Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Fabrication and characteriation of Josephson parametric amplifiers

Matthijs H. J. de Jong

Published Jan 1, 2018• 0 citations
OpenAlex

Abstract

In this thesis, a we have designed and fabricated a Josephson Parametric Amplifier (JPA) using a new double-angle evaporation method without a Dolan bridge. We have found and resolved several issues in the fabrication procedure, but it requires further tuning before being fully functional. We have also simulated the behaviour of a general parametric amplifier with an additional Duffing non-linear term, and found that this term appears to limit the oscillation amplitude. We have attempted to characterize Josephson junctions fabricated with the new double-angle evaporation procedure, but without much success. Using a different fabrication method, a JPA was made and successfully characterized. The maximum measured gain is 16 dB, with a bandwidth of 1 MHz. The noise temperature is comparable to the cryostat temperature of 250 mK, but it was not characterized accurately.

Related papers

Impedance-engineered Josephson parametric amplifier with single-step lithography

Lipi Patel, Samarth Hawaldar, Aditya Panikkar +2 more

We present an experimental demonstration of an impedance-engineered Josephson parametric amplifier (IEJPA) fabricated in a single-step lithography process. Impedance-engineering is implemented using a lumped-element series LC circuit. We use a simpler lithography process where the entire device—impedance transformer and Josephson parametric amplifier (JPA)—is patterned in a single electron beam lithography step, followed by a double-angle Dolan-bridge technique for Al–AlOx–Al deposition. We observe amplification with 18 dB gain over a wide 400 MHz bandwidth centered around 5.3 GHz with added noise approaching the quantum limit, and a saturation power of −114 dBm. To accurately explain our experimental results, we extend existing theories for IEJPAs to incorporate the full sine nonlinearity of both the JPA and the transformer. Our work provides a route to simpler realization of broadband JPAs and a theoretical foundation for a regime of JPA operation that has been less explored in literature.

arXiv:2507.09298•Applied Physics Letters•Dec 22, 2025•0 citations

Fabrication of Josephson parameter amplifier and its application in squeezing vacuum fluctuations*

Pengtao Song, Xueyi Guo, Kai Xu +7 more

Josephson parameter amplifier (JPA) is a microwave signal amplifier device with near-quantum-limit-noise performance. It has important applications in scientific research fields such as quantum computing and dark matter detection. This work reports the fabrication and characterization of broadband JPA devices and their applications in multi-qubit readout and squeezing of vacuum state. We use a process in which transmission lines and electrodes are made of niobium thin film and aluminum Josephson junctions are made by Dolan bridge technique. We believe this process is more convenient than the process we used previously. The whole production process adopts electron beam lithography technology to ensure high structural resolution. The test result shows that the gain value of the manufactured JPA can exceed 15 dB, and the amplification bandwidth is about 400 MHz. The noise temperature is about 400 mK at the working frequency of 6.2 GHz. The devices have been successfully used in experiments involving superconducting multi-qubit quantum processors. Furthermore, the device is applied to squeeze vacuum fluctuations and a squeezing level of 1.635 dB is achieved.

Chinese Physics B•Jun 3, 2021•1 citation

Fabrication and characterization of all-Nb lumped-element Josephson parametric amplifiers*

Hang Xue, Zhirong Lin, Wenbing Jiang +4 more

Josephson parametric amplifiers (JPAs) with nearly quantum-limited noise performance have become indispensable devices for the measurements of superconducting quantum information. We have developed an all-Nb lumped-element flux-driven JPA operating in the three-wave mixing mode. Our Nb-based JPA comprises Nb/Al-AlO x /Nb Josephson junctions, a parallel-plate capacitor with SiO2 dielectric sandwiched between two Nb layers, a bottom coplanar waveguides layer, and a top Nb wiring layer. We experimentally demonstrate a 20 dB gain over a 190 MHz bandwidth, a mean 1 dB compression of –123 dBm, and near quantum-limited noise performance. This fabrication process can be further used to design impedance transformed parametric amplifiers for multiple-qubit readout.

