Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Spectral response of a SNSPD with different thickness of NbN films

M. Hofherr, K. Ilin, A. Semenov, Николай Алексеевич Гиппиус, Dagmar Rall, Heinz‐Wilhelm Hübers, Michael Alan Siegel

Published Jan 1, 2009• 0 citations
OpenAlex

Related papers

Dependence of sensitivity on thickness of NbN film in Spiral-MKIDs

Daiki Oka, Daisuke Kurashina, Kensuke Nakajima +4 more

The Japan Society of Applied Physics•Jul 22, 2016•0 citations

Dependence of microwave characteristic and photoresponsivity on NbN film thickness in Spiral-MKIDs

Daiki Oka

The Japan Society of Applied Physics•Jul 17, 2015•0 citations

Dependence of noise equivalent power on NbN film thickness of spiral-MKIDs

Atsushi SAITO, Daiki Oka, Yoshiki Kato +4 more

IEICE Technical Report; IEICE Tech. Rep.•Aug 2, 2019•0 citations

Broadening of hot-spot response spectrum of superconducting NbN nanowire single-photon detector with reduced nitrogen content

D. Henrich, S. Dörner, M. Hofherr +6 more

The spectral detection efficiency and the dark count rate of superconducting nanowire single-photon detectors (SNSPD) have been studied systematically on detectors made from thin NbN films with different chemical compositions. Reduction of the nitrogen content in the 4 nm thick NbN films results in a decrease of the dark count rates more than two orders of magnitude and in a red shift of the cut-off wavelength of the hot-spot SNSPD response. The observed phenomena are explained by an improvement of uniformity of NbN films that has been confirmed by a decrease of resistivity and an increase of the ratio of the measured critical current to the depairing current. The latter factor is considered as the most crucial for both the cut-off wavelength and the dark count rates of SNSPD. Based on our results we propose a set of criteria for material properties to optimize SNSPD in the infrared spectral region.

arXiv:1207.2014•Journal of Applied Physics•Oct 1, 2012•54 citations

AlN-Buffered Superconducting NbN Nanowire Single-Photon Detector on GaAs

Ekkehart Schmidt, K. Ilin, M. Siegel

We investigated the suitability of AlN as a buffer layer for NbN superconducting nanowire single-photon detectors (SNSPDs) on GaAs. The NbN films with a thickness of 3.3-20 nm deposited onto GaAs substrates with an AlN buffer layer demonstrate a higher critical temperature, critical current density, and lower residual resistivity in comparison to films deposited onto bare substrates. Unfortunately, the thermal coupling of the NbN film to the substrate weakens. SNSPDs made of 4.9-nm-thick NbN films on buffered substrates (in comparison to detectors made from NbN films on bare GaAs) demonstrate three orders of magnitude lower dark count rates and about ten times higher detection efficiency at 900 nm being measured at 90% of the critical current. The system timing jitter of SNSPDs on buffered substrates is 72 ps, which is 36 ps lower than those on bare substrate. However, a weaker thermal coupling of NbN nanowire to the buffered substrate leads to a latching effect at bias currents > 0.97 IC.

arXiv:1609.09694•IEEE Transactions on Applied Superconductivity•Dec 19, 2016•24 citations

Influence of superconductor dirtiness on the SNSPD sensitivity-bandwidth trade-off

S. Haldar, Yash Sharma, Krishna Balasubramanian

arXiv:2411.05381•Applied Physics A•Jun 24, 2025•3 citations
The spectral detection efficiency and the dark count rate of superconducting nanowire single-photon detectors (SNSPD) have been studied systematically on detectors made from thin NbN films with different chemical compositions. Reduction of the nitrogen content in the 4 nm thick NbN films results in a decrease of the dark count rates more than two orders of magnitude and in a red shift of the cut-off wavelength of the hot-spot SNSPD response. The observed phenomena are explained by an improvement of uniformity of NbN films that has been confirmed by a decrease of resistivity and an increase of the ratio of the measured critical current to the depairing current. The latter factor is considered as the most crucial for both the cut-off wavelength and the dark count rates of SNSPD. Based on our results we propose a set of criteria for material properties to optimize SNSPD in the infrared spectral region.
We investigated the suitability of AlN as a buffer layer for NbN superconducting nanowire single-photon detectors (SNSPDs) on GaAs. The NbN films with a thickness of 3.3-20 nm deposited onto GaAs substrates with an AlN buffer layer demonstrate a higher critical temperature, critical current density, and lower residual resistivity in comparison to films deposited onto bare substrates. Unfortunately, the thermal coupling of the NbN film to the substrate weakens. SNSPDs made of 4.9-nm-thick NbN films on buffered substrates (in comparison to detectors made from NbN films on bare GaAs) demonstrate three orders of magnitude lower dark count rates and about ten times higher detection efficiency at 900 nm being measured at 90% of the critical current. The system timing jitter of SNSPDs on buffered substrates is 72 ps, which is 36 ps lower than those on bare substrate. However, a weaker thermal coupling of NbN nanowire to the buffered substrate leads to a latching effect at bias currents > 0.97 IC.