Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Entropy

From Quantum Probabilities to Quantum Amplitudes

S. Martínez-Garaot, M. Ll. Pons, D. Sokolovski

Published Dec 8, 2020• 2 citations
Publisher

Abstract

The task of reconstructing the system's state from the measurements results, known as the Pauli problem, usually requires repetition of two successive steps. Preparation in an initial state to be determined is followed by an accurate measurement of one of the several chosen operators in order to provide the necessary "Pauli data". We consider a similar yet more general problem of recovering Feynman's transition (path) amplitudes from the results of at least three consecutive measurements. The three-step histories of a pre- and post-selected quantum system are subjected to a type of interference not available to their two-step counterparts. We show that this interference can be exploited, and if the intermediate measurement is "fuzzy", the path amplitudes can be successfully recovered. The simplest case of a two-level system is analysed in detail. The "weak measurement" limit and the usefulness of the path amplitudes are also discussed.

DOI
10.3390/e22121389

Related papers

Quantum measurements, stochastic networks, the uncertainty principle, and not so strange "weak values"

D. Sokolovski

The outcomes of a series of measurements, made on a quantum system, form a sequence of random events which occur in a particular order. The system, together with a meter or meters, can be seen as following the paths of a stochastic network connecting all possible outcomes. The paths are shaped from the virtual paths of the system, and the corresponding probabilities are determined by the measuring devices employed. If the measurements are highly accurate, the virtual paths become "real", and the mean values of a quantity (a functional) is directly related to the frequencies with which the paths are travelled. If the measurements are highly inaccurate, the mean (weak) values are expressed in terms of the relative probabilities amplitudes. For pre- and post-selected systems they are bound to take arbitrary values, depending on the chosen transition. This is a direct consequence of the uncertainty principle, which forbids one to distinguish between interfering alternatives, while leaving the interference between them intact.

arXiv:1606.01845•Jun 6, 2016•0 citations

Quantum Measurements, Stochastic Networks, the Uncertainty Principle, and the Not So Strange “Weak Values”

D. Sokolovski

Suppose we make a series of measurements on a chosen quantum system. The outcomes of the measurements form a sequence of random events, which occur in a particular order. The system, together with a meter or meters, can be seen as following the paths of a stochastic network connecting all possible outcomes. The paths are shaped from the virtual paths of the system, and the corresponding probabilities are determined by the measuring devices employed. If the measurements are highly accurate, the virtual paths become “real”, and the mean values of a quantity (a functional) are directly related to the frequencies with which the paths are traveled. If the measurements are highly inaccurate, the mean (weak) values are expressed in terms of the relative probabilities’ amplitudes. For pre- and post-selected systems they are bound to take arbitrary values, depending on the chosen transition. This is a direct consequence of the uncertainty principle, which forbids one from distinguishing between interfering alternatives, while leaving the interference between them intact.

Mathematics•Sep 15, 2016•9 citations

The reconstruction problem and weak quantum values

Maurice A. de Gosson, Serge M. de Gosson

Quantum mechanical weak values are an interference effect measured by the cross-Wigner transform of the post- and pre-selected states, leading to a complex quasi-distribution ρ ϕ, ψ ( x , p ) on phase space. We show that the knowledge of ρ ϕ, ψ ( z ) and of one of the two functions ϕ, ψ unambiguously determines the other, thus generalizing a recent reconstruction result of Lundeen and his collaborators.

arXiv:1112.5773•Journal of Physics A Mathematical and Theoretical•Mar 1, 2012•12 citations

Complete characterization of post-selected quantum statistics using weak measurement tomography

Holger Friedrich Hofmann

The reconstruction of quantum states from a sufficient set of experimental data can be achieved with arbitrarily weak measurement interactions. Since such weak measurements have negligible back action, the quantum state reconstruction is also valid for the postselected subensembles usually considered in weak measurement paradoxes. It is shown that postselection can then be identified with a statistical decomposition of the initial density matrix into transient density matrices conditioned by the anticipated measurement outcomes. This result indicates that it is possible to ascribe the properties determined by the final measurement outcome to each individual quantum system before the measurement has taken place. The ``collapse'' of the pure state wave function in a measurement can then be understood in terms of the classical ``collapse'' of a probability distribution as new information becomes available.

arXiv:0907.0533•Physical Review A•Jan 6, 2010•59 citations

Weak values, “negative probability,” and the uncertainty principle

D. Sokolovski

A quantum transition can be seen as a result of interference between various pathways (e.g., Feynman paths), which can be labeled by a variable $f$. An attempt to determine the value of $f$ without destroying the coherence between the pathways produces a weak value of $\overline{f}$. We show $\overline{f}$ to be an average obtained with an amplitude distribution which can, in general, take negative values, which, in accordance with the uncertainty principle, need not contain information about the actual range of $f$ which contributes to the transition. It is also demonstrated that the moments of such alternating distributions have a number of unusual properties which may lead to a misinterpretation of the weak-measurement results. We provide a detailed analysis of weak measurements with and without post-selection. Examples include the double-slit diffraction experiment, weak von Neumann and von Neumann--like measurements, traversal time for an elastic collision, phase time, and local angular momentum.