Chinese Physics B•Mar 16, 2021•4 citations

Development of Josephson Parametric Amplifiers for quantum applications

Stefanos Basili

Quantum-limited parametric amplifiers have become increasingly interesting and relevant with the progressing field of quantum computing. However, currently it is still challenging to fabricate these complex devices. In this thesis, we developed cross type Josephson junctions (JJs), lumped element LC resonators, lumped element Josephson parametric amplifiers (JPAs) and Josephson traveling wave parametric amplifiers (JTWPAs). We found and resolved several fabrication issues however we suspect that both the JPA and JTWPA suffered from microshorts in the circuits during the cryogenic measurements. Nevertheless, we managed to measure the resonance frequency of the JPA and have noticed the flux focusing effect when we flux tune it. We preformed room temperature measurements on over 300 JJs and calculated the relative standard deviation (RSD) for various JJ sizes. We found the spread of 30 fabricated resonators and a rough estimate of their Q factors. The JTWPAs developed are non-degenerate four wave mixing amplifiers that use the resonant phase matching (RPM) technique to reduce the phase mismatch problem. The transmission through the measured JTWPA showed 50 dB loss probably caused by presumably a short from the transmission line to ground. However, when the JTWPA was driven with a pump we observed 20 dB increase in transmission in some frequency bands.

•Jan 1, 2020•0 citations

Fabrication of the Impedance-Matched Josephson Parametric Amplifier and the Study of the Gain Profile

Rui Liang Yang, Huiqiu Deng

We designed and fabricated an impedance-matched Josephson parametric amplifier (JPA) working in the flux-pump mode for the broadband amplification of microwave signals. A simple fabrication method suitable for a small cleanroom was developed. We also studied the phase response, as well as the gain, as a function of signal frequency and pump power at various pump frequencies. The phase response can be explained with the behavior of the nonlinear Duffing oscillator. The observed decrease of the resonance frequency as the pump power increases, as well as the emergence of an unstable bifurcation zone, are the characteristic nonlinear behavior of the Duffing oscillator. The features of the gain profile in the stable zone can be explained with a model adapted from the theoretical model for the two-dimensional gain profile of an impedance-matched, current-pumped JPA. Over 17 dB gain with a bandwidth more than 300 MHz (centered around 6.45 GHz) was observed. Our impedance-matched JPA is used for improving the fast readout fidelity of transmon qubits.

arXiv:1909.00707•IEEE Transactions on Applied Superconductivity•Apr 6, 2020•14 citations

Fabrication and characterization of impedance-transformed Josephson parametric amplifier

Zheng-Yang Mei, Xiaohui Song, X. C. Guo +10 more

In this paper, we introduce a method of using a double-layer resist lift-off process to prepare the capacitor dielectric layer for fabricating impedance-engineered Josephson parametric amplifiers (IMPAs). Compared to prior art, this method enhances fabrication success rate and accelerates production. The IMPA we made, experimentally achieves an instantaneous bandwidth over 950 (600) MHz with a gain exceeding 10 (14) dB, along with saturation input power of −115 dBm and near quantum-limited noise. We demonstrate the negligible backaction from the IMPA on superconducting qubits, resulting in no significant degradation of the relaxation time and coherence time of the qubits. The IMPA improves the signal-to-noise ratio from 1.69 to 14.56 and enables the amplification chain to achieve high quantum efficiency with η ≈ 0.26, making it a critical necessity for large-scale quantum computation.

