junctions is still possible above the gap frequency, SIS mixers with Al striplines have also been fabricated and good DC I-V characteristics have been observed. Heterodyne measurements of these mixers are now under preparation.