Building quantum networks ultimately requires strong use cases. As today's design and use of the Internet solely rests on the interconnection of classical computing devices, the development of hardware should take this dependence on an existing market into account. One might think quantum secure communication would be such a use case, but the entire design of the current Internet is built on the end-to-end argument and may reject the idea of implementing security as a physical layer protocol. On the other hand, higher data rates and reduced latency have been successfully used as key arguments for the conception of new communication standards. We thus argue that exactly these two figures of merit should be used again. We define two new initial stages of development of the quantum Internet, where in the first phase entanglement is only generated and used between network nodes, and in second phase entanglement swapping and thus distribution of entanglement over increasing distances becomes possible. In both phases, we show by simulation how the available new protocols increase the network capacity. Interestingly, following this envisioned approach can serve the needs of current market participants while paving the road for fully quantum applications in the future.
Building quantum networks ultimately requires strong use cases. As today's design and use of the Internet solely rests on the interconnection of classical computing devices, the development of hardware should take this dependence on an existing market into account. One might think quantum secure communication would be such a use case, but the entire design of the current Internet is built on the end-to-end argument and may reject the idea of implementing security as a physical layer protocol. On the other hand, higher data rates and reduced latency have been successfully used as key arguments for the conception of new communication standards. We thus argue that exactly these two figures of merit should be used again. We define two new initial stages of development of the quantum Internet, where in the first phase entanglement is only generated and used between network nodes, and in second phase entanglement swapping and thus distribution of entanglement over increasing distances becomes possible. In both phases, we show by simulation how the available new protocols increase the network capacity. Interestingly, following this envisioned approach can serve the needs of current market participants while paving the road for fully quantum applications in the future.
Quantum mechanics shows that if one is able to generate and manipulate entanglement over a distance, one is able to perform certain tasks which are impossible using only classical communication. Classical communication refers to what is used in the Internet of today. A quantum internet would therefore bring new capabilities to our highly connected world. These capabilities both involve (1) the ability to perform tasks with are provably impossible in the current Internet, such as unconditionally secure communication, and (2) the ability to perform certain tasks much more efficient, such as distributed (quantum) computing or extending the baseline of telescopes. To be able to build a quantum internet, two main components are needed: (i) hardware that can store, manipulate and entangle qubits and (ii) a software stack to control the hardware. The core task of both of these is to generate entanglement to be used by applications. In this thesis we focus on the latter, i.e. the development of software and protocols that enable entanglement generation using capable hardware. To enable a certain application, one can certainly, in theory, manually specify each operation the hardware should perform, involving micro-wave pulses, lasers etc. However, in practice this is not feasible, if not to say impossible, due to the complexity of the operations needed, especially in a distributed system such as a quantum network. What is needed is a software stack, which can help with abstracting complexity away in multiple layers. This allows for someone to program a protocol in one layer without knowing all the details of the lower layers. In particular, one can abstract away the hardware details, in order to make higher-layer protocols and applications hardware-agnostic. Therefore, to be able to build a universal, efficient and scalable quantum internet, a software stack is crucial. In chapter 2 we start discussing the networking part of a software stack. Namely, we introduce a network stack for a quantum internet, drawing parallels to the IP/TCP-suite of the classical Internet. We continue with proposing a service and interface of the lowest layer of the network stack: the link layer. The link layer is here responsible for generating entanglement between nodes in a quantum network which are directly connected by a quantum link, i.e. a fiber cable. When developing a protocol or application it is very useful to be able to run it. Both to see if the intended ideas make sense and also to check that the implementation is actually correct. Currently we do not have quantum hardware that exposes a full-fledge API that can be used to execute applications. For this reason, it is very useful to be able to instead simulate the hardware in a way that exposes the same API as the hardware being developed. In chapter 3 we introduce SimulaQron for this exact purpose. Any application of a quantum internet will need entanglement in one way or another. However, entanglement is generally hard to generate and is usually the bottleneck when executing an application. We would therefore like to make use of the generated entanglement in the most optimal way. To be able to do this we need to understand how entanglement can be transformed and distributed in a quantum network. We study the entanglement of a particular class of states called graph states in chapters 4 to 9 and how these states can be transformed in a quantum network.
A quantum internet is one of the promises of the second quantum revolution. New difficulties arise when the first quantum network (QN) hardware prototypes get closer to completion. The development of scalable QN systems is still in its early stages, yet a functioning network is more than simply the physical tools. The proposed method offers a QN protocol that addresses the novel conceptual and technological difficulties posed by quantum physics and enables end-to-end quantum communication. As the key procedure in quantum information science, quantum entanglement swapping (QES) has the potential to revolutionise QN communication. The suggested paradigm, which considers entanglement, enables safe communication utilising a trusted third party across a long-distance QN. The protocols might act as the basic structure of a future quantum internet. Even if scaling and entanglement coherence issues must be overcome, this research provides the groundwork for improving error-correcting codes and fault-tolerant quantum computers.