arXiv:2503.06936•AIP Advances•Jul 1, 2025•1 citation
In this thesis, a we have designed and fabricated a Josephson Parametric Amplifier (JPA) using a new double-angle evaporation method without a Dolan bridge. We have found and resolved several issues in the fabrication procedure, but it requires further tuning before being fully functional. We have also simulated the behaviour of a general parametric amplifier with an additional Duffing non-linear term, and found that this term appears to limit the oscillation amplitude. We have attempted to characterize Josephson junctions fabricated with the new double-angle evaporation procedure, but without much success. Using a different fabrication method, a JPA was made and successfully characterized. The maximum measured gain is 16 dB, with a bandwidth of 1 MHz. The noise temperature is comparable to the cryostat temperature of 250 mK, but it was not characterized accurately.
We present an experimental demonstration of an impedance-engineered Josephson parametric amplifier (IEJPA) fabricated in a single-step lithography process. Impedance-engineering is implemented using a lumped-element series LC circuit. We use a simpler lithography process where the entire device—impedance transformer and Josephson parametric amplifier (JPA)—is patterned in a single electron beam lithography step, followed by a double-angle Dolan-bridge technique for Al–AlOx–Al deposition. We observe amplification with 18 dB gain over a wide 400 MHz bandwidth centered around 5.3 GHz with added noise approaching the quantum limit, and a saturation power of −114 dBm. To accurately explain our experimental results, we extend existing theories for IEJPAs to incorporate the full sine nonlinearity of both the JPA and the transformer. Our work provides a route to simpler realization of broadband JPAs and a theoretical foundation for a regime of JPA operation that has been less explored in literature.
Josephson parameter amplifier (JPA) is a microwave signal amplifier device with near-quantum-limit-noise performance. It has important applications in scientific research fields such as quantum computing and dark matter detection. This work reports the fabrication and characterization of broadband JPA devices and their applications in multi-qubit readout and squeezing of vacuum state. We use a process in which transmission lines and electrodes are made of niobium thin film and aluminum Josephson junctions are made by Dolan bridge technique. We believe this process is more convenient than the process we used previously. The whole production process adopts electron beam lithography technology to ensure high structural resolution. The test result shows that the gain value of the manufactured JPA can exceed 15 dB, and the amplification bandwidth is about 400 MHz. The noise temperature is about 400 mK at the working frequency of 6.2 GHz. The devices have been successfully used in experiments involving superconducting multi-qubit quantum processors. Furthermore, the device is applied to squeeze vacuum fluctuations and a squeezing level of 1.635 dB is achieved.
Josephson parametric amplifiers (JPAs) with nearly quantum-limited noise performance have become indispensable devices for the measurements of superconducting quantum information. We have developed an all-Nb lumped-element flux-driven JPA operating in the three-wave mixing mode. Our Nb-based JPA comprises Nb/Al-AlO x /Nb Josephson junctions, a parallel-plate capacitor with SiO2 dielectric sandwiched between two Nb layers, a bottom coplanar waveguides layer, and a top Nb wiring layer. We experimentally demonstrate a 20 dB gain over a 190 MHz bandwidth, a mean 1 dB compression of –123 dBm, and near quantum-limited noise performance. This fabrication process can be further used to design impedance transformed parametric amplifiers for multiple-qubit readout.
Quantum-limited parametric amplifiers have become increasingly interesting and relevant with the progressing field of quantum computing. However, currently it is still challenging to fabricate these complex devices. In this thesis, we developed cross type Josephson junctions (JJs), lumped element LC resonators, lumped element Josephson parametric amplifiers (JPAs) and Josephson traveling wave parametric amplifiers (JTWPAs). We found and resolved several fabrication issues however we suspect that both the JPA and JTWPA suffered from microshorts in the circuits during the cryogenic measurements. Nevertheless, we managed to measure the resonance frequency of the JPA and have noticed the flux focusing effect when we flux tune it. We preformed room temperature measurements on over 300 JJs and calculated the relative standard deviation (RSD) for various JJ sizes. We found the spread of 30 fabricated resonators and a rough estimate of their Q factors. The JTWPAs developed are non-degenerate four wave mixing amplifiers that use the resonant phase matching (RPM) technique to reduce the phase mismatch problem. The transmission through the measured JTWPA showed 50 dB loss probably caused by presumably a short from the transmission line to ground. However, when the JTWPA was driven with a pump we observed 20 dB increase in transmission in some frequency bands.
We designed and fabricated an impedance-matched Josephson parametric amplifier (JPA) working in the flux-pump mode for the broadband amplification of microwave signals. A simple fabrication method suitable for a small cleanroom was developed. We also studied the phase response, as well as the gain, as a function of signal frequency and pump power at various pump frequencies. The phase response can be explained with the behavior of the nonlinear Duffing oscillator. The observed decrease of the resonance frequency as the pump power increases, as well as the emergence of an unstable bifurcation zone, are the characteristic nonlinear behavior of the Duffing oscillator. The features of the gain profile in the stable zone can be explained with a model adapted from the theoretical model for the two-dimensional gain profile of an impedance-matched, current-pumped JPA. Over 17 dB gain with a bandwidth more than 300 MHz (centered around 6.45 GHz) was observed. Our impedance-matched JPA is used for improving the fast readout fidelity of transmon qubits.
In this paper, we introduce a method of using a double-layer resist lift-off process to prepare the capacitor dielectric layer for fabricating impedance-engineered Josephson parametric amplifiers (IMPAs). Compared to prior art, this method enhances fabrication success rate and accelerates production. The IMPA we made, experimentally achieves an instantaneous bandwidth over 950 (600) MHz with a gain exceeding 10 (14) dB, along with saturation input power of −115 dBm and near quantum-limited noise. We demonstrate the negligible backaction from the IMPA on superconducting qubits, resulting in no significant degradation of the relaxation time and coherence time of the qubits. The IMPA improves the signal-to-noise ratio from 1.69 to 14.56 and enables the amplification chain to achieve high quantum efficiency with η ≈ 0.26, making it a critical necessity for large-scale quantum computation.