arXiv:0905.3810•Physical Review A•Oct 25, 2007•45 citations

Quantum Weak Values and the “Which Way?” Question

Anton Uranga, Elena V. Akhmatskaya, D. Sokolovski

The Uncertainty Principle forbids one to determine which of the two paths a quantum system has travelled, unless interference between the alternatives had been destroyed by a measuring device, e.g., by a pointer. One can try to weaken the coupling between the device and the system in order to avoid the veto. We demonstrate, however, that a weak pointer is at the same time an inaccurate one, and the information about the path taken by the system in each individual trial is inevitably lost. We show also that a similar problem occurs if a classical system is monitored by an inaccurate quantum meter. In both cases, one can still determine some characteristic of the corresponding statistical ensemble, a relation between path probabilities in the classical case, and a relation between the probability amplitudes if a quantum system is involved.

arXiv:2407.10360•Entropy•Mar 1, 2025•2 citations
The task of reconstructing the system's state from the measurements results, known as the Pauli problem, usually requires repetition of two successive steps. Preparation in an initial state to be determined is followed by an accurate measurement of one of the several chosen operators in order to provide the necessary "Pauli data". We consider a similar yet more general problem of recovering Feynman's transition (path) amplitudes from the results of at least three consecutive measurements. The three-step histories of a pre- and post-selected quantum system are subjected to a type of interference not available to their two-step counterparts. We show that this interference can be exploited, and if the intermediate measurement is "fuzzy", the path amplitudes can be successfully recovered. The simplest case of a two-level system is analysed in detail. The "weak measurement" limit and the usefulness of the path amplitudes are also discussed.
The outcomes of a series of measurements, made on a quantum system, form a sequence of random events which occur in a particular order. The system, together with a meter or meters, can be seen as following the paths of a stochastic network connecting all possible outcomes. The paths are shaped from the virtual paths of the system, and the corresponding probabilities are determined by the measuring devices employed. If the measurements are highly accurate, the virtual paths become "real", and the mean values of a quantity (a functional) is directly related to the frequencies with which the paths are travelled. If the measurements are highly inaccurate, the mean (weak) values are expressed in terms of the relative probabilities amplitudes. For pre- and post-selected systems they are bound to take arbitrary values, depending on the chosen transition. This is a direct consequence of the uncertainty principle, which forbids one to distinguish between interfering alternatives, while leaving the interference between them intact.
Suppose we make a series of measurements on a chosen quantum system. The outcomes of the measurements form a sequence of random events, which occur in a particular order. The system, together with a meter or meters, can be seen as following the paths of a stochastic network connecting all possible outcomes. The paths are shaped from the virtual paths of the system, and the corresponding probabilities are determined by the measuring devices employed. If the measurements are highly accurate, the virtual paths become “real”, and the mean values of a quantity (a functional) are directly related to the frequencies with which the paths are traveled. If the measurements are highly inaccurate, the mean (weak) values are expressed in terms of the relative probabilities’ amplitudes. For pre- and post-selected systems they are bound to take arbitrary values, depending on the chosen transition. This is a direct consequence of the uncertainty principle, which forbids one from distinguishing between interfering alternatives, while leaving the interference between them intact.
The reconstruction of quantum states from a sufficient set of experimental data can be achieved with arbitrarily weak measurement interactions. Since such weak measurements have negligible back action, the quantum state reconstruction is also valid for the postselected subensembles usually considered in weak measurement paradoxes. It is shown that postselection can then be identified with a statistical decomposition of the initial density matrix into transient density matrices conditioned by the anticipated measurement outcomes. This result indicates that it is possible to ascribe the properties determined by the final measurement outcome to each individual quantum system before the measurement has taken place. The ``collapse'' of the pure state wave function in a measurement can then be understood in terms of the classical ``collapse'' of a probability distribution as new information becomes available.
A quantum transition can be seen as a result of interference between various pathways (e.g., Feynman paths), which can be labeled by a variable fff. An attempt to determine the value of fff without destroying the coherence between the pathways produces a weak value of f‾\overline{f}f​. We show f‾\overline{f}f​ to be an average obtained with an amplitude distribution which can, in general, take negative values, which, in accordance with the uncertainty principle, need not contain information about the actual range of fff which contributes to the transition. It is also demonstrated that the moments of such alternating distributions have a number of unusual properties which may lead to a misinterpretation of the weak-measurement results. We provide a detailed analysis of weak measurements with and without post-selection. Examples include the double-slit diffraction experiment, weak von Neumann and von Neumann--like measurements, traversal time for an elastic collision, phase time, and local angular momentum.
The Uncertainty Principle forbids one to determine which of the two paths a quantum system has travelled, unless interference between the alternatives had been destroyed by a measuring device, e.g., by a pointer. One can try to weaken the coupling between the device and the system in order to avoid the veto. We demonstrate, however, that a weak pointer is at the same time an inaccurate one, and the information about the path taken by the system in each individual trial is inevitably lost. We show also that a similar problem occurs if a classical system is monitored by an inaccurate quantum meter. In both cases, one can still determine some characteristic of the corresponding statistical ensemble, a relation between path probabilities in the classical case, and a relation between the probability amplitudes if a quantum system is involved.