The Internet has revolutionized the way we live. It has enabled applications far beyond what it was originally built for, and it will continue to exceed our expectations for the future. Quantum computers, and the network that will connect them—the Quantum Internet— are likely going to follow the same path. Differently from normal computers, quantum computers can share a property called entanglement, which allows the qubits (quantum bits) to be connected at a much more fundamental level. This property enables a range of new applications that span secure communication to enhanced metrology. Over the past fifteen years, significant progress has been made in connecting rudimentary quantum network nodes via long-distance entanglement. Several quantum platforms have demonstrated entanglement generation between two physically separated qubits. In this thesis we take a significant step forward, both in terms of experimental complexity achieved, and in the abstraction of said complexity for future developments. Moving past two-node experiments required a fundamental redesign of our experimental apparatus, as well as developing the capabilities to control simultaneously the additional node. The first result of this thesis is building a three-node entanglement-based quantum network. We demonstrated distribution of Greenberger-Horne-Zeilinger states over the network, as well as a building block for larger networks: entanglement swapping. Differently from previous multi-node demonstrations, which relied on post-selection, our network is able to perform the entanglement distribution in a heralded fashion: a signal will notify the users that the protocol was successful, and that the state is ready to be used. The second result builds on the first, by adding control over a fifth qubit, improving the quality of the entanglement, and introducing a novel repetitive readout technique, to achieve quantum teleportation of a qubit from the third node to the first—nodes that do not share a direct entanglement channel. The third and final result is the demonstration of entanglement delivery using a quantum network stack. The Internet is built using a plethora of physical platforms: optical fibers, Ethernet cables, Wi-Fi, satellite signals etc. To abstract their functionality, and make applications work regardless of the underlying platform, a layered approach was developed in the 1970s (the Internet protocol). Taking inspiration from classical network stacks, we demonstrate the first two layers of a quantum network stack, the physical layer (where the qubits, lasers and signal generators live), and the link layer, which abstracts the concepts of qubit and entanglement generation such that they can be used by applications at the higher-layers, hiding the complexity of the quantum platform being used.
Quantum networks create a completely new way for communication, and the most important function of a quantum network is to generate long-distance quantum entanglement to serve a number of quantum applications. As the scale of the network expands, in order to establish end-to-end entanglement between two remote nodes, entangled pairs need to be generated and distributed among multiple repeaters along the path from the source to the destination, which requires a specific protocol to negotiate resource allocations and quantum operations among the repeaters. Thus, to realize such remote entanglement distribution in a quantum network, designing a stable and reliable protocol becomes urgent and necessary. In this article, we focus on how to guarantee the generation rate of entangled pairs between any two quantum nodes to meet the requirements of various quantum applications in a large-scale quantum network. We present a connection-oriented entanglement distribution protocol inspired by the connection-oriented communication model in classical networks. Our protocol is located in the network layer of the quantum network to enable end-to-end quantum communication. Three main features are provided by the proposed protocol: 1) it is reliable and can guarantee the successful entanglement generation; 2) it can reduce the influence of quantum decoherence via reducing the latency caused by resource competition; and 3) it can guarantee the rate of generating entanglement between two quantum nodes according to the requirement of quantum applications.
A first quantum revolution has already brought quantum technologies into our everyday life for decades: in fact, electronics and optics are based on the quantum mechanical principles. Today, a second quantum revolution is underway, leveraging the quantum principles of superposition, entanglement and measurement, which were not fully exploited yet. International innovation activities and standardization bodies have identified four main application areas for quantum technologies and services: quantum secure communications, quantum computing, quantum simulation, and quantum sensing and metrology. This paper focuses on quantum secure communications by addressing the evolution of Quantum Key Distribution (QKD) networks (under early exploitation today) towards the Quantum-ready networks and the Quantum Internet based also on entanglement distribution. Assuming that management and control of quantum nodes is a key challenge under definition, today, a main obstacle in exploiting long-range QKD and Quantum-ready networks concerns the inherent losses due to the optical transmission channels. Currently, it is assumed that a most promising way for overcoming this limitation, while avoiding the presence of costly trusted nodes, it is to distribute entangled states by means of Quantum Repeaters. In this respect, the paper provides an overview of current methods and systems for end-to-end entanglement generation, with some simulations and a discussion of capacity upper bounds and their impact of secret key rate in QKD systems.
This article summarizes the current status of classical communication networks and identifies some critical open research challenges that can only be solved by leveraging quantum technologies. Until now, the main goal of quantum communication networks has been security. However, quantum networks can do more than just exchange secure keys or serve the needs of quantum computers. In fact, the scientific community is still investigating the possible use cases/benefits that quantum communication networks can bring. Thus, this article aims to point out and clearly describe how quantum communication networks can enhance in-network distributed computing and reduce the overall end-to-end latency, beyond the intrinsic limits of classical technologies. Furthermore, we also explain how entanglement can reduce the communication complexity (overhead) that future classical virtualized networks will experience.